Simultaneous quantitation of seven alkaloids in processed Fuzi decoction by rapid resolution liquid chromatography coupled with tandem mass spectrometry

A rapid analytical method based on rapid resolution LC coupled with MS/MS was first established to quantify seven alkaloids in processed Fuzi decoction. The chromatographic method was optimized to allow simultaneous analysis of all analytes in 5 min and demonstrated good linearity (r > 0.9995), repeatability (RSD < 4.36%), intra‐ and interday precisions (RSD < 5.07%) with good accuracies (97.76–105.08%) and good recovery (95.0–107.5%) of seven alkaloids, namely higenamine, benzoylhypaconine, benzoylmesaconine, benzoylaconine, aconitine, hypaconitine, and mesaconitine. The LODs for these markers were in the range of 2.30–17.00 pg/mL. Quantitative analysis of the seven alkaloids in Baifupian decoction and Heishunpian decoction showed that the content of the seven marker chemicals varied significantly and concluded that the quality of Fuzi was greatly affected by different processed methods. The developed method could be used as a rapid, sensitive, and reliable approach for assessment of the quality of processed Fuzi and related decoction.     

An improved SPE method for fractionation and identification of phospholipids

This work reports an efficient and universal SPE method developed for separation and identification of phospholipids derived from complex biological samples. For the separation step, sequential combination of silica gel‐aminopropyl‐silica gel SPE cartridges is applied. This setup enables separation of phosphatidylcholine, lysophosphatidylcholine, phosphatidylethanolamine, phosphatidylglycerol, phosphatidic acid, phosphatidylinositol, phosphatidylserine, cardiolipin, and sphingomyelin into four fractions according to the polarity of their headgroups. Sample acquisition of the SPE fractions is performed by a high‐resolution LC‐MS system consisting of a hybrid linear IT Fourier transform ion cyclotron resonance mass spectrometer coupled to RP‐HPLC. The unequivocal advantage of our SPE sample preparation setup is avoidance of analyte peak overlapping in the determination step done by RP‐HPLC. Overlapping phospholipid signals would otherwise exert adverse ion suppression effects. An additional benefit of this method is the elimination of polar and nonpolar (e.g. neutral lipids) contaminants from the phospholipid fractions, which highly reduces contamination of the LC‐MS system. The method was validated with fermentation samples of organic waste, where 78 distinct phospholipid and sphingomyelin species belonging to six lipid classes were successfully identified.     

Application of supercritical fluid extraction coupled with counter–current chromatography for extraction and online isolation of unstable chemical components from Rosa damascena

Supercritical fluid extraction (SFE) coupled with high‐speed counter‐current chromatography (HSCCC) was successfully used for the extraction and online isolation of the unstable compounds from Rosa damascene in a single extraction and separation operation in two stages. The solvent systems of SFE/HSCCC were optimized with the help of multiexponential function model. At the first stage, the upper phase of the solvent system of n‐butanol–tert‐butyl methyl ether–acetonitrile–0.1% aqueous TFA (1.7:1.0:0.8:4.0, v/v/v/v) was used as both the SFE entrainer and the HSCCC stationary phase, and the target compounds were eluted with the corresponding lower phase to separate the hydrophobic compounds. At the second stage, the upper phase of the solvent system of n‐hexane–ethyl acetate–methanol–water (3.2:1.0:2.8:2.6, v/v/v/v) was used as both the SFE entrainer and the HSCCC stationary phase, followed by elution with the corresponding lower phase to separate the moderate hydrophobic compounds. Six compounds including formononetin, delphinidin, cyaniding, 5,6,4′‐trihydroxy‐7,8‐dimethoxy flavone, 5,3′‐dihydroxy‐7,8‐dimethoxy flavone, and 5‐hydroxy‐6,7,8,3′,4′‐pentamethoxy flavone were successfully separated in one extraction–separation operation within 300 min. The targeted compounds were identified by MS and NMR spectroscopy. This research has opened up great prospects for industrial application of SFE/HSCCC to the extraction and separation of unstable compounds.     

A rapid and convenient method for preparative separation of three indissolvable polyphenols from Euphorbia pekinensis by the flexible application of solvent extraction combined with counter‐current chromatography

A rapid and convenient method was established to preparatively isolate the three ellagic acid types of compounds, which were the main polyphenols in Euphorbia pekinensis, by flexibly applying solvent extraction combined with counter‐current chromatography (CCC). The total extract (extracted using 95% ethanol) of E. pekinensis was pretreated by two simple steps before CCC isolation, following the procedure: the total extract was extracted by classical solvent extraction using petroleum ether and ethyl acetate, respectively, and then the ethyl acetate extract was suspended using 95% ethanol, after being allowed to stand overnight, the sediment was obtained. Partial sediment (100 mg) was then directly separated by CCC with a two‐phase solvent system composed of chloroform‐95% ethanol‐water‐85% formic acid (50:50:50:5, v/v/v/v). About 22 mg of 3,3′‐dimethoxy ellagic acid (1), 12 mg of 3,3′‐di‐O‐methyl‐4‐O‐(β‐d ‐xylopyranosyl)ellagic acid (2), and 35 mg of ellagic acid (3) with purities of 96.0, 95.2, and 95.4% were obtained respectively in one step within 4 h. After being purified by washing with methanol, the purities of the three compounds obtained were all above 98%. The purities were determined by HPLC and their chemical structures were further identified by ¹H and ¹³C NMR spectroscopy. The recoveries were calculated as 84.6, 85.7, and 89.5%, respectively. The result demonstrated that the present isolation method was rapid, economical and efficient for the preparative separation of polyphenols from E. pekinensis.     

