D-N交替法与Schwartz交替法的收敛关系分析

This paper has demonstrated that the Schwartz alternating process must converge if D-N alternating process has converged. Its technique is that the overlapping regions in Schwartz alternating process are considered as independent domains, then Schwartz alternating process could be transformed into D-N alter-nating process. Finally the convergence estimation of Schwartz alternating process could be obtained. The results show that its convergence rate is same as that of D-N alternating process.     

Metallization of U3O8via catalytic electrochemical reduction with Li2O in LiCl molten salt

The concept of a novel electrochemical reduction process for the treatment of spent nuclear fuels in Li₂O-LiCl molten salt was proposed and fresh tests using U₃O₈ powder were carried out to elucidate the reaction mechanism and verify the feasibility of the process. Electrolysis of Li₂O and reduction of U₃O₈ powder took place simultaneously at the cathode part of the electrolysis cell via a catalytic EC mechanism and the conversion of U₃O₈ to U metal was more than 99%. This revised version was published online in June 2006 with corrections to the Cover Date.     

Focused ion beam Moiré method

A focused ion beam (FIB) Moiré method is proposed to measure the in-plane deformation of object in a micrometer scale. The FIB Moiré is generated by the interference between a prepared specimen grating and FIB raster scan lines. The principle of the FIB Moiré is described. The sensitivity and accuracy of deformation measurement are discussed in detail. Several specimen gratings with 0.14 and 0.20 μm spacing are used to generate FIB Moiré patterns. The FIB Moiré method is successfully used to measure the residual deformation in a micro-electro-mechanical system structure after removing the SiO₂ sacrificial layer with a 5000 lines/mm grating. The results demonstrate the feasibility of this method.     

溃坝问题的间断有限元方法

本文研究90年代初提出的Runge-Kutta间断Galerkin有限元方法，给出该方法的精度分析，通过经典算例验证该方法处理间断问题、捕捉锐利波形的能力，并将其推广到求解浅水问题．针对坝底无摩擦，无坡度的理想情形进行讨论，给出方溃坝和圆溃坝问题的数值模拟结果．     

酸糖蛋白手性柱分离6种手性化合物

通过考察缓冲液种类、浓度及其pH值对对映体在手性柱上的保留和分离行为的影响,以及流动相中加入不同种类、不同浓度的不带电荷的有机溶剂乙腈、甲醇、正丙醇、异丙醇、流动相流速和柱温对对映体分离能力的影响,优化了含碳手性中心的碱性药物苯丙哌林、酸性化合物MT-A5及MT-酸和含硫手性中心的质子泵抑制剂奥美拉唑、泮托拉唑、雷贝拉唑对映体分离条件,最佳手性分离条件为:苯丙哌林,0.05 mol/L磷酸二氢铵缓冲液(pH 3.0)-乙腈(95∶5,V/V)为流动相,流速为0.7 mL/m in,柱温为20℃;MT-A5及MT-酸,流动相为0.01 mol/L醋酸铵缓冲液(pH 5.0)-乙腈(74∶26,V/V),流速为0.9 mL/m in,柱温为20℃;泮托拉唑,流动相为10 mmol/L醋酸铵缓冲液(pH 5.5)-乙腈(93∶7,V/V),流速为0.9 mL/m in;柱温为20℃;奥美拉唑和雷贝拉唑,流动相为0.01 mol/L醋酸铵缓冲液(pH 3.0)-乙腈(95∶5,V/V),流速为0.7 mL/m in,柱温为20℃。实现了应用高效液相色谱法在α1-酸糖蛋白手性柱上对上述化合物的对映体分离,并成功用于手性药物合成中的对映体过量百分率的测定。     

Statistical theory for hydrogen bonding fluid system of A a D d type (I): The geometrical phase transition

The influence of hydrogen bonds on the physical and chemical properties of hydrogen bonding fluid system of A _a D _d type is investigated from two viewpoints by the principle of statistical mechanics. In detail, we proposed two new ways that can be used to obtain the equilibrium size distribution of the hydrogen bonding clusters, and derived the analytical expression of a relationship between the hydrogen bonding free energy and hydrogen bonding degree. For the nonlinear hydrogen bonding systems, it is shown that the sol-gel phase transition can take place under proper conditions, which is further proven to be a kind of geometrical phase transition rather than a thermodynamic one. Moreover, several problems associated with the geometrical phase transition and liquid-solid phase transition in nonlinear hydrogen bonding systems are discussed.     

