Scaling in Electrical Conductivity Measurements and Rheological Measurements of Monarch 700 Dispersions Stabilized by Polymers

For making stable dispersions of graphitic carbon black (Monarch 700), the effectiveness of three dispersants/polymers (hypermer LP1, hypermer B246, and OLOA 11000) in xylene is investigated. Hypermer LP1 (polyhydroxystearic acid) is a homopolymer and hypermer B246 (PEG 30-dipolyhydroxystearate) is a polyhydroxystearic acid/polyethylene oxide/polyhydroxystearic acid ABA block copolymer, while OLOA 11000 (polyisobutylene succinimide) has a polar head group (polyamine) attached to a hydrocarbon chain (polyisobutylene). Well-dispersed graphitic carbon black dispersions were prepared using dispersants at optimum concentrations. Percolation threshold and rheological threshold were determined by analyzing the variations in electrical conductivity and elastic modulus with concentration of carbon black. Above threshold concentration, scaling law was applied to experimental data of rheology (dynamic measurements) and electrical conductivity measurements to evaluate quality of the system. Effectiveness of polymers was investigated on the basis of value of critical exponent (t and t′, respectively) in scaling power law. Hypermer LP1 was proved to be a poor dispersant for Monarch 700 dispersions while other two polymers were found to be effective stabilizers.     

Design and Development of Oral Oil-in-Water Nanoemulsion Formulation Bearing Atorvastatin: In Vitro Assessment

The objective of the present investigation was to design a thermodynamically stable and dilutable nanoemulsion formulation of AT-Ca with minimum surfactant concentration that could improve its solubility as well as its oral bioavailability. The composition of optimized nanoemulsion formulation was Sefsol 218 and oleic acid (1:1) 10% w/w, as an oil phase, Tween-20 (19% w/w) as a surfactant, Carbitol (19% w/w) as a cosurfactant and distilled water (52% w/w) as an aqueous phase, containing 10 mg of AT. The optimized formulation showed higher% drug release (99.34%), lower droplet size (42.8 ± 0.42 nm) with low polydispersity index (0.237 ± 0.012), less viscosity (27.51 ± 1.01 cP) and infinite dilution capability. In vitro drug release from the nanoemulsion formulations was highly significant (p < 0.01) as compared to drug suspension.     

Impact of Various Parameters Over the Stability of Water-in-Vegetable Oil Emulsion

Theory regarding emulsification, its coalescence and impact of emulsifier over its stability has been updated. For the verification of the proposed theory, water-in-oil emulsion was prepared by mixing water and soybean oil in the presence and absence of emulsifier, monoglyceride. The effect of different parameters like emulsification time, contents of water, and concentration of emulsifier has been investigated on the emulsification and coalescence process of the emulsion. It was noted that the emulsion quality was highest if the mixture was homogenized for about 15 minutes and the water contents were 40% v/v. The addition of monoglyceride up to 0.5% w/v gave the most stable emulsion having higher quality than other composition. The results obtained were compared with the proposed theory and found to have good compositions.      

小麦秸秆发酵产生的真菌Pleurotus ostreatus IBL-02锰过氧化物酶的溶胶-凝胶固定化及其催化污水脱色(英文)

Solid state bio-processing of wheat straw was carried out through an indigenous fungal strain Pleurotus ostreatus IBL-02 under pre-optimized fermentation conditions. The maximum activity, 692±12 U/mL, of the industrially important manganese peroxidase (MnP) enzyme was recorded after five days of still culture incubation. The crude MnP was 2.1-fold purified with a specific activity of 860 U/mg after purification on a Sephadex-G-100 gel column. On native and SDS-PAGE electrophoresis gels, the purified MnP fraction was a single homogenous band of 45 kDa. An active fraction of MnP was immobilized using hydrophobic sol-gel entrapment comprising tetramethoxysilane (T) and propyltrimethoxysilane (P) at different T:P molar ratios. Characterization revealed that after 24 h incubation at varying pH and temperatures, the MnP fraction immobilized at a T:P ratio of 1:2 in the sol-gel retained 82% and 75% of its original activity at pH4 and 70 ℃, respectively. The optimally active fraction at a 1:2 T:P ratio was tested against MnSO4 as a substrate to determine the kinetic catalytic constants KM and Vmax . To explore the industrial applicability of P. ostreatus IBL-02 MnP, both the free and immobilized MnP were used for the decolorization of four different textile industrial effluents. A maximum of 100% decolorization was achieved for the different textile effluents within the shortest time period. A lower KM , higher Vmax , hyper-activation, and enhanced acidic and thermal resistance up to 70 ℃ were the novel catalytic features of the sol-gel immobilized MnP, suggesting that it may be a potential candidate for biotechnological applications particularly for textile bioremediation purposes.     

Highly Efficient Diglycolamide‐Based Task‐Specific Ionic Liquids: Synthesis,Unusual Extraction Behaviour,Irradiation, and Fluorescence Studies

Two new diglycolamide‐based task‐specific ionic liquids (DGA? TSILs) were evaluated for the extraction of actinides and lanthanides from acidic feed solutions. These DGA? TSILs were capable of exceptionally high extraction of trivalent actinide ions, such as Am³⁺, and even higher extraction of the lanthanide ion, Eu³⁺ (about 5–10 fold). Dilution of the DGA? TSILs in an ionic liquid, C₄mim⁺ ? NTf₂^?, afforded reasonably high extraction ability, faster mass transfer, and more efficient stripping of the metal ion. The nature of the extracted species was studied by slope analysis, which showed that the extracted species contained one NO₃^? anion, along with the participation of two DGA? TSIL molecules. Time‐resolved laser fluorescence spectroscopy (TRLFS) analysis showed a strong complexation with no inner‐sphere water molecule in the Eu^III? DGA? TSIL complexes in the presence and absence of C₄mim⁺ ? NTf₂^? as the diluent. The very high radiolytic stability of DGA? TSIL 6 makes it one of the most‐efficient solvent systems for the extraction of actinides under acidic feed conditions.     

