Thermal decompositions of kaolinite intercalation compounds

Through a combination of X-ray diffraction and thermal analysis (simultaneous TG-DTG-DTA and quasi-isothermal TG), it was shown that the molar ratio intercalation agent/kaolinite in all intercalation compounds is approximately 1. In a saturated atmosphere of the corresponding intercalation agent, the intercalation compounds are stable up to more than 150 °C.Decomposition of the potassium acetate intercalation compound proceeds simultaneously with the dehydroxylation of kaolinite at an extrapolated onset temperature of 360 °C. The high-temperature reactions (dehydroxylation and transformation) of kaolinite obtained through the decomposition of intercalation compounds with volatile intercalation agents depend on the conditions applied during decomposition.

---

Zusammenfassung Mittels Röntgenbeugung und thermischer Analyse (simultane TG-DTG-DTA und quasi-isotherme-quasi-isobare TG) konnte gezeigt werden, daß das molare Verhältnis Einlagerungsmedium/Kaolinit in allen Einlagerungsverbindungen etwa 1 ist. In gesättigter Atmosphäre des jeweiligen Einlagerungsmediums ist die Einlagerungsverbindung stabil bis über 150 °C. Die Zersetzung der Kaliumacetat-Einlagerungsverbindung läuft zusammen mit der Dehydroxylation des Kaolinits bei einer extrapolierten onset-Temperatur von 360 °C ab. Die Hochtemperaturreaktionen (Dehydroxylation, Phasenneubildung) von Kaolinit, der aus der Zersetzung von Einlagerungsverbindungen mit flüchtigen Einlagerungsmedien erhalten würde, werden von den Zersetzungsbedingungen beeinflußt.

---

- ( , , ) , - 1. , , 150°. — ** 360°, ** . , , .

     

Energetic and kinetic investigation of thermally induced molecular rearrangements of esters of (hydroxymethyl) hydridosilanes by DSC

Silanes of the type R¹R²Si(H)CH₂OEl(O)_xR _y ³ [R=organyl; El=C (x=y=1), S (x=2,y=1), P (x=1y=2)] undergo a thermally induced rearrangement to give silanes of the type R¹R²Si (CH₃)OEl(O)_xR _y ³ . The energetic (reaction enthalpy) and kinetic data (reaction order, enthalpy and entropy of activation) of this reaction were determined by means of differential scanning calorimetry. The results obtained are discussed in terms of mechanistic aspects.

---

Zusammenfassung Silane des Typs R¹R²Si(H)CH₂OE10_xR _y ³ mit R=organyl; E1=C (x=y=1), S(x=2, y=1) oder P (x=1,y=2) zeigen eine thermisch induzierte Umlagerung zu Silanen des Typs R¹R²Si(CH₃)OE10_xR _y ³ . Energetische (Reaktionsenthalpie) und kinetische Daten (Reaktionsordnung, Aktivierungsenthalpie und -entropie) dieser Umlagerungsreaktion wurden mittels DSC ermittelt. Die mechanistischen Aspekte der Ergebnisse werden diskutiert.

---

R¹R²Si(H)OE1(O)_xR _y ³ , R= , E1=C (x=y=1), S (x=2,y=1), P (x=1,y=2), R¹R²Si(CH₃)OE1(O)_xR _y ³ . ( ) ( , ) . .

---

     

Quantitative determination of element distributions in silicon based thin film solar cells using SNMS

The determination of elemental distributions in thin film solar cells based on amorphous silicon using electron beam SNMS is possible by quantifying the measured ion intensities. The relative sensitivity factors (RSFs) for all elements measured have to be known. The RSFs have been determined experimentally using implantation and bulk standards with known concentrations of the interesting elements. The measured RSFs have been compared with calculated RSFs. The model used for the calculation of the RSFs takes into account the probability for electron impact ionization and the dwell time of the neutrals inside the postionization region. The comparison between measured and calculated RSF shows, that this model is capable to explain the RSFs for most elements. Differences between calculated and measured values can be explained by the formation of hydride and fluoride molecules (in case of H and F) and influences of the angular distribution of the sputtered neutrals in case of Al. The experimentally determined RSFs have been used for a quantification of depth profiles of the i-, buffer-, p- and front contact layers of a-Si solar cells.     

