The structures of sulphur on Pd(111) studied by X-ray standing wavefield absorption and surface EXAFS

The surface structures of R30°-S and R19.1°-S on Pd(111) have been investigated by normal incidence X-ray standing wave (NIXSW) absorption and surface extended X-ray absorption fine structure (SEXAFS). NIXSW measurements show that the most likely site of S adsorption in the R30° phase is the threefold “fcc” hollow. The location of the S atoms at the “fcc” hollow site is consistent with S adsorption on the neighbouring fcc (111) transition metal surfaces. SEXAFS analysis revealed a S–Pd nearest neighbour bond distance of 2.28±0.04 Å. The results for the R19.1° phase suggest that the structure involves a mixed S–Pd overlayer, with the S–Pd vertical layer spacing equal to the Pd bulk 111 spacing.     

The local structure of SO2 and SO3 on Ni(1 1 1)

The normal incidence X-ray standing wave (NIXSW) technique, supported by X-ray photoelectron spectroscopy and near-edge X-ray absorption fine structure (NEXAFS), has been used to determine the local adsorption geometry of SO₂ and SO₃ on Ni(1 1 1). Chemical-state specific NIXSW data for coadsorbed SO₃ and S, formed by the disproportionation of adsorbed SO₂ after heating from 140 K to 270 K, were obtained using S 1s photoemission detection. For adsorbed SO₂ at 140 K the new results confirm those of an earlier study [Jackson et al., Surf. Sci. 389 (1997) 223] that the molecule is located above hollow sites with its molecular plane parallel to the surface and the S and O atoms in off-atop sites; corrections to account for the non-dipole effects in the interpretation of the NIXSW monitored by S 1s and O 1s photoemission, not included in the earlier work, remove the need for any significant adsorption-induced distortion of the SO₂ in this structure. SO₃, not previously investigated, is found to occupy an off-bridge site with the C_3v axis slightly tilted relative to the surface normal and with one O atom in an off-atop site and the other two O atoms roughly between bridge and hollow sites. The O atoms are approximately 0.87 Å closer to the surface than the S atom. This general bonding orientation for SO₃ is similar to that found on Cu(1 1 1) and Cu(1 0 0) both experimentally and theoretically, although the detailed adsorption sites differ.     

Dynamic surface behaviour of VPO catalysts under reactive and non-reactive gas compositions: an in situ XAS study

The surface of an activated vanadium phosphorus oxide (VPO) catalyst was investigated by means of in situ X-ray absorption spectroscopy in the total electron yield mode. We observed significant changes of the V L₃-near edge X-ray absorption fine structure (NEXAFS) when the material was transferred from room temperature to working conditions at 400 °C in the reaction atmosphere. We studied the same VPO material under different gas compositions comprising the reaction mixture of n-butane and oxygen, pure oxygen and vacuum to elucidate the influence of the gas–surface interaction and the effect of the temperature. The results of this extensive study indicate a dynamic response of the catalyst surface to the applied conditions.     

The local structure of SO2 and SO3 on Ni(1 1 1): A scanned-energy mode photoelectron diffraction study

O 1s and S 2p scanned-energy mode photoelectron diffraction (PhD) data, combined with multiple-scattering simulations, have been used to determine the local adsorption geometry of the SO₂ and SO₃ species on a Ni(1 1 1) surface. For SO₂, the application of reasonable constraints on the molecular conformation used in the simulations leads to the conclusion that the molecule is centred over hollow sites on the surface, with the molecular plane essentially parallel to the surface, and with both S and O atoms offset from atop sites by almost the same distance of 0.65 Å. For SO₃, the results are consistent with earlier work which concluded that surface bonding is through the O atoms, with the S atom higher above the surface and the molecular symmetry axis almost perpendicular to the surface. Based on the O 1s PhD data alone, three local adsorption geometries are comparably acceptable, but only one of these is consistent with the results of an earlier normal-incidence X-ray standing wave (NIXSW) study. This optimised structural model differs somewhat from that originally proposed in the NIXSW investigation.     

Adsorption of 5-halouracils on Au(111)

The immobilization of 5-halouracils on Au(111) has been studied by soft X-ray photoelectron spectroscopy (XPS) and near-edge X-ray absorption fine structure (NEXAFS) spectroscopy. Multilayer and monolayer films of 5-chlorouracil were deposited on the Au(111) surface by evaporation in vacuum while films of 5-bromouracil were absorbed in two modes: from the gas phase under ultrahigh vacuum conditions and from solution. The photoemission spectra of C, N and O 1s, Br 3d and Cl 2p as well as the absorption spectra at the N and O K-edges were measured for monolayers of 5-halouracil films and the nature of the bonding with the Au(111) surface has been determined. From the angular dependence of the NEXAFS spectra at the O and K-edges, we conclude that these 5-halouracils are lying nearly parallel to the Au(111) surface. Distinct chemical states and surface adsorption geometry of the 5-BrU molecules for monolayer coverage prepared in two different ways have been found.     

