High temperature transport and thermoelectric properties of Ca3−xErxCo4O9+δ

Ca_3−xEr_xCo₄O_9+δ (x=0, 0.05, 0.15, 0.3 and 0.5) samples were prepared using a sol-gel method followed by hot-pressing sintering technique. Powder X-ray diffraction analysis showed the single-phases of Ca_3−xEr_xCo₄O_9+δ were obtained up to x=0.3 and the crystallinity of the samples decreased with increasing Er-doping amount. The high-temperature (323-1073 K) thermoelectric properties of the samples were investigated. The substitution of Er³⁺ for Ca²⁺ resulted in the decrease of electrical conductivity, thermal conductivity and the increase of Seebeck coefficient for all the samples except the x=0.05 one. The dimensionless figure of merit ZT reached 0.28 at 1073 K for Ca_2.7Er_0.3Co₄O_9+δ, indicating the thermoelectric properties of CaCo₄O_9+δ can be enhanced by doping Er in the system.     

Thermoelectric properties of Ca3−xYxCo4O9+δ ceramics

The Ca_3?xY_xCo₄O_9+δ (x=0, 0.15, 0.3) ceramics were prepared by combining the polyacrylamide gel method and the spark plasma sinter (SPS) technology in order to improve the thermoelectric properties of Ca₃Co₄O_9+δ ceramics. The Seebeck coefficients and the resistivities of the Y-doped samples were obviously enhanced due to the decrease of carrier concentration, and their thermal conductivities were decreased due to the impurity scattering effect. The thermoelectric properties were improved at high temperature by Y-doping according to the power factor analysis and the thermoelectric figure of merit (ZT) data. The optimized figure of merit ZT=0.22 at 973 K was obtained for Ca_2.7Y_0.3Co₄O_9+δ.     

The effect of Mn substitution on thermoelectric properties of Ca3MnxCo4−xO9 at low temperatures

The effects of partial substitution of Mn for Co on the thermoelectric properties of Ca₃Mn_xCo_4−xO₉ (x=0, 0.03, 0.9), prepared by sol-gel process, were investigated at the temperatures from 380 K down to 5 K. The results indicate that the substitution of Mn for Co results in increase in thermopower at temperatures >∼80 K, and substantial (23-31% at 300 K) decrease in lattice thermal conductivity in the whole temperature range investigated. The temperature behavior of ZT suggests that Ca₃Mn_xCo_4−xO₉ with light Mn substitution would be a promising candidate for high-temperature thermoelectric applications.     

Superconductivity in CoSr2(Y1−xCax)Cu2O7+δ

The roles of aliovalent Ca^II-for-Y^III substitution and high-pressure-oxygen annealing in the process of ‘superconducterizing’ the Co-based layered copper oxide, CoSr₂(Y_1−xCa_x)Cu₂O_7+δ (Co-1212), were investigated. The as-air-synthesized samples up to x=0.4 were found essentially oxygen stoichiometric (−0.03≤δ≤0.00). These samples, however, were not superconducting, suggesting that the holes created by the divalent-for-trivalent cation substitution are trapped on Co in the charge reservoir. Ultra-high-pressure heat treatment carried out at 5 GPa and 500 °C for 30 min in the presence of Ag₂O₂ as an excess oxygen source induced bulk superconductivity in these samples. The highest T_c was obtained for the high-oxygen-pressure treated x=0.3 sample at ∼40 K.     

Photoluminescence in MgxSr1−xAl2O4:Eu, Ndand electron-vibrational interaction in the Eu 5d states

Green phosphor compositions Mg_xSr_1−xAl₂O₄:Eu, Nd (with x=0.05-0.25) were prepared by solid state reaction method. The effect of Mg substitution on photoluminescence characteristics was investigated. The photoluminescence show intense green emission for MgSrAl₂O₄:Eu²⁺, Nd³⁺ with long persistence. This green emission corresponds to transitions from 4f⁶5d¹ to 4f⁷ of Eu²⁺ ion. Comparative analysis of the excitation and emission spectra were used to evaluate the crystal field splitting of the 5d states of Eu²⁺ and the parameters of electron-vibrational interaction, such as Huang-Rhys factor, effective phonon energy, and zero-phonon line position.     

Power factors of late rare earth-doped Ca3Co2O6 oxides

Polycrystalline samples of (Ca_1−xR_x)₃Co₂O₆ with R = Gd, Tb, Dy and Ho at x=0-0.1 were synthesized and the effects of rare earth substitution on their thermoelectric properties were investigated. In the high-temperature region, the rare earth substitution resulted in an increase in the Seebeck coefficients (S), and the S values increased with decreasing ionic radius of rare earth elements in the order Gd³⁺>Tb³⁺>Dy³⁺>Ho³⁺. In contrast, the influence of rare earth substitution on the electrical resistivity was small. The high-temperature power factor was thereby improved by the late rare earth substitutions, particularly those with Ho³⁺ for Ca²⁺. For the Ho-doped samples (x≤0.05), the power factor was significantly improved by increasing Ho concentration.     