Electrochemical behavior of Li intercalation processes into a Li[NixLi(1/3−2x/3)Mn(2/3−x/3)]O2 cathode

Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂ (X=0.17, 0.25, 0.33, 0.5) compounds are prepared by a simple combustion method. The Rietvelt analysis shows that these compounds could be classified as having the α-NaFeO₂ structure. The initial charge-discharge and irreversible capacity increases with the decrease of x in Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂. Indeed, Li[Ni_0.50Mn_0.50]O₂ compound shows relatively low initial discharge capacity of 200 mAh/g and large capacity loss during cycling, with Li[Ni_0.17Li_0.22Mn_0.61]O₂ and Li[Ni_0.25Li_0.17Mn₀.₅₈]O₂ compounds exhibit high initial discharge capacity over 245 mAh/g and stable cycle performance in the voltage range of 4.8 -2.0 V. On the other hand, XANES analysis shows that the oxidation state of Ni ion reversibly changes between Ni²⁺ and about Ni³⁺, while the oxidation state of Mn ion sustains Mn⁴⁺ during charge-discharge process. This result does not agree with the previously reported ‘electrochemistry model’ of Li[Ni_xLi_(1/3−2x/3)Mn_(2/3−x/3)]O₂, in which Ni ion changes between Ni²⁺ and NI⁴⁺. Based on these results, we modified oxidation-state change of Mn and Ni ion during charge-discharge process.     

Characteristics and structures of weak efficient surfaces of production possibility sets

This paper studies the characteristics and structure of the weak surface of the production possibility set. We apply techniques and methods of transferring a polyhedral cone from its intersection form to its sum form, identify an intersection representation of the production possibility set. We give the structure theorem of weak surface of the production possibility set, which includes three complementary slackness conditions. We define the input weak efficiency and output weak efficiency for different DEA models according to the representation of the intersection form. It investigates the characteristics of the weak surfaces, and proves the structure theorems of input weak DEA efficiency and output weak DEA efficiency. The structure theorems establish weighted combination of inputs and outputs that are weak DEA efficient. Numerical examples are provided for illustration.     

Crystallographic report: Bis(norfloxacin)dilead(II) tetranitrate, [Pb2(H‐Norf)2(ONO2)4]

The centrosymmetric binuclear structure of [Pb₂(H‐Norf)₂(ONO₂)₄]shows the geometry around each lead(II) atom to be distorted trigonal bipyramidal with Pb–O distances ranging from 2.357(3) to 2.769(4) Å. Copyright © 2003 John Wiley & Sons, Ltd.     

Synthesis and characterization of white‐light‐emitting polyfluorenes containing orange phosphorescent moieties in the side chain

Two orange phosphorescent iridium complex monomers, 9‐hexyl‐9‐(iridium (III)bis(2‐(4′‐fluorophenyl)‐4‐phenylquinoline‐N,C^2′)(tetradecanedionate‐11,13))‐2,7‐dibromofluorene (Br‐PIr) and 9‐hexyl‐9‐(iridium(III)bis(2‐(4′‐fluorophenyl)‐4‐methylquinoline‐N,C^2′)(tetradecanedionate‐11,13))‐2,7‐dibromofluorene (Br‐MIr), were successfully synthesized. The Suzuki polycondensation of 2,7‐bis(trimethylene boronate)‐9,9‐dioctylfluorene with 2,7‐dibromo‐9,9‐dioctylfluorene and Br‐PIr or Br‐MIr afforded two series of copolymers, PIrPFs and MIrPFs, in good yields, in which the concentrations of the phosphorescent moieties were kept small (0.5–3 mol % feed ratio) to realize incomplete energy transfer. The photoluminescence (PL) of the copolymers showed blue‐ and orange‐emission peaks. A white‐light‐emitting diode with a configuration of indium tin oxide/poly(3,4‐ethylenedioxythiophene):poly(styrenesulfonate)/PIr05PF (0.5 mol % feed ratio of Br‐PIr)/Ca/Al exhibited a luminous efficiency of 4.49 cd/A and a power efficiency of 2.35 lm/W at 6.0 V with Commission Internationale de L'Eclairage (CIE) coordinates of (0.46, 0.33). The CIE coordinates were improved to (0.34, 0.33) when copolymer MIr10PF (1.0 mol % feed ratio of Br‐MIr) was employed as the white‐emissive layer. The strong orange emission in the electroluminescence spectra in comparison with PL for these kinds of polymers was attributed to the additional contribution of charge trapping in the phosphorescent dopants. © 2007 Wiley Periodicals, Inc. JPolym Sci Part A: Polym Chem 45: 1746–1757, 2007