Kalorimetrische Messungen an Mischungen von Nichtelektrolyten, 1. Mitt.: Molwärme des Systems 1,2-Dibromäthan-Benzol

Zusammenfassung Es wird der Aufbau eines Kalorimeters zur Bestimmung der spezif. Wärme von Flüssigkeiten beschrieben. Die Messungen werden nach einem kontinuierlichen adiabatischen Aufheizverfahren durchgeführt. Der Fehler in der Molwärme beträgt ca. ±0,4%. Die Methode erlaubt auch innerhalb relativ kleiner Temperaturbereiche eine Aussage über die Temperaturabhängigkeit der Wärmekapazität.Die Molwärme des Systems 1,2-Dibromäthan-Benzol wird zwischen 24 und 29°C über den ganzen Konzentrationsbereich vermessen. Die Mischungen zeigen negative C _p-Werte mit unsymmetrischem Konzentrationsverlauf. Für höhere Temperaturen ist eine Zunahme der Symmetrie zu erwarten.

---

A calorimeter has been described which serves to determine the heat capacities of liquids. In the measurements the calorimeter and the surroundings are heated continuously, so that adiabatic conditions prevail. The experimental error in the molar heat capacities is ca. ±0,4%. The method also permits the estimation of the temperature dependence of the heat capacities, even within relatively small temperature intervals.The molar heat capacity of the system 1,2-dibromoethane-benzene has been measured between 24° and 29°C for all concentrations. The C _p-values of the mixtures are negative and show an asymmetrical dependence on the concentration. For higher temperatures it is expected that the concentration dependence will become more nearly symmetrical.

---

---

Mit 3 Abbildungen     

Improvement in steroid screening for doping control with special emphasis on stanozolol

The Medical Commission of the International Olympic Committee forbids the use of anabolic androgenic steroids and beta2-agonists to improve athletic performance. In this work we have selected examples of anabolic androgenic compounds and their metabolites to evaluate the GC-MS analysis of some trimethylsilyl derivatives. The aim is to set the best GC conditions to improve the detection within the whole range of analyte elution temperatures. The initial column temperature was changed to 105 or 140 degrees C followed by 40 degrees C min(-1) to 200 degrees C and then 15 degrees C min(-1) to 300 degrees C. Using 140 degrees C as the initial oven temperature it was possible to obtain narrower initial analyte distributions for the compounds that elutes at the beginning of the chromatogram as clenbuterol, mabuterol, epimethylenediol and norandrosterone, without loss of derivatized metabolites signal. Later. eluting analytes, such as the stanozolol metabolites, furazabol and oxandrolone were not affected. Temperatures below 140 degrees C. resulted in partial derivatization for some analytes mainly stanozolol related structures. Therefore evaluation of derivatization conditions as occurring in three steps, the vial, vaporization chamber and capillary column, was thoroughly assessed. The new program temperature improves the signal-to-noise ratio for some compounds and shows adequate resolution for endogenous compounds. Some of the difficult key separations necessary for doping control enforcement were also obtained with the proposed method.     

Beiträge zur Chemie der Silicium—Stickstoff-Verbindungen, 21. Mitt.

Zusammenfassung Durch Umsetzung von Disilbercyanamid mit Organyl- und Alkoxy-halogensilanen wurden 9 bisher unbekannte zweifach silylsubstituierte Carbodiimide der Stoffgruppen (R₃SiN)₂C, [(RO)₃SiN]₂C, (R₂RSiN)₂C und R₃SiNCNSiR₃ dargestellt und in ihrer Struktur über¹⁴N- und¹H-kernmagnetische Resonanzmessungen, IR- und Raman-Spektren eindeutig als Carbodiimidderivate aufgeklärt.20. Mitt.:U. Wannagat undH. Kuckertz, Angew. Chem.75, 95 (1963).Zugleich 2. Mitt. über silylsubstituierte Carbodiimide; 1. Mitt.J. Pump undU. Wannagat, Ann. Chem.652, 21 (1962); Angew. Chem.74, 117 (1962); Österr. Chemiker-Ztg.62, 319 (1961).     

