Effect of Cold Atmospheric Pressure Plasma on Maize Seeds: Enhancement of Seedlings Growth and Surface Microorganisms Inactivation

Cold atmospheric pressure ambient air plasma generated by Diffuse Coplanar Surface Barrier Discharge (DCSBD) was investigated for inhibition of native microbiota and potentially dangerous pathogens (Aspergillus flavus, Alternaria alternata and Fusarium culmorum) on the maize surface. Moreover, the improvement of germination and growth parameters of maize seeds was evaluated. Maize (Zea mays L.; cv. Ronaldinio), one of the most important cultivated crops worldwide, was selected as the research material. Electrical measurements confirmed the high volume power density (80 W cm^?3) of DCSBD plasma. Non-equilibrium plasma state evaluated using optical emission spectroscopy showed values of vibrational and rotational temperature (2700?±?300) K and (370?±?75) K, respectively. Changes on the plasma treated seeds surface were studied by water contact angle measurement, scanning electron microscope analysis and Fourier transform infrared spectroscopy. A complete devitalisation of native microbiota on the surface of seeds was observed after a short treatment time of 60 s (bacteria) and 180 s (filamentous fungi). The plasma treatment efficiency of artificially contaminated maize seeds was estimated as a reduction of 3.79 log (CFU/g) in F. culmorum after a 60-s plasma treatment, 4.21 log (CFU/g) in A. flavus and 3.22 log (CFU/g) in A. alternata after a 300-s plasma treatment. Moreover, the obtained results show an increase in wettability, resulting in a better water uptake and in an enhancement of growth parameters. The investigated DCSBD plasma source provides significant technical advantages and application potential for seed surface finishing without the use of hazardous chemicals.     

Analysis of amino acids by combination of carrier ampholyte-free IEF with ITP

The use of carrier ampholyte-free IEF (CAF-IEF) with ITP mobilization and conductivity detection in ITP mode for preconcentration and analysis of amino acids is demonstrated. The analytical procedure consists of three subsequent steps. In the first step, amino acids are continuously dosed from an infinite volume reservoir by electromigration to the column, where a sharp, stationary neutralization reaction boundary (NRB) is created in between acidic and basic primary electrolyte. Here, amino acids are selectively focused (trapped), if their pI falls to the pH difference on both sides of the NRB (pH gap). Amino acids create sharp rectangular zones, arranged according to their pI values. In the second step, focused zones are mobilized. After accumulation of the detectable amount of amino acids, dosing electrolyte in the infinite volume reservoir is changed for the mobilizing electrolyte. The migration mode is changed from CAF-IEF to ITP and substances start to migrate toward the analytical capillary. In the third step, analytes are transferred into the analytical column equipped with a conductivity detector and are detected in the new leading electrolyte in an ITP migration mode. The presented CAF-IEF-ITP-ITP with time-dependent accumulation of the large-volume sample enables to achieve in a reasonable time a 100 times lower c-LOD (here in orders of nmol/L), than can be reached by conventional hyphenated ITP-ITP.     

Completion of quasi-topological groups

A topology of a quasi-topological group is induced by several natural semi-uniformities, namely right, left, two-sided and Roelcke semi-uniformities. A quasi-topological group is called complete if every Cauchy (in some sense—we examine several generalizations of Cauchy properties) filter on the two-sided semi-uniformity converges.We use the theory of Hausdorff complete semi-uniform spaces, see [B. Batíková, Completion of semi-uniform spaces, Appl. Categor. Struct. 15 (2007) 483-491], and show that Hausdorff complete quasi-topological groups form an epireflective subcategory of Hausdorff quasi-topological groups. But the reflection arrows need not be embeddings.For several types of Cauchy-like properties we show examples of quasi-topological groups that cannot be embedded into a complete group.     

A thermodynamically consistent model of shape-memory alloys

This contribution presents a non-isothermal mesoscopic model of single-crystalline shape-memory alloys within the framework of continuum mechanics. We briefly recall static mesoscopic modeling concepts as presented in e.g. [4, 5] and propose a thermomechanically consistent model featuring the heat equation and thermo-mechanical coupling. (© 2011 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim)     

Comprehensive two-dimensional liquid chromatography-time-of-flight mass spectrometry in the analysis of acidic compounds in atmospheric aerosols

A novel method utilising comprehensive two-dimensional liquid chromatography interfaced to electrospray ionisation time-of-flight mass spectrometry was developed for the determination of organic acids in atmospheric aerosols. The system was applied to the analysis of methanolic extracts of filters from a high volume sampler. The enhanced separation power of two-dimensional separation was demonstrated in the analysis of both rural and urban samples. Quantification was performed for compounds for which standards were available. Limit of detection was 2-200ng/ml. Average reproducibility of retention times in each dimensions was 0.1%, and average reproducibility of peak areas was 8% (10mug/ml, n=3).     

