Electron charge distribution of CaAl2−xZnx: Maximum entropy method combined with Rietveld analysis of high-resolution-synchrotron X-ray powder diffraction data

Using short wavelength X-rays from synchrotron radiation (SPring-8), high-resolution powder diffraction patterns were collected. In order to study both the structural relationship and the mechanism of stability in the CaAl_2−xZn_x system, among the Laves phases (MgCu₂ and MgNi₂ type) and KHg₂-type structures, the charge density distribution of CaAl_2−xZn_x as a function of x was obtained from the diffraction data by Rietveld analysis combined with the maximum entropy method (MEM). In the MEM charge density maps overlapping electron densities were clearly observed, especially in the Kagomé nets of the Laves phases. In order to clarify the charge redistribution in the system, the deformation charge densities from the densities formed by the constituent free atoms are discussed. In the ternary MgNi₂-type phase, partial ordering of Al and Zn atoms is observed, a finding that is supported by ab-initio total energy calculations.     

Infrared spectroscopic investigation of CO adsorption on SBA-15- and KIT-6-supported nickel phosphide hydrotreating catalysts

The infrared (IR) spectra of CO adsorbed on 10, 20, and 30 wt % nickel phosphide-containing reduced SBA-15 and KIT-6 mesoporous silica-supported catalysts have been studied at 300-473 K. On the catalysts containing a stoichiometric amount of phosphorus with 20 wt % loading, the most intense IR absorption band was observed at 2097-2099 cm(-1), which was assigned to CO terminally bonded to coordinatively unsaturated Ni(delta+) (0 < delta < 1) sites. The frequency of this band was 15 cm(-1), higher than that in the spectrum of a reduced Ni2P/SiO2 catalyst, indicating a modified Ni-P charge distribution. This band shifted to lower wavenumbers, and its intensity decreased, while the relative intensity of another band at 2191-2194 cm(-1) assigned to CO terminally bonded to P increased going to catalytically less active, excess-P-containing SBA-15-supported catalysts. CO also adsorbed as a bridged carbonyl (1910 cm(-1)) and as Ni(CO)4 (2050 cm(-1)) species, and the formation of surface carbonates was also identified. The nature of the surface acidity was studied by temperature-programmed desorption of ammonia (NH3-TPD). Weak and strong acid sites were revealed, and the high excess-P-containing catalyst released the highest amount of ammonia, indicating that a high concentration of strong acidity can be disadvantageous for reaching high hydrotreating catalytic activity. The modified Ni-P charge distribution, the mode of CO adsorption on surface nickel phosphide sites, as well as the acidity can be directly connected to the catalytic activity of these mesoporous silica-supported catalysts.     

Phenothiazinophanes: synthesis, structure, and intramolecular electronic communication

Ortho-phenylene, ethenylene, and ethylene-bridged phenothiazinophanes are synthesized by Suzuki coupling or McMurry dimerization and catalytic hydrogenation at ambient pressure. Intensive intramolecular electronic communication of the phenothiazinyl subunits is found according to cyclic voltammetry. In addition, the macrocycles display blue to green fluorescence with large Stokes shifts. In the solid state, the cyclophanes are arranged in unidimensional stacks. This orientation appears to be favorable for anisotropic charge transport in hole-transport materials for organic field effect transistors (OFET) applications.     

Structure and performance of silica-based monolithic HPLC columns

Silica-based monolithic columns were prepared for HPLC with systematic variations of the tetramethoxysilane (TMOS) and polyethylene oxide (PEO) content as reactants in a sol-gel process accompanied by phase separation. The resulting monoliths showed differences in the macropore and silica skeleton diameter as well as in the corresponding domain sizes (the sum of macropore and skeleton diameter). All monoliths were synthesized with a diameter of 4.6 mm and cladded with a suitable polyaryletheretherketone (PEEK) polymer in a standardized and optimized manner for the subsequent chromatographic evaluation of the resulting monolithic HPLC columns. The columns were tested under normal phase conditions using n-heptane/dioxane (95:5 v/v) as a mobile phase and 2-nitroanisole as a test compound for the determination of separation efficiency and permeability. Two different sets of columns were prepared: the first one in which the amount of PEO was stepwise decreased to yield monoliths with identical macropore volumes and variations in the domain sizes. The second group of materials was synthesized adjusting both TMOS and PEO quantities to yield monolithic columns with identical macropore diameters of about 1.80 microm but different skeleton diameters and macropore volumes. The chromatographic results suggest that an increase in the column performance cannot be achieved by just arbitrarily decreasing the domain size of a given column. From a certain point of "downsizing" the monolithic structure a loss of structural homogeneity can be observed, which is apparently responsible for a lower chromatographic performance.     

