超声吸收体物理参数对红外热成像测量高强度聚焦超声声场的影响

超声吸收体的物理参数对利用水听器和红外热成像技术的高强度聚焦超声(High-Intensity Focused Ultrasound,HIFU)声场测量结果具有重要影响。为了探索超声吸收体的物理参数(密度、声速、衰减系数、热扩散系数、定压比热容)对测量结果的影响规律,本文根据层状模型计算出相同声源功率输出时不同物理参数对应的超声吸收体内部声场和热场,利用有限差分法计算出超声吸收体表面在辐照过程中的温度变化;利用基于水听器和红外热成像技术的聚焦声场测量方法测量出焦域内不同位置上声场特征值(轴线声强和-6 dB声束宽度),与通过理论计算得到的声源在纯水中声场特征值进行比较,分析了不同物理参数对测量结果的影响。超声吸收体的声、热学参数中除了声速外,其它物理参数的变化引起声场特征值的测量造成最大相对差异率小于15%。因为声波传播速度的改变会导致超声吸收体内部热场分布变化,使测量结果与理论计算值有较大偏差,其中-6 dB声束宽度和轴线声强最大相对差异率为95.37%和69.97%。因此在选择超声吸收体的声、热学参数时应重点关注声波在吸收体内声速的影响。超声吸收体的声学参数与水的声学参数相近时,可以在焦域内获得较好的测量结果。      

Thermo-acoustic performance of full engine encapsulations – A numerical,experimental and psychoacoustic study

This paper presents the development and investigation of a thermo-acoustic encapsulation for a diesel engine by means of a combined approach of thermo-acoustic recordings, numerical simulations and psychoacoustic evaluation. The encapsulation is positioned in close proximity to the engine and completely surrounds the entire engine block. Experimental tests are performed with the help of an acoustic engine test bench, where the surface of the engine is observed by infrared cameras and the sound is monitored by a microphone-array. Thermal and acoustic measurements of the engine without an encapsulation are recorded and used as reference data for simulations to evaluate and improve the functionality of different design concepts of the encapsulation in comparison to the same engine without encapsulation. The received experimental results are also used to select proper materials as well as to design the heat insulating and sound absorbing encapsulation. Based on the experimental investigations, some weak points of the first prototype are identified. These experimental findings, as well as numerical simulations of the sound radiation, are used as a basis for further design improvements to the encapsulation. The new design that is developed shows a significant improvement in the insulation of the car engine, both thermally and acoustically. In the last step, the perception of the engine sounds are evaluated by measuring changes in the perceived loudness and sound preference of the engine with and without encapsulation by human participants. This allows for a more objective evaluation of the acoustic behavior of the developed engine encapsulation.     

Subjective evaluations of sound radiated by impacted plates, using the design of experiments method

This study combines physical and subjective approaches to evaluate the sound quality of impacted plates. A numerical model, based on the Hertz law of contact, has been used to determine the sound pressure level at any point in space resulting from an impact. Sounds synthesized using this model and those from experiments can then be exploited in a physical analysis and/or a subjective analysis of the effects associated with variations in parameters. Here the influence of certain physical parameters on the sound perception of impacted plates is evaluated through a design of experiments method and a subjective test of preference. The subjective test is based on an estimate of preference between two pairs of synthetic sounds by varying several structural parameters at the same time. This differs from other studies that vary only one parameter at a time and fix the other parameters.     

An analysis of the effects of structural parameter variations on the auditory perception of environmental noises transmitted through a simulated window

The present paper concerns the influence of the independent variation of some structural parameters on the auditory perception of environmental noises transmitted through a window. The pane of glass in its frame was modelled as a thin baffled plate with viscoelastic boundary conditions; transmitted noises were then synthesized by convolving a binaurally recorded environmental noise to different calculated impulse responses of the plate involving so many different values of the structural parameters (structural damping factor and mounting conditions). Stimuli were pairwise submitted to a jury of subjects who were asked to give dissimilarity and preference judgments. Analysis first allowed to identify the relevant auditory attributes that were likely used by the subjects in their differentiation task, and also focused on drawing up a preference ranking of the transmitted noises in order to provide recommendations for window structural modifications that could improve acoustic comfort in inner spaces. On this point, depending on the structural parameter, recommendations appear to be more or less consensual in relation to the outdoor sound context.     

