Characterisation of Sugar Cane Combustion Particles in the Araraquara Region, Southeast Brazil

Biomass burning is an important primary and secondary source of aerosol particles. The presence of carbonaceous particles in the respirable size range makes the study of this fraction important in view of possible health and climatic effects. The annual burning of sugar cane plantations causes emission of huge amounts of pyrogenic particles. Aerosol samples were collected in Araraquara city, São Paulo state, Brazil, during the harvest season for fine and coarse particles and bulk; they were analysed by electron-probe microanalysis, including facilities for low-Z element determination (low-Z EPMA) and by energy-dispersive X-ray fluorescence (EDXRF), in order to investigate the elemental composition of individual particles and bulk samples, respectively. Numerical analysis of the EPMA results by hierarchical clustering shows high contributions of carbonaceous particles that can be distinguished mainly in two different types: biogenic and carbon-rich. Additionally, two significant contributions of aluminosilicate particles were identified: as rather pure aluminosilicates or mixed with carbonaceous species. The EDXRF results are compatible with those of aerosol particles in Amazon, which is nowadays one of the main sources of biogenic particles in the world.     

Performance of the diffusive gradients in thin films technique for measuring Ca and Mg in freshwater

Measurements of the major cations Ca and Mg by the technique of diffusive gradients in thin films (DGTs) were systematically evaluated. The concentration in solution was calculated using Fick’s first law of diffusion from the directly measured flux to the DGT device. A selective cation exchange resin (Bio-Rad Chelex^®100), which has been used extensively with DGT for trace metals, such as Cd²⁺, Cu²⁺ and Ni²⁺, was used for this work.

Elution of Ca and Mg from the resin with 1 M HNO₃ was very reproducible. Measurements of Ca and Mg concentrations in synthetic solutions agreed well with the theoretical predictions. The negative response on uptake caused by lowered pH was investigated. Uptake was found to decline below pH 5. The capacity of the DGT device for Ca and Mg was also investigated to establish maximum deployment times for given concentrations.

Experiments with filtered and modified lake water show that DGT can be used to measure Ca and Mg when trace metals are present in the solution. An in situ deployment of DGT combined with an ultrafiltration study suggest that the Mg concentration measured by DGT is similar to the concentration found in the fraction <1 kDa.     

AB initio SCF LCAO MO Calculations on styrene

Minimal basis set ab initio SCF LCAO MO calculations with gaussian-type have been performed for different conformations of the styrene molecule. The computations show the molecule to be planar and the rotational barrier of the vinyl group is estimated to 3.9 kcal/mole.     

Measurement of Tumor Vascular Damage in Mice with 99m Tc-MIBI Following Photodynamic Therapy

Abstract— The clinical perfusion agent ^99mTc-MIBI was used to monitor changes in tumor vascular perfusion (TVP) induced by Photofrin® (Pll)-mediated photodynamic therapy (PDT). BALB/c mice bearing an EMT-6 tumor on each hind thigh were given an intravenous injection of 1, 2 or 5 mg kg⁻¹ PII. Twenty-four hours later, one tumor was illuminated (600–650 run, 200 mW cm⁻² 400 J cm⁻²) while the other served as a control. At various time intervals after PDT (0, 2 and 24 h) mice received an intravenous injection of ^99mTc-hexakismethoxy(sobutyusonitri-le (MIBI) (0.18 MBq g⁻¹) and were sacrificed 2 min later. The light-treated and the untreated tumors were then dissected, the radioactivity was counted and the percentage of the injected dose per gram of tumor (%ID g⁻¹) was calculated as a measure of TVP. We observed that TVP is drug dose dependent, develops progressively with time post-PDT and is inversely related to PDT efficacy. Our data show that early tumor retention of ^99mMIBI is a simple method to assess TVP and vascular damage induced by PDT.     

Redox activity and diffusion of hydrophilic, hydrophobic, and amphiphilic redox active molecules in a bicontinuous cubic phase

The objective was to examine how a bicontinuous cubic phase influences the diffusion and electrochemical activity of dissolved molecules. The cubic phase is a structure with three-dimensional continuous channels of water separated by an apolar membrane. A redox active molecule can dissolve in three different environments. A hydrophobic molecule will prefer the interior of the membrane, a hydrophilic molecule will prefer the water channels, and an amphiphilic molecule will be situated with its headgroup at the surface of the membrane and its tail in the interior. The electrochemical activity was measured with cyclic voltammetry and the transport behavior with chronocoulometry. All the molecules were redox active in the cubic phase; that is, all the molecules could reach the surface of the electrode and react. The cubic phase made the kinetics of the charge transfer slower, showing a quasi-reversible behavior. The reason may be that a layer of the membrane adheres to the hydrophobic electrode surface. The diffusion experiment showed that the diffusion was slower than in solution. The molecules that were restricted to diffuse within the membrane gave particularly low mass transport rates.     

Ultraviolet B radiation induces upregulation of calcitonin gene-related peptide levels in human Finn chamber skin samples

One of the neuropeptides that plays a role in UVB-induced immunomodulation is calcitonin gene-related peptide (CGRP), as demonstrated in several animal studies. CGRP can be detected in human skin, but effects of UVB exposure on CGRP levels in human skin are not known. We determined CGRP levels in human Finn chamber skin samples of 15 UVB-irradiated and 10 control volunteers. Filter samples were collected prior to and immediately after a UVB exposure protocol (5 consecutive days, with one personally determined minimal erythema dose (MED(jp)) per day). CGRP levels in filter samples were determined using a commercially available radioimmunoassay kit. CGRP could be detected in the filter samples and volunteers showed statistically significantly increased levels after UVB exposure. In addition, the CGRP levels of UVB-exposed volunteers were positively correlated with the dose of UVB in J/m(2) that they received on 5 consecutive days. In other words, higher UVB doses resulted in higher CGRP levels. In summary, CGRP, a mediator in UVB-induced immunomodulation, could be detected in human Finn chamber skin samples, and was significantly increased after UVB exposure. The CGRP level appeared to depend on the amount of UVB the volunteers received.     

