Oxygen isotope effect in chromium-doped Pr<Subscript>0.5</Subscript>Ca<Subscript>0.5</Subscript>MnO<Subscript>3</Subscript> manganites

The effect of oxygen isotope substitution on the properties of Pr_0.5Ca_0.5Mn_{1 ? x} Cr _x O₃ manganites (x = 0, 0.02, 0.05) have been studied. The introduction of chromium favors (i) the decomposition of a charge-ordered state and (ii) the appearance of a ferromagnetic metallic phase in Pr_0.5Ca_0.5Mn_{1 ? x} Cr _x ^16–18O₃. The isotope substitution ¹⁶O → ¹⁸O leads to a decrease in the content of the ferromagnetic phase, an increase in the charge-ordering transition temperature (T _CO), and a decrease in the ferromagnetic transition temperature (T _FM). The isotope mass exponent is evaluated.     

Electrical instability of LiCu<Subscript>2</Subscript>O<Subscript>2</Subscript> crystals

The temperature behavior of I-U curves and the field and temperature dependences of the electrical resistivity and dielectric permittivity of crystals of the LiCu₂O₂ phase have been studied. It was established that the crystals belong to p-type semiconductors and that their static resistivity in the range 80–260 K follows the Mott law ρ=Aexp(T₀/T)^1/4 describing variable-range hopping over localized states. At comparatively low electric fields, the crystals exhibit threshold switching and characteristic S-shaped I-U curves containing a region of negative differential resistivity. In the critical voltage region, jumps in the conductivity and dielectric permittivity are observed. Possible mechanisms of the disorder and electrical instability in these crystals are discussed.     

The influence of chromium impurity centers on the critical properties of a weakly polar ferroelectric Li<Subscript>2</Subscript>Ge<Subscript>7</Subscript>O<Subscript>15</Subscript>

The Cr³⁺ EPR spectra of Li₂Ge₇O₁₅ (LGO) crystals are analyzed in the temperature range of the ferroelectric phase transition. The temperature dependence of the local order parameter is determined from the measured splittings of the EPR lines in the polar phase. The experimental critical exponent of the order parameter β=0.31 in the range from the phase transition temperature T _C to (T _C -T) ～ 40 K corresponds to the critical exponent of the three-dimensional Ising model. Analysis of the available data demonstrates that, away from the phase transition temperature T _C , the macroscopic and local properties of LGO crystals are characterized by a crossover from the fluctuation behavior to the classical behavior described in terms of the mean-field theory. The temperature dependence of the local order parameter for LGO: Cr crystals does not exhibit a crossover from the Ising behavior (β=0.31) to the classical behavior (β=0.5). This is explained by the defect nature of Cr³⁺ impurity centers, which weaken the spatial correlations in the LGO host crystal. The specific features of the critical properties of LGO: Cr³⁺ crystals are discussed within a microscopic model of structural phase transitions.     

Pressure-induced superconductivity and structural transitions in Ba(Fe<Subscript>0.9</Subscript>Ru<Subscript>0.1</Subscript>)<Subscript>2</Subscript>As<Subscript>2</Subscript>

Electrical transport and structural characterizations of isoelectronically substituted Ba(Fe_0.9Ru_0.1)₂As₂ have been performed as a function of pressure up to ～ 30 GPa and temperature down to ～ 10 K using designer diamond anvil cell. Similar to undoped members of the AFe₂As₂ (A = Ca, Sr, Ba) family, Ba(Fe_0.9Ru_0.1)₂As₂ shows anomalous a-lattice parameter expansion with increasing pressure and a concurrent ThCr₂Si₂ type isostructural (I4/mmm) phase transition from tetragonal (T) phase to a collapsed tetragonal (cT) phase occurring between 12 and 17 GPa where the a is maximum. Above 17 GPa, the material remains in the cT phase up to 30 GPa at 200 K. The resistance measurements show evidence of pressure-induced zero resistance that may be indicative of high-temperature superconductivity for pressures above 3.9 GPa. The onset of the resistive transition temperature decreases gradually with increasing pressure before completely disappearing for pressures above ～ 10.6 GPa near the T-cT transition. We have determined the crystal structure of the high-T _c phase of Ru-doped BaFe₂As₂ to remain as tetragonal (I4/mmm) by analyzing the X-ray diffraction pattern obtained at 10 K and 9.7 ± 0.7 GPa, as opposed to inferring the structural transition from electrical resistance measurement, as in a previous report [S.K. Kim, M.S. Torikachvili, E. Colombier, A. Thaler, S.L. Bud’ko, P.C. Canfield, Phys. Rev. B 84, 134525 (2011)].     

Electron paramagnetic resonance of Cr<Superscript>3+</Superscript>-Li<Superscript>+</Superscript> centers in (Cr,Li): Mg<Subscript>2</Subscript>SiO<Subscript>4</Subscript> synthetic forsterite

