共查询到20条相似文献,搜索用时 125 毫秒
1.
塑料粘结炸药(PBX)的机械撞击感度远低于单纯炸药,这因为塑料包覆层改进了炸药晶体表面性质。本工作研究了含有燃烧向爆炸转变(DDT)抑制剂-三苯甲醇(TPC)对于黑索今(RDX)的机械感度影响,发现含TPC的RDX撞击感度低于不含TPC的。塑料粘结剂改进,并降低在撞击时热点产生的概率(P4),而TPC则降低热点传播的概率(P2)。可以预期含有TPC类型化合物的PBX机械感度可能会大幅度地降低。 相似文献
2.
3.
PBX颗粒力学性质对其撞击感度影响的初步研究 总被引:1,自引:0,他引:1
利用自行研制的应力测试系统研究了在机械撞击作用下粉状塑料粘结炸药(PBX)的表现。结果表明,由不同的聚氨酯(PU)溶液处理黑索今(RDX)得到的混和炸药PU-RDX,在机械撞击作用下给出的应力-时间曲线是多样的。而且PU-RDX的机械撞击感度随出现第二个应力峰的时间比(指不同的PU-RDX第二应力峰出现时间和仪器在空打时相应时间比)的增大,有下降的趋势。该时间比在一定程度上代表了粉状PU-RDX的塑性。研究在机械撞击作用下PBX的应力-时间特性有助于理解钝感炸药的机理、改进有关的工艺。 相似文献
4.
5.
粒度对HMX撞击感度的影响 总被引:17,自引:0,他引:17
采用12型工具法对炸药粒度与HMX(Cyclotetramethylenetetranitramine,奥克托今)撞击感度的关系进行了研究,并对撞击起爆机理进行了分析和探讨。结果表明:HMX炸药粒度对撞击感度有显著影响,且随着炸药粒度的增大,其撞击感度呈增大趋势。点火阶段对撞击起爆过程起决定性作用,影响点火阶段的因素就是决定其撞击感度高低的关键因素。晶体内部的活性中心是炸药受撞击时的起爆点,而且大晶粒炸药中更易形成优先点火的活性中心。 相似文献
6.
2~#炸药[重(,,-三硝基乙基-N硝基)乙二胺]是一个零氧平衡的高能炸药。在2~#炸药中混入少量HMX,以氟橡胶粘结,以TATB、石墨和石腊组成的复合钝感剂来钝感,得到了撞击感度和摩擦感度较低的B-01炸药配方。配方组成为2~#炸药/HMX/TATB/氟橡胶/聚苯乙稀/石墨/石腊=70/22/4/2/0.5/0.5/1。 该配方的特点是冲击波感度很高,很容易用2mm直径的柔爆索起爆。其撞击感度与TNT相当(4%),摩擦感度低于14%,爆轰能量相当于PBX-9404,而且容易在低比压下制成不同形状,因此它适用于某些特殊用途的装药。 相似文献
7.
用结构参数预测硝基类炸药的撞击感度 总被引:2,自引:0,他引:2
根据硝基类炸药分子内氢键、分子结构、对称性、氧平衡OB100、活性指数F、拥挤性等分子结构描述符,采用逐步回归法以及支持向量回归对156个硝基炸药的撞击感度进行了建模研究,并利用8个检验样本进行了对比。结果表明,OB100和F均与lgH50呈现负相关,且同一碳原子上化学基团数越多,感度越高;引发键-CH与-OH会引起硝基类炸药H50的降低;炸药中单位质量氢键越多,炸药感度越低;SVR模型对训练样本的建模能力比多元线性回归模型强,对检验样本的预测准确率也比多元线性回归模型高。SVR模型能够相对准确地预测硝基类炸药的撞击感度,在设计/合成钝感高能炸药时可起理论指导作用。 相似文献
8.
9.
10.
炸药撞击感度和热安全性是评价炸药安全性能的重要指标。为了对高温下炸药撞击敏感性变化规律进行可靠预测,本文中通过数值模拟,研究不同预加热温度下带壳PBX炸药装药在小弹丸低速撞击下的热力学响应,得到炸药点火前至点火阶段局部高温区的位置、形态、温度和应变随时间在炸药中分布的变化。结果显示,炸药发生点火的撞击阈值速度与烤燃温度的关系并非单一随温度升高而降低,而是在加热至348.15 K时达到最高;根据温度和应力应变云图分析可得,随着烤燃温度的提高,炸药强度下降,PBX炸药装药局部高温区快速升温的主导因素由局部剪切变为压缩。热软化对炸药的撞击敏感性起重要作用。 相似文献
11.
对《力学》中的物体自由度进行多方面分析,以深化教学、提高学生正
确分析物理问题的能力.使用实际教学分析的研究方法,在《力学》范围内讨论自由度与坐标、
自由与约束的关系并得以下结论:
(1) 同一物体的自由度随其所在的``空间'不同而不同, 不因坐标系的选取不同而
异, 在同类参考系中不因参考系的动静而有别;(2)自由度遵循叠加原理.