Synthesis and photoluminescence characteristics of (Sr, Ca)3B2O6:Eu for application in white light-emitting diodes

A series of yellow-green (Sr, Ca)₃B₂O₆:Eu phosphors have been synthesized using precursors prepared via a facile sol-gel route. The solid-solution phases crystallized to materials with the formula of Sr_3−x−yCa_xEu_yB₂O₆ with varied Ca²⁺ and Eu²⁺ contents. The emission peak centered at 540 nm under near-UV excitation exhibited a broad-band distribution in the range of 450-650 nm. The dependences of the luminescence intensity on the contents of Ca²⁺ substitution and Eu²⁺ dopant were also investigated. The composition in the host lattice sensitively affected the chromaticity index. Sr_1.21Ca_1.7Eu_0.09B₂O₆ (SCB:0.09Eu) was shown to possess the highest intensity and broadest emission band. Calcining temperature was shown to greatly influence the luminescent properties of SCB:0.09Eu. It is concluded that SCB:0.09Eu can be used as an efficient yellow-green phosphor for white light-emitting diodes (white LEDs) applications.     

Thermal, electrical, and electrochemical properties of Lanthanum-doped Ba0.5Sr0.5 Co0.8Fe0.2O3-δ

Crystal structure, thermogravimetry (TG), thermal expansion coefficient (TEC), electrical conductivity and AC impedance of (Ba_0.5Sr_0.5)_1-xLa_xCo_0.8Fe_0.2O_3-δ (BSLCF; 0.05?x?0.20) were studied in relation to their potential use as intermediate temperature solid oxide fuel cell (IT-SOFC) cathode. A single cubic pervoskite was observed by X-ray diffraction (XRD). The TEC of BSLCF was increasing slightly with the increasing content of La, and all the compounds showed abnormal expansion at high temperature. Proved by the TG result, it was associated with the loss of lattice oxygen. The electrical conductivity, which is the main defect of Ba_0.5Sr_0.5 Co_0.8Fe_0.2O_3-δ (BSCF), was improved by La doping, e.g., the compound of x=0.20 demonstrated a conductivity of σ=376 S cm⁻¹ at 392 °C. The increase of electrical conductivity resulted from the increased concentration of charge carrier induced by La doping. In addition, the AC impedance revealed the better electrochemical performance of BSLCF. For example, at 500 °C, the sample with composition x=0.15 yielded the resistance values of 2.12 Ω cm², which was only 46% of BSCF.     

The effect of Fe substitution on the electrical and thermal conductivity and thermopower of Ca3(FexCo1−x)4O9 synthesised by a sol–gel process

The effect of Fe substitution for Co on direct current (DC) electrical and thermal conductivity and thermopower of Ca₃(Co_1−xFe_x)₄O₉ (x = 0, 0.05, 0.08), prepared by a sol–gel process, was investigated in the temperature range from 380 down to 5K. The results indicate that the substitution of Fe for Co results in an increase in thermopower and DC electrical resistivity and substantial (14.9–20.4% at 300K) decrease in lattice thermal conductivity. Experiments also indicated that the temperature dependence of electrical resistivity ρ for heavily substituted compounds Ca₃(Co_1−xFe_x)₄O₉ (x = 0.08) obeyed the relation lnρ ∝ T^−1/3 at low temperatures, T < ~55K, in agreement with Mott’s two-dimensional (2D) variable range hopping model. The enhancement of thermopower and electrical resistivity was mainly ascribed to a decrease in hole carrier concentration caused by Fe substitution, while the decrease of thermal conductivity can be explained as phonon scattering caused by the impurity. The thermoelectric performance of Ca₃Co₄O₉ was not improved in the temperature range investigated by Fe substitution largely due to great increase in electrical resistivity after Fe substitution.     

Lu-induced spin entropy enhancement in Ca3Co4O9+δ system

The magnetothermopower have been studied in Lu-doped Ca_3?xLu_xCo₄O_9+δ. A strong magnetic field suppression of thermopower indicates large spin entropy contribution. The magnetothermopower for doped samples are overall enhanced compared with that for undoped Ca₃Co₄O_9+δ, providing an experimental evidence for the enhancement of spin entropy. Magnetic results confirm that Co⁴⁺ concentration is reduced by Lu doping. We suggest that the reduction in Co⁴⁺ concentration results in the enhanced spin entropy.