Voltage enhancement in dye-sensitized solar cell using (001)-oriented anatase TiO2 nanosheets

A nanocrystalline TiO₂ (anatase) nanosheet exposing mainly the (001) crystal faces was tested as photoanode material in dye-sensitized solar cells. The nanosheets were prepared by hydrothermal growth in HF medium. Good-quality thin films were deposited on F-doped SnO₂ support from the TiO₂ suspension in ethanolic or aqueous media. The anatase (001) face adsorbs a smaller amount of the used dye sensitizer (C101) per unit area than the (101) face which was tested as a reference. The corresponding solar cell with sensitized (001)-nanosheet photoanode exhibits a larger open-circuit voltage than the reference cell with (101)-terminated anatase nanocrystals. The voltage enhancement is attributed to the negative shift of flatband potential for the (001) face. This conclusion rationalizes earlier works on similar systems, and it indicates that careful control of experimental conditions is needed to extract the effect of band energetic on the current/voltage characteristics of dye-sensitized solar cell.     

Effect of Low Temperature Air Plasma Treatment on Wetting and Flow Properties of Kaolinite Powders

It was found in this study that the air plasma treatment of particular kaolinite has led to the change of its wettability, which was reflected in the decreased values of water contact angles of wetting from 88.7° for virgin kaolinite to 86.3° for 30?min air plasma treated one. Plasma treated samples show higher average surface energies in the wide range of coverage regimes in comparison to the virgin samples as determined by inverse gas chromatography. Results of these measurements confirmed our assumption, that air plasma treatment activates surface energy of the crystal planes of the kaolinite as reflected in the broadened dispersive surface energy distribution after 10?min treatment time. However with prolonged 30?min treatment time the dispersive surface energy distribution profile was decreased. We assume, that the latter decrease reflects the distorsion of the crystal lattice of the kaolinite as confirmed by FTIR analysis as reflected in changes of Si?CO?CSi and Al₂O?CH characteristic absorption bands. Calculated dispersive surface free energy for 24?% surface coverage was increased from original 35?mJ/m² to 40.3 and 40.8?mJ/m² for 10 and 30?min treatment times. There were determined yield locus and flow function dependencies at different stress levels for virgin and different time plasma treated samples (flow index??ff _c , effective angle of internal friction???? _e , unconfined yield strength???? _c ). It was found that by plasma treatment the character of the flow was shifting from region of very cohesive (ff _c ?=?2.39) to the cohesive (ff _c ?=?3.19). For untreated samples effective angle of internal friction was decreased with increasing applied consolidation stress, while for plasma treated kaolinite it was increased.     

Amphiphilic conetworks. II. Novel two‐step synthesis of poly[2‐(dimethylamino)ethyl methacrylate]–polyisobutylene,poly(N‐isopropylacrylamide)–polyisobutylene,and poly(N,N‐dimethylacrylamide)–polyisobutylene hydrogels

Amphiphilic polymer conetworks consisting of hydrophilic poly[2‐(dimethylamino)ethyl methacrylate], poly(N‐isopropylacrylamide), or poly(N,N‐dimethylacrylamide) and hydrophobic polyisobutylene chains were synthesized with a novel two‐step procedure. In the first step, a methacrylate‐multifunctional polyisobutylene crosslinker was prepared by the cationic copolymerization of isobutylene with 3‐isopropenyl‐α,α‐dimethylbenzyl isocyanate. In the second step, the methacrylate‐multifunctional polyisobutylene crosslinker, with a number‐average molecular weight of 8200 and an average functionality of approximately 4 per chain, was copolymerized radically with 2‐(dimethylamino)ethyl methacrylate, N‐isopropylacrylamide, or N,N‐dimethylacrylamide into transparent amphiphilic conetworks containing 42–47 mol % hydrophilic monomer. The synthesized conetworks were characterized with solid‐state ¹³C NMR spectroscopy and differential scanning calorimetry. The amphiphilic nature of the conetworks was proved by swelling in both water and n‐heptane. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 6378–6384, 2006