Characteristics of a hybridly mode-locked cw dye laser

We present experimental and theoretical results on the characteristics and random variations of subpicosecond pulses generated by a synchronously pumped cw dye laser with saturable absorber. The analysis of the power spectra indicates rapid fluctuations of the pulse duration of 40–50%, energy fluctuations of 3%, and a jitter of the repetition time of 0.1% corresponding to an absolute jitter of 12 ps. The latter is caused mainly by the temporal jitter of the pump laser. A mismatch of the lengths of the dye and the pump-laser cavity can result in a nonstationary mode-locking regime with a periodic change of the pulse parameters. The interpretation of the experimental results are supported by computer simulations of the pulse evolution process.     

Dual picosecond dye lasers synchronously pumped by a mode locked cw yag laser

The performance of a novel dual dye laser system synchronously pumped by the frequency doubled output of a mode-locked CW-YAG laser is evaluated in relation to pulsewidth, pulse substructure, pulse spectral width and timing jitter. The behavior of the system is adequately described by a theoretical model which includes the time dependent gain and losses due to frequency bandwidth, cavity length mismatch and output coupler. The jitter is significantly reduced from that obtained with CW gas laser pumping as a result of the shorter pump pulse (50 ns instead of ≈100 ps). A routine operating condition uses 2-plate birefringen filters, 0.8 W pump power at 532 nm, to yield two 2.0 ps pulses having a cross correlation width of 3.8 ps, and 30 mW average power from each laser.     

Characterization of the noise in continuously operating mode-locked lasers

An experimental and theoretical investigation of the fluctuations of the pulses from continuous-wave mode-locked lasers is presented. It is shown that these fluctuations can be detected and quantitatively characterized from measurements of the power spectrum of the light intensity. Such power spectra can be measured with great accuracy by shining the laser output on a suitable photodetector and by processing the detector signal with the use of an electronic spectrum analyzer. Different types of noise such as fluctuations of the pulse energy, pulse repetition time, and pulse duration, can be readily recognized from their characteristic spectral signature. Experimental results of noise measurements are presented for a synchronously mode-locked dye laser pumped by an acousto-optically mode-locked argon ion laser, and also for a colliding pulse passively mode-locked dye laser.     

Pulse properties of a synchronously mode-locked,cavity dumped,picosecond dye laser system

A synchronously mode-locked, cavity-dumped picosecond dye laser is described. The structure and intensity of the picosecond pulses measured under different conditions are reported. It was found that the structure of the pulses from the synchronously pumped dye laser depends critically on the length of the Ar⁺ laser pulses. At the shortest Ar⁺ laser pulses of about 70 ps the dye pulses are as short as 1.1 ps. With Ar⁺ laser pulses of 200 ps the dye laser pulses contains a broad satellite pulse which contains a large fraction of the total intensity. When a cavity dumper is added to the system one gets dye laser pulses 15–20 ps long with a substructure, which indicates incomplete mode-locking. Well mode-locked 1.5–2.0 ps pulses were obtained in the red part of the dye laser action spectrum, i.e. 620–650 nm for R6G, 595–608 nm for R 110 and 657–662 nm for RB, respectively. Addition of mode-locking dyes also improved the pulse quality at some wavelengths.     

On noise and fluctuations in a synchronously mode-locked cw laser system

A single-shot and synchronously-scanned streak camera, autocorrelation and noise spectrum analysing techniques are utilized to study the output characteristics of synchronously mode-locked cw lasers. Four main conclusions are drawn: (i) the pulse train from a synchronously-pumped dye laser reveals, besides phase jitter, considerable pulse shape fluctuations; (ii) autocorrelation measurements may be highly misleading when actual pulse shapes are considered; (iii) both the phase jitter and pulse shape fluctuations of the dye laser output are caused by the phase fluctuations of the pumping ion laser pulse train; (iv) the phase jitter of the ion laser proceeds from the fluctuations in the cavity roundtrip time with a characteristic time of about 5 s. Under optimum conditions the rms noise of the dye laser output was 2% and the phase jitter with respect to the rf sine drive of the acousto-optical mode-locker, 30 ps. A qualitative explanation fo the noise properties is given.     