Theoretical studies on the near edge X-ray absorption fine structure spectra of a hexanethiolate monolayer on Ag(1 0 0)

A theoretical study on the S K-edge near edge X-ray absorption fine structure (NEXAFS) of a hexanethiolate monolayer on Ag(1 0 0) has been performed by employing the multiple-scattering cluster (MSC) method. The unoccupied molecular orbitals of the system, which are closely correlated with resonances of the NEXAFS spectra, have been calculated by using the discrete variational (DV)-Xα method. The physical origins of the resonances are elucidated by these theoretical studies. It has been shown that the leading peak at 2470.3 eV is not a π*(S–C), but a resonance corresponding to the transition of 1s electrons into a hybrid orbital of the S(3p) atomic orbital of a hexanethiolate molecule and Ag atomic orbitals. The interaction between the adsorbate and the substrate induces other two weak resonances at 2475.2 and 2478.2 eV in the NEXAFS. The adsorption structure of a hexanethiolate monolayer on Ag(1 0 0) deduced from the theoretical analysis on the NEXAFS is in agreement with that from the SEXAFS of the system.     

Na/Si(111)3×1表面的NEXAFS研究

利用同步辐射光源测量Na2s二次电子部分产额谱得到Na诱导Si（111）3×1结构的近边Ｘ射线吸收精细结构（NEXAFS）谱，并用原子集团多重散射方法对几种可能的模型进行计算，与实验结果比较，认为Na/Si（111）3×1吸附结构与Mnch模型相一致．Na原子吸附在Si的顶位，Na—Si键长为0.3nm． 关键词：     

The adsorption and stability of sulfur containing amino acids on Cu{5 3 1}

The adsorption of l-cysteine and l-methionine amino acids on a chiral Cu{5 3 1} surface was investigated with high resolution X-ray photoelectron spectroscopy (XPS) and carbon K-edge near edge X-ray absorption fine structure (NEXAFS) Spectroscopy using synchrotron radiation. XPS shows that at 300 K l-cysteine adsorbs through two oxygen, a nitrogen and a sulfur atom, in a four point ‘quadrangular footprint’, whereas l-methionine adsorbs through only two oxygen and a nitrogen atom in a ‘triangular footprint’. NEXAFS was used to clarify the adsorption geometry of both molecules, which suggests a binding orientation to the top layer and second layer atoms in two different orientations associated with adsorption sites on {1 1 0} and {3 1 1} microfacets of the Cu{5 3 1} surface.     

Theoretical study on adsorption of thiophenethiolate molecule on Au(1 1 1) surface

We have theoretically studied the adsorption of a thiophenethiolate (C₄H₃S-S) molecule on the Au(1 1 1) surface by first-principles calculations. It is found that the bridge site is the most stable adsorption site with the adsorption energy of 1.02 eV. In the optimized adsorption geometry, the bond between the head S atom and the connected C atom in the tail thiophene molecule is tilted by 57.2° from the surface normal. In addition, the adsorption of thiophenethiolate induces large relaxations of the surface Au atoms around it. Furthermore, weak interactions between the S atom in the tail thiophene ring and the Au atoms also contribute to the adsorption on the Au surface.     

NEXAFS study of HCOO/Ag(110): Evidence for dynamic bending

The structure of the surface formate on Ag(110) at 300 K was studied by near-edge X-ray absorption fine structure (NEXAFS) at the carbon K-edge. Interpretation of the NEXAFS spectra of the formate intermediate with a localized bond picture is inconsistent with the findings of previous vibrational studies. Rather, the resonances must be assigned to transitions to delocalized molecular orbitals, whereupon the results agree with the bidentate configuration deduced from the vibrational experiments. A bonding geometry is determined with respect to the surface normal in which the O-O direction lies parallel to the plane of the surface; no azimuthal ordering was detected. The molecular plane appears to be inclined at an angle of 30 ± 15°. This apparent tilt may be due to a dynamical motion of the species about the surface normal in which the molecular plane oscillates and rotates about the surface normal. These results indicate different bonding geometries for formate on Ag(110) and Cu(110).