Adsorption properties of activated carbon from waste newspaper prepared by chemical and physical activation

Adsorption properties of activated carbons prepared from waste newspaper by chemical and physical activation were investigated using water vapor, ammonia, methane, and methylene blue (MB) as adsorbents. The water vapor adsorption isotherms show type V behavior and the maximum vapor adsorption of the chemically and physically activated products is about 1050 and 450 ml/g, respectively. The higher water vapor adsorption of the chemically activated products is attributed to the higher specific surface area (S(BET)) and greater hydrophilic activity (arising from the surface oxygen-containing functional groups) than in the physically activated products. The adsorption of ammonia and methane was measured by temperature-programmed desorption (TPD). NH(3) adsorption is found to be higher in the chemically activated product than in the physically activated product while methane adsorption is slightly higher in the physically activated products even though these have lower S(BET) values. In the MB adsorption, the chemically activated products show higher adsorption (390 mg/g) than the physically activated product. These results are suggested to be related to the surface characteristics.     

Reaction of poly(vinyl alcohol) with formaldehyde and polymer stereoregularity. Model compounds

The reaction of stereoisomers of pentane-2, 4-diol and heptane-2, 4, 6-triol with formaldehyde was investigated as a model for the formalization reaction of poly(vinyl alcohol) in order to determine effect of the stereochemical configuration of the polyol molecules on the reaction. The isotactic (meso) diol portion reacted with formaldehyde to give cis-formal several times faster than did the syndiotactic (dl) diol portion to give trans-formal at 30–80°C. In the reaction of heterotactic (meso-dl) triol which provides both the isotactic and syndiotactic diol portions in a molecule, the proportion of trans-formal in the total formal decreased as the reaction proceeded. This shows that the formation of cis-formal is also favored thermodynamically to a greater extent, and hence the intramolecular migration of trans-formal to cis-formal did occur during the reaction. The rates of hydrolysis of formals of the diols were compared with those of the triols in order to see the effect of a hydroxyl group adjacent to the formal ring on the reaction. No appreciable rate difference was observed between the dimer and trimer models both in cis- and trans- formals. Therefore it was deduced from these results that the increase of the rate of hydrolysis of poly(vinyl formal) with the increase of hydroxyl groups along the polymer chain is a characteristic of macromolecules that is not observed in the low molecular weight models.     

Determination of electrochemical kinetic parameters by square-wave polarography: Polarographic reduction of Zn(II) in 1 M KCl,KBr, and KNCS solutions

A new method of determining electrochemical kinetic parameters by square-wave polarography was presented, in which the faradaic current at θ/2, θ being the half-period of superimposed square-wave voltage, was used for the analysis. The method gave the following kinetic parameters for the electrode reaction, Zn(II) + 2e(Hg), in aqueous solutions at 25° C: k_c^θ=0.0052 cm s^?1 and α_c=0.36 in 1 M KCl, k_c^θ=0.011 cm s^?1 and α_c=0.30 in 1 M KBr, and k_c^θ=0.020 cm s^?1 and α_c=0.52 in 1 M KNCS. Induced adsorption of Zn(II) on the dropping mercury electrode was suggested in solutions containing thiocyanate ions.     

Chiral ligand-controlled asymmetric conjugate addition of lithium amides to enoates

The external chiral ligand-controlled asymmetric conjugate addition reaction of lithium amides with alpha,beta-unsaturated esters provided beta-amino esters in high yields and high enantioselectivities.     

Thermal and photochemical rearrangements of 1,4-dithiin sulfoxides

Thermolysis of 2,5-diphenyl-1,4-dithiin-1-oxide afforded 2-formyl-2,4-diphenyl-1,3-dithiole, which was obtained also in photolysis along with another rearranged product, 2-benzoyl-4-phenyl-1,3-dithiole.     

