Dissociative chemisorption and energy transfer for methane on Ir(111)

A 3-parameter local hot spot model of gas-surface reactivity is employed to analyze and predict dissociative sticking coefficients for CH(4) incident on Ir(111) under varied nonequilibrium and equilibrium conditions. One Ir surface oscillator and the molecular vibrations, rotations, and translational energy directed along the surface normal are treated as active degrees of freedom in the 14 dimensional microcanonical kinetics. The threshold energy for CH(4) dissociative chemisorption on Ir(111) derived from modeling molecular beam experiments is E(0) = 39 kJ/mol. Over more than 4 orders of magnitude of variation in sticking, the average relative discrepancy between the beam and theoretically derived sticking coefficients is 88%. The experimentally observed enhancement in dissociative sticking as beam translational energies decrease below approximately 10 kJ/mol is consistent with a parallel dynamical trapping/energy transfer channel that likely fails to completely thermalize the molecules to the surface temperature. This trapping-mediated sticking, indicative of specific energy transfer pathways from the surface under nonequilibrium conditions, should be a minor contributor to the overall dissociative sticking at thermal equilibrium. Surprisingly, the CH(4) dissociative sticking coefficient predicted for Ir(111) surfaces at thermal equilibrium, based on the molecular beam experiments, is roughly 4 orders of magnitude higher than recent measurements on supported nanoscale Ir catalysts at 1 bar pressure, which suggests that substantial improvements in catalyst turnover rates may be possible.     

Cationic Ir(III) alkylidenes are key intermediates in C-H bond activation and C-C bond-forming reactions

This work describes the chemical reactivity of a cationic (η(5)-C(5)Me(5))Ir(III) complex that contains a bis(aryl) phosphine ligand, whose metalation determines its unusual coordination in a κ(4)-P,C,C',C" fashion. The complex (1(+) in this paper) undergoes very facile intramolecular C-H bond activation of all benzylic sites, in all likelihood through an Ir(V) hydride intermediate. But most importantly, it transforms into a hydride phosphepine species 4(+) by means of an also facile, base-catalyzed, intramolecular dehydrogenative C-C coupling reaction. Mechanistic studies demonstrate the participation as a key intermediate of an electrophilic cationic Ir(III) alkylidene, which has been characterized by low-temperature NMR spectroscopy and by isolation of its trimethylphosphonium ylide. DFT calculations provide theoretical support for these results.     

Six-dimensional quantum dynamics of dissociative chemisorption of H2 on Ru(0001)

Six-dimensional quantum dynamics calculations on dissociative chemisorption of H(2) on Ru(0001) are performed. The six-dimensional potential energy surface is generated using density functional theory. Two different generalized gradient approximations are used, i.e., RPBE and PW91, to allow the results to be compared. The dissociation probability for normally incident H(2) on a clean Ru(0001) surface is calculated. Large differences between the reaction probabilities calculated using the RPBE and PW91 are seen, with the PW91 results showing a much narrower reaction probability curve and a much higher reactivity. Using the reaction probabilities and assuming normal energy scaling reaction rates are generated for temperatures between 300 and 800 K. The rate generated using the PW91 results is higher by about a factor 5 than the rate based on the RPBE results in the range of temperatures relevant to ammonia production.     

Hydration processes of electrolyte anions and cations on pt(111), Ir(111), Ru(001) and Au(111) surfaces: coadsorption of water molecules with electrolyte ions

Water adsorption on Pt( 111) and Ru(001) treated with oxygen, hydrogen chloride and sodium atom at 20 K has been studied by Fourier transform infrared spectroscopy, scanning tunneling microscopy and surface X-ray diffraction. Water molecules chemisorb predominantly on the sites of the electronegative additives, forming hydrogen bonds. Three types of hydration water molecules coordinate to an adsorbed Na atom through an oxygen lone pair. In contrast, water molecules adsorb on electrode surfaces in a simple way in solution. In 1 mM CuSO4 + 0.5 M H2SO4 solution on an Au(111) electrode surface, water molecules coadsorb not only with sulfuric acid anions through hydrogen bonding but also with copper, over wide potential ranges. In the first stage of underpotential deposition (UPD), each anion is accommodated by six copper hexagon (honeycomb) atoms on which water molecules dominate. At any UPD stage water molecules interact with both the copper atom and sulfuric acid anions on the Au(111) surface. Water molecules also coadsorb with CO molecules on the surface of 2 x 2-2CO-Ru(001). All of the hydration water molecules chemisorb weakly on the surfaces. There appears to be a correlation between the orientation of hydrogen bonding water molecules and the electrode potential.     

Quantum dynamics of dissociative chemisorption of CH(4) on Ni(111): Influence of the bending vibration

Two-dimensional, three-dimensional, and four-dimensional quantum dynamic calculations are performed on the dissociative chemisorption of CH(4) on Ni(111) using the multiconfiguration time-dependent Hartree (MCTDH) method. The potential energy surface used for these calculations is 15-dimensional (15D) and was obtained with density functional theory for points which are concentrated in the region that is dynamically relevant to reaction. Many reduced dimensionality calculations were already performed on this system, but the molecule was generally treated as pseudodiatomic. The main improvement of our model is that we try to describe CH(4) as a polyatomic molecule by including a degree of freedom describing a bending vibration in our three-dimensional and four-dimensional models. Using a polyspherical coordinate system, a general expression for the 15D kinetic energy operator is derived, which discards all the singularities in the operator and includes rotational and Coriolis coupling. We use seven rigid constraints to fix the CH(3) umbrella of the molecule to its gas phase equilibrium geometry and to derive two-dimensional, three-dimensional, and four-dimensional Hamiltonians, which were used in the MCTDH method. Only four degrees of freedom evolve strongly along the 15D minimum energy path: the distance of the center of mass of the molecule to the surface, the dissociative C[Single Bond]H bond distance, the polar orientation of the molecule, and the bending angle between the dissociative C[Single Bond]H bond and the umbrella. A selection of these coordinates is included in each of our models. The polar rotation is found to be important in determining the mode selective behavior of the reaction. Furthermore, our calculations are in good agreement with the finding of Xiang et al. [J. Chem. Phys. 117, 7698 (2002)] in their reduced dimensional calculation that the helicopter motion of the umbrella symmetry axis is less efficient than its cartwheel motion for promoting the reaction. The effect of pre-exciting the bend modes is qualitatively incorrect at higher energies, suggesting the necessity of including additional rotational and vibrational degrees of freedom in the model.     

