串联系统可靠性虚拟系统法置信下限的小样本性质

本文讨论了具有r个成败型元件串联系统可靠性的置信下限问题。研究了虚拟系统法置信下限的小样本性质,证明了,在通常情况下虚拟系统法置信下限要大于常见的L-M法置信下限.更一般地,本文证明了在成败型试验中,当成功数与试验数之比保持不变时,试验次数的增加将直接缩小成功率置信区间的长度。     

Onn-th commutators with nilpotent or regular values in rings

Then-th commutator for a,b in a ringR is defined inductively as follows: [a,b]₁=[a,b]=ab−ba and[a,b] _n=[[a,b]₋₁,b]. We characterize the ringsR without non-zero nil right ideals in which[a,b] _nis nilpotent or regular for alla,b∈R. We also examine the case whereR is a semiprime ring with involution in which[t ₁, t₂]_nis nilpotent or regular for all tracest ₁,t₂∈R.     

Measurements of climatic parameters and ground-level ozone at Terra Nova Bay in Antarctica

Summary The results of local meteorology, solar radiation and ground-level ozone measurements taken in Antarctica during the second Italian expedition (December 86–February 87) at Terra Nova Bay are presented. During the summer months the site of the Italian base camp is characterized by a thin strip of deglaciated ground, along which the temperature measurements close to the ground and up to 6 m high show a strongly superdiabatic profile. This irregular trend of the temperature in the surface layer is mainly due to the notable incoming amounts of radiation and to the extreme transparency of the atmosphere. This is also shown by the low values of the ratio between total radiation and diffuse radiation. The ground is thus subjected to intense heating, especially in the warmer hours of the day, while the surface layer of the atmosphere will be characterized by strong upward heat fluxes and by turbulent convective movements. Vertical-temperature-profile measurements show an almost forced persistence in the superdiabatic trend, which tends towards isothermic values only as a resultof rapid variations in the direction and intensity of the wind, connected to the downward flux of cold air masses, shown also by the simultaneous increases in ground-level ozone concentrations which would support the presence of dry-deposition processes in the lower layer. However, the complex local orography and the horizontal discontinuity (sea, deglaciated coast, snow-covered surfaces) do not permit a correct application of profile flux relations, normally used in studies on groundlevel dry-deposition. Paper presented at the IV Congresso del Gruppo Nazionale per la Fisica dell'Atmosfera e dell'Oceano, June 22–24, 1987, Rome.     

Realization of optical limiting with a magnetic fluid film

In this paper, optical limiting property in a magnetic fluid film is studied. The relationship between the emergent power and the incident power is investigated experimentally and theoretically. It is found that the limiting threshold is linear with the diaphragm aperture which accord with the theoretical prediction. The external magnetic field will affect the limiting property, and increase the limiting threshold.     

Rotationally Invariant Proof of Bell’s Theorem Without Inequalities for 4k-Dimensional (k=1,2,...) Systems

We present rotationally invariant proof of Bell‘s theorem without inequalities for spin-(2N 1)/2system (N = 2k-1,k = 1, 2, 3, 4...) with only two particles, which is a generalization of Cabello‘s study [Phys. Rev. A 67 (2003)032107].     

Development of a universal constant rate thermal analysis system for being used with any thermoanalytical instrument

The SCTA method implies to control the temperature in such a way that the reaction rate changes with the time according to a function previously defined by the user. Constant Rate Thermal Analysis (CRTA) is one of the most commonly used SCTA methods and implies achieving a temperature profile at which the reaction rate remains constant all over the process at a value previously selected by the user. This method permits to minimize the influence of heat and mass transfer phenomena on the forward reaction. The scope of this work is to develop a universal CRTA temperature controller that could be adapted to any thermoanalytical device. The thermoanalytical signal is programmed to follow a preset linear trend by means of a conventional controller that at the time controls a second conventional temperature programmer that forces the temperature to change for achieving the trend programmed for the thermoanalytical signal. Examples of the performance of this control system with a Thermobalance and a Thermomechanical Analyser (TMA) are given.     

Local algebras in the representation of MV-algebras

In this paper we present several results about local MV-algebras, extending existing results given for MV-chains. The role of local MV-algebras in sheaf representation and weak boolean product is stressed and the relationship of local MV-algebras with varieties of MV-algebras is analyzed. Presented by S. Pulmannova. Received November 11, 2005; accepted in final form December 20, 2005.     

带有奇异项的临界增长p-Laplace方程的非平凡解

本文研究了一种带有奇异项的临界增长p-Laplace方程在N维空间中的有界集上非平凡解的问题,利用山路引理和集中紧性原理,得出方程在非线性项满足一定条件下有非平凡解的结果.     

Dynamic Nonlinear Modelization of Operational Supply Chain Systems

Supply Chain Management (SCM) is an important activity in all producing facilities and in many organizations to enable vendors, manufacturers and suppliers to interact gainfully and plan optimally their flow of goods and services. To realize this, a dynamic modelling approach for characterizing supply chain activities is opportune, so as to plan efficiently the set of activities over a distributed network in a formal and scientific way. The dynamical system will result so complex that it is not generally possible to specify the functional forms and the parameters of interest, relating outputs to inputs, states and stochastic terms by experiential specification methods. Thus the algorithm that will presented is Data Driven, determining simultaneously the functional forms, the parameters and the optimal control policy from the data available for the supply chain. The aim of this paper is to present this methodology, by considering dynamical aspects of the system, the presence of nonlinear relationships and unbiased estimation procedures to quantify these relations, leading to a nonlinear and stochastic dynamical system representation of the SCM problem. Moreover, the convergence of the algorithm will be proved and the satisfaction of the required statistical conditions demonstrated. Thus SCM problems may be formulated as formal scientific procedures, with well defined algorithms and a precise calculation sequence to determine the best alternative to enact. A “Certainty equivalent principle” will be indicated to ensure that the effects of the inevitable uncertainties will not lead to indeterminate results, allowing the formulation of demonstrably asymptotically optimal management plans.     

用OZSAD软件实现复合式变焦凸轮曲线优化设计

变焦距光学系统凸轮曲线设计是保证光学系统变焦精确、平滑和驱动力均衡的关键。以2运动组元变焦系统的牛顿法变焦推导公式为依据，分析等间隔设计和等角距设计凸轮曲线方法的特点，结合EBA20X10光学镜头设计实例，探讨了结合2者优点实现复合式凸轮曲线优化设计的方法。文中等间距是指变倍透镜组沿光轴的移动量与凸轮转角呈线性关系，凸轮曲线沿圆周展开为直线；等角距是指系统焦距与凸轮转角呈线性关系。最后介绍了可实现3种凸轮曲线辅助设计的软件工具OZSAD V1.2。设计结果表明，该设计方法可以降低凸轮曲线压力角，减少总展开角及加工点对数，还可保证凸轮的设计精度。