Modelling of mechanism of agglomeration of KCl crystallization

The article presents an analysis into agglomeration during KCl vacuum crystallization. The theoretical and experimental investigations into the mechanism of agglomeration during mass crystallization result in an extension of the growth phenomena within the known model equations. The basis for this is essentially constituted by the collision model concepts of the theory of floculation in disperse systems. The parameters derived from the microprocess analysis (energy dissipation, content of solids, growth rate of individual grains) lead to model equations which are confirmed by laboratory and test trials.     

Relationship of Morphological Types of Dynamic Forms of Crystals

Crystallography Reports - The relationship of morphological spectra (sets of data on the morphological types of real polyhedral crystals and their probabilities under current physicochemical...     

Development of Pauling's concepts of geometric characteristics of atoms

The evolution of the geometric characteristics introduced by Pauling and their dependence on the specific features of the structure and chemical bonds have been considered. The values of the covalent and van der Waals radii are given as well as their relationships and mutual transitions.     

A review of measurement of thermophysical properties of silicon melt

Measurements of thermophysical properties of Si melt and supplementary study of X-ray scattering/diffraction by the authors' group were reviewed. The values obtained differed variously from those of literature. Density was 2–3% larger, surface tension 20–30% smaller, viscosity up to 40% larger, electrical conductivity 8% smaller, spectral emissivity more or less in good agreement with literature values, and thermal diffusivity a few percent larger. An anomalous density jump was found near the melting point. Surface tension and viscosity also showed anomaly. A strange time-dependent change of density was observed over 3 h after melting. X-ray analyses suggested a slight change in local atom ordering, but showed no sign of cluster formation. An addition of 0.1 at% gallium caused the density jump to disappear, while that of boron caused no change. An EXAFS study of the former melt indicated a strong interaction between Ga and Si atoms as if molecules of GaSi₃ existed. The implications of the measured properties are a possibility of soft-turbulence in an Si melt in a relatively large crucible, a more complicated manner of intake of oxygen depleted molten Si from the free surface region to underneath the growing crystal, and a relaxation of the melt after melting arising from trapped gas species.     

Generation of crystal structures of heteromolecular compounds by the method of discrete modeling of packings

Within the method of discrete modeling of packings, an algorithm of generation of possible crystal structures of heteromolecular compounds containing two or three molecules in the primitive unit cell, one of which has an arbitrary shape and the other (two others) has a shape close to spherical, is proposed. On the basis of this algorithm, a software package for personal computers is developed. This package has been approved for a number of compounds, investigated previously by X-ray diffraction analysis. The results of generation of structures of five compounds—four organic salts (with one or two spherical anions) and one solvate—are represented.     

Velocities of Disappearance and Lifetime of Faces of Growing Crystals

The formulae for absolute R_disap and relative R velocities of disappearance and lifetime τ of faces of growing crystals have been derived for stationary growth. It was shown that the quantities are determined by the relative growth velocity R_A/R_critA of the vanishing face A with respect to the critical growth velocity R_critA and by the geometry of a crystal expressed by the trigonometric functions of interfacial angles β and γ formed between face A and the adjacent faces. R increases and τ decreases with the increase in R_A/R_critA to certain limiting values. The calculations have been verified and illustrated by the experimental results for triclinic potassium bichromate (KBC) crystals. Results enable ones to predict values of velocities of disappearance and lifetimes of undesirable, supplementary faces of any real crystal.     

Comparative analysis of two methods of calculation of the orientation of domain walls in ferroelastics

Two types of domain-wall equations are analyzed: the equations derived by the Sapriel method and the equations obtained by interface matching of the thermal-expansion tensor. It is shown that, for W-type domain walls, these methods yield the same equations. For W′-type domain walls, the equations obtained by different methods coincide for proper ferroelastics and differ for improper ferroelastics.     

Dependence of the parameters of equations of viscous flow on chemical composition of silicate melts

The temperature dependence of viscosity of silicate melts is discussed in the framework of the Avramov–Milchev (AM) equation. The composition is described by means of two parameters: the molar fraction, x, and the “lubricant fraction”, l. The molar fraction is the sum of the molar parts x_i of all oxides dissolved in SiO₂, the molar fraction of the latter being 1 ? x. It is shown that, with sufficient precision, two of the parameters of the AM equation can be presented as unique functions of the molar fraction. On the other hand, x is not sufficient to determine properly the reference temperature T_r , at which viscosity is η_r = 10¹³ [dPa.s]. Therefore, additional parameter, “lubricant fraction” l, is introduced. For each of the components, l_i is a product of molar part x_i and a specific dimensionless coefficient 0 ≤ k_i ≤ 1 accounting for the specific contribution of this component to the increased mobility of the system. It is demonstrated that, for l > 0, the reference temperature is related to the “lubricant fraction” l through the reference temperature T_r,SiO2 of pure SiO₂.     

