Simultaneous determination of cocaine and its metabolites with caffeine in rat serum microsamples by high-performance liquid chromatography

A single, isocratic high-performance liquid chromatographic method is described for the determination of cocaine and three of its metabolites along with caffeine in serum microsamples (50 microliters). The small sample size permits the tracking of pharmacokinetic data over time in individual, small animals. The method also was used to demonstrate that cocaine, benzoylecgonine and norcocaine in rat serum samples were stable for at least a month without the presence of sodium fluoride.     

Analysis of Ginkgo biloba for the presence of ginkgotoxin and ginkgotoxin 5'-glucoside

Hot water extracts of Ginkgo biloba seeds were analyzed for the presence of ginkgotoxin (4'-O-methylpyridoxine) by reversed-phase liquid chromatography (LC) using methanol-0.05M KH2PO4 (1 + 9, v/v) adjusted to pH 3 as mobile phase. Detection was by fluorescence (excitation 280 nm, emission 370 nm). A straight line calibration curve was obtained for the 10-100 ng injected. After addition of beta-glucosidase (37 degrees C/h), an earlier eluting peak disappeared and the ginkgotoxin peak increased. The identity of the ginkgotoxin was confirmed by LC/MS and LC/MS/MS. LC/MS/MS also confirmed the 5'-glucoside by comparison with the 3-glucoside. This is the first identification of a glucoside of ginkgotoxin in Ginkgo biloba. An unknown compound of MW 267 also observed in the Ginkgo biloba seed extract was shown not to be 3,5'-diacetylginkgotoxin by its different LC retention time. Extraction of ground Ginkgo biloba seeds with boiling water in a Soxhlet for 2 x 2 h yielded a total of 179 microg/g of free ginkgotoxin. The concentration in powder from Ginkgo biloba capsules was several times lower than this (17-64 microg/g) in 3 samples but higher in another (457 microg/g). Canned ginkgo seeds (white nuts) contained no detectable free ginkgotoxin but the glucoside was present. Different extraction times were studied: 0.5 h gave only 52 microg/g free ginkgotoxin in the ginkgo seeds. However, boiling an extract for 4 h showed about 15% loss of ginkgotoxin and its glucoside.     

A theoretical examination of the acid-catalyzed and noncatalyzed ring-opening reaction of an oxirane by nucleophilic addition of acetate. Implications to epoxide hydrolases

Ab initio and density functional calculations have been performed to gain a better understanding of the epoxide ring-opening reaction catalyzed by epoxide hydrolase. The S(N)2 reaction of acetate with 1S,2S-trans-2-methylstyrene oxide to provide the corresponding diol acetate ester was studied with and without general-acid catalysis. MP2 and DFT (B3LYP) calculations predict, for the noncatalyzed reaction, a central barrier of approximately 20-21 kcal/mol separating the reactants from products depending on which carbon center in the epoxide is undergoing attack. From these gas-phase reactions the immediate alkoxide products are not energetically far below their associated transition states such that the reaction is predicted to be endothermic. Inclusion of aqueous solvation effects via a polarizable continuum model predicts the activation barrier to increase by almost 10 kcal/mol due to the solvation of the acetate ion nucleophile. The activation barrier for the epoxide ring-opening reaction is reduced to approximately 10 kcal/mol when phenol, as the general-acid catalyst, is included in the gas-phase calculations. This is due to the immediate product being the neutral ester rather than the corresponding alkoxide. The transition state in the general-acid-catalyzed reaction is earlier than that for the noncatalyzed reaction and the reaction is highly exothermic. Molecular mechanics calculations of 1S,2S-trans-2-methylstyrene oxide in the active site of murine epoxide hydrolase show two possible binding conformations. Both conformers have the epoxide oxygen forming hydrogen bonds with the acidic hydrogens of the catalytic tyrosines (Tyr381 and Tyr465). These two conformations likely lead to different products since the nucleophile (Asp333-CO(2)(-)) is positioned to react with either carbon center in the epoxide.     

Analysis of the contribution of skeletal vibrations to the heat capacity of linear macromolecules in the solid state

Automatic computer programs are developed to calculate one- two-, and three-dimensional Debye functions. Prior tables of these functions are critically reviewed. Also, strategies are derived to calculate Debye temperatures from heat capacities. Both, simple three-dimensional Debye analyses and Tarasov analyses were carried out on 35 linear macromolecules. The experimental heat capacities for these analyses were collected in the ATHAS data bank. It is shown that the skeletal heat capacity of linear macromolecules is often best represented by only two vibrations per chain atom. For most of the all-carbon chain macromolecules the intramolecular skeletal heat capacity can be given by C_vs=D₁[520 (28/MW)^1/2] whereMW is the molecular mass andD ₁ represents the one-dimensional Debye function. Polyoxides show a higher intramolecular theta temperature, but a lower intermolecular theta temperature. Double bonds and phenylene groups in the chain increase the intramolecular theta temperature.Dedicated to Prof. Dr. F. H. Müller.On leave from the Lumumba Peoples' Friendship University, Moscow, USSR.     

The reaction of chlorine monofluoride with selenium dioxide,tetrachloride and sulphur tetrachloride

Chlorine monofluoride reacts with SCl₄ and SeCl₄ to give the corresponding tetrafluorides, with SeO₂ it yields SeOF₂ and with excess ClF, SeF₄. The behaviour of the tetrafluorides, tetrachlorides, dioxides, and oxydifluorides of sulphur, selenium and tellurium with ClF are compared.     