讨论了质点系的总自由度及相关计算问题,并指出研究《力学》中自由度的意义. 相似文献
12.
13.
When the state and input matrices of a multivariable linear time-invariant system are perturbed, the problem of the estimation of pole perturbance of closed-loop system is considered by making use of the theory of branching of solutions for nonlinear equations. 相似文献
14.
1.IntroductionThestudyofoscillator}'behaviorofneutraldifferentialequationsisarelativealnewfieldandisveryinterestinginapplications.Inrecentyears.theoscillatorytheoryfortheseequationshasbeenextensivelydeveloped.WerefertotherecentbookbyGyoriandLadaSI'I,Baino… 相似文献
15.
SWT-120风洞稳定段的性能测量 总被引:1,自引:0,他引:1
在普通超音速风洞中,由于受到噪声干扰,很难进行有效的边界层转捩特性试验研究,针对超声速流动特点发展较低噪声风洞十分必要,而稳定段设计的好坏直接影响到下游试验段噪声水平。本文介绍一座低噪声风洞稳定段的结构和性能测量结果。先对稳定段的结构设计做了简单介绍,然后对实验结果进行分析,实验结果表明在大角度扩散段内装置孔锥,稳定段安装消音夹层和阻尼网组等部件后,气流的速度脉动和压力脉动明显降低,其中压力脉动降低一个量级,速度脉动为1%。进一步优化设计和改进工艺,速度脉动还可进一步降低。测量结果表明SWT-120稳定段的设计是成功的,对我们以后发展更高性能的静风洞有借鉴和参考价值。 相似文献
16.
郭兴明 《应用数学和力学(英文版)》1996,17(5):445-450
CHARACTERISTICSOFSUBDIFFERENTIALSOFFUNCTIONS(郭兴明)CHARACTERISTICSOFSUBDIFFERENTIALSOFFUNCTIONS¥GuoXingming(ReceivedJune16,1995... 相似文献
17.
以汉中市综合管廊为工程背景,通过有限元软件,首先模拟分析综合管廊早龄期温度场,随后将温度场结果附加到管廊结构中求解温度应力,从而分析综合管廊早龄期混凝土温度应力与浇筑长度的关系。模拟分析发现:综合管廊在混凝土浇筑早期,温度场沿长度方向变化不显著,且随着浇筑长度的增加,温度场不变;在墙体温度上升阶段,墙体内部沿长度方向的应力主要为压应力,当墙体混凝土内部温度达到最高,混凝土开始降温,结构内变形由膨胀逐渐变为收缩,内力由压应力逐渐变为拉应力,随着时间的变化,墙体内外温差趋于稳定,墙体温度应力也逐渐平稳,此时温度应力主要受外界环境变化影响;当综合管廊浇筑长度在60m范围内,浇筑长度越大,温度应力越大,但当浇筑长度超过60m,温度应力不再增加。 相似文献
18.
唐文亮 《应用数学和力学(英文版)》1983,4(1):117-126
This paper reports a type of laws which governs action poten-tial of nervous impulses,and it is discussed by general form-nonlinear dispersive process.We find that the nervous wave is aslowly varying amplitude solitary wave in the small dispersivecase.we prove that the solitary wave is not generated in the or-dinary dispersion,but a travelling wave with varying amplitudesmay be obtained.The stability of various possible action poten-tials and bifurcation in overdamped case are also discussed inthis paper. 相似文献
19.
Prof. Dr. Sc. A.Ya. Malkin S.A. Bolgov V.P. Begishev V.A. Mansurov 《Rheologica Acta》1992,31(4):345-350
Simultaneous measurements of the components of dynamic modulus at the set of frequencies were made by Fourier-Transform Mechanical Spectroscopy (FTMS) to investigate the curing process of a segmented polyurethane.The whole process of curing is treated as consisting of three stages. In the first stage, the material can flow and this stage is complete at the gel-point. In the second stage, the curing proceeds in the network and ends with phase separation of aggregating segments (blocks) of polymeric chains. In the third stage, the curing continues in the two-phase system. The object of investigation was the transition from the second to the third stage. It was shown that the position of the maximum of loss tangent depends on frequency and does not coincide with different characteristic points marking the time dependencies of G and G. This is due to the formation of micro-particles of the newly formed phase. The FTMS method is used for separation of the modulus changes into parts related to formation of chemical and physical networks.Special means of treating calorimetric measurements identified a weak maximum heat output at the moment corresponding to the transition point. 相似文献
20.
In this paper we use the method of derivative expansion of multiple scales of singularperturbations and we have solve the forced vibration equation of a particle attached to anonlinear spring under the influence of slight viscous damping.The problem is of the fourthorder nonlinearity.Tle four cases discussed are: the soft excitation of non-resonance,thehard excitation of non-resonance,the soft excitation of resonance,the hard excitation ofresonance. 相似文献