Trends in Preconcentration Procedures for Metal Determination Using Atomic Spectrometry Techniques

 Methods for metal preconcentration are often described in the literature. However, purposes are often different, depending on whether the methods are applied in environmental, clinical or technological fields. The respective method needs to be efficient, give high sensitivity, and ideally also is selective which is useful when used in combination with atomic spectroscopy. This review presents the actual tendencies in metal preconcentration using techniques such as Flame Atomic Absorption Spectrometry (FAAS), Electrothermal Atomic Absorption Spectrometry (ETAAS), Hydride Generation Atomic Absorption Spectrometry (HGAAS), Inductively Coupled Plasma Optical Emission Spectrometry (ICP OES) and Inductively Coupled Plasma Mass Spectrometry (ICP-MS). Procedures based on related to electrochemical, coprecipitation/precipitation, liquid–liquid and solid–liquid extraction and atom trapping mechanisms are presented. Correspondence: Department of Analytical Chemistry, Universidade Estadual de Campinas – UNICAMP, P.O. Box 6154, 13083-970 Campinas, Brazil. e-mail: zezzi@iqm.unicamp.br Received December 20, 2001; accepted October 11, 2002     

Solution properties of poly p-isopropyl α-methylstyrene

Two series (S and F) of poly p-isopropyl α-methylstyrene were characterized by viscometry, light scattering (LS), osmometry and gel permeation chromatography (GPC). S-samples were prepared by bulk anionic polymerization whereas F-samples were obtained on fractionation by preparative GPC of a polymer also prepared in bulk but with a different initiator. The K parameter in the Mark-Houwink relation was 5.55 × 10^?4 for series-S and 4.50 × 10^?4 for series-F, whereas the exponent a was 0.55 for both series. The Mark-Houwink equations for series-S and -F hold good at 25 and 30° for both toluene and tetrahydrofuran as solvents and have been corrected for polydispersity. The chain dimensions obtained with LS were much higher than those computed from the viscosity data indicating that the hydrodynamic theories in their present state should not be used for the calculation of chain dimensions. The deviations from the GPC universal calibration curve of polystyrene observed with some samples were attributed to structural differences among the polymers and to their high polydispersity.     

Thin-layer chromatography combined with diode laser desorption/atmospheric pressure chemical ionization mass spectrometry

The desorption of an analyte by a continuous wave diode laser from a porous surface of a thin-layer plate covered with a graphite suspension is presented. The thermally desorbed analyte molecules are ionized in the gas phase by a corona discharge at atmospheric pressure. Therefore, both essential processes--the desorption and the ionization of analyte molecules, which are often performed in one step--are separated. The target preparation is easy and fast since no additional extraction process is required. The mass spectrometric background signal was mostly limited to the low mass range showing no interference with typical compounds of interest. In this study, the calmative and antihypertensive drug reserpine was chosen as model analyte, which is often used for specification of mass spectrometers. No fragmentation was observed because of efficient collisional cooling under atmospheric pressure. The influence of diode laser power and the composition of the graphite suspension were investigated, and a primary optimization was performed.     

Oxygen rearrangement of molecular ions of 3-phenylpropionates

The oxygen rearrangement in molecular ions of 3-phenylpropionates has been investigated with the aid of mass analyzed ion kinetic energy spectra. Elimination of an allyl radical followed by expulsion of ketene from the molecular ion of allyl 3-phenylpropionate is shown to result in formation of protonated benzaldehyde. The oxygen rearrangement has been found to be inoperative in ionized methyl 3-methyl-3-phenylbutyrate. [M ? CH₃ ? CH₂CO]⁺ ions in the spectrum of the latter compound are formed by elimination of the 3-methyl substituent and subsequent methoxy migration.     

Experimental studies on the applicability of the Kelvin equation to highly curved concave menisci

The thermodynamic properties of liquids trapped in microscopic pores are described in theory by the Kelvin equation, which relates the equilibrium meniscus curvature to the relative vapor pressure. We report here two series of experiments designed to test the validity of the Kelvin equation by direct measurement of the mean radius of curvature of the surface of cyclohexane condensed between crossed mica cylinders. In one series of experiments, the relative vapor pressure of the volatile cyclohexane was controlled by mixing it with a relatively involatile solute (n-dodecane or n-hexadecane). We found that the mean radius of curvature rapidly reached that predicted by the Kelvin equation at each relative vapor pressure of the volatile liquid, but that there was also a slow, but continuous, accumulation of the “involatile” solute at the point of condensation as the system approached true equilibrium. Such accumulation of very low vapor pressure materials may be one factor responsible for the discordant results reported by earlier workers. We find that the process of impurity buildup is complex, and suggest that studies of real porous systems may be affected by accumulation of “involatile” impurities through the vapor phase and by surface diffusion. The other series of experiments was designed to eliminate the impurity problem by maintaining the vapor pressure by temperature control of the pure liquid. The results from this series of experiments were not time dependent, and no evidence of contamination was found. The measured radii were within ±6% of those predicted by the Kelvin equation, for radii in the range 4–20 nm. We conclude that the thermodynamic basis of the Kelvin equation is valid in principle for menisci with radii as low as 4 nm.