Soft-x-ray laser interferometry of a pinch discharge using a tabletop laser

We have used a tabletop soft-x-ray laser and a wave-front division interferometer to probe the plasma of a pinch discharge. A very compact capillary discharge-pumped Ne-like Ar laser emitting at 46.9 nm was combined with a wave division interferometer based on Lloyd's mirror and Sc-Si multilayer-coated optics to map the electron density in the cathode region of the discharge. This demonstration of the use of tabletop soft-x-ray laser in plasma interferometry could lead to the widespread use of these lasers in the diagnostics of dense plasmas.     

Generation of millijoule-level soft-x-ray laser pulses at a 4-Hz repetition rate in a highly saturated tabletop capillary discharge amplifier

Laser pulses with energies of as much as 1 mJ were generated at a wavelength of 46.9 nm by single-pass amplification in a 34.5 cm-long Ne-like Ar capillary discharge plasma. The large gain-length product of this plasma column allows for soft-x-ray amplification in a highly saturated regime, resulting in efficient energy extraction. Average laser output pulse energy of 0.88 mJ and peak power of 0.6 MW were obtained at a repetition rate of 4 Hz. With an estimated peak spectral brightness of approximately 1x10(23)photons /(s mm(2)mrad> (2)0.01% bandwidth) this tabletop laser is one of the brightest soft-x-ray sources to date.     

Optimization toward a high-average-brightness soft-x-ray laser pumped at grazing incidence

We report the near-field imaging characterization of a 10 Hz Ni-like 18.9 nm molybdenum soft-x-ray laser pumped in a grazing incidence pumping (GRIP) geometry with a table-top laser driver. We investigate the effect of varying the GRIP angle on the spatial behavior of the soft-x-ray laser source. After multiparameter optimization, we were able to find conditions to generate routinely a high-repetition-rate soft-x-ray laser with an energy level of up to 3 microJ/pulse and to 6x10(17) photons/s/mm2/mrad2/(0.1% bandwidth) average brightness and 1x10(28) photons/s/mm2/mrad2/(0.1% bandwidth) peak brightness.     

Dense plasma diagnostics with an amplitude-division soft-x-ray laser interferometer based on diffraction gratings

We report the demonstration of an amplitude-division soft-x-ray interferometer that can be used to generate high-contrast interferograms at the wavelength of any of the saturated soft-x-ray lasers (5.6-46.9 nm) that are available at present. The interferometer, which utilizes grazing-incidence diffraction gratings as beam splitters in a modified Mach-Zehnder configuration, was used in combination with a tabletop 46.9-nm laser to probe a large-scale (~2.7-mm-long) laser-created plasma.     

Highly directive 18.9 nm nickel-like molybdenum x-ray laser operating at 150 mJ pump energy

We experimentally demonstrate that by longitudinally pumping 2 mm long molybdenum preformed plasma with high-intensity 475 fs duration laser pulse, a highly directive soft-x-ray laser at 18.9 nm wavelength is generated. The divergence of the beam is evaluated to be of the submilliradian order, and only requires a pump laser energy of 150 mJ.     

Damage and ablation of large bandgap dielectrics induced by a 46.9 nm laser beam

We applied a 0.3 mJ, 1.7 ns, 46.9 nm soft-x-ray argon laser to ablate the surface of large bandgap dielectrics: CaF2 and LiF crystals. We studied the ablation versus the fluence of the soft-x-ray beam, varying the fluence in the range 0.05-3 J/cm2. Ablation thresholds of 0.06 and 0.1 J/cm2 and ablation depths of 14 and 20 nm were found for CaF2 and LiF, respectively. These results define new ablation conditions for these large bandgap dielectrics that can be of interest for the fine processing of these materials.     

Electron density characterization by use of a broadband x-ray-compatible wave-front sensor

The use of a Hartmann wave-front sensor to accurately measure the line-integrated electron density gradients formed in laser-produced and z-pinch plasma experiments is examined. This wave-front sensor may be used with a soft-x-ray laser as well as with incoherent line emission at multikilovolt x-ray energies. This diagnostic is significantly easier to use than interferometery and moiré deflectometry, both of which have been demonstrated with soft-x-ray lasers. This scheme is experimentally demonstrated in the visible region by use of a Shack-Hartmann wave-front sensor and a liquid-crystal spatial light modulator to simulate a phase profile that could occur when an x-ray probe passes through a plasma. The merits of using a Hartmann sensor include a wide dynamic range, broadband or low-coherence-length light capability, high x-ray efficiency, two-dimensional gradient determination, multiplexing capability, and experimental simplicity. Hartmann sensors could also be utilized for wavelength testing of extreme-ultraviolet lithography components and x-ray phase imaging of biological specimens.     