城市历史街区声景观及视听感知实验研究*

城市历史街区声景观是空间环境的重要内容,直接影响人们的感知体验。论文以济南老城泉水街区为例研究城市历史街区的声景观并进行视听感知实验。结果表明,现场声元素喜好度显著高于实验室单听评价。鸟鸣、鹅叫声在现场和实验室评分都较高,大流速流量水景声在现场评分高而实验室评分低,小流速流量水景声在实验室和安静环境中评分较高,在吵闹环境中评分较低;声环境满意度与视觉景观优美度、声源组成喜好度、安静度之间存在显著正相关关系,与环境声压级存在显著负相关关系,但当较高的环境声压级主要由水声贡献时,声环境满意度明显提高;应从提高景观优美度、优化声源组成、降低环境声压级等方面进行声景观设计。论文为声元素喜好度和声环境满意度研究提供参考。     

Evaluation of multichannel reproduced sound: scaling auditory attributes underlying listener preference

A study was conducted with the goal of quantifying auditory attributes that underlie listener preference for multichannel reproduced sound. Short musical excerpts were presented in mono, stereo, and several multichannel formats to a panel of 40 selected listeners. Scaling of auditory attributes, as well as overall preference, was based on consistency tests of binary paired-comparison judgments and on modeling the choice frequencies using probabilistic choice models. As a result, the preferences of nonexpert listeners could be measured reliably at a ratio scale level. Principal components derived from the quantified attributes predict overall preference well. The findings allow for some generalizations within musical program genres regarding the perception of and preference for certain spatial reproduction modes, but for limited generalizations across selections from different musical genres.     

Transmission of low-frequency sound through the water-to-air interface

L.M. Brekhovskikh revealed and studied the important role played by inhomogeneous waves emitted by a point source when they pass through an interface with a medium in which the velocity of sound is lower, for example, from water to air. This paper studies the energy characteristics of sound emitted into air by an underwater point source. The energy transfer due to inhomogeneous waves is shown to cause the phenomenon of anomalous transparency of the interface for low-frequency sound. The anomalous transparency manifests itself in that the energy flux through the interface increases with decreasing frequency of sound and, at sufficiently low frequencies, almost all of the acoustic energy produced by the underwater source is emitted into air. Conversely, at high frequencies, when the contribution of the inhomogeneous waves becomes negligible, the water-to-air interface is similar to a perfectly reflecting surface and almost all of the acoustic energy produced by the source is emitted into water. The anomalous transparency phenomenon changes the conventional opinion on the possibility of acoustic coupling between points in water and air and on the role played by physical processes evolving in the water column in generating atmospheric acoustic noise.     

A three-dimensional model for T-shaped acoustic resonators with sound absorption materials

Recent development in noise control using T-shaped acoustic resonators calls for the development of more reliable and accurate models to predict their acoustic characteristics, which is unfortunately lacking in the literature. This paper attempts to establish such a model based on three-dimensional theory for T-shaped acoustic resonators containing sound absorption materials. The model is validated by experiments using various configurations. Predictions on fundamental and high-order resonance frequencies are compared with those obtained from the one-dimensional model and finite element analyses, and the effects of the physical and geometric parameters of the absorption materials on the resonance frequencies and Q-factor are also investigated numerically and experimentally. Limitations and applicability of existing one-dimensional models are assessed. The proposed general three-dimensional model proved to be able to provide an accurate and reliable prediction on the resonance frequencies for T-shaped acoustic resonators with or without absorption materials. This can eventually meet the requirement for resonator array design in terms of accuracy.     

脉冲超声换能器声场测试系统的设计*

脉冲超声换能器是超声检测的关键部件,为了获取其声场特性参数,文中基于小球反射法原理,采用虚拟仪器技术和单片机技术设计了声场测试系统。系统的程控交互界面采用了美国国家仪器公司研制开发的图形化编程软件LabVIEW来设计,在程控交互界面程序中通过调用动态链接库DLL来对系统核心硬件超声发射接收卡进行数据通信及对卡功能进行设置,同时系统上位机通过RS232串口与下位机单片机通讯,实现对三轴扫查平台的多种扫查方式控制。该系统可实时显示脉冲换能器声压分布图像,并可通过对声压分布数据实现对换能器近场长度及扩散角等参数的测量。     

Acoustic comfort in large dining spaces

This study carried out a questionnaire field investigation in two typical large dining spaces. The results suggest that the acoustic comfort of diners has an influence on the comfort evaluation of the overall dining environment, and background noise is an important factor affecting the acoustic comfort evaluation of diners. The role of various individual sound sources in background noise has been investigated, considering general background music, speech sound, activity sound, and mechanical noise, and it has been revealed that background music, other diners’ speech sound and tableware’s impact sound has a dominant impact on the acoustic comfort evaluation of diners. Compared with the existence of background music in background noise, diners’ acoustic comfort evaluation is higher than that without background music. The loudness, articulation, noise level and preference degree of various individual sound sources are factors which affect diners’ acoustic comfort evaluation on sound sources. In terms of demographic and social factors, gender and the frequency of dining out have a significant impact on diners’ acoustic comfort evaluation.