Single-receiver geoacoustic inversion using modal reversal

This paper introduces a single-receiver geoacoustic-inversion method based on dispersion analysis and adapted to low-frequency impulsive sources in shallow-water environments. In this context, most existing methods take advantage of the modal dispersion curves in the time-frequency domain. Inversion is usually performed by matching estimated dispersion curves with simulated replicas. The method proposed here is different. It considers the received modes in the frequency domain. The modes are transformed using an operator called modal reversal, which is parameterized using environmental parameters. When modal reversal is applied using parameters that match the real environment, dispersion is compensated for in all of the modes. In this case, the reversed modes are in phase and add up constructively, which is not the case when modal reversal is ill-parameterized. To use this phenomenon, a criterion that adds up the reversed modes has been defined. The geoacoustic inversion is finally performed by maximizing this criterion. The proposed method is benchmarked against simulated data, and it is applied to experimental data recorded during the Shallow Water 2006 experiment.     

Particle filtering for dispersion curve tracking in ocean acoustics

A particle filtering method is developed for dispersion curve extraction from spectrograms of broadband acoustic signals propagating in underwater media. The goal is to obtain accurate representation of modal dispersion which can be employed for source localization and geoacoustic inversion. Results are presented from the application of the method to synthetic data, demonstrating the potential of the approach for accurate estimation of waveguide dispersion characteristics. The method outperforms simple time-frequency analysis providing estimates that are very close to numerically calculated dispersion curves. The method also provides uncertainty information on modal arrival time estimates, typically unavailable when traditional methods are used.     

Geoacoustic inversion in a dispersive waveguide using warping operators

This paper presents a single receiver geoacoustic inversion method adapted for low-frequency impulsive sources. It is applied to light bulb data collected during the Shallow Water 2006 experiment. The inversion is carried out by extracting dispersion curves from the received signal, and comparing them to simulated replicas. To achieve dispersion curve estimation in the time-frequency domain, modal separability is improved using a signal processing method called warping. The inversion scheme allows for a reliable estimation of the New Jersey Shelf sediment properties (compressional sound speed and density). It also provides an accurate estimation of the source/receiver range.     

地声参数及传播损失不确定性估计与建模

地声参数的不确定性对水声传播具有重要的影响。通过贝叶斯理论建立水声环境不确定性推理模型,理论推导了地声参数的似然函数以及地声参数和传播损失的后验概率密度,并采用MCMC(Markov Chain Monte Carlo)进行了仿真计算,给出了地声参数的二维后验联合概率密度和一维边缘概率密度,在此基础上对传播损失的不确定性进行了估计,得到了传播损失80%的可信区间。仿真和实验结果表明,该方法适用于地声参数反演和不确定性估计,并能获取因地声参数不确定性导致的传播损失不确定性估计。     

一种基于简正波模态消频散变换的声源距离深度估计方法

针对浅海环境中传播的低频宽带水声脉冲信号,基于简正波水平波数差和波导不变量之间的关系,本文提出了一种利用距离-频散参数二维平面聚焦测距与匹配模态能量定深的目标声源定位方法.首先,通过将由频散参数和波导不变量表示的前几阶模态相速度与由环境模型计算的相速度进行对比分析,从而估计出前几阶模态的频散参数和环境的波导不变量.其次,利用估计出的频散参数值和波导不变量对接收信号进行消频散变换处理,只有当接收信号的距离参数等于目标声源距离时,各号简正波的幅度均达到最大值,在距离-频散参数二维平面上,出现声压聚焦的现象,利用此现象可以估计目标声源的距离.不仅如此,消频散变换后的接收信号,前几阶模态在时域上明显地分离开来,可以准确地估计出前几阶模态的能量,采用多模态能量匹配的方式,可以估计出目标声源的深度.最后,通过对仿真和冬季获得的气枪信号数据处理结果验证了本文方法的有效性.     

