First CRDS-measurements of water vapour continuum in the 940 nm absorption band

Measurements of near-infrared water vapour continuum using continuous wave cavity ring down spectroscopy (cw-CRDS) have been performed at around 10611.6 and . The continuum absorption coefficients for N₂-broadening have been determined to be and at , and and at , respectively.These results represent the first near-IR continuum laboratory data determined within the complex spectral environment in the 940 nm water vapour band and are in reasonable agreement with simulations using the semiempirical CKD formulation.     

Atomic structure of thin dysprosium-silicide layers on Si(1 1 1)

We report on scanning tunneling microscopy results of thin dysprosium-silicide layers formed on Si(1 1 1). In the submonolayer regime, both a and a 5 × 2 superstructure were found. Based on images taken at different tunneling conditions, a structure model could be developed for the superstructure. For one monolayer, a 1 × 1 superstructure based on hexagonal DySi₂ was observed, while several monolayers thick films are characterized by a superstructure from Dy₃Si₅.     

Modelling of phase transitions and reaction at CO adsorption on oxygen precovered Pd(1 1 1)

Using the interaction parameters up to the third neighbors and activated form of O and CO diffusion and their reaction, the model has been proposed for Monte-Carlo simulations describing the catalytic O + CO → CO₂ reaction and occurring phase transitions on Pd(1 1 1) surface. Upon adsorption of CO the pre-adsorbed oxygen transforms from p(2 × 2)_O phase into and phases in the limit of room and moderate temperatures, respectively. We demonstrate that the kinetic effects determine both the occurrence of the p(2 × 1)_O and disappearance of the phases at moderate and low temperatures, respectively. Using reaction rate as a fit parameter, we show that at room temperature the start of the reaction can be synchronized with the occurrence of phase.     

Surface phase diagram and temperature induced phase transitions of Sn/Cu(1 0 0)

Room temperature deposition of Sn on Cu(1 0 0) gives rise to a rich variety of surface reconstructions in the submonolayer coverage range. In this work, we report a detailed investigation on the phases appearing and their temperature stability range by using low-energy electron diffraction and surface X-ray diffraction. Previously reported reconstructions in the submonolayer range are p(2 × 2) (for 0.2 ML), p(2 × 6) (for 0.33 ML), ()R45° (for 0.5 ML), and c(4 × 4) (for 0.65 ML). We find a new phase with a structure for a coverage of 0.45 ML. Furthermore, we analyze the temperature stability of all phases. We find that two phases exhibit a temperature induced reversible phase transition: the ()R45° phase becomes ()R45° phase above 360 K, and the new phase becomes p(2 × 2) also above 360 K. The origin of these two-phase transitions is discussed.     

Electronic structure of dysprosium silicide films grown on a Si(1 1 1) surface

The thickness-dependent electronic structures of Dy silicide films grown on a Si(1 1 1) surface have been investigated by angle-resolved photoelectron spectroscopy. Two (1×1) periodic bands, both of them cross the Fermi level, have been observed in the silicide films formed by Dy coverages of 1.0 monolayer and below, and more than five () periodic bands have been observed in thicker films. Taking the () periodic structure of Dy atoms in the submonolayer silicide film into account, the periodicity of the two metallic bands indicate that they mainly originate from the orbitals of Si atoms, which form a (1×1) structure. Of the () periodic bands observed in thick films, four of them are well explained by the folding of the (1×1) bands into a () periodicity. Regarding the other band, the three () periodic bands would originate from the electronic states related to the inner Si layers that form a () structure, and the one observed in the 3.0 ML film only might originate from the electron located at the interface between bulk Si and the Dy silicide film.     

Aromatic interactions in the close packing of phenyl-imides at Cu(1 1 0) surfaces

The oxidation of aniline at Cu(1 1 0) surfaces at 290 K has been studied by XPS and STM. A single chemisorbed product, assigned to a phenyl imide (C₆H₅N(a)), is formed together with water which desorbs. Reaction with preadsorbed oxygen results in a maximum surface concentration of phenyl imide of 2.8 × 10¹⁴ mol cm⁻² and a surface dominated by domains of three structures described by , and unit meshes. However, concentrations of phenyl imide of up to 3.3 × 10¹⁴ mol cm⁻² were obtained from the coadsorption of aniline and dioxygen (300:1 mixture) resulting in a highly ordered biphasic structure with and domains. Comparison of the STM and XPS data shows that only half the phenyl imides at the surface are imaged. Pi-stacking of the phenyl rings is proposed to account for this observation.     

