Theoretical study of multi-mode optically pumped NH3 FIR laser

The two or multi-mode optically pumped NH₃ FIR laser had been studied theoretically. The NH₃ molecular gas was assumed to be a three-level system and obeyed the time-dependent behavior of the density matrix equations. Considering the situation of playing the two or multi-mode optical pumping and the FIR laser field were same polarized. The gain coefficient and the output FIR power of the system could be calculated by using the iteration method.It had been predicted that the two or multiple longitudinal mode optically pumped NH₃ FIR laser could have a greater output power or higher lasing efficiency than single mode pumped FIR laser under suitable selected operating parameters of laser.Supported by The Education Foundation of PRC.     

FIR Laser Efficiency Enhancement by Double Resonance Tuning

FIR Resonators with aperture coupling are shown to have resonance effects at the pumping frequency. Detailed calculations show that these effects can be enhanced by proper choice of the Gaussian parameters of the input pumping laser. The result should be an increase in efficiency of the FIR laser. A procedure is given to tune the cavity to both the FIR and pumping frequency simultaneously.     

FIR Laser Efficiency Enhancement by Double Resonance Tuning-Detailed Analysis

In a previous paper by the author (Ref. 1), FIR laser resonators with aperture coupling were shown to have resonance effect at the frequency that could be used to enhance the efficiency of the laser. This paper studies this effect over a wide range of laser parameters such as coupling aperture, cavity length and Fresnel Number. A set of curves are given to help a FIR laser designer optimize the laser.     

A magnetic resonance spectrometer for FIR frequencies; Measurement on LiErF4

A magnetic resonance spectrometer is described with an HCN laser and an optically pumped FIR laser as radiation sources. The latter enables us to measure magnetic resonances at many frequencies throughout the FIR range. High magnetic fields up to 35 T are generated by means of a capacitor discharge with 10 ms pulse duration. The results of our measurments on LiErF₄ are in good agreement with resonance conditions calculated from parameters found by Hansen et al[10]. Different aspects of FIR magnetic resonance spectroscopy are discussed.     

Study of the spectral characteristics and the output coupling of pulse optically pumped cavity SMMW laser

The miniaturization of OPFIRL plays an important role in application of this new wavelength range of electromagnetic wave, especially in that of spaceflight where efficiency and miniature are emphasized.[1][8] So it is important to optimize the operating parameters of OPFIRL. This article will start with density matrix equations, then calculate the FIR output power density under different operating conditions by means of iteration calculation. And then parameters of the laser will be changed in order to study it's spectral characteristic of the FIR laser. We found that, working under the optimum operating gas pressure, FIF output power varies with the output coupling of the cavity OPFIRL. There is an optimum value of reflection coefficient R_o of the output window which makes the output FIR power denity and spectral characteristic of miniature OPFIRL optimum.     

The energy exchange and the optimum length of the sample tube of opfirl

The energy exchange between the pumping laser and FIR signal in the optically pumped FIR laser (OPFIRL) system was studied. The iteration method has been used to calculate the power density of the pumping and FIR signals at any point along the optical axis of the sample tube. It was found that the power density of the FIR signal did not always increase along the length of the laser tube. There was a maximum FIR power density at the appropriate point in the sample tube. If the distance of maximum power point from the entrance of the OPFIRL tube was taken as the length of sample tube Z_opt, the maximum FIR laser output should be obtained. This was the optimum length of OPFIRL tube. The value of Z_opt was closely related to the parameter of OPFIRL such as the pumping power density, the pumping detuning and the frequency of the FIR laser. The energy-exchange and the maximum output of the fir laser were calculated under the ideal condition.     

Applications of high resolution spectroscopy to the identification of far-infrared laser emission from optically pumped13CH3OH

High-resolution infrared (IR) and far infrared (FIR) Fourier transform absorption spectra have been employed to investigate assignments of FIR laser lines reported from optically-pumped¹³CH₃OH. The spectroscopic measurements are used in conjunction with the reported IR pump and FIR laser frequencies to form closed combination loops for several systems, serving to confirm the assignments and in some cases to improve the accuracy of the FIR laser frequencies. Frequency predictions from combination differences are also presented for a number of potential new FIR laser lines.     

Spectral Characteristics of Raman Emissions from Miniature Pulsed Optically Pumped Far Infrared Laser

A miniature FIR laser with a sample-tube in 10 or 20cm length were constructed, and the laser's cavity consisted of a pair of metallic meshes, with NH3 molecules as active medium pumped by a TEA-CO2 laser, a series of FIR laser lines were observed. By taking account of the properties of the Fabry-Perot cavity and the gain characteristics of Raman transitions in the miniature optically pumped FIR laser, the spectral characteristics of the FIR laser were studied.     

