基于高双折射Sagnac环的可调环形腔掺铒光纤激光器理论与实验研究

报道了一种利用偏振控制器（PC）和保偏光纤（PMF）组成的高双折射Sagnac干涉环实现选频和调谐的环形腔掺铒光纤激光器.理论模拟了PMF和PC对波长的控制作用.实验中调节PC得到了单波长、双波长和多波长激光；并验证了滤波间隔随PMF长度的变化规律.实验中得到了斜率效率20%，3 dB线宽0.016 nm，30 dB线宽0.097 nm，边模抑制比（SMSR）40 dB左右的稳定激光输出. 关键词： 光纤激光器 Sagnac干涉环 环形腔 掺铒光纤     

基于偏振保持掺Er3+光纤的高稳定性单波长光纤激光器

研制出光敏偏振保持掺Er³⁺光纤，通过在这种光纤上紫外写入三个光纤光栅，形成对抽运激光高转化效率的谐振腔.在输出功率为23.617dBm、工作波长为976nm的激光抽运下，得到均值功率为9.20dBm、均值中心波长为1554.554nm的单波长激光输出.在室温下800min（约13.3h）的测量时间内，其输出功率的波动为±0.05dB，中心工作波长的波动为±0.0015nm. 关键词： 光纤激光器 3+光纤')" href="#">偏振保持掺Er³⁺光纤 光纤Bragg光栅     

基于半导体光放大器的可调谐多波长光纤激光器

报道了一种新型环形腔可调谐多波长光纤激光器，腔内以半导体光放大器为增益介质，利用高双折射光纤构成的高双折射环形镜的滤波特性，在室温下，获得了基本符合ITU-T标准100GHz的17个波长以上的稳定多波长输出.各信道峰值功率差小于6 dB，线宽小于0.102 nm，信噪比大于25 dB.通过调节高双折射环形镜内的偏振控制器状态实现了这一组波长整体在50GHz范围内连续可调谐.并利用实验方法，对该光纤激光器应用于掺铒光纤放大器对多信道放大性能测试的可行性进行了初步探讨.     

Experimental observation of lasering behavior in wavelength-switchable fiber laser with arrayed waveguide grating

A simple and wavelength-switchable fiber laser consisting mainly of an Erbium-doped fiber amplifier (EDFA) which provides the optical gain and an 1 × 40 (1 input channel to 40 output channels) arrayed waveguide grating (AWG) that supports wavelength selection is reported. The lasering behavior in wavelength-switchable fiber laser is investigated experimentally. One can obtain wavelength-switchable single-longitudinal-mode (SLM) single wavelength laser with different wavelength by changing different channel of the AWG as the wavelength selection element. Lasering wavelength hopping in dual wavelength laser operation for low pump power is experimentally observed. The wavelength hopping and the output power of the laser is controlled by using a variable optical attenuator (VOA). The wavelength hopping operation is eliminated for high pump power. One can obtain switchable dual wavelength laser with different wavelength by selecting different two channels of the AWG. The output laser exhibits a good performance having a high sidemode suppression ratio (SMSR), narrow line-width and symmetrical spectrum.     

光纤光栅选频掺Yb3+双包层光纤激光器

利用相位掩模法 ,在D形内包层掺Yb3 双包层光纤一端直接写制出Bragg光栅 ,用作双包层光纤激光器的输出腔镜 .试验得到了线宽为 0 196nm ,波长为 10 5 8 2nm ,最高输出功率为 5 70mW的稳定激光输出 ,解决了激光器中模式竞争造成的输出不稳定现象 .从速率方程出发 ,对激光器的输出功率与抽运功率、光栅反射率的关系以及最佳光纤长度进行了理论分析 ,结果与实验符合很好     

掺钕保偏光纤激光器的研究

对掺钕光纤激光器输出功率沿光纤的分布以及不同光纤长度下抽运功率和输出功率沿光纤的分布进行了数值模拟.以808nm半导体激光器为抽运源，掺钕双包层保偏光纤为增益介质，对保偏光纤激光器进行了探索性的实验研究.分别就光纤不同弯曲形状和弯曲半径对激光器输出功率指标和偏振特性的影响进行了研究，实验中发现在1060nm和1092nm处有两个峰值.在波长1060nm处得到了7.35W的连续偏振激光输出，斜率效率为58.3％. 关键词： 激光技术 光纤激光器 掺钕保偏光纤 偏振     

Switchable dual-wavelength polarization-maintaining erbium-doped fiber laser using an optical circulator as the all-reflecting mirror

A simple and effective switchable dual-wavelength polarization-maintaining erbium-doped fiber laser is proposed and demonstrated. Only using a uniform fiber Bragg grating written directly in a segment of the photosensitive and polarization-maintaining erbium-doped fiber as the wavelength selector and an optical circulator as the all-reflecting mirror, a stable simultaneous dual-wavelength oscillation is achieved with a wavelength spacing of 0.364 nm experimentally by exploiting the polarization hole burning effect at room temperature. The output can be switched between single- and dual-wavelength by adjusting the polarization controller. The 3-dB bandwidth and the side mode suppression ratio of the laser’s outputs are measured to be less than 0.01 nm and more than 50 dB. The power fluctuation and wavelength drift are measured to be less than 0.50 dB and 0.020 nm over an hour.     

An efficient S-band brillouin erbium fiber laser with additional EDFA

A short wavelength band brillouin–erbium fiber laser (S-band BEFL) with enhanced characteristics is demonstrated using an additional erbium-doped fiber amplifier (EDFA) in the sub-loop of the laser system. Compared with the conventional BEFL without the additional EDFA, the enhanced BEFL has improved the number of channels as well as the flatness of the brillouin Stoke's peak power. By incorporating a double-pass EDFA, a stable output laser comb up to 8 channels was obtained at 1503 nm wavelength region with peak power variation for the first three Stokes is reduced from 30.9 to 5.4 dB. The incorporation of additional EDFA also increases the tuning range of the BEFL, which the maximum tuning range of 1.8 nm was obtained with the single-pass scheme. The S-band BEFL has constant spacing of 0.09 nm or 11 GHz, which has a potential application in dense wavelength division multiplexed system.     

Stable single-longitudinal-mode fiber laser using PM FBG F-P etalon and PM fiber saturable absorber

we present a stable and high efficiency single-longitudinal-mode (SLM) fiber ring laser by using polarization-maintaining fiber Bragg grating Fabry-Perot (PM FBG F-P) etalon combining PM fiber saturable absorber. The PM FBG F-P etalon, which is directly fabricated in hydrogen-loaded PM fiber, is used as reflector and mode-selecting component to reduce the longitudinal-mode density greatly. Meanwhile, a segment un-pumped PM Er³⁺-doped fiber (EDF) serves as saturable absorber to suppress mode hopping and ensure the stable SLM operation. Stable SLM laser output at 1550.4 nm with linewidth of 2.0 kHz is observed. Laser output power is 43.7 mW for a pump power of 148 mW, optical-optical efficiency is 29.5% and signal-to-noise ratio (SNR) is larger than 55 dB.     

双端泵浦保偏光纤激光器

 以两台808 nm半导体激光器LD1和LD2为泵浦源,对光纤激光器双端泵浦进行了研究,获得了6.5 W的激光输出。实验分别测出了LD1和LD2半导体激光器单端泵浦和双端泵浦时的输出功率,对双端泵浦输出功率与单端泵浦功率之和进行了比较,利用双端泵浦提高了泵浦效率和输出激光功率。同时测量了输出激光的偏振度,通过计算得到双端泵浦输出激光的偏振度为0.5。