Mechanism of thermal expansion of structural modifications of zinc pyrovanadate

Crystal chemical characteristics of the α and β modifications of Zn₂V₂O₇ are calculated based on in situ high-temperature X-ray measurements. The expansion of the structure is found to be strongly anisotropic up to the negative volumetric thermal expansion of the α-Zn₂V₂O₇ unit cell in the temperature range of 300–600°С, α _V =–17.94 × 10^–6 1/K. The transformations of the “hard” and “soft” sublattices with an increase temperature and at the phase transition are considered in detail. It is shown that the negative volumetric thermal expansion of α-Zn₂V₂O₇ is due to the degeneracy of the zigzag-like shape of zinc–oxygen columns at constant distances between their vertices.     

A SAXS study of kinetics of aggregation of silica sols

SAXS in situ experiments on the evolution of TMOS solutions during hydrolysis and polycondensation lead to power laws with scaling exponents ≈ 2. It is suggested that this could be the result of the polydispersity of the samples and that only an apparent fractal dimension can be obtained in this way. Kinetic studies tend to indicate that agglomeration in the sol is the result of a diffusion-controlled process.     

Effect of Supersaturation on Disappearance of Faces of Growing Crystals

Growth conditions affect the velocities of disappearance and lifetime of faces of growing crystals. Supersaturation is a factor which causes either an increase or a decrease in velocities of disappearance of faces and their lifetime depending on the mechanism and kinetics of growth of disappearing and adjacent faces. The possible relationships between velocities of disappearance of faces, their lifetime and supersaturation have been derived and discussed.     

Study of the possibility of interactive control of the surface profile of X-ray optical elements

We investigate the possibility of controlling the curvature parameters of parabolic mirrors that are modular elements of two types consisting of a base and thin inserts placed at the opposite side of the work surface. In the first type of modular elements, bending is controlled by the difference in the coefficients of the thermal expansion of the base and inserts. In the second type of elements, the profile is changed by the piezoelectric straining of the inserts under an electric field. A correlation is established between the parameters of modular elements and their surface curvature profile.     

Activity of nonparallel center of growth of (001) face of TGS single crystal under inconstant conditions of crystallization

Morphologic and kinetic behaviour of the hill of the (001) face of TGS crystal, generated by unparallel dislocation center of growth under inconstant supersaturation and temperature has been experimentally examined. Some irreversible changes in the shape of the hill top, as a hysteresis in its normal rate of growth is registered. A model, on the base of which a qualitative anylsis of the phenomenon is proposed.     

Luminescence of crystals of divalent tungstates

Crystals of divalent tungstates are characterized by two main luminescence spectral ranges: a short-wavelength (blue) luminescence band in the range 390–420 nm and a group (often two groups) of longer wavelength (green) bands in the range 480–520 nm. For crystals of calcium, strontium, barium, cadmium, magnesium, zinc, and lead tungstates, it is shown that the wavelength corresponding to the maximum of the blue luminescence band (λ_max) correlates with the melting temperature (T_m) of these compounds. The position of the blue luminescence band is the same (in the range 510–530 nm) for crystals with different divalent cations. Annealing in vacuum and electron irradiation decrease the intensity of both blue and green luminescence bands but do not change the ratio of their maximum intensities. This circumstance suggests that vacancies serve as luminescence quenchers to a greater extent rather than facilitate the formation of emission centers responsible for a particular luminescence band.     

Micromorphology of as-grown surfaces of crystals

This paper describes and discusses the micromorphology of as-grown surfaces of single crystals. After a brief introduction to the methods of observation of surfaces, the mechanism of growth and development of crystals is first outlined. Here the formation of bunches and macrosteps, the relationship between the growth mechanism and the surface entropy factor, and the effect of impurities on the surface morphology are described. Common structures observed on the as-grown surfaces are then explained in relation to growth conditions of the crystals. The following growth structures are described: elementary spirals, macrospirals, hillocks of dislocation and nondislocation origin, interlacing and slip patterns, macrosteps, inclusions, block structures, growth striations and impurity striations.     

Mechanism of spatial ordering of dislocations during plastic deformation of crystals

Mechanisms of spatial ordering of dislocations during plastic deformation of crystals are considered. The system of evolution equations, which take into account the effects of elastic and correlated interactions of screw dislocations, is derived. The study is performed with due regard for the dynamics of spatial fluctuations of the dislocation density.     

磷蛋白对牙本质晶脱矿动力学的影响

应用等组分晶体生长方法,研究了牙本质晶、羟基磷灰石、釉质晶脱矿动力学.并探索了磷蛋白对牙本质晶脱矿动力学过程的影响.实验条件为:溶液温度:T=37±0.5℃;溶液酸度:pH=4.5±0.03;初始离子强度:IS=0.15mol/L;溶液的饱和度:δ＝-0.60;-0.74;-0.86.研究结果表明:当δ=-0.60时,牙本质晶、釉质晶和羟磷灰石脱矿反应过程的特征明显不同.前两者的饱和溶解量比后者大一个数量级.羟磷灰石的特征反应周期比釉质晶和牙本质晶短15倍左右,初始反应速率慢30倍.牙本质晶脱矿初始反应速率Ri随δ的减低而快速增加.磷蛋白对牙本质晶的脱矿过程起抑制作用,但存在临界值.当磷蛋白在溶液中的浓度超过临界值后,其反应速率的变化很小.磷蛋白抑制作用在较大程度上依赖于溶液的饱和度.