Preparation of Polycrystalline Antimonic Acid Films by Electrophoretic Deposition

Cubic antimonic acid (Sb₂O₅·nH₂O) films were successfully prepared on stainless steel and Si(100) substrates by electrophoretic deposition (EPD) using two types of sols. The sols were prepared by reacting an H₂O₂ aqueous solution with Sb(O-i-C₃H₇)₃ or metallic Sb powder. The resulting films were found to consist of fine particles of cubic Sb₂O₅·nH₂O single crystals with uniform particle sizes of 30 nm and 150 nm. The weight of the Sb₂O₅·nH₂O deposit on the anode Si(100) substrate by EPD increased linearly with the current density in the range of 0–0.67 mA cm^–2, when the sol pH was over 7. The proton conductivity of the polycrystalline Sb₂O₅·nH₂O discs, formed from the two types of sols, was evaluated by an ac impedance method at room temperature under controlled levels of relative humidity.     

Ion-Pair Solvent Extraction of EDTA Anions with Tetraalkylammonium Ions in Various Organic Solvents

Summary.  The ion-pair solvent extraction behavior of ethylenediaminetetraacetate (EDTA) anion by various tetraalkylammonium ions was investigated at 25.0 ± 0.1°C. The extraction of EDTA exceeded 90% from the basic aqueous solution into the organic solvents such as n-hexane and benzene derivatives containing tri-n-octylmethylammonium chloride, but EDTA was hardly extracted from acidic solution. Among the chemical species of EDTA in aqueous solution, edta ⁴⁻ is the most extractable one. On the other hand, the extraction of EDTA was less than 1% into chloroform and 1,2-dichloroethane even from the basic aqueous solution. The effect of the structure of alkylammonium ion was also examined. Tetra-n-hexylammonium and tetra-n-octylammonium ions could not extract EDTA even from the basic aqueous solution, while the use of tri-n-octylmethylammonium and di-n-lauryldimethylammonium ions enhances the extraction of EDTA. These results suggest that the steric hindrance in the ion-pair of alkylammonium and EDTA anion in the organic phase affects the extractability of EDTA containing ion-pair. The solution structure of ion-pair in the organic phase was calculated by MMFF force field and the steric effect in the ion-pair was also suggested. From the extraction constants obtained, the possibility of the extraction separation of EDTA has been shown. Present address: Chemistry Department, Heilongjiang University, Harbin, China     

Ion-exclusion chromatography with conductimetric detection of aliphatic carboxylic acids on a weakly acidic cation-exchange resin by elution with benzoic acid-beta-cyclodextrin

In this study, an aqueous solution consisting of benzoic acid with low background conductivity and beta-cyclodextrin (beta-CD) of hydrophilic nature and the inclusion effect to benzoic acid were used as eluent for the ion-exclusion chromatographic separation of aliphatic carboxylic acids with different pKa values and hydrophobicity on a polymethacrylate-based weakly acidic cation-exchange resin in the H+ form. With increasing concentration of beta-cyclodextrin in the eluent, the retention times of the carboxylic acids decreased due to the increased hydrophilicity of the polymethacrylate-based cation-exchange resin surface from the adsorption of OH groups of beta-cyclodextrin. Moreover, the eluent background conductivity decreased with increasing concentration of beta-cyclodextrin in 1 mM benzoic acid, which could result in higher sensitivity for conductimetric detection. The ion-exclusion chromatographic separation of carboxylic acids with high resolution and sensitivity was accomplished successfully by elution with a 1 mM benzoic acid-10 mM cyclodextrin solution without chemical suppression.     

Unexpected formation of benzaldehydes by the reactions of dithioacetals derived from cinnamaldehydes with 2,3-dichloro-5,6-dicyano-p-benzoquinone in aqueous solvents

1,3-Dithianes 1 , 1,3-dithiolanes 2 , and diphenyl dithioacetals 3 derived from cinnamaldehydes reacted with 2,3-dichloro-5,6-dicyano-p-benzoquinone in aqueous solvents to give benzaldehydes 4 . Hydride transfer from 1–3 to 2,3-dichloro-5,6-dicyano-p-benzoquinone followed by hydrolysis and oxidative carbon-carbon bond cleavage would produce benzaldehydes 4 .