Nanosecond optical parametric oscillator based on large-aperture periodically poled RbTiOAsO(4)

We report on optical parametric oscillators (OPO's) based on periodically poled RbTiOAsO(4) (PP RTA), which are pumped by Q -switched solid-state lasers. With a diode-pumped Nd:YVO(4) laser (pulse energy, 800microJ ; pulse duration, 5.5 ns; repetition rate, 1 kHz) the PP RTA OPO generated 1.58-microm signal and 3.26-microm idler radiation with a signal pulse energy of 45microJ . The large aperture of 3 mmx3 mm of the PP RTA crystal also permitted OPO operation with pump pulse energies as high as 65 mJ, provided by a flash-lamp-pumped Q -switched Nd:YAG laser (pulse duration, 20 ns; repetition rate, 10 Hz). With this pump source the OPO generated signal pulse energies as high as 17 mJ, corresponding to an efficiency of 26%. The performance of this OPO shows that large-aperture PP RTA crystals are well suited for pulsed nanosecond OPO operation with pump pulse energies of tens of millijoules.     

High-power picosecond LiB3O5 optical parametric oscillators tunable in the blue spectral range

The paper reports on an experimental investigation and numerical analysis of noncritically and critically phasematched LiB₃O₅ (LBO) optical parametric oscillators (OPOs) synchronously pumped by the third harmonic of a cw diode-pumped mode-locked Nd:YVO₄ oscillator–amplifier system. The laser system generates 9.0 W of 355-nm mode-locked radiation with a pulse duration of 7.5 ps and a repetition rate of 84 MHz. The LBO OPO, synchronously pumped by the 355-nm pulses, generates a signal wave tunable in the blue spectral range 457–479 nm. With a power of up to 5.0 W at 462 nm and 1.7 W at 1535 nm the conversion efficiency is 74%. The OPO is characterized experimentally by measuring the output power (and its dependence on the pump power, the transmission of the output coupler and the resonator length) and the pulse properties (such as pulse duration and spectral width). Also the beam quality of the resonant and nonresonant waves is investigated. The measured results are compared with the predictions of a numerical analysis for Gaussian laser and OPO beams. In addition to the blue-signal output visible-red 629-nm radiation is generated by sum-frequency mixing of the 1.535-μm infrared idler wave with the residual 1.064-μm laser radiation. A power of 1.25 W of 1.535-μm idler radiation and 5.7 W of 1.064-μm laser light generated a red 629-nm output power of 2.25 W. Received: 2 February 2000 / Revised version: 28 July 2000 / Published online: 22 November 2000     

Mid-infrared ZGP OPO pumped by near-degenerate narrowband type-I PPKTP parametric oscillator

The total pulse energy of the signal and idler in a near-degenerate type-I periodically poled KTiOPO₄ (PPKTP) optical parametrical oscillator (OPO) was spectrally confined within a 2 nm spectral bandwidth at 2.13 μm. This was achieved by using a volume Bragg grating as the output coupler. Both the signal and the idler from the PPKTP OPO were then simultaneously used to pump a mid-infrared ZnGeP₂ (ZGP) OPO. The 2 nm bandwidth was narrower than the ZGP crystal acceptance bandwidth and, thus, made efficient conversion in the second OPO possible. A total slope efficiency of 10% from 1.06 μm to the 3.5–5 μm region was demonstrated, generating 250 μJ in the mid-IR with only 3.6 mJ of 1.06 μm pump energy. This corresponds to a Nd:YAG pump to mid-IR conversion efficiency of 7%. PACS 42.65.Yj; 42.72.Ai; 42.40.Eq     

All-solid-state cw mode-locked picosecond KTiOAsO4 (KTA) optical parametric oscillator

4 (KTA) optical parametric oscillator (OPO) synchronously pumped by a cw diode-pumped mode-locked Nd:YVO₄ oscillator–amplifier system. The laser system (pumped by 84 W of cw 808-nm diode radiation) generates 7-ps-long pulses at 1.064 μm with a repetition rate of 83.4 MHz and an average power of 29 W. The OPO, synchronously pumped by the 1.064-μm laser pulses, consists of a 15-mm-long KTA crystal (cut for type II noncritical phase-matching) in a folded signal resonant linear resonator. The average powers of the 1.54-μm signal radiation and the 3.47-μm idler radiation are 14.6 W and 6.4 W, respectively. The total OPO output of 21 W corresponds to an internal efficiency of 75%. The experimental investigations include measurements of the OPO output power (and its dependence on the pump power, the transmission of the output coupler, and the resonator length) and of the pulse properties (such as pulse duration and spectral width). The measured results are in good agreement with the predictions of a numerical analysis based on a split-step Fourier method. Received: 4 May 1998     

High-efficiency mid-infrared laser from synchronous optical parametric oscillation and amplification based on a single MgO:PPLN crystal

This paper presents a specially designed optical parametric oscillator (OPO) which achieved high-efficiency mid-infrared laser of 2.83 μm. The cascaded nonlinear interactions of OPO and optical parametric amplifier (OPA) were simultaneously realized in a single MgO:PPLN crystal. The signal oscillation of 1.70 μm was used to pump a secondary parametric process that resulted in amplification of the idler laser of 2.83 μm. When the MgO:PPLN crystal with a grating period of 31.2 μm was pumped by a 1.064 μm laser and operated at 148°C, the quasi-phase-matching of both OPO and OPA could be simultaneously achieved. Average output power of 7.68 W at 2.83 μm was obtained for 25 W of pump at 7 kHz. The power conversion efficiency of 2.83 μm laser was 30.7%, which was evidently higher than common OPOs.     