Electronic structure of the Sb-induced Si(1 1 3)2 × 5 surface

The surface electronic structure of Sb/Si(1 1 3)2 × 5 was investigated by angle-resolved photoemission spectroscopy experiments. This reveals Sb/Si(1 1 3)2 × 5 to have three surface bands with anisotropic two-dimensional characteristics. The band widths of the surface bands along is larger than along . The number of surface bands of Sb/Si(1 1 3)2 × 5 and their band dispersions along and are quite analogous with those of Sb/Si(1 1 3)2 × 2 composed of Sb adatom and Si tetramer chains. The electronic structure analogy suggests that Sb/Si(1 1 3)2 × 5 and Sb/Si(1 1 3)2 × 2 have common building blocks such as Sb adatom and Si tetramer chains.     

The v6 = 1 and v6 = 2 vibrational states of DCF3

The high-resolution infrared spectra of DCF₃ were reinvestigated in the ν₆ fundamental band region near 500 cm⁻¹ and around 1000 cm⁻¹ with the aim to assign and analyze the overtone level of the asymmetric CF₃ bending vibration v₆ = 2.The present paper reports on the first study of both its sublevels (A₁ and E corresponding to l = 0 and ±2, respectively) through the high-resolution analysis of the overtone band and the hot and bands.The well-known “loop method”, applied to and , yielded ground state energy differences Δ(K, J) = E₀(K, J) − E₀(K − 3,J) for the range of K = 6 to 30.In the final fitting of molecular parameters, we used the strategy of fitting all upper state data together with the ground state rotational transitions.This is equivalent to that calculating separately the and coefficients of the K-dependent part of the ground state energy terms from the combination loops.All rotational constants of the ground state up to sextic order could be refined in the calculation.This led to a very accurate determination of C₀ = 0.18924413(25) cm⁻¹, , and also .In the course of analyzing simultaneously the overtone band together with the and ν₆ bands, the original assignment of the fundamental ν₆ band [Bürger et al., J. Mol. Spectrosc. 182 (1997) 34-49] was found to be incompatible with the present one. Assignments of the (k + 1, l₆ = +1)/(k − 1,l₆ = −1) levels had to be interchanged, which changed the value of Cζ₆ = −0.14198768(26) cm⁻¹ and the sign of the combination of constants C − B − Cζ in the v₆ = 1 level to a negative value.     

Coadsorption of CO and C6H6 on Co(0 0 0 1)

We have studied the influence of CO on the adsorption of benzene on the Co(0 0 0 1) surface using LEED, XPS, TDS and work function measurements. CO was found to reduce the benzene adsorption, but even at saturation CO exposure no complete blocking was observed. Thermal desorption of the coadsorbed layer featured CO and H₂ peaks indicating partial dehydrogenation of benzene and retaining of the CO bond. Ordered LEED structures were found with all coverages: Pre-adsorption of CO led to patterns already seen for pure carbon monoxide adsorption. Pre-adsorption of benzene showed the known structure of pure benzene also with small CO exposures, but higher CO exposures yielded a mixture of and patterns.     

Sub-Doppler high-resolution excitation spectroscopy of the S1 ← S0 transition of dibenzofuran

Rotationally resolved ultrahigh-resolution fluorescence excitation spectra of the S₁ ← S₀ transition of dibenzofuran have been observed using the technique of crossing a collimated molecular beam and the single-mode UV laser beam. 3291 rotational lines of the band and 3047 rotational lines of the band have been assigned. The band has been found to be a b-type transition, in which the transition moment is along the twofold symmetry axis of this molecule, and only the ΔK_a = ± 1 transitions were observed. The excited state is identified to be the S₁¹A₁(ππ^∗) state. In contrast with this, the band has been found to be an a-type transition in which the transition moment is along the long axis in plane. It indicates that the intensity of this vibronic band arises from vibronic coupling with the S₂¹B₂(ππ^∗) state. We determined the accurate rotational constants and the molecule have been shown to be planar both in the ground and excited states.     

