Synthesis of Multifunctional Mn‐Doped CdTe/ZnS Core/Shell Quantum Dots

The synthesis of a novel water‐soluble Mn‐doped CdTe/ZnS core‐shell quantum dots using a proposed ultrasonic assistant method and 3‐mercaptopropionic acid (MPA) as stabilizer is descried. To obtain a high luminescent intensity, post‐preparative treatments, including the pH value, reaction temperature, reflux time and atmosphere, have been investigated. For an excellent fluorescence of Mn‐doped CdTe/ZnS, the optimal conditions were pH 11, reflux temperature 100°C and reflux time 3 h under N₂ atmosphere. While for phosphorescent Mn‐doped CdTe/ZnS QDs, the synthesis at pH 11, reflux temperature 100°C and reflux time 3 h under air atmosphere gave the best strong phosphorescence. The characterizations of Mn‐doped CdTe/ZnS QDs were also identified using AFM, IR, powder XRD and thermogravimetric analysis. The data indicated that the photochemical stability and the photoluminescence of CdTe QDs are greatly enhanced by the outer inorganic ZnS shell, and the doping Mn²⁺ ions in the as‐prepared quantum dots contribute to strong luminescence. The strong luminescence of Mn‐doped CdTe/ZnS QDs reflected that Mn ions act as recombination centers for the excited electron‐hole pairs, attributing to the transition from the triplet state (⁴T₁) to the ground state (⁶A₁) of the Mn²⁺ ions. All the experiments demonstrated that the surface states played important roles in the optical properties of Mn‐doped CdTe/ZnS core‐shell quantum dots.     

Ascorbic Acid Induced Enhancement of Room Temperature Phosphorescence of Sodium Tripolyphosphate‐Capped Mn‐Doped ZnS Quantum Dots: Mechanism and Bioprobe Applications

Although quantum dot (QD)‐based room temperature phosphorescence (RTP) probes are promising for practical applications in complex matrixes such as environmental, food and biological samples, current QD‐based‐RTP probes are not only quite limited but also exclusively based on the RTP quenching mechanism. Here we report an ascorbic acid (AA) induced phosphorescence enhancement of sodium tripolyphosphate‐capped Mn‐doped ZnS QDs, and its application for turn‐on RTP detection. The chelating ability allows AA to extract the Mn and Zn from the surface of the QDs and to generate more holes which are subsequently trapped by Mn²⁺, while the reducing property permits AA to reduce Mn³⁺ to Mn²⁺ in the excited state, thereby enhancing the excitation and orange emission of the QDs. The enhanced RTP intensity of the QDs increases linearly with the concentration of AA in the range of 0.05–0.8 μM . Thus, a QD‐based RTP probe for AA is developed. The proposed QD‐based turn‐on RTP probe avoids tedious sample pretreatment, and offers good sensitivity and selectivity for AA in the presence of the main relevant metal ions and other molecules in biological fluids. The limit of detection (3s) of the developed method is 9 nM AA, and the relative standard deviation is 4.8 % for 11 replicate detections of 0.1 μM AA. The developed method is successfully applied to the analysis of real samples of human urine and plasma for AA with quantitative recoveries from 96 to 105 %.     

Sensing during In Situ Growth of Mn‐Doped ZnS QDs: A Phosphorescent Sensor for Detection of H2S in Biological Samples

Monitoring the in situ growth of Mn‐doped ZnS quantum dots is shown to be a route to selectively detect H₂S, an important endogenously produced signalling molecule. The use of Mn²⁺ as a dopant resulted in orange phosphorescence, making it possible to avoid the background fluorescence from biological surroundings that can occur at other wavelengths. The choice of ZnS QDs as the host material ensured selectivity, since only sulfide can precipitate Zn²⁺ and Mn²⁺ from aqueous solution.     

