Scanning tunneling microscopy/spectroscopy on multi-layered cuprate superconductor Ba2Ca5Cu6O12 (O1−x Fx)2

Scanning tunneling microscopy/spectroscopy (STM/STS) measurements on multi-layered cuprate superconductor Ba₂Ca₅Cu₆O₁₂ (O_1−x F_x)₂ are carried out. STM topographies show randomly distributed bright spot structures with a typical spot size of 0.8 nm. These bright spots are occupied about 28% per one unit cell of c-plane, which is comparable to the regular amount of apical oxygen of 20% obtained from element analysis. Tunneling spectra simultaneously show both the small and the large gap structures. These gap sizes at 4.9 K are about Δ 15 meV and 90 meV, respectively. The small gap structure disappears at the temperature close to T_C, while the large gap persists up to 200 K. Therefore, these features correspond to the superconducting gap and pseudogap, respectively. These facts give evidence for some ordered state with large energy scale even in the superconducting state. For the superconducting gap, the ratio of 2Δ/K_BT_C = 4.9 is obtained with T_C = 70 K, which is determined from temperature dependence of the tunneling spectra.     

Synthesis, characterization and melt processing of Y1−x(Yb0.9Nd0.1)xBa2Cu3Oz superconductors

Effects of a combined substitute of Yb and Nd on Y site on the superconducting properties of YBa₂Cu₃O_y have been studied. We synthesized Y_1−x(Yb_0.9Nd_0.1)_xBa₂Cu₃O_z compound with x = 0.2, 0.4, 0.6, 0.8 and 1.0. Here, the ratio of Yb–Nd was fixed to be 9:1 for obtaining 123 phase without secondary phases. The melt processing thermal profiles for Y_1−x(Yb_0.9Nd_0.1)_xBa₂Cu₃O_z with x = 0.2 and 0.4 and the addition of 40 mol% {Y_1−x(Yb_0.9Nd_0.1)_x}₂BaCuO₅ and 0.5 wt% Pt in air were determined on the basis of the thermal analysis results. All samples showed a low grain growth rate, particularly for high x values, which may be partially ascribed to un-optimized thermal schedules. Although almost all the samples exhibited low J_c values, the sample with x = 0.2 exhibited T_c of 88.8 K and a relatively high J_c value of 16,000 A/cm² at 77 K for H//c-axis.     

Preparation and electrical properties of a pyrochlore-related Ce2Zr2O8−x phase

A pyrochlore-related Ce₂Zr₂O_8−x phase has been prepared in a reduction reoxidation process from Ce_0.5Zr_0.5O₂ powders. Ce₂Zr₂O_8−x, based on a cubic symmetry with a=1.053 nm, decomposes in nitrogen at 800 °C, but remains stable up to 900 °C in air. It shows mixed oxygen ionic and electronic conductivity. The bulk conductivity at 700 °C is 4×10⁻⁴ S cm⁻¹ in air and 1×10⁻² S cm⁻¹ in nitrogen, and the activation energy is 1.27 eV in air. In nitrogen, the Arrhenius law is not obeyed, and a curved plot was obtained from 400 to 700 °C; then, the conductivity decreased rapidly due to the thermal decomposition of Ce₂Zr₂O_8−x.     

Temperature dependence of the indirect band gap, steepness parameter and related optical constants of [Kx(NH4)1−x]2ZnCl4 mixed crystals

Optical transmittance measurements near the absorption edge of [K_x(NH₄)_1−x]₂ZnCl₄ mixed crystals, where x=0.00, 0.232, 0.522, 0.644, 0.859 and 1.00, are reported over 276–350 K range. Analysis reveals that the type of transition is the indirect allowed one. The absorption edge shifted towards lower energy with increasing temperature. It is shown that [K_x(NH₄)_1−x]₂ZnCl₄ mixed crystals with x0.644 reveal a phase transition at 319 K, this phase disappeared at high concentrations of K⁺ ions. The steepness parameter is given, its value is used to estimate the temperature dependence of the indirect energy gap. In the region of the absorption edge, the absorption coefficient obeys Urbach's rule. Urbach parameters are investigated as a function of temperature.     

Effect of Ca doping on the superconducting properties of GdBaSrCu3O7−δ bulk samples

Gd_1−xCa_xBaSrCu₃O_7−δ samples (0  x  0.1) were prepared via solid-state reaction. Four-point probes method was used for resistance versus temperature measurements. Results show decrease in T_c by increasing x content. This variation is assumed to be irrelevant to the different phases or impurity effects since X-ray patterns show all samples are tetragonal single-phase. Ca doping decreases the oxygen content and lattice parameters of the samples. It is suggested that Ca prevents the dislocation of oxygen, and then disrupts the hole concentration of the system and antiferromagnetic correlation at CuO₂ planes. Subsequently, destroys the superconductivity of the samples.     

