Surface dynamics of Mo(1 1 0)–H and Mo(1 1 0)–Li

We compare the surface dynamics of the adsorbate systems Mo(1 1 0)–H and Mo(1 1 0)–Li. In both cases electron energy loss spectroscopy measurements revealed strong substrate surface phonon anomalies. Whereas the phonon anomaly of the hydrogen-covered surface was unequivocally assigned to be of the Kohn type, the anomalous behavior of the surface phonons of the lithium-covered surface remained obscure. In this paper we develop an experimental criterion based on the dispersion of adsorbate phonons, which allows to decide whether the observed substrate surface phonon anomaly is of the Kohn type or not. Employing this criterion we now definitely rule out that the anomaly on Mo(1 1 0)–Li is due to the Kohn effect.     

The Fe3O4 origin of the “Biphase” reconstruction on α-Fe2O3(0 0 0 1)

The so-called Biphase termination on α-Fe₂O₃ has been widely accepted to be a structure with a 40 Å unit supercell composed of coexisting islands of Fe_1−xO and α-Fe₂O₃. Based on thermodynamic arguments and experimental evidence, including transmission electron diffraction, imaging, magnetic and spectroscopic information, it is found that the previously proposed structure model is inaccurate. The actual Biphase structure is instead a layered structure related to the reduction of α-Fe₂O₃ to Fe₃O₄. A model for the Biphase termination is proposed which does not contain islands of Fe_1−xO but instead consists of bulk α-Fe₂O₃ and a Fe₃O₄-derived overlayer. The proposed model is consistent with all current and previously reported experimental findings.     

Growth of epitaxial thin Pd(1 1 1) films on Pt(1 1 1) and oxygen-terminated FeO(1 1 1) surfaces

Thin Pd films (1-10 monolayers, ML) were deposited at 35 K on a Pt(1 1 1) single crystal and on an oxygen-terminated FeO(1 1 1) monolayer supported on Pt(1 1 1). Low energy electron diffraction, Auger electron spectroscopy, and Kr and CO temperature programmed desorption techniques were used to investigate the annealing induced changes in the film surface morphology. For growth on Pt(1 1 1), the films order upon annealing to 500 K and form epitaxial Pd(1 1 1). Further annealing above 900 K results in Pd diffusion into the Pt(1 1 1) bulk and Pt-Pd alloy formation. Chemisorption of CO shows that even the first ordered monolayer of Pd on Pt(1 1 1) has adsorption properties identical to bulk Pd(1 1 1). Similar experiments conducted on FeO(1 1 1) indicate that 500 K annealing of a 10 ML thick Pd deposit also yields ordered Pd(1 1 1). In contrast, annealing of 1 and 3 ML thick Pd films did not result in formation of continuous Pd(1 1 1). We speculate that for these thinner films Pd diffuses underneath the FeO(1 1 1).     

Anharmonicity in Al vicinal surfaces of (1 0 0) with (1 1 1) step

Molecular dynamics simulations incorporating an analytic embedded atom potential have been used to investigate the atomic structure and surface order of the Al vicinal surfaces for the temperature up to 900 K. The relaxation, mean square vibrational amplitude, and structure factor as a function of temperature, and of the terrace width for the p(1 0 0) × (1 1 1) surfaces (2 ≤ p ≤ 10) are discussed. The obtained structure factor indicates that the anharmonic effect reduces with increasing terrace widths. The decrease of surface energy with increasing terrace width also supports this conclusion.     

High resolution analysis of the rotational levels of the (0 0 0), (0 1 0), (1 0 0), (0 0 1), (0 2 0), (1 1 0) and (0 1 1) vibrational states of SO2

A high resolution (0.0018 cm⁻¹) Fourier transform instrument has been used to record the spectrum of an enriched ³⁴S (95.3%) sample of sulfur dioxide. A thorough analysis of the ν₂, 2ν₂ − ν₂, ν₁, ν₁ + ν₂ − ν₂, ν₃, ν₂ + ν₃ − ν₂, ν₁ + ν₂ and ν₂ + ν₃ bands has been carried out leading to a large set of assigned lines. From these lines ground state combination differences were obtained and fit together with the existing microwave, millimeter, and terahertz rotational lines. An improved set of ground state rotational constants were obtained. Next, the upper state rotational levels were fit. For the (0 1 0), (1 1 0) and (0 1 1) states, a simple Watson-type Hamiltonian sufficed. However, it was necessary to include explicitly interacting terms in the Hamiltonian matrix in order to fit the rotational levels of the (0 2 0), (1 0 0) and (1 0 1) states to within their experimental accuracy. More explicitly, it was necessary to use a ΔK = 2 term to model the Fermi interaction between the (0 2 0) and (1 0 0) levels and a ΔK = 3 term to model the Coriolis interaction between the (1 0 0) and (0 0 1) levels. Precise Hamiltonian constants were derived for the (0 0 0), (0 1 0), (1 0 0), (0 0 1), (0 2 0), (1 1 0) and (0 1 1) vibrational states.     