Demonstration of a spatial filtering amplifier for high-order harmonics

We report what is to our knowledge the first demonstration of spatial filtering of a high-order harmonic beam into a soft-x-ray laser plasma amplifier at 32.8 nm. After amplification the seed energy is enhanced by a factor of 50, and the beam profile of the amplified beam exhibits an Airy-like shape due to the spatial filtering by the optical field ionized plasma. Moreover, the transverse coherence of the spatially filtered amplified beam is strongly enhanced, resulting in the generation of a peak coherent power of 0.9 x 10(5) to 1.8 x 10(5) W.     

Continuous high-repetition-rate operation of collisional soft-x-ray lasers with solid targets

We have generated a laser average output power of 2 microW at a wavelength of 13.9 nm by operating a tabletop laser-pumped Ni-like Ag laser at a 5 Hz repetition rate, using a solid helicoidal target that is continuously rotated and advanced to renew the target surface between shots. More than 2 x 10(4) soft-x-ray laser shots were obtained by using a single target. Similar results were obtained at 13.2 nm in Ni-like Cd with a Cd-coated target. This scheme will allow uninterrupted operation of laser-pumped tabletop collisional soft-x-ray lasers at a repetition rate of 10 Hz for a period of hours, enabling the generation of continuous high average soft-x-ray powers for applications.     

Features of femtosecond laser pulse reflection from a sharp boundary of relativistic laser plasma

The features of femtosecond laser pulse reflection from a plasma target of near-critical density were analytically and numerically studied in a wide range of laser pulse intensities and durations. Based on analytical calculations, it is shown that the pulse reflectance at a constant intensity decreases with decreasing pulse duration. Based of numerical simulation results, it is shown that, as a superintense femtosecond laser pulse is incident on a plasma layer with a concentration close to the critical one, a quasi-periodic electron-density structure is formed in the plasma bulk, which can both increase and decrease the the laser pulse reflectance.     

Focusing coherent soft-x-ray radiation to a micrometer spot size with an intensity of 10(14) W/cm2

We investigate the focusability of intense coherent soft-x-ray radiation generated by high-order harmonic conversion. The 27th-harmonic wave at 29.6 nm is focused by an off-axis parabolic mirror with a SiC/Mg multilayer coating. Focal-spot images are observed from the visible fluorescence induced by the soft-x-ray photons on a Ce:YAG scintillator. We demonstrate focusing of the soft-x-ray beam to a 1-microm spot size with a peak intensity of 1 x 10(14) W/cm2, which is to our knowledge the highest ever reported in the soft-x-ray region.     

脉冲光纤激光修锐青铜金刚石砂轮等离子体特性研究

采用光栅光谱仪 对脉冲光纤激光修锐青铜金刚石砂轮过程中产生的等离子体空间分辨发射光谱进行了测量. 研究了500–600 nm波段范围内的等离子体空间发射光谱强度随激光平均功率和脉冲重复频率的变化情况. 结果表明: 等离子体辐射光谱强度在其径向膨胀方向上距离砂轮表面约2.4 mm处达到最大值. 在局部热力学平衡假设条件下, 根据等离子体中六条铜原子谱线的相对强度, 利用Boltzmann 图法, 计算得到在不同激光功率和重复频 率条件下的等离子体电子温度沿砂轮径向方向的分布规律. 实验结果表明: 在激光修锐青铜金刚石砂轮过程中, 距离砂轮表面约3 mm处等离子体电子温度出现峰值, 其温度最高可达4380 K, 且等离子体电子温度随着激光参数和 空间位置的改变呈现出不同的演变规律. 关键词： 脉冲光纤激光 等离子体发射光谱 激光修锐 电子温度     

利用单飞秒激光脉冲驱动类氖钛X射线激光的研究

提出了一种利用单飞秒激光脉冲驱动类氖钛X射线激光的物理方案.利用自相似方法研究了不同脉冲前沿的单飞秒激光辐照钛平板靶产生的类氖钛X射线激光等离子体的特性,得到了电子温度、电子密度和定标长度三者的定标律,讨论了给定输入参数下各定标律曲线的特性.研究表明,利用单个飞秒激光能够实现X射线激光的产生,而且脉冲前沿强度随时间增长平缓的飞秒激光有利于驱动X射线激光.本研究为实验上实现单飞秒激光脉冲驱动X射线激光提供了一种新的方案.     