Synthetic single crystals of chromium-and lithium-doped forsterite, namely, (Cr,Li): Mg₂SiO₄, are studied using electron paramagnetic resonance spectroscopy. It is revealed that, apart from the known centers Cr³⁺(M1) and Cr³⁺(M2) (with local symmetries C_i and C_s, respectively), these crystals involve two new types of centers with C₁ symmetry, namely, Cr³⁺(M1)′ and Cr³⁺(M2)′ centers. The standard parameters D and E in a zero magnetic field [zero-field splitting (ZFS) parameters expressed in GHz] and principal components of the g tensor are determined as follows: D=31.35, E=8.28, and g=(1.9797, 1.9801, 1.9759) for Cr³⁺(M1)′ centers and D=15.171, E=2.283, and g=(1.9747, 1.9769, 1.9710) for Cr³⁺(M2)′ centers. It is found that the lowsymmetric effect of misalignment of the principal axes of the ZFS and g tensors most clearly manifests itself (i.e., its magnitude reaches 19°) in the case of Cr³⁺(M2)′ centers. The structural models Cr³⁺(M1)-Li⁺(M2) and Cr³⁺(M2)-Li⁺(M1) are proposed for the Cr³⁺(M1)′ and Cr³⁺(M2)′ centers, respectively. The concentrations of both centers are determined. It is demonstrated that, upon the formation of Cr³⁺-Li⁺ ion pairs, the M1 position for chromium appears to be two times more preferable than the M2 position. Reasoning from the results obtained, the R₁ line (the ²E → ⁴A₂ transition) observed in the luminescence spectra of (Cr,Li): Mg₂SiO₄ crystals in the vicinity of 699.6 nm is assigned to the Cr³⁺(M1)′ center.     

Fabrication and dielectric properties of modified calcium (Pb<Subscript>0.75</Subscript>Ba<Subscript>0.25</Subscript>)(Zr<Subscript>0.7</Subscript>Ti<Subscript>0.3</Subscript>)O<Subscript>3</Subscript> ceramics

The aim of the present work is to report investigations concerning the influence of homovalent modificators on relaxor properties of PBZT 25/70/30 ceramics. The selection of the proper homovalent additive was very important. Literature reports as well as data taken from the periodic table indicated, that calcium ions substitute themselves for lead ions with high likelihood of occurrence. The investigations showed that the substitution significantly changed the microstructure of ceramics – with grains of calcium modified ceramics decreasing and density increasing. The XRD measurements indicate that the pure PBZT ceramics as well as calcium dopant were characterised by tetragonal structure with space group I4 /mmm. Addition of calcium leads to a slight decrease in the lattice constant and crystal structure. The calcium modification also changes the dielectric properties. The temperature characteristic of the dielectric constant achieved a broadened maximum at temperature T_m, which decreases with increasing Ca content. The properties typical for ferroelectric relaxors weaken with increasing calcium dopant.     

Specific features of the structure,magnetic properties,and heat capacity of intercalated compounds Cr<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript>TiSe<Subscript>2</Subscript>

Structural features, magnetic properties, and heat capacity of Cr _x TiSe₂ intercalated compounds with a layered structure have been studied experimentally for 0 ≤ x ≤ 0.5. It is shown that, at high chromium concentrations (x > 0.25), the magnetic properties of the compounds are strongly affected by the degree of ordering and distribution pattern of the intercalated atoms. Depending on the cooling rate of samples of the same composition (x = 0.5), an antiferromagnetic or a cluster-glass-type state can be obtained. Heat capacity measurements have revealed a nonmonotonic variation in the lattice rigidity with increasing concentration of intercalated atoms.     

Many-electron model of band structure and metal-insulator transition under pressure in FeBO<Subscript>3</Subscript>

A many-electron model is proposed for the band structure of FeBO₃ with regard to strong electron correlations in the d⁴, d⁵, and d⁶ configurations. Under normal conditions, FeBO₃ is characterized by a dielectric charge-transfer gap in the strong correlation regime U?W. With increasing pressure, not only does the d-band W width grow but simultaneously the effective Hubbard parameter U_eff sharply drops, which is due to the crossover of high-spin and low-spin ground state terms of the Fe²⁺, Fe³⁺, and Fe⁴⁺ ions. It is predicted that a transition from the semiconducting antiferromagnetic state to the metallic paramagnetic state will occur in the high-pressure phase with increasing temperature.     

Electronic and optical properties of Fe<Subscript>2</Subscript>SiO<Subscript>4</Subscript> under pressure effect: ab initio study

We report first-principles studies the structural, electronic, and optical properties of the Fe₂SiO₄ fayalite in orthorhombic structure, including pressure dependence of structural parameters, band structures, density of states, and optical constants up to 30 GPa. The calculated results indicate that the linear compressibility along b axis is significantly higher than a and c axes, which is in agreement with earlier work. Meanwhile, the pressure dependence of the electronic band structure, density of states and partial density of states of Fe₂SiO₄ fayalite up to 30 GPa were presented. Moreover, the evolution of the dielectric function, absorption coefficient (α(ω)), reflectivity (R(ω)), and the real part of the refractive index (n(ω)) at high pressure are also presented.     

Pressure dependence of the superconducting state parameters of a binary Ca<Subscript>70</Subscript>Mg<Subscript>30</Subscript> metallic glass superconductor

Theoretical computation of the pressure dependence of superconducting state parameters of a binary Ca₇₀Mg₃₀ metallic glass has been performed using the model potential formalism. Explicit expressions have been derived for the volume dependence of the electron-phonon coupling strength λ and the Coulomb pseudopotential μ*, considering the variation of the Fermi momentum k _F and Debye temperature θ_D with volume. Well-known Ashcroft’s empty core model pseudopotential and five different types of the local-field correction functions, namely, Hartree, Taylor, Ichimaru-Utsumi, Farid et al. and Sarkar et al. have been used for obtaining pressure dependence of transition temperature T _C and the logarithmic volume derivative Φ of the effective interaction strength N ₀ V for the metallic glass superconductor. It has been obtained that T _C of Ca₇₀Mg₃₀ metallic glass decreases rapidly with increasing pressure up to 60% decrease in the volume, for which the μ* and Φ curves show a linear nature. The superconducting phase disappears at about 60% decrease in the volume.