Adsorption of water on TiN (1 0 0), (1 1 0) and (1 1 1) surfaces: A first-principles study

We use first-principles density functional theory-based calculations in the analysis of the interaction of H₂O with (1 0 0), (1 1 0) and (1 1 1) surfaces of TiN, and develop understanding in terms of surface energies, polarity of the surface and chemistry of the cation, through comparison with H₂O adsorption on ZrN. While water molecule physisorbs preferentially at Ti site of (1 0 0) and (1 1 1) surfaces, it adsorbs dissociatively on (1 1 0) surface of TiN with binding stronger than almost 1.32 eV/molecule. Our analysis reveals the following general trends: (a) surfaces with higher energies typically lead to stronger adsorption, (b) dissociative adsorption of H₂O necessarily occurs on a charge neutral high energy surface and (c) lower symmetry of the (1 1 0) plane results in many configurations of comparable stability, as opposed to the higher symmetry (1 0 0) and (1 1 1) surfaces, which also consistently explain the results of H₂O adsorption on MgO available in literature. Finally, weaker adsorption of H₂O on TiN than on ZrN can be rationalized in terms of greater chemical stability of Ti arising from its ability to be in mixed valence.     

Density functional theory investigation of CN on Cu(1 1 1), Ni(1 1 1) and Ni(1 0 0)

The adsorption of CN on Cu(1 1 1), Ni(1 1 1) and Ni(1 0 0) has been investigated using density functional theory (DFT). While experimental studies of CN on Cu(1 1 1) show the molecular axis to be essentially parallel to the surface, the normally-preferred DFT approach using the generalised gradient approximation (GGA) yields a lowest energy configuration with the C-N axis perpendicular to the surface, although calculations using the local density approximation (LDA) do indicate that the experimental geometry is energetically favoured. The same conclusions are found for CN on Ni(1 1 1); on both surfaces bonding through the N atom is always unfavourable, in contrast to some earlier published results of ab initio calculations for Ni(1 1 1)/CN and Ni(1 0 0)/CN. The different predictions of the GGA and LDA approaches may lie in subtly different relative energies of the CN 5σ and 1π orbitals, a situation somewhat similar to that for CO adsorbed on Pt(1 1 1) which has proved challenging for DFT calculations. On Ni(1 0 0) GGA calculations favour a lying-down species in a hollow site in a geometry rather similar to that found experimentally and in GGA calculations for CN on Ni(1 1 0).     

Fourfold in-plane magnetic anisotropy in epitaxial Fe(1 1 0)/Cu(0 0 1) and Fe(1 1 0)/Ni(0 0 1) bilayers

Epitaxial Fe(1 1 0) films with thicknesses of 100-800 nm on Cu(0 0 1) and Ni(0 0 1) buffer layers grown on MgO(0 0 1) substrates have been fabricated. These films contain Fe(1 1 0) crystallites which are in the Pitsch orientation relationship. Magnetization and the fourfold in-plane magnetic anisotropy constants of these films have been determined by torque measurements. All the samples under study are characterized by a fourfold magnetic anisotropy with easy axes parallel to the [1 0 0] and [0 1 0] directions of Cu(0 0 1) and Ni(0 0 1) layers. The measured values of the constant for Fe(1 1 0)/Cu(0 0 1) are found to depend on deposition temperature; a maximum value of (2.5±0.1)×10⁵ erg/cm³ is reached after annealing at 600 °С. The in-plane torque measurements on Fe(1 1 0)/Ni(0 0 1) bilayers obtained at 300 °С, on the other hand, exhibit a constant value of (2.7±0.1)×10⁵ erg/cm³. Assuming an exchange interaction between the Fe(1 1 0) crystallites, which are in the Pitsch orientation relationship, the fourfold in-plane magnetic anisotropy has been calculated as 2.8×10⁵ erg/cm³. The deviations of the experimental values from the predicted one may be explained by the formation of a polycrystalline phase within the Fe(1 1 0) layer and a partial disorientation of the epitaxial crystallites.     

Inclusive (p, π) reactions at 201 and 180 MeV

Inclusive proton-induced charged pion production was studied on ¹²C, ⁸⁹Y and ^natPb at 201 and 180 MeV. A QQD spectrometer was used for forward angles and a plastic scintillator range spectrometer for backward angles. The angular dependence, variation with the pion energy, and total cross sections are deduced from doubly differential cross section measurements.