A cadmium photoionization laser pumped by laser induced plasma radiation from a multi foci device

Soft x-rays from a laser-produced plasma were used to perform innershell photoionization of Cd atoms and to generate laser radiation at 442 nm. To achieve longer interaction zones between the Cd vapor and the soft x-ray flux, up to three plasma spots have been applied. In this way a maximum laser energy of 300 J with a 600 mJ Nd:YAG laser for the plasma production was achieved. Experimental investigations and corresponding rate-equation calculations indicate, that photoelectrons play an important role in the total laser kinetics.     

Nonlinear interaction of a circularly polarized electromagnetic wave with a dense laser plasma

The interaction of an intense circularly polarized laser pulse with a layer of plasma of supercritical density is studied. The nonlinear skin effect for the electromagnetic field and the coefficient of collisionless absorption of the laser pulse were calculated analytically. It is shown that, in the process of interaction with the plasma, the laser pulse generates solitons propagating through the plasma layer and transferring the radiation through the opaque medium. The coefficient of transparency of the plasma layer for the soliton-like penetration of the laser radiation was calculated. The plasma parameters at which the collisionless absorption is small as compared to the transformation of the laser energy into solitons were found.     

Sampling measurement of soft-x-ray-pulse shapes by femtosecond sequential ionization of Kr+ in an intense laser field

We propose a sampling technique for measuring the shape of ultrashort soft-x-ray pulses. The technique uses the transient state of Kr+ ions that is produced by the femtosecond sequential evolution of Kr ions during optical-field-induced ionization as an ultrafast x-ray-absorption sampling gate. We demonstrate the technique by measuring the pulse shape of the 51st harmonic (15.6 nm) generated by a 100-fs titanium:sapphire laser pulse. The measured pulse duration is 220 fs. Our experimental result confirms that the sequential evolution of Kr+ ions from neutral Kr to Kr2+ is the dominant contribution to the ionization process from the aspect of time-domain measurement.     

A New Discharge Scheme of a Prepulse Plus Two Main Pulses for Capillary-Discharge Soft-X-Ray Laser

Reducing the capillary-discharge current is one way of possibly decreasing the pumping power requirement. We examine the influence of various discharge currents on laser intensity and determine the suitable pre-discharge condition for a 46.9-nm discharge-pumped Ne-like Ar soft-x-ray amplifier. The experimental results show that a high additional pre-pulse current at amplitude of several kA and with a very short duration of several tens of nanosecond can effectively decrease the amplitude of the main discharge current at the lasing time. We propose a new discharge scheme of a pre~pulse plus two main pulses which appears to significantly decrease the requirement for discharge current. This in turn may decrease the pumping power requirement for the capillary discharge laser and can greatly increase laser efficiency.     

Plasma-aided radiation guiding in a free-electron laser

The introduction of a plasma in a free-electron laser (FEL) helps radiation guiding via nonlinear refraction. At high-radiation power density, when oscillatory electron velocity is comparable to the electron thermal velocity, the radiation pushes plasma radially out, forming a depleted plasma duct and guiding the radiation. The radius of the self-trapped laser is ~c/ω_po, where ω_po is the unperturbed plasma frequency and c is the velocity of light in vacuum     

Cross-focusing of two laser beams in a plasma

Cross-focusing of two copropagating laser beams in a plasma is investigated using paraxial ray theory. If the lasers have a frequency difference equal to the electron plasma frequency, they can drive a large amplitude plasma wave. The ponderomotive force due to the plasma wave forces the plasma electrons outwards thereby generating a parabolic density profile giving rise to cross-focusing. The results show a decrease in threshold for focusing by two orders of magnitude as compared to focusing due to the ponderomotive force of the laser beams.     

Microdroplet evolution induced by a laser pulse

Interaction between high-power ultrashort laser pulse and giant clusters (microdroplets) consisting of 10⁹ to 10¹⁰ atoms is considered. The microdroplet size is comparable to the laser wavelength. A model of the evolution of a microdroplet plasma induced by a high-power laser pulse is developed, and the processes taking place after interaction with the pulse are analyzed. It is shown theoretically that the plasma is superheated: its temperature is approximately equal to the ionization potential of an ion having a typical charge. The microdroplet plasma parameters are independent of the pulse shape and duration. The theoretical conclusions are supported by experimental studies of x-ray spectra conducted at JAERI, where a 100-terawatt Ti-sapphire laser system was used to irradiate krypton and xenon microdroplets by laser pulses with pulse widths of 30 to 500 fs and intensities of 6×10¹⁶ to 2×10¹⁹W/cm².