Monitoring some phenoxyl-type N-methylcarbamate pesticide residues in fruit juices using high-performance liquid chromatography with peroxyoxalate-chemiluminescence detection

A systematic investigation of optimal conditions for determining three of the most common phenoxyl-type N-methylcarbamate pesticides (carbaryl, carbofuran and propoxur) in fruit juices by HPLC with peroxyoxalate-chemiluminescence detection is described. The required pre-column hydrolysis of pesticides and derivatization of their hydrolytic metabolites with dansyl chloride was simultaneously carried out in a short time thanks to the micellar catalytic effect provided by cetyltrimethyl ammonium bromide micelles on the hydrolysis step. The liquid chromatographic separation of the dansylated phenols was performed on a reversed-phase C18 column with isocratic elution. The analytes were detected by using an integrated derivatization chemiluminescence detection unit based on the bis(2,4,6-trichlorophenyl)oxalate-hydrogen peroxide system. Fruit juice samples containing 4.0-1500 microg/l pesticides were analysed with a precision of ca. 6.5%. After contamination of the fruit juice samples, average recovery > 93% at fortification levels of 10-100 microg/l was obtained.     

Kinetic fluorimetric determination of nanogram amounts of manganese, based on its catalysis of the oxidation of 2-hydroxybenzaldehyde thiosemicarbazone with hydrogen peroxide

A kinetic method is described for the determination of trace amounts of manganese(II), based on its catalytic effect on the oxidation of 2-hydroxybenzaldehyde thiosemicarbazone by hydrogen peroxide. The reaction is followed by measuring the rate of change of fluorescence (lambda(ex) 365 and lambda(em) 440 nm). The calibration is linear over the manganese range 2-9 ng ml with a precision of +/-1%. The proposed method suffers from few interferences.     

Flow injection system for hydrolysable tannin determination

A flow injection system was proposed to evaluate the transient product of a colorimetric reaction between hydrolysable tannin and potassium iodate (KIO₃) solution. The system optimization was accomplished by using statistical methods based on experimental design. Flow rate of KIO₃ solution, sample volume, carrier flow rate, and reaction coil were the selected factors for evaluation. On screening step, complete factorial 2⁴ was used and two levels for each selected factor were studied. For the optimization phase, a centered face composite design 2² + star was employed to evaluate sample volume and flow rate of KIO₃ solution, which were the factors identified in the screening phase as having more influence on the absorbance signal. After optimization, the proposed system was compared with batch determination. Some characteristics, such as analytical frequency, reagent consumption and chemical residues generation presented better results by the use of the proposed system if compared with batch method. The system presented good repeatability with standard deviation lower than 3%, for n = 10, linearity (R² = 0.9974) for tannic acid standard, analytical frequency of 15 injections h^− 1 and limit of quantification of 24 mg L^− 1 of tannic acid. Good results were obtained when the proposed system was applied to hydrolysable tannin determination in Stryphnodendron barbatimão, Eucalyptus citriodora and Phyllanthus niruri, samples of plants commonly used in popular medicine.     

Simultaneously multiply-configurable or superposed molecular logic systems composed of ICT (internal charge transfer) chromophores and fluorophores integrated with one- or two-ion receptors

Integrated "ICT chromophore-receptor" systems show ion-induced shifts in their electronic absorption spectra. The wavelength of observation can be used to reversibly configure the system to any of the four logic operations permissible with a single input (YES, NOT, PASS 1, PASS 0), under conditions of ion input and transmittance output. We demonstrate these with dyes integrated into Tsien's calcium receptor, 1-2. Applying multiple ion inputs to 1-2 also allows us to perform two- or three-input OR or NOR operations. The weak fluorescence output of 1 also shows YES or NOT logic depending on how it is configured by excitation and emission wavelengths. Integrated "receptor(1)-ICT chromophore-receptor(2)" systems 3-5 selectively target two ions into the receptor terminals. The ion-induced transmittance output of 3-5 can also be configured via wavelength to illustrate several logic types including, most importantly, XOR. The opposite effects of the two ions on the energy of the chromophore excited state is responsible for this behaviour. INHIBIT and REVERSE IMPLICATION are two of the other logic types seen here. Integration of XOR logic with a preceding OR operation can be arranged by using three ion inputs. The fluorescence output of these systems can be configured via wavelength to display INHIBIT or NOR logic under two-input conditions. The superposition or multiplicity of logic gate configurations is an unusual consequence of the ability to simultaneously observe multiple wavelengths.     

