非等间距高频波导线阵列指向性研究

研究了非等间距高频波导组成的线阵列的远场垂直指向性。提出了更符合实际应用的高频波导线阵列非等间距排列模型。通过分析同相点声源阵列的指向性,结合扬声器线阵列乘积理论得到了计算所提出模型远场垂直指向性的方法,对模型进行了有限元仿真,并实验验证了理论计算值的准确性,最后分析了高频波导线阵列非等间距排列对指向性的影响。结果表明:该方法简单有效。在有效辐射率相等的情况下,非等间距高频波导线阵列与等间距线阵列的远场指向性主瓣差异很小。      

扬声器线阵列高频波导有效辐射率的测量方法

研究了一种获取扬声器线阵列高频波导有效辐射率的简单可靠的方法。利用乘积理论和菲涅尔原理,得出在副瓣角度处扬声器线阵列与单节高频波导的垂直指向性相等,且均与其有效辐射率呈sinc函数的简单关系。按照此理论,通过实验测量单节高频波导单元的指向性,得到线阵列的有效辐射率平均值为82.5%,并测量整个线阵列进行验证实验,计算均方误差为0.051。结果表明,该方法可以快速得到阵列的有效辐射率,且准确度高。      

基于超指向性多极子矢量阵的水下低频声源方位估计方法研究

针对水下低频声源的方位估计问题,基于基元紧密排列的二维矢量阵,建立了一种超指向性波束形成方法.根据矢量基元差分运算构建各阶多极子模型,获得了几乎与频率无关的模态函数,并经加权计算可在低频条件下实现超指向性波束,以解决阵列孔径对波束性能的限制.同时,结合输出信噪比最大准则所得波束,分析了超指向性波束形成算法的稳定性与波导的影响程度,探索模态阶数与阵列参数的选取原则.通过阵列性能的仿真计算与实际阵列的测量数据表明,该算法可在小尺寸阵列孔径下获得良好的阵列波束,兼具了水下线型超指向性阵和环形超指向性阵的优点,可有效实现水下低频声源的水平方位估计;且波束性能可通过调节模态阶数与基元间距以达到最佳,并受水下声波导多途与频散效应影响有限.     

截断阶梯Legendre函数加权阵列恒定束宽波束特性分析*

连续Legendre函数加权的恒定束宽换能器(CBT)阵列可以在一定频率范围内采用与频率无关的简单阵元权重实现恒定束宽的波束特性。然而常规CBT阵列需要为每个阵元配置相应的阵元权重,当阵元数量较大时会增加复杂度。该文分析了截断阶梯Legendre函数加权的面阵列,包括球面阵、柱面阵和平面阵,并且分别分析了Legendre函数球面加权方法和Legendre函数柱面加权方法应用于上述阵列的性能。结果表明,截断阶梯Legendre函数加权对波束方向的影响可以忽略,而主要影响波束宽度。对于面阵列,当采样阶梯不大于3 dB,截断点不大于-21 dB时,截断阶梯Legendre函数加权能很好近似连续Legendre函数加权。因此截断阶梯Legendre函数加权可以在保证CBT阵列性能的前提下有效减少阵元加权系数的数量。     

面向目标的定向声辐射技术及其应用研究

面向目标的定向声辐射是指利用声源特性和阵列信号处理技术,将声波传送至目标方向或区域的声场控制方法。本文介绍了定向声辐射技术的原理和进展,重点阐述了普通扬声器阵列和参量阵扬声器这两种声源形式的理论、算法和应用研究。其中,针对扬声器阵列,主要分析了基于声能量对比度控制的声聚焦技术;针对参量阵扬声器,综述了利用非线性效应产生高指向性可听声的计算方法、信号预处理和应用等进展。面向目标的定向声辐射技术的研究对实现智能声场控制有着重要意义。     

水下应用的电容式微机械超声换能器阵列设计

为提高用于水下成像的电容式微机械超声换能器的指向性,文中用ANSYS力电耦合分析法设计了工作频率为400 k Hz的收发一体传感器的结构参数并完成了实验验证。同时研究了阵列设计方法,分析了电容式微机械超声换能器阵列各参数对指向性的影响,完成了从微小敏感单元到阵列的设计,实现了阵列指向性的优化设计。该阵列为16阵元的线阵,阵元间距为1.925 mm,阵元宽度为1.82 mm。进行了水下指向性测试,实验表明该线阵的-3 dB主瓣宽度为5?,最大旁瓣级为-13.5 dB,对称性好。该设计是实现较远距离的探测,提高成像分辨率的前提。     

微纳相控线阵超声换能器参数的理论分析*

微纳相控线阵超声换能器参数(阵元数目、阵元宽度及阵元间距)直接影响其横向声场分布,而其横向声场分布是能否实现高成像分辨率、大探测深度的决定性因素,也是制备换能器的主要依据。该文利用数值模拟研究微纳相控线阵超声换能器阵元参数对其横向声场中主瓣强度、-3 dB主瓣宽度、第一级旁瓣及栅瓣的影响。结果表明,主瓣强度随着阵元数目增加而增大,随阵元间距减小而增大,随着阵元宽度的增大呈现先增大后减小的趋势;-3 dB主瓣宽度随着阵元数目和阵元间距的增大而减小,随着阵元宽度的减小而减小;此外,减小阵元数目、减小阵元间距或增大阵元宽度均可以抑制旁瓣;栅瓣在阵元间距满足一定条件时可以完全消除。通过这些研究为微纳相控线阵超声换能器的优化设计与制备提供理论参考。     