Fe monolayers on InAs(0 0 1): An in situ study of surface, interface and volume magnetic anisotropy

The magnetic anisotropy of epitaxial Fe films with thicknesses in the range of 2-142 monolayers (ML) grown on {4×2} reconstructed InAs(0 0 1) was investigated by in situ ferromagnetic resonance. The easy magnetization direction was found to be parallel to the -direction for Fe films below 4 ML, while it rotates by 45^° toward the -direction. It is observed that both surface-interface and volume contribution to the perpendicular anisotropy favor an easy axis perpendicular to the film plane. The cubic surface-interface anisotropy is relatively large with easy axes along -directions in contrast to the volume contribution which favors easy axes along the -directions. The volume contribution is found to be larger than the Fe bulk cubic anisotropy. A thickness independent uniaxial anisotropy has been found in films with a thickness of 2 up to 142 ML.     

Diode laser spectroscopy of CO2 at 790 nm

Absorption lines of ¹²C¹⁶O₂ have been examined by using a tunable diode laser spectrometer in the region around (790 nm). The spectrometer sources are commercially available double heterostructure InGaAlAs tunable diode lasers (TDLs) operating in the “free-running” mode, which allowed the detection of the line positions within . The observed carbon dioxide absorption lines belong to the combination overtone 2ν₂+5ν₃ ro-vibrational band with intensities ranging around .     

Fourier transform emission spectroscopy of CoCl in the 500 nm region

Fourier transform emission spectra of CoCl were obtained with a tube furnace-DC discharge source in the 450-500 nm spectral region. In addition to observing two different band systems, which were assigned as [20.7] and [21.3] by Adam et al. [J. Mol. Spectrosc. 212 (2002) 111], we obtained data for additional sub-bands and vibrational levels. In contrast to the previous work, intense Q branches are seen in the [21.3]- bands which indicate that these bands are likely ΔΛ≠0 transitions. The equilibrium rotational constant B_e for the ground state is 0.1801104(28) cm⁻¹, the equilibrium bond length is 2.065122(16) Å and ΔG_1/2 is 430.418(5) cm⁻¹.     

STM study of l-serine adsorption on Cu(0 0 1)

The adsorption of l-serine on Cu(0 0 1) surface at 310 K was studied by scanning tunneling microscope (STM). l-serine molecules on the Cu(0 0 1) initially formed a domain of thick lines with a order structure along the direction on the terraces regardless of the coverage of serine. The thick lines were partly replaced by thin line along the direction, and completely disappeared in 2 h. It is considered that in these structures hydrogen bonds involved in hydroxymethyl group between adsorbates play some role in addition to intermolecular hydrogen bond between a hydrogen atom of amino group and an oxygen atom of carboxy group for alanine adsorption.     

MRCI studies on the electronic structure of AlN and AlN, and the electron affinity of AlN

Using multireference configuration-interaction methods and double to triple-zeta basis sets with semidiffuse and polarization functions, potential energies and spectroscopic constants for low-lying doublet, and quartet states of AlN⁻ were calculated. has R_e=3.280 bohr and . lies 0.17 eV above the ground state. Using an estimated electron affinity of 2.1 eV for AlN, four states of AlN⁻ are found to be stable, namely , , , and . Comparisons with the isovalent anions BN⁻ (three stable states) and AlP⁻ (seven stable states) are made. Photo-detachment of an electron from the state of AlN⁻ can lead to an accurate determination of the energy difference between the two close-lying lowest states of AlN, and , predicted here to be 0.09 eV apart.     

Co-induced nano-structures on Si(1 1 1) surface

The interaction of cobalt atoms with silicon (1 1 1) surface has been investigated by means of scanning tunneling microscopy (STM) and low-energy electron diffraction (LEED). Besides the Co silicide islands, we have successfully distinguished two inequivalent Co-induced reconstructions on Si(1 1 1) surface. Our high-resolution STM images provide some structural properties of the two different derived phases. Both of the two phases seem to form islands with single domain. The new findings will help us to understand the early stage of Co silicide formations.