Doped zinc sulfide quantum dots based phosphorescence turn-off/on probe for detecting histidine in biological fluid

We report a turn-on phosphorescence probe for detection of histidine based on Co²⁺-adsorbed N-acetyl-l-cysteine (NAC) capped Mn: ZnS quantum dots (QDs) which is directly synthesized by the hydrothermal method. The phosphorescence of NAC-Mn: ZnS QDs is effectively quenched by Co²⁺ attributing to the adsorption of Co²⁺ onto the surface of QDs with a concomitant in suppressing the recombination process of hole and electron of QDs. The phosphorescence of Co²⁺-adsorbed NAC-Mn: ZnS QDs can be recovered by binding of Co²⁺ with histidine. The quenching and regeneration of the phosphorescence of NAC-Mn: ZnS QDs have been studied in detail. The as-prepared QDs-based probe is applied to determine histidine with a linear range of 1.25–30 μM and a detection limit of 0.74 μM. The relative standard deviation for eleven repeat detections of 20 μM histidine is 0.65%. Co²⁺-adsorbed NAC-Mn: ZnS QDs show high sensitivity and good selectivity to histidine over other amino acids, metal ions and co-existing substances. The proposed QDs probe has been successfully applied to determination of histidine in human urine samples with good recoveries of 98.5–103%.     

Ratiometric two-photon excited photoluminescence of quantum dots triggered by near-infrared-light for real-time detection of nitric oxide release in situ

Probe-donor integrated nanocomposites were developed from conjugating silica-coated Mn²⁺:ZnS quantum dots (QDs) with MoS₂ QDs and photosensitive nitric oxide (NO) donors (Fe₄S₃(NO)₇⁻, RBS). Under excitation with near-infrared (NIR) light at 808 nm, the Mn²⁺:ZnS@SiO₂/MoS₂-RBS nanocomposites showed the dual-emissive two-photon excited photoluminescence (TPEPL) that induced RBS photolysis to release NO in situ. NO caused TPEPL quenching of Mn²⁺:ZnS QDs, but it produced almost no impact on the TPEPL of MoS₂ QDs. Hence, the nanocomposites were developed as a novel QDs-based ratiometric TPEPL probe for real-time detection of NO release in situ. The ratiometric TPEPL intensity is nearly linear (R² = 0.9901) with NO concentration in the range of 0.01∼0.8 μM, which corresponds to the range of NO release time (0∼15 min). The detection limit was calculated to be approximately 4 nM of NO. Experimental results confirmed that this novel ratiometric TPEPL probe possessed high selectivity and sensitivity for the detection of NO against potential competitors, and especially showed high detection performance for NIR-light triggered NO release in tumor intracellular microenvironments. These results would promote the development of versatile probe-donor integrated systems, also providing a facile and efficient strategy to real-time detect the highly controllable drug release in situ, especially in physiological microenvironments.     

基于Mn掺杂ZnS量子点室温磷光法检测盐酸巴马汀

本文以3-巯基丙酸(3-Mercaptopropionic Acid,MPA)为稳定剂,采用水相合成法制备了Mn掺杂ZnS量子点(Mn∶ZnS QDs),基于Mn∶ZnS QDs的室温磷光性质,盐酸巴马汀(Palmatine Hydrochloride,PaH)可与Mn∶ZnS QDs发生静电作用,使得Mn∶ZnS QDs发生室温磷光猝灭效应,从而发展了一种高效、快速检测人体体液中痕量PaH的新方法。实验结果表明,当PaH的浓度在0.75~30μmol/L范围时,其浓度与室温磷光猝灭强度(ΔIRTP)呈良好的线性关系,相关系数为0.996,检出限为0.35μmol/L,加标回收率为94.0%~103.3%。     

CdS/ZnS core-shell quantum dots capped with mercaptoacetic acid as fluorescent probes for Hg(II) ions