Travelling-wave amplified spontaneous emission excited in a prismatic geometry

A new experimental realisation of the travelling-wave amplified spontaneous emission (TWASE) is described utilising a prismatic arrangement to get the pulse front delay in the pump beam. Rhodamine dye solutions were pumped by the amplified 25 ps long 555 nm pulses of a distributed feedback dye laser. The pulse shortening in the TWASE resulted in 12 ps output pulses with 18% energy efficiency. The observed spectrum showed numerous lines, and it contained the amplified Raman line of the pump beam. Several spots were found in the far-field zone of the generated TWASE.     

A high-power subpicosecond distributed feedback dye laser system pumped by a mode-locked Nd: YAG laser

The design and operation characteristics of a distributed feedback dye laser (DFDL) system pumped by the second harmonic of a flashlamp pumped mode-locked Nd: YAG laser are described. The DFDL oscillator facilitates a large tuning range with nearly Fourier limited pulse durations of about 1.6 ps. The combined action of saturated absorption and amplification results in a pulse shortening to about 600 fs, with small fluctuations in the pulse duration. Output pulse energies of more than 400 J are achieved, corresponding to a peak power of more than 650 MW. Since the dye amplifiers are pumped by pulses of only 25 ps duration the amplified spontaneous emission (ASE) is very low, typically less than 10^–4.     

Generation of tunable subnanosecond laser pulses with a nitrogen laser pumped dye laser amplifier system

A simple method for generating single tunable subnanosecond dye laser pulses is described. A Rhodamin 6G dye laser is transversely pumped by a subnanosecond UV pulse of a TEA nitrogen laser. The narrowband output of the dye laser is amplified and shortened in a synchronously pumped amplifier. Narrowband pulses with a duration of 30–40 ps (fwhm) and a pulse power of 30 kW are obtained. They are tunable over the range of 580–600 nm.     

同步泵浦PML飞秒激光研究

采用CW锁模YAG倍频激光器同步泵浦PML飞秒染料激光器,产生了平均脉宽约55fs、功率为15mW的光脉冲。文章在理论和实验上还研究了同步泵浦飞秒激光脉冲产生技术。     

New single-pulse generation technique for distributed feedback dye lasers

The distributed feedback dye laser (DFDL) generates a train of picosecond pulses when pumped well above threshold. This DFDL emission can be quenched by injecting a laser pulse into DFDL. By proper timing of the quencher laser pulse, only the first DFDL pulse is generated while the successive pulses are suppressed. Operational characteristics and practical design considerations of such a quenched DFDL are given. With 2.5 ns long pump pulses from a N₂ laser, a shortest DFDL pulse of 17 ps was obtained at 380 nm.     

300 Femtosecond pulses at 497 nanometer generated by an excimer laser pumped cascade of distributed feedback dye lasers

The setup is a cascade of 3 lasers: A competing cavity dye laser pumped by a XeCl excimer laser, followed by two distributed feedback dye lasers. The typical durations of the pulses from the lasers are 100 ps, 5 ps, and 300 fs, respectively. The output pulses at 497 nm are amplified up to 500 MW. The shortest pulse duration obtained was 198 fs.     

Transient behaviour of pulsed dye lasers

Some aspects of the transient behaviour of pulsed dye lasers are investigated both theoretically and experimentally. Relaxation oscillations induced in the output from a dye cell by an external reflector have been observed and explained, using a rate equation approximation to the physical situation in the dye cell. These oscillations are shown to play an important part in the generation of short laser pulses from long cavity dye lasers. Finally, it is proposed that 10 ps pulses can be obtained from conventional dye lasers pumped by 100 ps pulses from a high-pressure nitrogen laser.     

Synchronized picosecond pulse generation with a synchronously pumped dye laser and a compressed Nd: YAG laser for non-degenerate transient grating experiments

We have set up a laser system which simultaneously provides synchronized picosecond pulses in the visible and at a wavelength of 1.06 m with a repetition rate of 76 MHz. The set-up consists of a dye laser synchronously pumped by the second harmonic of a cw mode-locked Nd:YAG laser and a fiber-grating compressor for the fundamental wavelength of the Nd;YAG laser. Crosscorrelation measurments reveal the time jitter between the two pulse trains to be less than 10 ps. As a first application we have performed non-degenerate transient grating experiments in semiconductors. The non-degenerate technique allows to use excitation energies well above the bandgap energy and to separate non-linear refractive index effects from photoinduced absorption or transmission changes.     