Study of miniature optically pumped NH3 fir cavity laser

A miniature NH₃ molecule FIR cavity laser of 15cm in length pumped by a TEA CO₂ laser was built. The spectral characteristics of the cavity laser and the optimum operating parameters were studied.Supported by the National Natural Sciences Foundation of China     

有限冲击响应滤波器在四频激光陀螺中的应用

针对目前四频差动激光陀螺光学解调方案可靠性和温度特性差的特点,介绍一种基于FPGA的数字拍频解调方案。分析了四频差动激光陀螺数字拍频解调对电路系统的需求,对数字拍频解调的关键部件低通滤波器进行了设计与实现。根据四频差动激光陀螺的特性参数计算滤波器的通带截止频率及阻带截止频率,使用MATLAB的滤波器设计和分析工具FDATool完成了有限冲击响应（FIR）数字滤波器的参数设计,并利用Xilinx公司的FPGA集成开发环境ISE实现FIR数字滤波器的片上系统设计。仿真和实验结果表明,所设计的FIR数字滤波器对四频差动激光陀螺的和频分量衰减达到-66 dB,满足四频差动激光陀螺拍频解调的需求,并有助于实现四频差动激光陀螺的小型化和数字化。     

Assignment of FIR Laser Lines of Hydrazine

With 228 known FIR laser emissions, hydrazine is the most prolific laser active molecules after methanol. But, due to the complexity of its rovibrational spectrum, only a few assignments of hydrizine FIR laser transitions are found in literature. Here we analyze 44 FIR laser lines of hydrazine excited by 20 different CO₂ pumps. The pump transitions are compared to available assignments of IR amino-wagging transitions. We propose values for the J and K quantum numbers involved in 41 FIR laser transitions, for 22 of them we give also the symmetry species.     

Measurements and assignments of new large offset CD3OH FIR laser lines

By using an acoustooptic modulator we extend the 300 MHz tunability of a waveguide CO₂ laser to 480 MHz. The CD₃OH was optically pumped by the 10R(32), 10R(34), and 10R(36) CO₂ laser lines, and 17 new FIR laser lines were discovered. The Stark effect on previously known FIR laser lines was investigated, and some tentative FIR laser lines assignments are suggested.     

Frequency measurements of far infrared laser lines by means of MIM point contact diodes

We present frequency measurements of 85 Far Infrared (FIR) laser lines ranging from 2 748 GHz to 421 GHz. We use the heterodyne technique of mixing FIR laser transitions and microwave radiation on MIM point contact diodes to determine the FIR frequencies.Work supported by Consiglio Nazionale delle Ricerche -Italia and INFM (Consorzio Interuniversitario di Fisica della Materia)     

Investigation of 13CH3OH methanol: new laser lines and assignments

We have reinvestigated ¹³CH₃OH as a source of far-infrared (FIR) laser emission using a CO₂ laser as a pumping source. Thirty new FIR laser lines in the range 36.5 μm to 202.6 μm were observed and characterized. Five of them have wavelengths between 36.5 and 75 μm and have sufficient intensity to be used in LMR spectroscopy. Using Fourier-transform spectroscopic data in the infrared (IR) and FIR regions we have determined the assignment for 10 FIR laser transitions and predict nine frequencies for laser lines which have yet to be observed. Received: 17 July 2000 / Published online: 6 December 2000     

Operating parameter optimization of optically pumped CH3OH far-infrared laser

By solving the density matrix equations of a quantum system, the output power intensity of an optically pumped CH₃OH FIR laser (CH₃OH-OPFIRL) was calculated by means of iteration method, and the spectral characteristics were got. Base on the calculation, optimization of operating parameters including operating gas pressure, pumped power and output coupling coefficient of the CH₃OH cavity laser were systematically studied. Experimental, a series of FIR emissions of the CH₃OH cavity laser pumped by TEA-CO₂ laser with 9P(16) line were measured. The experimental results were in good agreement with theoretical calculations. The project was supported by the Special Research Foundation of Doctorate Station in University of P.R.C.     

Revision on the calculation of optically pumped FIR laser spectrum with Doppler broadening and pressure broadening effects

By means of iteration method and also taking into account Doppler broadening and pressure braodening effect of IR pumping laser, the output power density of optically pumped NH₃ molecules FIR laser is calculated by solving density matrix equations of three-level system. The results of theoretical calculation shows that, in comparison with the FIR laser under the assumption of ideal monochromatic IR pumping, the output power density of FIR laser in the case of Doppler broadening and pressure broadening IR pumping decreases much more. Meanwhile, via the revision of Doppler broadening and pressure broadening effect, the theoretical value of optimum operating gas pressure reduces, which is in better agreement with the experimental value. Further study shows that the revision of Doppler broadening effect is more fit for the conventional FIR laser with a 2m sample tuble and the revision of pressure broadening effect is much more suitable for the miniature FIR laser with a short sample tube of 5 to 20cm in length.Supported by the National Natural Sciences Foundation of P.R.China and the NSF of Guangdong Province.     

Heterodyne investigations into FIR laser outputs and quasi-optical Schottky barrier diode detectors

Heterodyne investigations using laser/microwave mixing techniques have been applied to a FIR laser and a quasi-optical Schottky type detector. Techniques for identifying various laser parameters will be discussed. The heterodyne techniques resulted in NEP (2 × 10^-19 W/Hz at 496 μm) and bandwidth (9 GHz) specifications for the detector.     

Instabilities in optically pumped infrared lasers

The unstable emission of an optically pumped FIR gas laser is theoretically analysed through numerical resolution of the associated Maxwell-Bloch equations. The instability domain in the main control parameters space is determined and an example of chaotic behaviour is examined.     

Energy Exchanged Process of Superradiant Optically Pumped Far-Infrared Laser with Buffer Gas

By means of solving the density matrix equations, base on the mechanism model of buffer gas, the output intensity of FIR and the FIR signal gain coefficient Gs and IR pumping signal absorption coefficient Gp were calculated, energy exchanged process of superradiant OPFIRL with buffer gas was analyzed. It was found that after adding buffer gas into the laser medium, the FIR output could be increased, and the active region of a FIR laser was lengthened.