Identification (GC and GC-MS) of unsaturated acetates in Elasmopalpus lignosellus and their biological activity (GC-EAD and EAG)

Two insect colonies of Elasmopalpus lignosellus were reared in our laboratory, the first being initiated from pupae obtained from a cornfield in the region of Sete Lagoas, Minas Gerais and the second from a cornfield in the region of Goiania, Goiás. From the two colonies, two extracts were prepared from the pheromone glands of virgin E. lignosellus females. The extract obtained from the first colony was designated as extract 1 while the extract obtained from the second colony was designated as extract 2. Extract 1 was analyzed by gas chromatography-mass spectrometry (GC-MS) with (Z)-9-hexadecenyl acetate [(Z)-9-HDA] and (Z)-11-hexadecenyl acetate [(Z)-11-HDA] being identified and confirmed by the formation of DMDS derivatives. In addition, a third acetate, which could be either (E)-8-hexadecenyl acetate [(E)-8-HDA] or (E)-9-hexadecenyl acetate [(E)-9-HDA] was detected by GC-MS. Extract 2 was analyzed by gas chromatography (GC) and gas chromatography-electroannetography (GC-EAD) revealing the presence of (Z)-11-HDA and (Z)-9-TDA. In addition, the same compounds elicited a response with the E. lignosellus male antenna obtained from the second insect colony. Electroantennography (EAG) screening with the male E. lignosellus antenna (obtained from the second insect colony) was conducted with the 23 possible tetradecenyl acetates (TDA) and 22 hexadecenyl acetates (HDA) as standards. Out of the 23 TDA isomers evaluated, only (Z)-9-TDA elicited a response and out of the 22 HDA [(Z) and (E) isomers gamma2 to delta13] evaluated only (Z)-11-HDA elicited a response. The acetate compositions of two extracts obtained from insects originating from the two states (Minas Gerais and Goiás) of Brazil were different from one another as well as from that obtained from insects in Tifton, GA, USA. The bioactivity data (GC-EAD) of the extract 2 differed from those reported for the Tifton, GA, USA population. These data suggest polymorphism in relation to the insect populations found in Brazil and in the USA. The possibility of the existence of an E. lignosellus sub-species cannot be ruled out.     

Comparison of the Structural Information on Sol-Gel Systems Provided by Pyrene Labeled Fluorescent Probes

The influence of the acid catalyst concentration on the structural evolution of a sol-gel system was studied by doping TEOS based starting solutions with two fluorescent probes: a polystyrene chain (M _n =1700) and a much shorter alkane chain (M=172), both of them labeled at both ends with 1-pyrenyl. For this purpose, each probe was incorporated in two TEOS∶H₂O∶C₂H₅OH mixtures (molar ratios 1∶4∶1), one at pH 1.2 and the other at pH 2.5 (respectively below and above the isoelectric point of silica). Very low concentrations of the probes were used (≤10⁻⁶ M), so the pyrene dimmers and excimers were formed only intramolecularly. The ratios of excimer to monomer fluorescence intensities at excitation wavelength of 360 nm (where mainly the ground state pyrene dimmers are excited) were studied as a function of time. Different evolutions of these ratios were observed, which allowed us to predict that the silica structure developsvia the formation of primary particles, even at pH values below the isoelectric point of silica, where it is not possible to directly detect their formation.     

Diorganotin(IV) derivatives of substituted benzohydroxamic acids with high antitumor activity