Bead cellulose derivatives as supports for immobilization and chromatographic purification of proteins

Characteristic data are presented for Divicell, a macroporous bead cellulose with excellent flow parameters. The preparation of Divicell derivatives and their properties are described with respect to their application as chromatographic supports. The ion exchangers Divicell DEAE and Divicell CM were manufactured in two types with different exclusion limits and an available capacity for proteins of up to 100 mg/ml gel. Divicell Blue is a bead cellulose with covalently bound Cibacron Blue F3G-A and was found to be a very suitable adsorbent for the selective separation and purification of human serum albumin. Activation of Divicell with sodium periodate, epichlorohydrin and 5-norbornene-2,3-dicarboximido carbonochloridate provided activated supports used for immobilization of ligands in organic solvents and in aqueous solutions. Coupling of amines, diamines, amino acids, carbohydrates and proteins is described. The immobilized ligands retained their biological activity as determined by their specific adsorption of proteins. Divicell alkyl derivatives were tested in hydrophobic interaction chromatography with bovine serum albumin as a model. Examples are presented of the application of Divicell derivatives to the purification of biomacromolecules such as immunoglobulins and lectins by affinity chromatography. The results were comparable to those obtained using the corresponding Sepharose-derived absorbents.     

Determination of trace elements in zeolites by laser ablation ICP-MS

Laser ablation inductively coupled plasma mass spectrometry using a quadrupole-based mass spectrometer (LA-ICP-QMS) was applied for the analysis of powdered zeolites (microporous aluminosilicates) used for clean-up procedures. For the quantitative determination of trace element concentrations three geological reference materials, granite NIM-G, lujavrite NIM-L and syenite NIM-S, from the National Institute for Metallurgy (South Africa) with a matrix composition corresponding to the zeolites were employed. Both the zeolites and reference materials were fused with a lithium borate mixture to increase the homogeneity and to eliminate mineralogical effects. In order to compare two different approaches for the quantification of analytical results in LA-ICP-MS relative sensitivity coefficients (RSCs) of chemical elements and calibration curves were measured using the geostandards. The experimentally obtained RSCs are in the range of 0.2-6 for all elements of interest. Calibration curves for trace elements were measured without and with Li or Ti as internal standard element. With a few exceptions the regression coefficients of the calibration curves are better than 0.993 with internal standardization. NIM-G granite reference material was employed to evaluate the accuracy of the technique. Therefore, the measured concentrations were corrected with RSCs which were determined using lujavrite reference material NIM-L. This quantification method provided analytical results with deviations of 1-11% from the recommended and proposed values in granite reference material NIM-G, except for Co, Cs, La and Tb. The relative standard deviation (RSD) of the determination of the trace element concentration (n = 5) is about 1% to 6% using Ti as internal standard element. Detection limits of LA-ICP-QMS in the lower microg/g range (from 0.03 microg/g for Lu, Ta and Th to 7.3 microg/g for Cu, with the exception of La) have been achieved for all elements of interest. Under the laser ablation conditions employed (lambda: 266 nm, repetition frequency: 10 Hz, pulse energy: 10 mJ, laser power density: 6 x 10(9) W/cm2) fractionation effects of the determined elements relative to the internal standard element Ti were not observed.     

Synthesis and characterization of the new 22-π aromatic furan-containing macrocycle, “ozaphyrin”

The new 22-π, aromatic “pentaplanar” macrocycle, ozaphyrin ( 6 ), has been synthesized by a McMurry coupling of 5,5′-diformyl-4,4′-dipropyl-2,2′-bipyrrole ( 1 ) with 2,5-bis(5-formyl-4-propyl-2-pyrrolyl)furan ( 5 ). This synthetic pathway to ozaphyrin and its characterization by ¹H nmr spectroscopy, uv-visible spectroscopy, cyclic voltammetry, and X-ray crystallography are described. The structure consists of layers of planar, staggered macrocycles stacked perpendicular to the α-axis. Ozaphyrin crystallizes with four formula units in the monoclinic space group C⁵_2h-P2₁/n in a cell of dimensions a = 10.481(7) Å, b = 17.353(17) Å, c = 18.726(12) Å, and β = 102.84(5)° (108 K). The structure has been refined on F² (5171 unique reflections, 411 variables) to R_w(F_o²) = 0.165. The conventional agreement index R(F) is 0.074 for the 3289 reflections have F_o²>2o(F_o²).     