Microwave dielectric properties of (1 − x)(Mg0.95Co0.05)TiO3–x(Na0.5La0.5)TiO3 ceramic system

The microstructures and the microwave dielectric properties of the (1 − x)(Mg_0.95Co_0.05)TiO₃–x(Na_0.5La_0.5)TiO₃ ceramic system were investigated. Two-phase system was confirmed by the XRD patterns and the EDX analysis. A co-existed second phase (Mg_0.95Co_0.05)Ti₂O₅ was also detected. The microwave dielectric properties are strongly related to the density and the matrix of the specimen. A new microwave dielectric material 0.88(Mg_0.95Co_0.05)TiO₃–0.12(Na_0.5La_0.5)TiO₃, possessing an excellent combination of dielectric properties: ε_r  22.36, Q × f  110,000 GHz (at 9 GHz), τ_f  2.9 ppm/°C), is proposed as a candidate dielectric for GPS patch antennas.     

Electric polarization memory effect in a magnetoelectric multiferroic CuFe1−xGaxO2

Magnetic oxide CuFeO₂ is a magnetoelectric multiferroic with new type of spin–polarization coupling different from that in the spin-current mechanism, where magnetic field-induced or nonmagnetic impurity-induced proper helical magnetic ordering generates a spontaneous electric polarization parallel to the helical axis. Using a CuFe_1−xGa_xO₂ sample with x=0.035, in which the single ferroelectric phase is realized below T_N8 K in zero magnetic field unlike CuFe_1−xAl_xO₂, we have performed pyroelectric current, thermally stimulated current (TSC) and polarized neutron diffraction measurements to study a memory effect that the electric polarization is partially preserved even for 2nd-cooling from above T_N without poling electric field. It was found that the charge trapped during 1st-cooling with poling electric field, which is released as TSC on heating, plays an important role in the memory effect.     

Si-nanostructures formation in amorphous silicon nitride SiNx:H deposited by remote PECVD

The formation of silicon nanoclusters embedded in amorphous silicon nitride (SiN_x:H) can be of great interest for optoelectronic devices such as solar cells. Here amorphous SiN_x:H layers have been deposited by remote microwave-assisted chemical vapor deposition at 300 °C substrate temperature and with different ammonia [NH₃]/silane [SiH₄] gas flow ratios (R=0.5−5). Post-thermal annealing was carried out at 700 °C during 30 min to form the silicon nanoclusters. The composition of the layers was determined by Rutherford back scattering (RBS) and elastic recoil detection analysis (ERDA). Fourier transform infrared spectroscopy (FTIR) showed that the densities of SiH (2160 cm⁻¹) and NH (3330 cm⁻¹) molecules are reduced after thermal annealing for SiN:H films deposited at flow gas ratio R>1.5. Breaking the SiH bonding provide Si atoms in excess in the bulk of the layer, which can nucleate and form Si nanostructures. The analysis of the photoluminescence (PL) spectra for different stoichiometric layers showed a strong dependence of the peak characteristics (position, intensity, etc.) on the gas flow ratio. On the other hand, transmission electron microscopy (TEM) analysis proves the presence of silicon nanoclusters embedded in the films deposited at a gas flow ratio of R=2 and annealed at 700 °C (30 min).     

The experimental and theoretical investigation of vibration spectra in ferroelectric semiconductor SbSBrxI1−x crystals

The vapor grown SbSBr_xI_1−x (x=0.1; 0.5; 0.9) crystals with clear mirror surfaces have been used for infrared reflection measurements with Fourier spectrometer. The vibration frequencies along c(z)-axis have been derived from Kramers–Kroning and optical parameters fitting analysis of the experimental reflectivity spectra at T=300 K. The theoretical vibration spectra of SbSBr_xS_1−x (x=0.1; 0.5; 0.9) crystals in paraelectric phase (T=300 K) along c(z)-axis have been determined in quasiharmonic approximation by diagonalization of dynamical matrix. The theoretical vibration spectra of these crystals in a–b(x−y) plane have been determined in harmonic approximation. In this work we discuss the nature of anharmonism in SbSBr_xI_1−x crystals along the c(z)-axis.     

Structure, ferroelectric and piezoelectric properties of (Bi1−x−yNa0.925−x−yLi0.075)0.5BaxSryTiO3 lead-free piezoelectric ceramics

Lead-free multi-component ceramics (Bi_1−x−yNa_{0.925−x−y}Li_0.075)_0.5Ba_xSr_yTiO₃ have been prepared by an ordinary sintering technique and their structure and electrical properties have been studied. All the ceramics can be well-sintered at 1100 °C. X-ray diffraction patterns shows that Li⁺, Ba²⁺ and Sr²⁺ diffuse into the Bi_0.5Na_0.5TiO₃ lattices to form a new solid solution with a pure perovskite structure, and a morphotropic phase boundary (MPB) is formed at 0.04 < x < 0.08. As compared to pure Bi_0.5Na_0.5TiO₃ ceramic, the coercive field E_C of the ceramics decreases greatly and the remanent polarization P_r of the ceramics increases significantly after the formation of the multi-component solid solution. Due to the MPB, lower E_C and higher P_r, the piezoelectricity of the ceramics is greatly improved. For the ceramics with the compositions near the MPB (x = 0.04–0.08 and y = 0.02–0.04), piezoelectric coefficient d₃₃ = 133–193 pC/N and planar electromechanical coupling factor k_P = 16.2–32.1%. The depolarization temperature T_d reaches a minimum value near the MPB. The temperature dependences of the ferroelectric and dielectric properties suggest that the ceramics may contain both the polar and non-polar regions at temperatures near/above T_d.