微型扬声器摆动模态对其辐射声场的影响*

与传统电动式扬声器单元相比,微型扬声器单元由于缺少定位支片等部件,更容易受到摆动模态的影响。该文利用激光传感器采集微型扬声器单元振膜各点振动位移,通过理论计算,从辐射声压级、辐射指向性等角度探究矩形微型扬声器单元摆动模态对其辐射声场的影响。经过研究发现,摆动模态会造成微型扬声器单元频响凹陷、中低频存在指向性等现象,对其辐射声场产生明显的影响。     

参量阵扬声器在管道噪声控制中的研究*

为了解决管道有源噪声控制中声反馈造成的系统复杂度和计算量的增加,文中引入参量阵扬声器作为次级声源,利用其强指向性减小控制系统的声反馈。为了验证该方法可行性,本文分别在直管和L管中,对600 Hz单频噪声和频率范围为500 Hz~1000 Hz的窄带噪声进行了管道有源噪声控制,同时测量了参量阵扬声器的管内声场和降噪范围。结果表明,参量阵扬声器声反馈小,在没有声反馈补偿的条件下对单频噪声的降噪效果基本达到了声反馈补偿条件下普通扬声器的降噪效果,对窄带噪声的降噪效果稍差。此外,通过测量管道声场和降噪量,确定了参量阵扬声器的降噪区域为误差传感器下游整个管道,降噪面积为管道整个截面。这说明参量阵扬声器作为次级声源降低了系统的复杂度和算法的计算量,并取得了较好的降噪效果。     

一种强指向性基阵的设计及声场计算

提出了一种新的基阵:将90个小圆环分布于半径不同的5个同心圆周上,对每个小圆环采用了抛物型的振速加权。通过改变阵元尺寸、间距等参数研究了声场特征的变化。计算结果表明,该基阵模型具有非常高的指向性和抑制旁瓣的能力。通过优化阵元组合方式和参数,可获得最佳的声压分布效果。     

An alternative method to measure the on-axis difference-frequency sound in a parametric loudspeaker without using an acoustic filter

The self-demodulation characteristic of finite-amplitude ultrasonic sound waves can be applied with parametric loudspeaker to reproduce audible sound with highly directivity. But measuring the difference-frequency sound is still a problem due to the spurious sound generated as a result of nonlinearity caused by the product of the primary waves at the receiving system. In this paper, based on the phase-cancellation method and the Gaussian beam expansion technique, an alternative method is proposed to measure the on-axis difference-frequency sound accurately without using any traditional acoustic filter, where the spurious sound can be greatly reduced or even eliminated. The proposed method is more suitable for the case where the piston source in the parametric loudspeaker comprises multiple small piezoelectric transducers (PZTs) and each transducer element in the array may have different frequency response. The validity of the proposed method is confirmed both by simulations and experiments.     

Maximization of the directivity ratio with the desired audible gain level for broadband design of near field loudspeaker arrays

This paper mainly addresses design methods for near field loudspeaker arrays. These methods have been studied recently since they can be used to realize a personal audio space without the use of headphones. From a practical view point, they can also be used to form a directional sound beam within a short distance from the sources especially using a linear loudspeaker array. In this regard, we re-analyzed the previous near field beamforming methods in order to obtain a comprehensive near field beamforming formulation. Broadband directivity control is proposed for multi-objective optimization, which maximizes the directivity with the desired gain, where both the directivity and the gain are commonly used array performance measures. This method of control aims to form a directive sound beam within a short distance while widening the frequency range of the beamforming. Simulation and experimental results demonstrate that broadband directivity control achieves higher directivity and gain over our whole frequency range of interest compared with previous beamforming methods.     

Experimental Estimation of the Emission Directivity of a Moving Surface Vessel in Shallow Water

The possibility of constructing an acoustic model of a surface ship’s noise emission in the far field using monopole-type emitters uniformly distributed along the hull is investigated. Experimental data obtained in shallow water are used to calculate the characteristics of equivalent monopole emission sources that form a total sound field similar to the sound field from a moving surface ship. The powers of each monopole and the cross-correlations between them are calculated. For the selected discrete components and linear model of an extended source, the directivity patterns are constructed, reduced to the free space. In the experiments and calculations, technical tools and algorithms were used that ensure high-precision positioning of the vessel with respect to the receiving elements of the array. An equivalent model of the waveguide transfer function in the operations area was preliminarily obtained by acoustic waveguide calibration using specially developed equipment, experimental techniques, and processing algorithms. This made it possible to use adequate seafloor models and the waveguide transfer function when calculating the equivalent sound field and directivity pattern. Good agreement is shown between the calculated and experimental data, both of the directivity pattern and field distribution along the transit characteristics. Practical recommendations are given for developing methods to measure the noise fields of surface vessels.

     

优化扬声器阵列的指向性与声功率级

提出了同时优化扬声器阵列的指向性和声功率级的方法。运用该方法可以优化扬声器阵列的输入电压分布,获得指向性和声功率级二者兼顾的扬声器阵列。本方法不必使用复杂的与频率相关的信号处理装置。模拟结果和实验测量结果表明该方法是可行的和有效的。