共查询到19条相似文献,搜索用时 265 毫秒
1.
2.
作为一种有可能作为永久信息存储的材料,合成出一种新的双偶氮材料(BA1)。当样品被波长为532nm的光激发时,几乎大部分BA1分子从反-反态转化到顺-顺态,产生了光致双折射。因此,研究了BA1分子掺杂的PMMA薄膜的光致双折射和透过信号与入射光强度的关系。实验结果表明:透过信号强度随着泵浦光的增强而增强。通过偏振态互相平行(SS)和垂直(SP)的两束偏振光用来研究偏振全息存储,结果表明SP光栅形成的衍射信号要比SS光栅的衍射信号强很多。 相似文献
3.
介绍了在近代物理实验中开设偶氮染料甲基橙掺杂PVA薄膜的光致双折射特性实验.实验结果表明样品的光致双折射反应程度和激发光功率成正比例关系;在激发光功率一定的情况下,当激发光偏振方向与探测光偏振方向夹角为45°时样品的光致双折射反应程度达到最大. 相似文献
4.
5.
6.
7.
利用偏振全息记录的方法在一种含偶氮侧链的液晶聚合物薄膜中写入了二维偏振光栅.实验采用两束正交偏振的532 nm线偏光作为写入光,在样品同一点上分别记录了相互垂直的两个一维偏振光栅,继而对所构成的二维偏振光栅的特性进行了研究.实验结果表明:二维光栅的衍射效率比一维光栅低,其偏振特性是两个一维光栅元特性的叠加;二维光栅衍射效率对入射光偏振态的依赖性和光栅的偏振转换性质来源于材料中线双折射和圆双折射的共同作用.
关键词:
偏振全息
二维光栅
偶氮液晶聚合物 相似文献
8.
9.
不同基体刚性偶氮化合物光致光学各向异性及其唯象模拟 总被引:1,自引:0,他引:1
在不同刚性的聚合物基体聚甲基丙烯酸甲酯(PMMA)、聚乙烯咔唑(PVK)和聚苯乙烯(PS)薄膜基体中掺入相同质量分数(均为0.003)的分散红13(DRl3)偶氮染料。以线偏振连续Ar^+激光(514nm)作为控制光,连续He-Ne激光(632.8nm)作为信号光考察了具有相同厚度的三种样品在相同控制光功率(15mW)下的光致双折射效应。实验发现刚性较大的聚乙烯咔唑基体样品的双折射效应最小,刚性最小的聚苯乙烯基体样品的双折射效应最大。在偶氮生色团光致异构的四能级模型基础上,建立一新的唯象的模型。在模型中引入描述聚合物基体刚性的参量s,通过数值计算描述了不同基体刚性参量s对偶氮生色团光致异构取向的影响。计算结果表明,基体的刚性越大,样品的光致双折射效应越小,定性地解释了实验现象。 相似文献
10.
将偶氮化合物乙基橙样品置于一对正交的偏振片之间,用一束激发光照射该样品,分别测量 在激发光的不同强度和不同偏振方向下探测光的透射功率,研究样品的双折射特性.实验表 明,透射光的饱和值和稳定值与激发光强成正比,且与激发光偏振方向有关,探测光与激发 光振动方向的夹角(θ)为45°时,其值最大;若θ不太小(>10°),sin22θ 与透射光的饱和值、稳定值成线性关系.同时,利用巴俾涅补偿器对样品的双折射率差进 行了测量,分别得到了绿光激发前后的准确数值为1.11×10-3和3.57×10 -3.
关键词:
偶氮
双折射
测量 相似文献
11.
12.
Fuli Zhao Jun Wu Zhihua Pan Changshun Wang Jinwen Zhang Yi Zeng Xuemin Lu 《Optics Communications》2012,285(21-22):4180-4183
Photoinduced anisotropy and polarization holographic recording were investigated in an azobenzene-containing ionic self-assembly complex. The complex film was found to possess large photoinduced dichroism (D~0.36) and photoinduced birefringence (Δn~10?2). A noteworthy observation was that the photoinduced birefringence did not show any decay, but strongly increased after switching off the pump light at room temperature. The diffracted signals of the polarization holographic gratings, written by two orthogonally linear and circular polarized beams respectively, exhibited similar inverse relaxation behavior as the photoinduced birefringence after switching off the writing lights. A discussion about the mechanism accounting for the abnormal relaxation process of photoinduced birefringence is presented. 相似文献
13.