Controlled kinetics of non-enzymatic chemiluminescence reactions for simple imaging of DNA and protein

A robust and sensitive non-enzymatic chemiluminescence (CL) imaging method is presented. In the method a fast-emitting CL reaction is tuned to furnish a slower-emitting reaction suitable for simple CL imaging. Typically, non-enzymatic CL reactions between luminol or fluorescein and oxygen species generated by KCN as catalyst, were rather fast and unsuitable for CL imaging; the speed of the reactions could, however, be reduced substantially by changing KCN for CH(3)CN or benzonitrile. Light emission from the tuned CL reaction was intense and long-lived, and even with a simple arrangement high sensitivity could be achieved. The maximum CL peak was reached after approximately 1.5 min in the presence of 25% acetonitrile, and as little as 16 fmol commercial isoluminol-labeled streptavidin was detected and visualized on either microplate or membrane. The approach was further illustrated by imaging of DNA on a membrane and of antibody on a microplate by use of biotin-streptavidin chemistry. Overall, this simple, economical, and sensitive CL imaging system is expected to be very useful in biochemical analysis, and greatly complements currently used enzyme-based CL imaging methods, especially in routine applications.     

Analysis of organic acids and inorganic anions in beverage drinks by capillary electrophoresis

To meet the need for a new and validated analytical method for simultaneous determination of inorganic and organic acid anions in beverage drinks, a capillary zone electrophoresis (CZE) procedure had been developed based on a new background electrolyte (BGE) system containing 3 mmol/L 1,3,5-benzenetricarboxylic acid (BTA), 15 mmol/L tris(hydroxymethyl)aminomethane and 1.5 mmol/L tetraethylenepentamine (TEPA) at pH 8.4. Baseline separation of anions commonly found in beverage drinks could be achieved in less than 14 min with indirect UV detection at 240 nm. Comigration problems for hydroxycarboxylic acids could be solved using TEPA as BGE additive. The results indicate excellent repeatability for migration time (RSD, 0.27-0.67%, n = 5) and good precision for both peak height (RSD, 3.2-4.2%, n = 5) and peak area (RSD, 3.1-4.5%, n = 5). Under the optimized conditions and using corrected peak area for quantitation, an excellent linear dynamic range (with correlation coefficient > 0.997 in a concentration range from 0.005 to 2.0 mmol/L) and low detection limit (1-4 micro mol/L) were obtained for all the anions investigated. The applicability and reliability of the CE procedure developed were established by parallel method determination using established ion chromatography procedure for the analysis of inorganic and organic acid anions in orange juice and wine samples. Our CZE procedure provided a sensitive and economic technique for simultaneous determination of inorganic and organic acid anions in orange juice, red and white wine samples.     

An annulene-fused cyclopentadienide. A photochromic cyclopentadienodimethyldihydropyrene where the fused cyclopentadienide group resembles benzene in its effect on the dihydropyrene-metacyclophanediene valence isomerization

The synthesis of the green cyclopentadiene-fused dimethyldihydropyrene 12 was achieved in 36% yield in 7 steps from the parent dihydropyrene 3. Reaction of 12 with KH or LiCH(2)SiMe(3) gave the [14]annulene-fused cyclopentadienide anion quantitatively. In the (1)H NMR spectra, the internal methyl protons of 12 at delta -3.9, change dramatically on formation of anion 5, becoming deshielded to delta -1.82. This is caused by the reduction in diatropicity of the [14]annulene ring on fusion to the 6pi-cyclopentadienide ring. The anion is also a photochromic switch. Irradiation of the closed form 5 with visible light opens it to the open form 5', which reverts to the closed form 5 either with UV light or thermally. The switching behavior is between that of the parent 3/3' and the benzannelated system 4/4' and suggests that in its effect on the photoswitching, cyclopentadienide is behaving chemically similar to benzene.     

Gold particle interaction in regular arrays probed by surface enhanced Raman scattering

Lithographically designed two-dimensional arrays consisting of gold nanoparticles deposited on a smooth gold film are used as substrate to examine the SERS effect of the trans-1,2-bis (4-pyridyl) ethylene molecule. These arrays display two plasmon bands instead of the single one observed for the same arrays of particles but deposited on indium tin oxide coated glass. Laser excitation within the short wavelength band does not bring about any SERS spectrum, while excitation within the long wavelength band yields SERS spectra with a gain per molecule rising up to 10(8). The simultaneous investigation of extinction and Raman spectra of arrays exhibiting various topography parameters enables us to suggest an interpretation for both the occurrence of the two plasmon resonances and for the high Raman enhancement. We suggest to assign the short wavelength band to a plasmon wave propagating at the gold glass interface and the long wavelength one to an air/gold surface plasmon mode modified by particle-particle interaction.     

Direct aziridination of alkenes by a cationic (salen)ruthenium(VI) nitrido complex

[RuVI(N)(salchda)(CH3OH)]PF6 (1) (salchda = N,N'-bis(salicylidene)o-cyclohexyldiamine dianion) reacts readily with 2,3-dimethyl-2-butene at room temperature in the presence of pyridine or 1-methylimidazole to give initially [RuIV(Az1(-H))(salchda)(py)]PF6 (2, Az1 = 2,2,3,3-tetramethylaziridine), which is then slowly reduced to [RuIII(Az1)(salchda)(py)]PF6 (3). 1 also reacts with a variety of aryl-substituted alkenes such as styrene and trans-beta-methylstyrene in the presence of py or 1-MeIm to give the corresponding ruthenium(III) aziridine complexes. The structures of 3 and [RuIII(Az2)(salchda)(1-MeIm)]PF6 (4, Az2 = trans-2-methyl-3-phenylaziridine) have been determined by X-ray crystallography. The Ru-N(aziridine) distances (2.1049, 2.097 A) are consistent with a neutral aziridine ligand. The C-C and C-N distances in the aziridine ligands are all indicative of single bonds.