8.30 μm singly resonant ZnGeP2 optical parametric oscillators pumped by a Tm,Ho:GdVO4 laser

A single resonator 8.30 μm ZnGeP₂ (ZGP) optical parametric oscillators (OPO) was reported in the paper. The OPO was pumped by a 10.2-W Tm,Ho:GdVO₄ laser at 8 kHz in a Q-switch mode, a 170-mW idler was obtained at 8.30 μm, and the output power of the idler and signal wave was 1.0 W, corresponding to an optical-optical conversion efficiency of 10.3% and a slope efficiency of 20.9%. Tm,Ho:GdVO₄ laser was pumped by a 30-W fiber-coupled laser diode (LD) at the center wavelength of 801 nm. The output wavelength of Tm,Ho:GdVO₄ laser was at 2.05 μm, and the energy per pulse of 1.28 mJ in 18 ns was achieved at 8 kHz with the peak power of 71.1 kW.     

High-power mid-infrared tunable optical parametric oscillator based on 3-mm-thick PPMgCLN

The experimental results of a high-power tunable mid-IR laser are presented. The optical parametric oscillator (OPO) with a 3-mm-thick PPMgCLN crystal was pumped by a 1.064 μm pulse laser. When the pump power of the 1.064 μm laser was 151 W at 10 kHz, and the operating temperature of the PPMgCLN with 5% MgO doping was 100°C, average output power of 23.7 W at 3.91 μm was obtained with a slope efficiency of 18.2% for the idler resonant OPO. The variation of the 3.91 μm output power was about ±4% in 10 min continuous operation. The beam quality factor M ² was less than 2.6. The average output power of 27.4 W at 3.91 μm was also obtained with 151 W pump power and the slope efficiency of 20.9% for the signal resonant OPO by changing the coating parameters of the OPO cavity mirrors. The mid-IR wavelength tunability of 3.7–4.0 μm can be achieved by adjusting the temperature of a 29 μm period PPMgCLN crystal from 200 to 30°C.     

Bismuth triborate (BiB3O6) optical parametric oscillators

We report the phase matching of parametric frequency conversion in the nonlinear material BiB₃O₆ (BiBO) and on an investigation of optical parametric oscillators (OPOs) of this new crystal. Based on the calculation of collinear type I and type II phase matching within the refractive-index planes, the most favorable directions for phase matching are identified for OPOs pumped by the fundamental or the harmonics of 1064-nm Nd-doped lasers. Based on these results, pulsed 532-nm-pumped ns OPOs are realized. The pump source is either a Q-switched high repetition rate (10 kHz) Nd:YVO₄ laser (with a pulse energy of 24 J) or a low repetition rate (10 Hz), high pulse energy (120 mJ) Nd:YAG laser system. The BiBO OPO pumped by the Nd:YVO₄ laser showed a very low threshold of 0.047 J/cm². At an average pump power of 2.4 W the total OPO output power was 630 mW. By changing the phase-matching angle within the yz plane from 0 to 11.6° the signal wavelength was tuned from 735 nm to 970 nm, while the spectral width changed from 0.2 nm to 1.4 nm. By pumping the OPO with the Nd:YAG laser, the OPO had a threshold of 0.12 J/cm², a steep slope (59%) and a high total efficiency (of up to 48%). Due to divergence broadening the spectral width changes from 8.5 nm at 800 nm to 70 nm near degeneracy. The properties of BiBO determined from the experimental results are compared with those of well-known nonlinear materials such as BBO, LBO and KTP. PACS 42.65.-k; 42.65.Yj; 42.70.-a; 42.70.Mp     

高亮度人眼安全KTP OPO激光器

采用多模NdYAG激光器泵浦非临界相位匹配的KTP-OPO,获得了光束角2.3 mrad、输出能量400 mJ、平均功率12 W、光-光转换效率40%的1 572 nm激光.泵浦源的参数为能量1 J、重复频率30 Hz.分析认为采用KTP OPO将NdYAG激光器的1 μm激光转换到人眼安全波段的方法是获得1.5 μm激光的最有效的手段之一;非临界相位匹配的KTP OPO的主要优点是大的接受角和无走离,因此即使多纵模激光泵浦情况下也可以获得很高的转换效率.     

High-Power,high-repetition-rate operation of a period-continuously-tunable optical parametric oscillator at 3.78–4.62 μm based on a fan-out periodically poled MgO-doped lithium niobate

We present a period-continuously-tunable optical parametric oscillator based on a fan-out MgO:PPLN with a grating period range from 26.9 to 29.5 μm. The OPO was pumped by a Q-switched Nd:YAG laser with a repetition of 10 kHz. With a grating period of 29.3 μm and 22.0 W pump power, the idler output power at 3.78 μm arrived at 3.40 W. With a period of 27.1 μm and 13.5 W pump, the idler output at 4.58 μm arrived at 0.36 W. This is, to our best knowledge, the highest average power for pulsed OPO operating near 4.5 μm based on PPLN or MgO:PPLN. By translating the fan-out MgO:PPLN, the idler wavelength was tuned continuously from 3.78 to 4.62 μm.