Mixed micelles of a PEO-PPO-PEO triblock copolymer (P123) and a nonionic surfactant (C12EO6) in water. a dynamic and static light scattering study

The present article reports on static and dynamic light scattering (SLS and DLS) studies of aqueous solutions of the nonionic surfactant C12EO6 and the poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) triblock copolymer EO20PO68EO20 (P123) at temperatures between 25 and 45 degrees C. In water, P123 self-assembles into spherical micelles with a hydrodynamic radius of 10 nm, and at 40 degrees C, these micelles consist of 131 unimers. Addition of C12EO6 leads to an association of the surfactant molecules to the P123 micelles and mixed micelles are formed. The size and structure of the mixed micelles as well as interparticle interactions were studied by varying the surfactant-to-copolymer (C12EO6/P123) molar ratio. The novelty of this study consists of a composition-induced structural change of the mixed micelles at constant temperature. They gradually change from being spherical to polymer-like with increasing C12EO6 content. At low C12EO6/P123 molar ratios (below 12), the SLS measurements showed that the molar mass of the mixed micelles decreases with an increasing amount of C12EO6 in the micelles for all investigated temperatures. In this regime, the mixed micelles are spherical and the DLS measurements revealed a decrease in the hydrodynamic radius of the mixed micelles. An exception was found for C12EO6/P123 molar ratios between 2 and 3, where the mixed micelles become rodlike at 40 degrees C. This was the subject of a previous study and has hence not been investigated here. At high molar ratios (48 and above), the polymer-like micelles present a concentration-induced growth, similar to that observed in the pure C12EO6/water system.     

Suppressed dependence of polarization on epitaxial strain in highly polar ferroelectrics

A combined experimental and computational investigation of coupling between polarization and epitaxial strain in highly polar ferroelectric PbZr(0.2)Ti(0.8)O3 (PZT) thin films is reported. A comparison of the properties of relaxed (tetragonality c/a approximately 1.05) and highly strained (c/a approximately 1.09) epitaxial films shows that polarization, while being amongst the highest reported for PZT or PbTiO3 in either film or bulk forms P(r) approximately 82 microC/cm(2)), is almost independent of the epitaxial strain. We attribute this behavior to a suppressed sensitivity of the A-site cations to epitaxial strain in these Pb-based perovskites, where the ferroelectric displacements are already large, contrary to the case of less polar perovskites, such as BaTiO3. In the latter case, the A-site cation (Ba) and equatorial oxygen displacements can lead to substantial polarization increases.     

A calorimetry and light scattering study of the formation and shape transition of mixed micelles of EO20PO68EO20 triblock copolymer (P123) and nonionic surfactant (C12EO6)

The interaction between the nonionic surfactant C12EO6 and the poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) triblock copolymer EO20PO68EO20 (P123) has been investigated by means of isothermal titration and differential scanning calorimetry (DSC) as well as static and dynamic light scattering (SLS and DLS). P123 self-assembles in water into spherical micelles at ambient temperatures. At raised temperatures, the DSC data revealed a sphere-to-rod transition of the P123 micelles around 60 degrees C. C12EO6 interacts strongly with P123 micelles in aqueous solution to give mixed micelles with a critical micelle concentration (cmc) well below the cmc for pure C12EO6. The presence of C12EO6 also lowers the critical micelle temperature of P123 so aggregation starts at significantly lower temperatures. A new phenomenon was observed in the P123-C12EO6 system, namely, a well-defined sphere-to-rod transition of the mixed micelles. A visual phase study of mixtures containing 1.00 wt % P123 showed that in a narrow concentration range of C12EO6 both the sphere-to-rod transition and the liquid-liquid phase separation temperature are strongly depressed compared to the pure P123-water system. The hydrodynamic radius of spherical mixed micelles at a C12EO6/P123 molar ratio of 2.2 was estimated from DLS to be 9.1 nm, whereas it is 24.1 nm for the rodlike micelles. Furthermore, the hydrodynamic length of the rods at a molar ratio of 2.2 is in the range of 100 nm. The retarded kinetics of the shape transition was detected in titration calorimetric experiments at 40 degrees C and further studied by using time-resolved DLS and SLS. The rate of growth, which was slow (>2000 s), was found to increase with the total concentration.     

Modification and re-validation of the ethyl acetate-based multi-residue method for pesticides in produce

The ethyl acetate-based multi-residue method for determination of pesticide residues in produce has been modified for gas chromatographic (GC) analysis by implementation of dispersive solid-phase extraction (using primary–secondary amine and graphitized carbon black) and large-volume (20 μL) injection. The same extract, before clean-up and after a change of solvent, was also analyzed by liquid chromatography with tandem mass spectrometry (LC–MS–MS). All aspects related to sample preparation were re-assessed with regard to ease and speed of the analysis. The principle of the extraction procedure (solvent, salt) was not changed, to avoid the possibility invalidating data acquired over past decades. The modifications were made with techniques currently commonly applied in routine laboratories, GC–MS and LC–MS–MS, in mind. The modified method enables processing (from homogenization until final extracts for both GC and LC) of 30 samples per eight hours per person. Limits of quantification (LOQs) of 0.01 mg kg⁻¹ were achieved with both GC–MS (full-scan acquisition, 10 mg matrix equivalent injected) and LC–MS–MS (2 mg injected) for most of the pesticides. Validation data for 341 pesticides and degradation products are presented. A compilation of analytical quality-control data for pesticides routinely analyzed by GC–MS (135 compounds) and LC–MS–MS (136 compounds) in over 100 different matrices, obtained over a period of 15 months, are also presented and discussed. At the 0.05 mg kg⁻¹ level acceptable recoveries were obtained for 93% (GC–MS) and 92% (LC–MS–MS) of pesticide–matrix combinations.