An assessment of the liquid–gas partitioning behavior of major wastewater odorants using two comparative experimental approaches: liquid sample-based vaporization vs. impinger-based dynamic headspace extraction into sorbent tubes

The gas–liquid partitioning behavior of major odorants (acetic acid, propionic acid, isobutyric acid, n-butyric acid, i-valeric acid, n-valeric acid, hexanoic acid, phenol, p-cresol, indole, skatole, and toluene (as a reference)) commonly found in microbially digested wastewaters was investigated by two experimental approaches. Firstly, a simple vaporization method was applied to measure the target odorants dissolved in liquid samples with the aid of sorbent tube/thermal desorption/gas chromatography/mass spectrometry. As an alternative method, an impinger-based dynamic headspace sampling method was also explored to measure the partitioning of target odorants between the gas and liquid phases with the same detection system. The relative extraction efficiency (in percent) of the odorants by dynamic headspace sampling was estimated against the calibration results derived by the vaporization method. Finally, the concentrations of the major odorants in real digested wastewater samples were also analyzed using both analytical approaches. Through a parallel application of the two experimental methods, we intended to develop an experimental approach to be able to assess the liquid-to-gas phase partitioning behavior of major odorants in a complex wastewater system. The relative sensitivity of the two methods expressed in terms of response factor ratios (RF_vap/RF_imp) of liquid standard calibration between vaporization and impinger-based calibrations varied widely from 981 (skatole) to 6,022 (acetic acid). Comparison of this relative sensitivity thus highlights the rather low extraction efficiency of the highly soluble and more acidic odorants from wastewater samples in dynamic headspace sampling.     

Phenylpropanoids from Tanacetum baltistanicum with Nematocidal and Insecticidal Activities

Chemistry of Natural Compounds - One new and seven known secondary metabolites 1–8 were isolated, and the nematocidal and insecticidal activities of major compounds from Tanacetum...     

Determination of Lambda-Cyhalothrin and Malathion Residues in Locust by Gas Chromatography with Electron Capture Detection

Journal of Analytical Chemistry - A reliable, easy, and reproducible method was developed for the quantification of λ-cyhalothrin and malathion residues in desert locust. For the extraction, a...     

Defects-engineered tailoring of tri-doped interlinked metal-free bifunctional catalyst with lower gibbs free energy of OER/HER intermediates for overall water splitting

Controllable tailoring of metal-free/carbon-based nanostructures tends an encouraging way to enhance the bifunctional activity of electrodes, but a great challenge owing to the sluggish kinetics of oxygen evolution reaction (OER) and hydrogen evolution reaction (HER). Herein, a facile tempted-defects assisted fractionation strategy is presented to synthesize N, S, and O tri-doped metal-free catalyst (DE-TDAP). Due to this effective tempted-defects and heteroatoms interlinking in DE-TDAP, it delivers the lowest overpotential toward both the OER (346 mV) and HER (154 mV) at 10 mA cm^?2. Remarkably, the DE-TDAP-electrode carries only a cell voltage of 1.81 V at 10 mA cm^?2 for overall water splitting and long-term stability. Considerably, the density functional theory (DFT) calculation exposes that the tailored-defects in tri-doped interlinking could enhance bifunctional catalytic performance devising from lower Gibbs free energy of OER/HER intermediates on active sites. This struggle henceforth provides a perceptive understanding of the synergetic principles of heteroatom-interlinking-tailoring nanostructures in water splitting.     

Selenium Alleviates the Adverse Effect of Drought in Oilseed Crops Camelina (Camelina sativa L.) and Canola (Brassica napus L.)

Drought poses a serious threat to oilseed crops by lowering yield and crop failures under prolonged spells. A multi-year field investigation was conducted to enhance the drought tolerance in four genotypes of Camelina and canola by selenium (Se) application. The principal aim of the research was to optimize the crop yield by eliciting the physio-biochemical attributes by alleviating the adverse effects of drought stress. Both crops were cultivated under control (normal irrigation) and drought stress (skipping irrigation at stages i.e., vegetative and reproductive) conditions. Four different treatments of Se viz., seed priming with Se (75 μM), foliar application of Se (7.06 μM), foliar application of Se + Seed priming with Se (7.06 μM and 75 μM, respectively) and control (without Se), were implemented at the vegetative and reproductive stages of both crops. Sodium selenite (Na₂SeO₃), an inorganic compound was used as Se sources for both seed priming and foliar application. Data regarding physiochemical, antioxidants, and yield components were recorded as response variables at crop maturity. Results indicated that WP, OP, TP, proline, TSS, TFAA, TPr, TS, total chlorophyll contents, osmoprotectant (GB, anthocyanin, TPC, and flavonoids), antioxidants (APX, SOD, POD, and CAT), and yield components (number of branches per plant, thousand seed weight, seed, and biological yields were significantly improved by foliar Se + priming Se in both crops under drought stress. Moreover, this treatment was also helpful in boosting yield attributes under irrigated (non-stress) conditions. Camelina genotypes responded better to Se application as seed priming and foliar spray than canola for both years. It has concluded that Se application (either foliar or priming) can potentially alleviate adverse effects of drought stress in camelina and canola by eliciting various physio-biochemicals attributes under drought stress. Furthermore, Se application was also helpful for crop health under irrigated condition.