Pressure and temperature dependence of the gas‐transport properties of dense poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] membranes

The gas‐transport properties of poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] (6FDA‐2,6‐DAT) have been investigated. The sorption behavior of dense 6FDA‐2,6‐DAT membranes is well described by the dual‐mode sorption model and has certain relationships with the critical temperatures of the penetrants. The solubility coefficient decreases with an increase in either the pressure or temperature. The temperature dependence of the diffusivity coefficient increases with an increase in the penetrant size, as the order of the activation energy for the diffusion jump is CH₄ > N₂ > O₂ > CO₂. Also, the average diffusion coefficient increases with increasing pressure for all the gases tested. As a combined contribution from sorption and diffusion, permeability decreases with increases in the pressure and the kinetic diameter of the penetrant molecules. Even up to 32.7 atm, no plasticization phenomenon can be observed on flat dense 6FDA‐2,6‐DAT membranes from their permeability–pressure curves. However, just as for other gases, the absolute value of the heat of sorption of CO₂ decreases with increasing pressure at a low‐pressure range, but the trend changes when the feed pressure is greater than 10 atm. This implies that CO₂‐induced plasticization may occur and reduce the positive enthalpy required to create a site into which a penetrant can be sorbed. Therefore, a better diagnosis of the inherent threshold pressure for the plasticization of a glassy polymer membrane may involve examining the absolute value of the heat of sorption as a function of pressure and identifying the turning point at which the gradient of the absolute value of the heat of sorption against pressure turns from a negative value to a positive one. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 354–364, 2004     

Relationship between the dynamic softening transition and wet sliding friction of elastomer compounds

For properly chosen elastomer compounds, thermorheological characterization is combined with an examination of the variation of the wet sliding friction with temperature. A conceptual argument leads to the assumption that the wet sliding friction should maximize at the energy dissipation peak associated with the dynamic softening transition at a characteristic frequency determined by the sliding speed and the effective smallest surface asperity scale. The dynamic softening transition is characterized with the peak in tan δ/G′ⁿ, where tan δ is the loss tangent, G′ is the elastic modulus, and n is a constant between 0 and 1. The William–Landel–Ferry transform is uncritically applied for extrapolating the position of the peak in tan δ/G′ⁿ at high frequencies. Even based on the criterion of tan δ, the results obtained on a concrete surface indicate that the effective smallest asperity scale is of order of 100 μm. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2467–2478, 2004     

Differential scanning calorimetry and thermogravimetric analysis investigation of the thermal properties and degradation of some radiation‐grafted films and membranes

The influence of irradiation and grafting on the crystallinity of three base polymers has been investigated with differential scanning calorimetry. Grafting has the largest effect on the base polymer crystallinity and results in a reduction of the crystallinity. The thermal degradation of the base polymers and grafted films has been investigated with thermogravimetric analysis. The extent of the fluorination of the base polymer, the irradiation method, and the graft level all influence the thermal degradation and its activation energy. It is proposed that the variation of the chain lengths of the grafted polystyrene chains is actually a primary underlying factor responsible for the influence of these various parameters on the degradation process. The first results of a comparative thermal analysis of some fuel‐cell membranes are also presented, and the promise and shortcomings of this method are discussed. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2612–2624, 2004     

Baker＇s Yeast Mediated Reduction of Optically Active Diketone

Baker‘s yeast mediated reduction of optically active diketone is described. The two keto groups are efficiently differentiated and the ee value of the recovered material is considerably raised. It affords highly optically active key intermediates efficiently for the synthesis of natural polyhydroxylated agarofuran products.     

Galerkin method for optimal control of second‐order evolution equations

This paper presents the Galerkin approximation of the optimization problem of a system governed by non‐linear second‐order evolution equation where a non‐linear operator depends on derivative of the state of the system. The control is acting on a non‐linear equation. After giving some results on the existence of optimal control we shall prove the existence of the weak and strong condensation points of a set of solutions of the approximate optimization problems. Each of these points is a solution of the initial optimization problem. Finally we shall give a simple example using the obtained results. Copyright © 2004 John Wiley & Sons, Ltd.     

Modelling of an underground waste disposal site by upscaling

In this paper, we study the global behaviour of an underground waste disposal in order to have an accurate upscaled model suitable for the computations involved in safety assessment processes. We start from a detailed model describing the transport of pollutant leaking from a high number of units. Using the method of homogenization, going to the limit, we obtain first a macroscopic model where the sources are now appearing globally. Then we compute a first‐order matched asymptotic expansion and we give the error estimates for this approximation. Copyright © 2004 John Wiley & Sons, Ltd.     

Dynamic boundary stabilization of a Reissner–Mindlin plate with Timoshenko beam

This paper is concerned with well‐posedness results for a mathematical model for the transversal vibrations of a two‐dimensional hybrid elastic structure consisting of a rectangular Reissner–Mindlin plate with a Timoshenko beam attached to its free edge. The model incorporates linear dynamic feedback controls along the interface between the plate and the beam. Classical semigroup methods are employed to show the unique solvability of the coupled initial‐boundary‐value problem. We also show that the energy associated with the system exhibits the property of strong stability. Copyright © 2004 John Wiley & Sons, Ltd.     

Artificial boundary conditions for Petrovsky systems of second order in exterior domains and in other domains of conical type

The approximation of solutions to boundary value problems on unbounded domains by those on bounded domains is one of the main applications for artificial boundary conditions. Based on asymptotic analysis, here a new method is presented to construct local artificial boundary conditions for a very general class of elliptic problems where the main asymptotic term is not known explicitly. Existence and uniqueness of approximating solutions are proved together with asymptotically precise error estimates. One class of important examples includes boundary value problems for anisotropic elasticity and piezoelectricity. Copyright © 2004 John Wiley & Sons, Ltd.     

Parabolic Capacity and Soft Measures for Nonlinear Equations

We first introduce, using a functional approach, the notion of capacity related to the parabolic p-Laplace operator. Then we prove a decomposition theorem for measures (in space and time) that do not charge the sets of null capacity. We apply this result to prove existence and uniqueness of renormalized solutions for nonlinear parabolic initial boundary-value problems with such measures as right-hand side.     

Coupling of a multilevel fast multipole method and a microlocal discretization for the 3-D integral equations of electromagnetism

The aim of this work is to propose an accurate and efficient numerical approximation for high frequency diffraction of electromagnetic waves. In the context of the boundary integral equations presented in F. Collino and B. Després, to be published in J. Comput. Appl. Math., the strategy we propose combines the microlocal discretization (T. Abboud et al., in: Third International Conference on Mathematical Aspects of Wave Propagation Phenomena, SIAM, 1995, pp. 178–187) and the multilevel fast multipole method (J.M. Song, W.C. Chew, Microw. Opt. Tech. Lett. 10 (1) (1995) 14–19). This leads to a numerical method with a reduced complexity, of order O(N^4/3ln(N)+N_iterN^2/3), instead of the complexity O(N_iterN²) for a classical numerical iterative solution of integral equations. Computations on an academic geometry show that the new method improves the efficiency, for a solution with a good level of accuracy. To cite this article: A. Bachelot et al., C. R. Acad. Sci. Paris, Ser. I 336 (2003).