Rapid determination of catecholamines in urine samples by nonaqueous microchip electrophoresis with LIF detection

A method was developed for the rapid separation of catecholamines by nonaqueous microchip electrophoresis (NAMCE) with LIF detection, A homemade pump‐free negative pressure sampling device was used for rapid bias‐free sampling in NAMCE, the injection time was 0.5 s and the electrophoresis separation conditions were optimized. Under the optimized conditions, the samples were separated completely in <1 min. The average migration times of the epinephrine (E), dopamine (DA), and norepinephrine (NE) were 34.26, 43.81, and 50.07 s, with an RSD of 1.05, 1.26, and 0.89% (n = 7), respectively. The linearity of the method ranged from 0.0125 to 2.0 mg/L for E and 0.025～4.0 mg/L for DA and NE, with correlation coefficients ranging between 0.9978 and 0.9986. The detection limits of E, DA, and NE were 2.5, 5.0, and 5.0 μg/L, respectively. The recoveries of E, DA, and NE in spiked urine samples were between 86 and 103%, with RSDs of 4.5～6.8% (n = 5). The proposed NAMCE with LIF detection combined with a pump‐free negative pressure sampling device is a simple, inexpensive, energy efficient, miniaturized system that can be successfully applied for the determination of catecholamines in urine samples.     

Impact of photogenerated charge behaviors on luminescence of Eu3+-incorporated microporous titanosilicate ETS-10

A series of Eu³⁺-incorporated ETS-10 samples were successfully prepared based on the traditional ion exchange method. The relationship between photogenerated charge behaviors and luminescent properties has been investigated in detail. It has been demonstrated that as a result of the charge transfer from the titanate quantum wires to Eu³⁺ crystal field states, the host matrix ETS-10 functions as the sensitizer of Eu³⁺ to enhance the red luminescence, while Eu³⁺ cations contribute to the recombination of photogenerated charges. The behavior of photogenerated charges has significant impact on the luminescent properties of Eu³⁺-incorporated ETS-10 materials.     

Trigonal‐Bipyramidal and Square‐Pyramidal Chromium?Manganese Chalcogenide Clusters, [E2CrMn2(CO)n]2− (E=S,Se, Te; n=9, 10): Synthesis,Electrochemistry, UV/Vis Absorption,and Computational Studies

The reactions of E powder (E=S, Se) with a mixture of Cr(CO)₆ and Mn₂(CO)₁₀ in concentrated solutions of KOH/MeOH produced two new mixed Cr? Mn? carbonyl clusters, [E₂CrMn₂(CO)₉]^2? (E=S, 1 ; Se, 2 ). Clusters 1 and 2 were isostructural with one another and each displayed a trigonal‐bipyramidal structure, with the CrMn₂ triangle axially capped by two μ₃‐E atoms. The analogous telluride cluster, [Te₂CrMn₂(CO)₉]^2? ( 3 ), was obtained from the ring‐closure of Te₂Mn₂ ring complex [Te₂Mn₂Cr₂(CO)₁₈]^2? ( 4 ). Upon bubbling with CO, clusters 2 and 3 were readily converted into square‐pyramidal clusters, [E₂CrMn₂(CO)₁₀]^2? (E=Se, 5 ; Te, 6 ), accompanied with the cleavage of one Cr? Mn bond. According to SQUID analysis, cluster 6 was paramagnetic, with S=1 at room temperature; however, the Se analogue ( 5 ) was spectroscopically proposed to be diamagnetic, as verified by TD‐DFT calculations. Cluster 6 could be further carbonylated, with cleavage of the Mn? Mn bond to produce a new arachno‐cluster, [Te₂CrMn₂(CO)₁₁]^2? ( 7 ). The formation and structural isomers, as well as electrochemistry and UV/Vis absorption, of these clusters were also elucidated by DFT calculations.     

A one‐dimensional silver(I) coordination polymer based on the 2‐[2‐(pyridin‐4‐yl)‐1H‐benzimidazol‐1‐ylmethyl]phenol ligand exhibiting photoluminescence

A one‐dimensional Ag^I coordination complex, catena‐poly[[silver(I)‐μ‐{2‐[2‐(pyridin‐4‐yl)‐1H‐benzimidazol‐1‐ylmethyl]phenol‐κ²N²:N³}] perchlorate monohydrate], {[Ag(C₁₉H₁₅N₃O)]ClO₄·H₂O}_n, was synthesized by the reaction of 2‐[2‐(pyridin‐4‐yl)‐1H‐benzimidazol‐1‐ylmethyl]phenol (L) with silver perchlorate. In the complex, the L ligands are arranged alternately and link Ag^I cations through one benzimidazole N atom and the N atom of the pyridine ring, leading to an extended zigzag chain structure. In addition, the one‐dimensional chains are extended into a three‐dimensional supramolecular architecture via O—H...O hydrogen‐bond interactions and π–π stacking interactions. The complex exhibits photoluminescence in acetonitrile solution, with an emission maximum at 390 nm, and investigation of the thermal stability reveals that the network structure is stable up to 650 K.