Hydrogen bonding in ε-caprolactam dimer: a quantum-chemical study

The equilibrium geometries, vibrational frequencies, and IR band intensities were calculated for the monomer and hydrogen-bonded cyclic dimer of -caprolactam (1) by the density functional B3LYP/6-311++G(d,p) method and compared with the experimental data. The gas phase IR spectrum of monomer of 1 was first measured. The calculated hydrogen bonding enthalpy H/2 in the hydrogen-bonded dimer in the gas phase (–5.93 kcal/mol) is consistent with the published data. The computed scaled (scaling factor 0.97) vibrational frequencies of the monomer and dimer are in good agreement with the experimental data. The geometry of the -caprolactam monomer remains nearly unchanged in its dimer except for the N-H, C-O, and C-N bond lengths that respectively change from 1.012, 1.230, and 1.369 in the former to 1.029, 1.246, and 1.350 in the latter. The frequencies, eigenvectors, and IR intensities of the amide modes of the monomer and dimer differ dramatically. The calculated NH and CO frequency shifts due to hydrogen bonding are in good agreement with the experimental data, but theoretical intensification of the NH IR band is much greater than that observed experimentally (by nearly 69 times vs. 11 times, respectively). The calculated N...O intermolecular distance in the structure of -caprolactam dimer equals the experimental value (2.89 ). The influence of the basis set employed on the results of calculations is discussed.Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 1818–1825, September, 2004.     

Reactions of imides with samarium(ii) iodide

The tendency of a series of imides and lactams to react with samarium(II) iodide was investigated. Under the action of Sml₂ at 20 °C, one of the carbonyl groups ofN-phenylphthalimide was reduced to a CHOH or CH₂ group depending on the molar ratio of the reagents and the order of their introduction into the reaction mixture. Both CO groups ofN-acetylcaprolactam are reduced with SmI₂ under similar conditions, whereas the CO group of -caprolactam is not reduced by SmI₂.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1236–1238, May, 1996.     

Extraction-spectrophotometric determination of iron with 2-(2′-benzothiazolylazo)-4,6-dimethylphenol

An extraction-spectrophotometric method for the determination of trace amounts of iron based on its extraction into chloroform with 2-(2-benzothiazolylazo)-4,6-dimethylphenol (BTADMP) from a pH 6.5 medium has been developed. The extracted 12 FeBTADMP complex species allow the determination of 4–30gmg of iron (=3.92×10⁴1·mol^–1·cm^–1 at 790 nm). The method is highly selective and has been applied to the determination of iron in polymineral-polyvitamin pharmaceutical products.     

Properties of aqueous salt solutions of poly(ethylene oxide). Cloud points, θ temperatures

The determination of the properties of aqueous salt solutions of poly(ethylene oxide) has been extended to the cloud point, and temperature measurements have been made at several concentrations for various salts (flourides, iodides, acetates, formates, phosphates, bromides, thiosulfates and perchlorates). The resulting dependency of the critical temperatures (mostly between 290–350 K) on the molar concentration can be expressed as sequences showing the decreasing effect of anion species or cation species in salting out the polymer. The decreasing order of effectiveness of the anions in reducing the temperature is PO ₄ > HPO ₄ > S₂O ₃ > H₂PO ₄ ^– >F^– > HCOO^– > CH₃COO^– > Br^– > I^–. The order for cations is K⁺ Rb⁺ Na⁺ Cs⁺ > Sr⁺⁺ > Ba⁺⁺ Ca⁺⁺ > NH ₄ ⁺ > Li⁺. The changes brought about in temperatures by the salts were found to be the results of the changes taking place in the hydrophilic and hydrophobic interactions among polymer, solvent and additive salts and of the change of water structure by structure making or structure breaking ions, and of the influence of salts on the hydration sheath of the polymer.     

Reactions of ε-caprolactam with dialkyl(aryl)dichlorosilanes and triethylchlorosilane

Conclusions Reactions of -caprolactam with dialkyl(aryl)dichlorosilanes and triethylchlorosilane were investigated. Six new alkyl(aryl)silyl derivatives of -caprolactam were isolated and examined.Translated from Izvestiya Akademii Nauk SSSR, Seriya Khimicheskaya, No. 5, pp. 1157–1159, May, 1970.     