High power subpicosecond pulse generation from a synchronously pumped dye laser combined with an external compressor

A new scheme of subpicosecond pulse generation based on a dye laser is described. Output pulses of 15 ps from a rhodamine-6G laser pumped synchronously by a frequency-double mode-locked Nd: YAG laser are compressed into 0.8 ps pulses of 2 MW by two passes of saturable absorber (DODCI) and saturable amplifier (rhodamine-6G). The technique is useful for generating widely tunable, high power repetitive subpicosecond pulses.     

Picosecond and subpicosecon pulse generation in synchronously pumped mode-locked cw dye lasers

Generation of tunable near-infrared picosecond and subpicosecond pulses in a synchronously pumped cw mode-locked Oxazine-1-perchlorate dye laser has been investigated for different values of the important system parameters. The experimental results confirm the predictions of a simple theoretical model which describes the steady-state pulse duration in terms of gain modulation strength, pump power, intracavity bandwidth, pump pulse length and cavity detuning. For a pump-pulse length of 100 ps and a bandwidth of more than 500 Å for the intracavity tuning element dye-laser pulses as short as 0.35 ps have been obtained. Under these conditions up to 100 mW of average output power were provided. In addition, mode-locking of an Oxazine 750 dye laser by synchronous pumping with the cw train of pulses obtained from the Oxazine-1-Perchlorate laser is reported.     

Simple picosecond dye laser system pumped by a frequency doubled,optically compressed Q-switched mode-locked Nd:YAG laser

Using the frequency doubled output of the 3 ps pulses from a temporally compressed cw Q-switched and mode-locked Nd:YAG laser, a simple synchronously pumped dye laser was constructed to give frequency tunable operation with short pulses in the 5–10 ps range and peak powers of ～ 15 kW. A circularly scanning streak camera operating in stroboscopic mode was also used to examine pulse formation in the dye laser.     

Mode-locking of cw dye laser using externally modulated pumping laser

A new mode-locking method of tunable dye laser is described. This simple and practical method requires only an external intensity modulator to the pumping source. After the simple analytical considerations, the experimental work was done using an Ar laser pumped Rhodamin 6G dye laser and an acousto-optic modulator. As results, stable continuous trains of mode-locked pulses were obtained throughout in the ordinary lasing range 570–630 nm. The pulse width, estimated to be 30–50 ps by SHG autocorrelation measurements, is limited by the bandwidth of Lyot filter used. It is also shown experimentally that this method can be applicable for the suppression of the growth of double pulses in passive mode-locking with saturable absorber (DODCI).     

啁啾脉冲堆积用于光脉冲整形

报道了一种利用100 ps啁啾脉冲堆积产生2．2 ns任意整形脉冲的脉冲整形系统。采用掺Yb~(3 )光纤锁模振荡器得到稳定的锁模光脉冲序列,将该锁模脉冲通过啁啾光纤光栅展宽并通过1 nm带宽的高斯形光谱滤波器滤波,得到标准的100 ps高斯形啁啾脉冲序列,将此脉冲选单经过光纤延迟线组成的32路脉冲堆积器,得到了精度为32 bit的重复频率为1 Hz的2．2 ns任意整形光脉冲。研究了堆积脉冲的特性,分析了宽带啁啾堆积整形脉冲的光谱时间扫描特性对激光驱动惯性约束聚变打靶束匀滑的优化作用。实验测得了该系统输出的2．2 ns整形光脉冲具有小于50 ps的上升沿,与100 ps啁啾脉冲的时间抖动小于4 ps。     

Generation of nearly transform-limited pulses in subnanosecond region with TEA nitrogen-laser-pumped dye laser

A dye laser is transversely pumped by a TEA nitrogen laser with 700 ps duration. The dye laser pulse has a spectral linewidth of 0.007 nm and a pulse width of ≈ 140 ps, giving a time-bandwidth product of 1.5. It is pointed out that the fluorescence lifetime of the laser dye plays an important role in generation of laser emission using a long laser cavity under subnanosecond pulse pumping.     

非等强度,等脉冲相关技术测量甲酚紫染料的吸收恢复时间

利用非等强度、等脉冲相关技术测量甲酚紫染料吸收恢复时间。实验结果给出了甲酚紫染料吸收恢复时间为158ps。