宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

Assisted Cloning and Orthogonal Complementing of an Arbitrary Unknown Two-Qubit Entangled State

Based on A.K. Pati‘s original idea [Phys. Rev. A 61 (2000) 022308] on single-qubit-state-assisted clone, very recently Zhan has proposed two assisted quantum cloning protocols of a special class of unknown two-qubit entangled states [Phys. Lett. A 336 (2005) 317]. In this paper we further generalize Zhan‘s protocols such that an arbitrary unknown two-qubit entangled state can be treated.     

Fuzzy convex sets in median algebras

The fuzzification of convex sets in median algebras is considered, and some of their properties are investigated. A characterization of finite valued fuzzy convex set is given.     

Active long pulse shaping technique of pulsed CO2 laser using multi-pulse discharge control

We describe the pulse forming of pulsed CO₂ laser using multi-pulse superposition technique. Various pulse shapes, high duty cycle pulse forming network (PFN) are constructed by time sequence. This study shows a technology that makes it possible to make various long pulse shapes by activating SCRs of three PFN modules consecutively at a desirable delay time with the aid of a PIC one-chip microprocessor. The power supply for this experiment consists of three PFN modules. Each PFN module uses a capacitor, a pulse forming inductor, a SCR, a high voltage pulse transformer, and a bridge rectifier on each transformer secondary. The PFN modules operate at low voltage by driving the primary of HV pulse transformer. The secondary of the transformer has a full-wave rectifier, which passes the pulse energy to the load in a continuous sequence.We investigated various long pulse shapes as different trigger time intervals of SCRs among three PFN modules. As a result, we could obtain laser beam with various pulse shapes and durations from about 250 to 1000 μs.     

U：CaF2晶体的分凝特性与光谱性质

应用TGT法生长了直径为75mm的U：CaF2晶体，宏观上透明完整.应用公式K0=Cs/Cl计算了U在CaF2晶体中的分凝系数等于0.53.应用溶质分布一般公式Cs=K0C0(1-g)K0-1，计算U的浓度分布与测量值，数值符合说明晶体生长过程接近平衡状态.分析不同条件下生长的U: CaF2晶体的晶胞参数和吸收光谱，结果表明生长气氛决定U的价态及电荷补偿机理：无PbF2存在的条件下，U为+4价，晶体呈绿色；PbF2的加入起到氟化去氧作用，U倾向于以离子半径最接近于Ca2+的U3+存在，晶体呈红色.从晶体生长开始到结束的部位，U3+:CaF2晶体吸收光谱的峰位不变，峰强呈现与U浓度相同的增加趋势.U3+:CaF2晶体外层厚约5mm处呈黄色，含有U3+和U2+的混合价态离子，其原理是石墨坩埚的还原作用通过单质铅，使部分的U3+进一步还原成了U2+. 关键词： 铀 氟化钙晶体 分凝系数 晶胞参数     

Some new results on superimposed codes

A (w,r) cover‐free family is a family of subsets of a finite set such that no intersection of w members of the family is covered by a union of r others. A (w,r) superimposed code is the incidence matrix of such a family. Such a family also arises in cryptography as the concept of key distribution pattern. In the present paper, we give some new results on superimposed codes. First we construct superimposed codes from super‐simple designs which give us results better than superimposed codes constructed by other known methods. Next we prove the uniqueness of the (1,2) superimposed code of size 9 × 12, the (2,2) superimposed code of size 14 × 8, and the (2,3) superimposed code of size 30 × 10. Finally, we improve numerical values of upper bounds for the asymptotic rate of some (w,r) superimposed codes. © 2004 Wiley Periodicals, Inc.     

Efficient microwave induced direct α-halogenation of carbonyl compounds

A novel and direct method for the synthesis of α-halocarbonyl compounds using sequential treatment of carbonyl compounds with [hydroxy(tosyloxy)iodo]benzene followed by magnesium halides under solvent-free microwave irradiation conditions is described.     

The Iyengar Type Inequalities with Exact Estimations and the Chebyshev Central Algorithms of Integrals

In this paper, both low order and high order extensions of the Iyengar type inequality are obtained. Such extensions are the best possible in the same sense as that of the Iyengar inequality. hzrthermore, the Chebyshev central algorithms of integrals for some function classes and some related problems are also considered and investigated.     

The Analysis and Improving of the Microwave Exciter in the Lower Hybrid Wave System

When we carry out lower hybrid wave heating and current driving plasma experiment at tokamak, we need mega-watt order of microwave power. The microwave signal at frequency of 2450 MHz is generated by a microwave exciter. According to the experiment＇s demands, the microwave exciter must provide output power of 1.5～ 2. 5 W with stabilized frequency and amplitude tobe used as the klystron input. Being amplified by the klystron, the microwave signal is transmitted through the transmitting system to the antenna and is emitted into the HL-2A tokamak. So we can see that the microwave exciter＇s function is very important to the lower hybrid wave heating and current driving plasma experiment.