Effects of inorganic salts on the properties of aqueous poly(vinylpyrrolidone) solutions

Cloud point curves and temperatures have been determined for aqueous solutions of poly(vinylpyrrolidone) at several concentrations for a variety of inorganic salts (phosphates, monohydrogen phosphates, sulfates, carbonates, dihydrogen phosphates and fluorides). The resulting dependency of the critical temperatures (mostly between 289 and 350 K) on the molar concentration can be expressed as sequences showing the decreasing effect of anion species or cation species in salting out the polymer. The decreasing order of effectiveness of the anions in reducing the temperatures is PO ₄ ^3– >HPO ₄ ^2– >SO ₄ ^2– CO ₃ ^2– >H₂PO ₄ ^– >F^–. The order for cation is Na⁺>K⁺. The changes brought about in temperatures by the salts were found to be the results of the changes taking place in the hydrophilic and hydrophobic interactions among polymer, solvent and additive salts and of the change of water structure by structure making or structure breaking ions, and of the influence of salts on the hydration sheath of the polymer.Deceased     

Reactions of Polyfluorinated Telomeric Alcohols with ε-Caprolactam

The possibility of preparing fluorinated oligomeric derivatives of -aminocaproic acid by reaction of polyfluorinated telomeric alcohols H(CF₂CF₂) _n CH₂OH (n = 1-4) with -caprolactam under conditions of homogeneous catalysis (triethylamine, dimethylformamide) was examined. The thermal stability of the oligomers was studied in relation to the fluorine content.     

Nucleation of the β-modification of isotactic polypropylene

The effects of the organic pigments C.I.P. RED 177 and C.I.P. Yellow 83 as nucleating agents on the crystallization of polypropylene were studied by DSC. The anthraquinone pigment exerted a significant effect, resulting in structural modifications with lower melting point, and particularly the -modification. The DSC curves exhibit four transition regions, with the following temperature intervals: I. 415–417 K, II. 423–425 K, III. 430–432 K and IV. 438–439 K. For evaluation of the -nucleation effect of pigments, the ratio (H ₁+H ₂)/(H ₃+H ₄) was suggested.     

Partition coefficients of ω-phenylalkanols between water and sodium deoxycholate micelles

The partition coefficient of -phenylalkanols [C₆H₅(CH₂)_mpOH, m _p =3–6] between water and micelles of sodium deoxycholate (NaDC) has been determined by a differential spectroscopic method at 25°C. The linear dependence of thestandard free energy change of transfer calculated from the partition coefficient on the alkyl chain length of the alkanols (m _p 4) yields the standard free energy change per methylene group [G^o(CH₂)]. G^o(CH₂) value for the present system, –3.21 kJ-mol ^–1 is larger in magnitude than that for sodium dodecylsulfate (SDS)--phenylalkanol system, –2.40 kJ-mol ^–1 . The result indicates that the alkyl chain of -phenylalkanols has higher affinity to NaDC micelles than to SDS micelles although the molecular structure of NaDC is more rigid and bulkier than that of SDS and the aggregation number of micelles of the former is much smaller than that of micelles of the latter. On the basis of the linear relation between the effect of added -phenylalkanols on the critical micelle concentration of NaDC (–dC_cmc/dC_a) and the partition coefficient, it is found that the degree of ionization of NaDC micelles is not influenced by solubilization of -phenylalkanols into the micelles.     

Scattering from concentration fluctuations in polymer blends: A monte carlo investigation

The collective scattering function S_coll( ), which describes light (neutron-, x-ray) scattering under wavevector , is obtained from Monte Carlo simulations for a symmetrical polymer mixture. The polymers are modelled by self-avoiding walks ofN _A=N_B=N steps on a simple cubic lattice, where a fraction _V of sites is left vacant, and an attractive energy occurs if two neighboring sites are taken by the same kind of monomer. Spinodal curves are estimated from linear extrapolation of S _coll ^–1 (0) vs./k _B T, whereT is the temperature. Also the single chain structure factor is obtained and the de Gennes random phase approximation (RPA) can thus be tested. Unexpectedly, strong deviations are found if one species is very dilute. The estimation of an effective Flory-Huggins-parameter from scattering data is also discussed.Contributed paper delivered at the Tagung der Deutschen Physikalischen Gesellschaft, Fachausschuß Polymerphysik, Hamburg, March 14–16, 1987.