A series of diorganotin(IV) and dichlorotin(IV) derivatives of 4-X-benzohydroxamic acids, [HL(1) (X = Cl) or HL(2) (X = OCH(3))] formulated as [R(2)SnL(2)] (R = Me, Et, nBu, Ph or Cl; L = L(1) or L(2)), along with their corresponding mixed-ligand complexes [R(2)Sn(L(1))(L(2))] have been prepared and characterized by FT-IR, (1)H, (13)C, and (119)Sn NMR spectroscopy, mass spectrometry, elemental analysis, and melting points. In addition, single-crystal X-ray diffraction analyses were carried out for [Me(2)SnL(2)] (L = L(1) or L(2)), which show coordination structures intermediate between distorted octahedra and bicapped tetrahedra. The hydroxamate ligands are asymmetrically coordinated by the oxygen atoms, the carbonyl oxygen atom is further away from the metal center than the other oxygen atom. The complexes are stable monomeric species; most of them are soluble not only in chlorohydrocarbon solvents, but also in alcohols and hydroalcoholic solutions. In polar solvents, the mixed-ligand complexes gradually decompose into the corresponding single-ligand complex couples. The complexes exhibit in vitro antitumor activities (against a series of human tumor cell lines) which, in some cases, are identical to, or even higher than, that of cisplatin. For the dialkyltin complexes, the activity increases with the length of the carbon chain of the alkyl ligand and is higher in the case of the chloro-substituted benzohydroxamato ligand. The [nBu(2)Sn(L(1))(2)] complex displays a high in vivo activity against H22 liver and BGC-823 gastric tumors, and has a relatively low toxicity.     

Preliminary characterization of anhydrous ethanol used in Brazil as automotive fuel

This work reports preliminary studies on the characterisation of anhydrous ethanol (AEA) used as an automotive fuel mixed with gasoline in Porto Alegre (South Brazil). Pre-concentration of the impurities contained in 1000 ml of AEA was carried on through solid-phase extraction using XAD4 resin. The main compounds in the extract were identified by means of spectral data from the library of the equipment. The concentrate was then fractionated using a preparative liquid chromatographic column filled with activated silica gel and the elution procedure was carried out with, n-hexane, n-hexane-benzene (1:1, v/v) and dichloromethane. Prior to analysis by GC-MS, each fraction was reduced to 1 ml with a gentle stream of nitrogen. Saturated linear hydrocarbons and aromatic hydrocarbons eluted in the first fraction and oxygenated compounds such as aldehydes. ketones and alcohols, eluted in the second one. were the main compounds detected in the sample.     

Determination of moxifloxacin in tablets and human urine by square-wave adsorptive voltammetry

This work presents an electroanalytical methodology developed for square-wave voltammetry based in the electrochemical reduction in hanging mercury drop electrode (HMDE), which is simple, fast, reliable and sensitive for determination of moxifloxacin (MOXI) in tablets and spiked urine human samples. The support electrolyte that provided a more defined and intense peak current for MOXI determination was the phosphate buffer 0.04 mol l^{− 1} pH 8.0. In the best-optimized conditions the drug presented an only peak of reduction at − 1.38 V vs. Ag/AgCl, using an E_acc. of − 0.30 V. An LOD of 0.44 and 3.20 ng ml^{− 1} and an LOQ of 1.46 and 10.60 ng ml^{− 1} were found for the pure standard of moxifloxacin and in the presence of matrix, respectively. A good recovery was obtained for assay spiked urine samples and a good quantification of MOXI was achieved in a commercial formulation. The methodology proposed was more sensitive than the spectrofluorimetric and spectrophotometric method with precision and accuracy equivalent.     

Cloud point extraction of vanadium in parenteral solutions using a nonionic surfactant (PONPE 5.0) and determination by flow injection-inductively coupled plasma optical emission spectrometry

A preconcentration and determination methodology for vanadium at trace levels in parenteral solutions was developed. Cloud point extraction was successfully employed for the preconcentration of vanadium prior to inductively coupled plasma atomic optical emission spectrometry (ICP-OES) coupled to a flow injection (FI) system. The vanadium was extracted as vanadium-2-(5-bromo-2-pyridylazo)-5-diethylaminophenol [V-(5-Br-PADAP)] complex, at pH 3.7 mediated by micelles of the nonionic surfactant polyoxyethylene (5.0) nonylphenol (PONPE 5.0). The extracted surfactant-rich phase (100 mul) was mixed with 100 mul of ethanol and this final volume injected into ICP-OES for the vanadium determination. Under these conditions, the 50 ml sample solution preconcentration allowed raising an enrichment factor of 250-fold; however, it was possible to obtain a theoretical enrichment factor of 500-fold. The lower limit of detection (LOD) obtained under the optimal conditions was 16 ng l(-1). The precision for 10 replicate determinations at the 2.0 mug l(-1) V level was 2.3% relative standard deviation (RSD), calculated with the peak heights. The calibration graph using the preconcentration system for vanadium was linear with a correlation coefficient of 0.9996 at levels near the detection limits up to at least 50 mug l(-1). The method was successfully applied to the determination of vanadium in parenteral solution samples.