We have synthesised water soluble CdS/ZnS core-shell quantum dots (QDs) capped with mercaptoacetic acid (MAA). They were characterised by UV–vis absorption spectroscopy, fluorescence spectroscopy, FT-IR and transmission electron microscopy. Such QDs can be used as fluorescent probes for the determination of metal ions because they quench the fluorescence of the QDs. The QDs exhibit absorption and emission bands at 345?nm and 475?nm respectively, which is more longer wavelength compared to MAA-capped CdS QDs and obviously is the result of the larger particle size. The fluorescence intensity of CdS-based QDs is strongly enhanced by coating them with a shell of ZnS. In addition, such functionalised QDs are more sensitive to Hg(II) ions. Parameters such as pH, temperature and concentration of the QDs have been optimised. A high selectivity and sensitivity toward Hg(II) ions is obtained at pH 7.4 and a concentration of 12.0?mg of QDs per L. Under optimum conditions, the fluorescence intensity of CdS/ZnS QDs is linearly proportional to the concentration of Hg(II) in the range from 2.5 to 280?nM, with a detection limit of 2.2?nM. The effect of potentially interfering cations was examined and confirmed the high selectivity of this material.

Near‐Infrared Emission from Tin–Lead (Sn–Pb) Alloyed Perovskite Quantum Dots by Sodium Doping

Phase‐stable CsSn_xPb_1?xI₃ perovskite quantum dots (QDs) hold great promise for optoelectronic applications owing to their strong response in the near‐infrared region. Unfortunately, optimal utilization of their potential is limited by the severe photoluminescence (PL) quenching, leading to extremely low quantum yields (QYs) of approximately 0.3 %. The ultra‐low sodium (Na) doping presented herein is found to be effective in improving PL QYs of these alloyed QDs without alerting their favourable electronic structure. X‐ray photoelectron spectroscopy (XPS) studies suggest the formation of a stronger chemical interaction between I^? and Sn²⁺ ions upon Na doping, which potentially helps to stabilize Sn²⁺ and suppresses the formation of I vacancy defects. The optimized PL QY of the Na‐doped QDs reaches up to around 28 %, almost two orders of magnitude enhancement compared with the pristine one.     

基于Mn掺杂ZnS量子点的室温磷光传感应用的研究进展

与一般有机染料分子相比,半导体材料量子点具有优异的光学性能,在多个领域得到了广泛的应用.量子点具有窄而对称且可调的发射波长、宽激发强吸收、抗光漂白能力强以及水溶性好等诸多优势,引起了研究者广泛关注.为了增加量子点的斯托克斯位移从而很好地避免量子点的自猝灭现象,引入掺杂物是一种很有效的方式.掺杂量子点不仅保留了量子点原有的优点,而且还赋予量子点额外的优异性能.如Mn掺杂ZnS量子点生物相容性好,不含Cd和Hg等有害元素,而且Mn2+的加入使其具有优异的室温磷光特性.磷光检测能很好地避开生物背景荧光的干扰,使得Mn掺杂ZnS量子点能够广泛应用于磷光生物分析.本文综述了Mn掺杂ZnS量子点在室温磷光分析中的研究进展,着重介绍了几种具有启发意义的设计策略,包括其发光机理以及应用于离子、分子以及生物大分子等的检测.     

Electrophoretic properties of BSA-coated quantum dots

Low toxic InP/ZnS quantum dots (QDs), ZnS:Mn²⁺/ZnS nanocrystals and CdSe/ZnS nanoparticles were rendered water-dispersible by different ligand-exchange methods. Eventually, they were coated with bovine serum albumin (BSA) as a model protein. All particles were characterised by isotachophoresis (ITP), laser Doppler velocimetry (LDV) and agarose gel electrophoresis. It was found that the electrophoretic mobility and colloidal stability of ZnS:Mn²⁺/ZnS and CdSe/ZnS nanoparticles, which bore short-chain surface ligands, was primarily governed by charges on the nanoparticles, whereas InP/ZnS nanocrystals were not charged per se. BSA-coated nanoparticles showed lower electrophoretic mobility, which was attributed to their larger size and smaller overall charge. However, these particles were colloidally stable. This stability was probably caused by steric stabilisation of the BSA coating.