Effect of trace amounts of water on organic solvent transport through gamma-alumina membranes with varying pore sizes

The transport behavior of toluene and n-hexane in gamma-alumina membranes with different pore diameters was studied. It was shown that the permeability of water-lean hexane and toluene is in agreement with Darcy's law down to membrane pore diameters of 3.5 nm. The presence of molar water fractions of 5-8 x 10(-4) in these solvents led to a permeability decrease of the gamma-alumina layer by a factor of 2-4 depending on pore size. In general, a lower permeability was found for hexane than for toluene. Moreover, in the presence of water a minimum applied pressure of 0.5-1.5 bar was required to induce net liquid flow through the membrane. These phenomena were interpreted in terms of capillary condensation of water in membrane pores with a size below a certain critical diameter. This is thought to lead to substantial blocking of these pores for transport, so that the effective tortuosity of the membrane for transport of hydrophobic solvents increases.     

Synthesis and conformational analysis by 1H NMR and restrained molecular dynamics simulations of the cyclic decapeptide [Ser-Tyr-Ser-Met-Glu-His-Phe-Arg-Trp-Gly]

Summary The design of enzyme mimics with therapeutic and industrial applications has interested both experimental and computational chemists for several decades. Recent advances in the computational methodology of restrained molecular dynamics, used in conjunction with data obtained from two-dimensional ¹H NMR spectroscopy, make it a promising method to study peptide and protein structure and function. Several issues, however, need to be addressed in order to assess the validity of this method for its explanatory and predictive value. Among the issues addressed in this study are: the accuracy and generizability of the GROMOS peptide molecular mechanics force field; the effect of inclusion of solvent on the simulations; and the effect of different types of restraining algorithms on the computational results. The decapeptide Ser-Tyr-Ser-Met-Glu-His-Phe-Arg-Trp-Gly, which corresponds to the sequence of ACTH_1–10, has been synthesized, cyclized, and studied by two-dimensional ¹H NMR spectroscopy. Restrained molecular dynamics (RMD) and time-averaged restrained molecular dynamics (TARMD) simulations were carried out on four different distance-geometry starting structures in order to determine and contrast the behavior of cyclic ACTH_1–10 in vacuum and in solution. For the RMD simulations, the structures did not fit the NOE data well, even at high values of the restraining potential. The TARMD simulation method, however, was able to give structures that fit the NOE data at high values of the restraining potential. In both cases, inclusion of explicit solvent molecules in the simulation had little effect on the quality of the fit, although it was found to dampen the motion of the cyclic peptide. For both simulation techniques, the number and size of the NOE violations increased as the restraining potential approached zero. This is due, presumably, to inadequacies in the force field. Additional TARMD vacuum-phase simulations, run with a larger memory length or with a larger sampling size (16 additional distance-geometry structures), yielded no significantly different results. The computed data were then analyzed to help explain the sparse NOE data and poor chymotryptic activity of the cyclic peptide. Cyclic ACTH_1–10, which contains the functional moieties of the catalytic triad of chymotrypsin, was evaluated as a potential mimic of chymotrypsin by measurement of the rate of hydrolysis of esters of L-and d-phenylalanine. The poor rate of hydrolysis is attributed to the flexibility of the decapeptide, the motion of the side chains, which result in the absence of long-range NOEs, the small size of the macrocycle relative to that of the substrate, and the inappropriate orientation of the Gly, His, and Ser residues. The results demonstrate the utility of this method in computer-aided molecular design of cyclic peptides and suggest structural modifications for future work based on a larger and more rigid peptide framework.     

PHOTOSENSITIZING PROPERTIES OF BACTERIOCHLOROPHYLLIN a and BACTERIOCHLORIN a, TWO DERIVATIVES OF BACTERIOCHLOROPHYLL a

Abstract The photosensitizing properties of two water soluble derivatives of bacteriochlorophyll a , bacteriochlorophyllin a and bacteriochlorin a (lacking the central Mg-ion) were investigated and compared to those of hematoporphyrin derivatives. At physiological pH the oxygen consumption rate of histidine, tryptophan, dithiothreitol and guanosine upon illumination was 3 to 4 times higher when bacteriochlorin a was used as photosensitizer than when hematoporphyrin derivatives were used. Especially bacteriochlorin a proved to be an effective sensitizer for the killing of L929 cells. Because bacteriochlorin a has an absorption maximum at 765 nm in phosphate buffered saline (allowing a light penetration in tissue about ten times larger than at 630 nm) and a high molar absorption coefficient (32 000 M cm⁻¹) it has promising possibilities for the application in photodynamic therapy.     

Selective pervaporation of water through a nonselective microporous titania membrane by a dynamically induced molecular sieving mechanism

Pervaporation experiments were performed on microporous titania membranes using several binary liquids containing 2-20 wt % water. The membrane was nonselective in the separation of water from alcohols and p-dioxane but showed a remarkably high selectivity in the separation of water from ethylene glycol/water mixtures with < or =15 mol % water. The absence of selectivity under most conditions is explained by the large pore size (0.9 nm) of microporous titania. The high selectivity for water in the separation from ethylene glycol can be explained by the formation of a hydrogen-bonded network of ethylene glycol in the micropores, which blocks transport of ethylene glycol, while water can still permeate through. These networks are disrupted by water at higher concentrations, leading to full loss of membrane selectivity.