All optical switching in azo-polymer planar waveguide 总被引:1,自引:0,他引:1
In this paper all optical switching in planar methyl red doped poly (methyl methacrylate) (MR/PMMA) waveguide and the effects of different parameters on this process are presented. Switching was achieved by a 488 nm Ar ion laser (pump beam) on a 633 nm He-Ne laser (probe beam) when passed through the waveguide. The effect of temperature and pump intensity, polarization and chopping frequency on switching is investigated. The switching process is attributed to trans-cis-trans photoisomerization of azo dyes in the polymer host. By studying the absorption spectrum of the sample, it is shown that both pump and probe laser beams are effective on the switching process. 相似文献
14.
The nonlinear refraction and photoinduced birefringence of chlorophosphonazo I (CPA I ) doped PVA thin films were investigated. The single-beam Z-scan measurement showed that CPA I doped PVA thin film possessed a large value of nonlinear refractive index (n2=1.82×10−12 cm2/W) under a pulse 532 nm excitation, and the mechanism accounting for the process of nonlinear refraction was discussed in term of resonant electronic effect. Moreover, fast and stable molecular reorientation was observed when investigating the photoinduced birefringence of CPA I doped PVA thin film with a CW 532 nm laser as pump light and a CW 650 nm laser as probe light. 相似文献
15.
Bassam Abbas Yousef T. Salman Moustafa S. El-Daher 《Journal of Macromolecular Science: Physics》2015,54(12):1457-1465
Photoinduced birefringence in poly(methyl methacrylate) (PMMA), polymeric thin films doped with di-azo Sudan G was investigated. A pump-probe method was used to study the dynamic behavior of the birefringence. The mechanism for the inducement of birefringence is discussed in terms of the photoisomerization of the di-azo Sudan G molecules. The results showed that the dynamic evolution of the photoinduced birefringence was such that the average birefringence increased, saturated, and then decreased with respect to the laser pump intensity. Also, an exponential-like relationship was observed between both the saturation and the isotropic states of the averaged transmitted probe beam (expressing the residual anisotropy) and the birefringence on one hand, and the intensity amplitudes of the pumping powers on the other hand. 相似文献
16.
Mueller matrix measurements were used to characterize the polarization properties of liquid crystal-based reflective type twisted nematic (TN) special light modulator (SLM) at oblique incidence of the laser beam. The experimentally obtained Mueller matrices were used to obtain the combination of polarization optics required to optimize it for phase only modulation. The results indicate that minimum intensity modulation is obtained with the use of a polarizer followed by a quarter wave plate (QWP) in polarization state generator (PSG) arm and a QWP followed by an analyzer in polarization state analyzer arm (PSA). Polarization parameters such as retardance, rotation and depolarization were calculated from the experimentally obtained Mueller matrices using polar decomposition method at different angle of incidences of the laser beam and the results has been discussed. The similarity between retardance and depolarization curve as a function of address voltage of TNSLM indicated that depolarization is mainly associated with errors in retardance values. Further, spectral Mueller matrix measurements were used to obtain intensity modulation response in the range of wavelengths 450-700 nm for broadband applications. 相似文献
17.
18.
Yanhua Luo Zengchang Li Ru Chen Qijin Zhang Gangding Peng Gang Zou Bing Zhu 《Optics Communications》2009,282(12):2348-2353
Based on the photoinduced birefringence in azo materials, the model of the birefringent long period fiber gratings (BLPFGs) has been proposed and the transmission of such birefringent fiber gratings was further simulated by the coupled mode theory. In order to obtain the optimum condition for making birefringent azopolymer optical fiber (APOF) gratings the photoinduced birefringence of azo dye and methyl methacrylate (MMA) copolymers was systematically studied. After photosensitivity study of azo samples, using Teflon technique, azo dye containing single mode polymer optical fiber (POF) was fabricated. Finally, BLPFGs can be fabricated in azopolymer fiber using polarized 532 nm laser. A 120 μm LPFG with a 50% duty cycle has been successfully written within the core of the fiber with 532 nm laser by an amplitude mask method. Under polarized microphotography, the grating was observed when the optical axis was set at 45° with the direction of the first polarizing lens of the polarization microscope. 相似文献
19.
Polarization holographic recording was investigated in a liquid-crystalline azobenzene side-chain polymer. A highly stable
polarization holographic grating with the diffraction efficiency of 12.6% was written in the polymer film by two orthogonally
linearly polarized 532 nm beams with equal intensities of 150 mW/cm2. The polarization grating was studied with a 633 nm probe beam by surveying the conversion of the polarization state of the
probe beam and measuring the dependence of diffraction efficiency on the polarization direction of the probe beam. It was
found that the ± first-order diffraction efficiency and the polarization of the diffracted wave depended strongly on the polarization
of the readout wave. The unusual diffraction properties of the recorded grating were attributed to the presence of the circular
photoinduced birefringence.
PACS 42.40.Ht; 42.40.Lx; 78.20.Fm 相似文献