Geoacoustic inversion based on reflection model of effective density fluid approximation

In order to obtain the physical and geoacoustic properties of marine sediments,an inverse method using reflection loss of different grazing angles is presented.The reflection loss is calculated according to the reflection model of effective density fluid approximation.A two-step hybrid optimization algorithm combining differential evolution and particle swarm optimization along with Bayesian inversion is employed in estimation of porosity,mean grain size,mass density and bulk modulus of grains.Based on the above physical parameters,geoacoustic parameters,including sound speed and attenuation,are further calculated.According to the numerical simulations,we can draw a conclusion that all the parameters can be well estimated with the exception of bulk modulus of grains.In particular,this indirect inverse method for bottom geoacoustic parameters performs high accuracy and strong robustness.The relative errors are 0.092%and 17%,respectively.Finally,measured reflection loss data of sandy sediments at the bottom of a water tank is analyzed,and the estimation value,uncertainty and correlation of each parameter are presented.The availability of this inverse method is verified through comparison between inverse results and part of measured parameters.     

利用多角度海底反向散射信号进行地声参数估计

针对现有海底地声参数估计方法的不足,提出了利用相控参量阵浅地层剖面仪接收的多角度海底反向散射信号进行地声参数估计的方法,首先利用正下方和斜入射方向上沉积层上、下表面的差频反向散射信号进行沉积层厚度和声速估计,然后利用正下方沉积层上、下表面两个不同频率的差频信号的反向散射信号估计沉积层衰减系数,最后利用正下方沉积层上表面原频反向散射信号估计沉积层阻抗,计算沉积层密度从而解决和声速的耦合性,通过水池试验验证了该方法的有效性。     

The impact of water column variability on horizontal wave number estimation and mode based geoacoustic inversion results

The influence of water column variability on low-frequency, shallow water geoacoustic inversion results is considered. The data are estimates of modal eigenvalues obtained from measurements of a point source acoustic field using a horizontal aperture array in the water column. The inversion algorithm is based on perturbations to a background waveguide model with seabed properties consistent with the measured eigenvalues. Water column properties in the background model are assumed to be known, as would be obtained from conductivity, temperature, and depth measurements. The scope of this work in addressing the impact of water column variability on inversion is twofold. Range-dependent propagation effects as they pertain to eigenvalue estimation are first considered. It is shown that mode coupling is important even for weak internal waves and can enhance modal eigenvalue estimates. Second, the effect of the choice of background sound speed profile in the water column is considered for its impact on the estimated bottom acoustic properties. It is shown that a range-averaged sound velocity profile yields the best geoacoustic parameter estimates.     

基于等效密度流体近似反射模型反演海底参数

为了获取海底沉积物的物理和地声特性,根据等效密度流体近似反射模型得到的不同掠射角下的海底反射损失,利用差分进化算法和粒子群算法相结合的两级混合优化算法以及Bayesian反演方法对海底沉积物的孔隙度、平均颗粒粒度、颗粒质量密度以及颗粒体积弹性模量进行反演,再根据这4个物理参数的估计值进一步计算出海底地声参数,包括声速和衰减。通过反演结果与仿真真值的比较可以看出,除颗粒体积弹性模量外,得到的估计结果是令人满意的,特别是这种间接反演海底地声参数的方法对地声参数的估计具有较高的精确性和较强的稳健性,相对误差分别为0.092%和17%。最后,对实验室水池池底沙质沉积物的反射损失数据进行处理,给出了沙质沉积物各参数的估计值、不确定性和相关性,并通过反演结果与部分实测参数值的比较验证了反演方法的可行性。      

Passive geoacoustic inversion with a single hydrophone using broadband ship noise

An inversion scheme is proposed, relying upon the inversion of the noise of a moving ship measured on a single distant hydrophone. The spectrogram of the measurements exhibits striations which depend on waveguide parameters. The periodic behavior of striations versus range are used to estimate the differences of radial wavenumber between couples of propagative modes at a given frequency. These wavenumber differences are stacked for several frequencies to form the relative dispersion curves. Such relative dispersion curves can be synthesized using a propagation model feeded with a bottom geoacoustic model. Inversion is performed by looking for the bottom properties that optimize the fit between measured and predicted relative dispersion curves. The inversion scheme is tested on simulated data. The conclusions are twofold: (1) a minimum 6 dB signal to noise ratio is required to obtained an unbiased estimate of compressional sound speed in the bottom with a 3 m s(-1) standard deviation; however, even with low signal to noise ratio, the estimation error remains bounded and (2) in the case of a multi-layer bottom, the scheme produces a single depth-average compressional sound speed. The inversion scheme is applied on experimental data. The results are fully consistent with a core sample measured around the receiving hydrophone.