Adsorption of [D2]methanol on Ru(001)--O surfaces: the influence of preadsorbed oxygen on the methoxide geometry.

The influence of oxygen precoverage on the bonding geometry of methoxide on Ru(001) was studied using the isotopically labeled molecule CHD2OH by reflection-absorption infrared spectroscopy (RAIRS). This molecule is an excellent model because the vibrational spectra of CHD2O- may be unambiguously correlated with the adsorption configuration. For Ru(001)--O layers with an effective oxygen coverage (theta0) between 0.25 and 0.6 ML (ML=monolayer), the influence of the oxygen precoverage was shown to vary with the initial methanol exposure. For an extremely low dose of [D2]methanol (0.01 L; L=Langmuir, 1 L=10(-6) torr s), at 90 K, no oxygen-coverage effects were detected on the geometry of [D2]methoxide: it adsorbs in an upright orientation (pseudo-C(3v) local symmetry), just as on clean Ru(001). An increase in the methanol exposure to 0.1 L, at the same temperature, results in the formation of a disordered layer of tilted methoxide: for theta(O)=0.25 ML, C(s)/C1 and intrinsic C1 configurations are present on the surface, whereas for theta(O)> or =0.5 ML, only the former species were identified. The thermal activation of these tilted layers to 105 K results in a lower coverage of upright methoxide for any oxygen precoverage, coadsorbed with decomposition products, as confirmed by the detection of adsorbed formaldehyde and, on the denser oxygen layer (theta(O)=0.6 ML), formate. The influence of the oxygen precoverage becomes determinant when annealing a [D2]methanol multilayer to 105 K: for theta(O)=0.25 ML, the RAIR spectrum correlates with a disordered layer of tilted methoxide and formaldehyde, whereas for theta(O)=0.6 ML upright methoxide, formate, and carbon monoxide were identified. On clean Ru(001), for methanol exposures > or =0.1 L, the C(3v) methoxide configuration was never attained upon thermal activation.     

The chemistry of trimethylamine on Ru(001) and O/Ru(001)

The interaction and reactivity of trimethylamine (TMA) has been studied over clean and oxygen-covered Ru(001) under UHV conditions, as a model for the chemistry of high-density hydrocarbons on a catalytic surface. The molecule adsorbs intact at surface temperature below 100 K with the nitrogen end directed toward the surface, as indicated from work function change measurements. At coverage less than 0.05 ML (relative to the Ru substrate atoms), TMA fully dissociates upon surface heating, with hydrogen as the only evolving molecule following temperature-programmed reaction/desorption (TPR/TPD). At higher coverage, the parent molecule desorbs, and its desorption peak shifts down from 270 K to 115 K upon completion of the first monolayer, indicating a strong repulsion among neighbor molecules. The dipole moment of an adsorbed TMA molecule has been estimated from work function study to be 1.4 D. Oxygen precoverage on the ruthenium surface has shown efficient reactivity with TMA. It shifts the surface chemistry toward the production of various oxygen-containing stable molecules such as H2CO, CO2, and CO that desorb between 200 and 600 K, respectively. TMA at a coverage of 0.5 ML practically cleans off the surface from its oxygen atoms as a result of TPR up to 1650 K, in contrast to CO oxidation on the O/Ru(001) surface. The overall reactivity of TMA on the oxidized ruthenium surface has been described as a multistep reaction mechanism.     

Six-dimensional potential energy surface of the dissociative chemisorption of HCl on Au(111) using neural networks

We constructed a six-dimensional potential energy surface(PES)for the dissociative chemisorption of HCl on Au(111)using the neural networks method based on roughly 70000 energies obtained from extensive density functional theory(DFT)calculations.The resulting PES is accurate and smooth,based on the small fitting errors and good agreement between the fitted PES and the direct DFT calculations.Time-dependent wave packet calculations show that the potential energy surface is very well converged with respect to the number of DFT data points,as well as to the fitting process.The dissociation probabilities of HCl initially in the ground rovibrational state from six-dimensional quantum dynamical calculations are quite diferent from the four-dimensional fixed-site calculations,indicating it is essential to perform full-dimensional quantum dynamical studies for the title molecule-surface interaction system.     

An extended Hückel study of hydrogen and oxygen chemisorption on Ru(001) surface

Extended Hückel MO theory has been applied to treat the chemisorption of hydrogen and oxygen atoms on Ru(001) surfaces. The site of chemisorption, surface-adatom distance, chemisorption energy and the vibrational frequency of the adatom on the surface have been calculated. For different sites, the chemisorption energy (E_c) results are as follows: For hydrogen, |E_c|(centre) > |E_c|(top) > |E_c|(bridge); while for oxygen, |E_c|(bridge) > |E_c|(top) > |E_c|(centre). These results are critically discussed in the light of the recent results obtained from the electron energy-loss spectroscopy (EELS) experiments.