Electric‐field tuning of magnetoelectric properties in Metglas/piezofiber composites

The tunability of magnetoelectric (ME) properties by applied dc electric field (E) was systematically investigated for a laminate composite consisting of Metglas, Pb(Zr_x Ti_1–x)O₃ fiber, and interdigitated electrodes. The ME coefficients and equivalent magnetic noise were found to be dependent on E. This dependence is attributed to variations in the magnetic properties. The dielectric properties and noise charge density were relatively invariant to E. A 1.3× improvement in the ME coefficient was obtained at the Villari point under E = 300 V/mm relative to E = 0 V/mm. (© 2012 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Equivalent magnetic noise in magnetoelectric Metglas/Pb(Mg1/3Nb2/3)O3‐PbTiO3 laminate composites

We have experimentally and theoretically investigated the equivalent magnetic noise in a magnetoelectric Metglas/ 0.7Pb(Mg_1/3Nb_2/3)O₃‐0.3PbTiO₃ laminate sensor unit by considering the constituent noise sources of dielectric loss (N_DE) and DC leakage resistance (N_R). In the low frequency range (f = 1 Hz), theory predicts that N_R dominates the noise charge (1.6 times larger than N_DE), with a 1 Hz noise of 9.1\;{\rm pt}/\sqrt {\rm Hz}. The experimental equivalent magnetic noise was 10.8\;{\rm pt}/\sqrt {\rm Hz}. This observed value is slightly higher than the predicted one, which might be due to an oversimplification of the theoretical model in terms of electrical charge amplifier and external vibration noise sources. (© 2011 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

磁致伸缩/压电层叠复合材料磁电效应分析

采用有限元分析软件COMSOL5.0建立了三维悬臂梁模型,分析了磁致伸缩/压电/磁致伸缩叠层复合材料的磁电系数α_(ME),并就几何参数对复合结构磁电系数的影响进行了优化分析.首先,利用稳态求解器研究了磁电层状复合结构内部的应力、应变、位移以及电势分布情况,利用瞬态求解分析了磁电复合结构各变量动态分布规律;其次,应用小信号频域分析研究了该结构的谐振频率以及在不同偏置磁场对输出电压的影响,结果表明,随着直流偏置磁场的增加,输出电压逐渐减小.改变复合材料不同层的厚度,分析了磁电层与压电层厚度比t_m/t_p对磁电系数的影响,结果表明,随着厚度比增加,α_(ME)逐渐增大,其增加速率逐渐减小;最后,分析了磁电系数α_(ME)随复合结构面积、长宽比的变化情况.分析表明,α_(ME)随磁电复合结构面积的增加逐渐增加,其增加速率逐渐减小;当磁电复合结构面积恒定时,其磁电系数随长宽比L/W增加表现出先增加后减小的趋势,存在最优值.     

High‐temperature ferroelectricity and strong magnetoelectric effects in a hybrid organic–inorganic perovskite framework

A Cu‐based organic–inorganic perovskite framework exhibits high‐temperature ferroelectricity with strong magnetoelectric effects. Both electric field control of magnetization and magnetic field control of polarization are realized. Theoretical calculations suggest that a new mechanism of hybrid improper ferroelectricity arising from the Jahn–Teller distortions of magnetic metal ions and tilting of the organic cations are responsible for the peculiar multiferroic behaviors.

     

Magnetic Field‐Controlled Release of Paclitaxel Drug from Functionalized Magnetoelectric Nanoparticles

Using magnetoelectric nanoparticles (MENs) for targeted drug delivery and on‐demand, field‐controlled release can overcome the control challenges of the conventional delivery approaches. The magnetoelectric effect provides a new way to use an external magnetic field to remotely control the intrinsic electric fields that govern the binding forces between the functionalized surface of the MEN and the drug load. Here, a study is reported in which the composition of the intermediate functionalized layer is tailored to control not only the toxicity of the new nanoparticles but also the threshold magnetic field for the dissociation of the drug from 30‐nm CoFe₂O₄–BaTiO₃ core–shell MENs in a controllably wide field range, from below 10 to over 200 Oe, as required to facilitate superficial, intermediate, and deep‐tissue drug delivery. Paclitaxel is used as a test drug. Specific experiments are described to maintain low toxicity levels and to achieve controllable dissociation of the drug molecules from the MENs' surface at three different subranges—low (<10 Oe), moderate (100 Oe), and high (>200 Oe)—by selecting the following 2‐nm intermediate layers: i) glycerol monooleate (GMO), ii) Tween‐20, and iii) ethyl‐3‐(3‐dimethylaminopropyl)carbodiimide (EDC). Field‐dependent FTIR, absorption spectra, atomic force microscopy, magnetometry analysis, zeta‐potential measurements, and blood circulation experiments are used to study the described functionalization effects.     

Multiferroic behaviour of epitaxial NiFe2O4--BaTiO3 heterostructures

Multiferroic NiFe2O4 （NFO）-BaTiO3 （BTO） bilayered thin films are epitaxially grown on （001） Nb-doped SrTiO3 （STO） substrates by pulsed-laser deposition （PLD）. Different growth sequences of NFO and BTO on the substrate yield two kinds of epitaxial heterostructures with （001）-orientation, i.e. （001）-NFO/（001）-BTO/substrate and （001）- BTO/（001）-NFO/substrate. Microstructure studies from x-ray diffraction （XRD） and electron microscopies show differences between these two heterostructures, which result in different multiferroic behaviours. The heterostructured composite films exhibit good coexistence of both ferroelectric and ferromagnetic properties, in particular, obvious magnetoelectric （ME） effect on coupling response.     

多铁性磁电器件研究进展

多铁性材料可以实现力、电、磁等多物理场之间的相互耦合,在小尺寸、快速响应和低功耗的磁电器件领域具有重要的应用前景.在应用需求的推动下,以具有磁电耦合效应的多铁性材料为基础的磁电器件在设计、微纳加工和性能优化等方面的研究取得了持续的进展.本文简要介绍了基于磁电耦合效应的几种原型器件的最新进展,包括可调谐电感、滤波器、磁电存储器、能量回收器、磁电传感器和磁电天线等,分析总结了各种磁电器件的工作原理及其性能表现,讨论了当前多铁性磁电器件研究所面临的问题和挑战,并提出了改进磁电器件性能的研究方向.     

单相ABO3型多铁材料的磁电耦合及磁电性质研究

实验发现多铁性钙钛矿物质YMnO₃和BiMnO₃在接近磁有序相变温度时,其介电常数和正切损失会出现异常,这些现象说明在物质的磁性和介电性质之间存在耦合.通过对系统磁性和铁电性之间可能磁电耦合方式的分析,考虑在系统哈密顿量中加入与自旋关联和极化相关的耦合项,对铁电子系统应用软模理论,对磁性运用基于海森伯模型的量子平均场近似,研究了外磁场诱导的极化、介电的变化和外电场诱导的磁化的变化等,并将以上结果与实验进行了比较和分析,较为合理地解释了一些多铁钙钛矿物质中的磁电现 关键词： 多铁 磁电耦合 铁电 铁磁