Results of the ASTM Nuclear Methods intercomparison on NIST apple and peack leaves standard reference materials

The ASTM Task Group on Nuclear Methods of Chemical Analysis (E10.05.12) has conducted a trace element intercomparison among some of its members over the past two years. Eight non-NIST laboratories submitted data using nuclear techniques, with a total of 111 values for the apple leaves and 116 values for the peach leaves, on 46 and 50 elements, respectively. This intercomparison provided a unique opportunity for the analytical laboratories, because the analytical values submitted could be later compared to the NIST certified values. For the seven elements which were certified by NIST and had three or more intercomparison values, the results showed that: 1) 61% of all 56 intercomparison values submitted had results whose stated uncertainty overlapped the uncertainty limits of the NIST certified values, and 2) less than 6% of the intercomparison values had means which fell outside ±20% of the NIST values. In general, the intercomparison values submitted showed excellent agreement with the NIST values. However, many reported uncertainties accompanying intercomparison values appeared overly optimistic.     

Further correlations between fragment ion intensity and critical energy. Unimolecular covalent bond fragmentation

A correlation of fragment ion intensity with critical energy found in the collisional activation spectra of [C₄Ph]⁺˙ ions produced by electron impact can also be found in the unimolecular mass-analysed ion kinetic energy spectra of these ions. The P(E) functions of the unimolecular and collisionally activated ions should differ not only in width but also in structure and therefore, the hypothesis that P(E) functions do not have an important effect on these correlations is tested successfully.     

THE VISUAL PROCESS: PHOTOPHYSICS and PHOTOISOMERIZATION OF MODEL VISUAL PIGMENTS and THE PRIMARY REACTION

Abstract— A systematic comprehensive consideration of the emission spectroscopy, emission lifetimes, transient spectroscopy, as well as quantum yields of fluorescence, triplet occupation and photoisomeriz-ation is given for a wide variety of polyene derivatives including retinyl and longer, as well as shorter chainlength homologs. Absorption spectral properties and the results and significance of theoretical calculations are also included. Chainlength, solvent and temperature effects on state order and photophysical as well as photoisomerization properties are evaluated. The mechanism for the primary light step in vision is considered in light of photophysical and photoisomerization data on model visual pigments and rhodopsin.     

Biosynthesis of anthecotuloide,an irregular sesquiterpene lactone from Anthemis cotula L. (Asteraceae) via a non-farnesyl diphosphate route

Retrobiosynthetic analysis of the allergenic sesquiterpene lactone, anthecotuloide, suggested that this natural product could be formed either by head to head condensation of geranyl diphosphate with dimethylallyl diphosphate, or from farnesyl diphosphate (FPP), the accepted regular sesquiterpene precursor via the rearrangement of a germacranolide precursor. Isotopic labelling of anthecotuloide has now been achieved by feeding [1-(13)C]-glucose, [U-13C6]-glucose and [6,6-(2)H2]-glucose to aseptically grown plantlets of Anthemis cotula(family Asteraceae). Analysis of labelling patterns and absolute 13C abundances using quantitative 13C NMR spectroscopy showed that the isoprene building blocks of this sesquiterpene are formed exclusively via the MEP terpene biosynthetic pathway. This was supported by results from an experiment using [U-13C6]-glucose. A deuterium labelling experiment using [6,6-(2)H2]-glucose supported the original proposal and showed that anthecotuloide is formed from a non FPP precursor. Isotope ratio mass spectrometry suggested that there were two pathways for sesquiterpene biosynthesis in A. cotula.