Clean-up methods for polycyclic aromatic hydrocarbons analyses by capillary gas chromatography

Summary Comparative results of pre-treatment methods for the extracts of polycyclic aromatic hydrocarbons (PAHs) from airborne particulate matter for quantitative determination by gas chromatography (GC) are presented. The first method included liquid-liquid extraction and column liquid adsorption chromatography. In the second procedure the extract was fractionated by liquid-liquid chromatography and liquid adsorption chromatography. In the last procedure two different solid phase extraction (SPE) cartridges examined makes it possible to separate PAHs and remove paraffinic compounds which is very important for the quantitative GC analysis of the PAHs. Recoveries of PAH standards and some their derivatives were determined and the contents of 15 of the most important PAHs, were compared. Presented at the 21^st ISC held in Stuttgart, Germany, 15^th–20^th September, 1996     

Chemical analysis of polycyclic aromatic hydrocarbons by surface-enhanced Raman spectroscopy

The use of surface-enhanced Raman spectroscopy (SERS) for trace determination of polycyclic aromatic hydrocarbons (PAHs) is described. This paper focuses on the development of SERS-active substrates that are specific for the characterization and spectroscopic study of PAHs. The SERS-active substrates are based on thin gold films evaporated on a glass surface previously treated with a mercaptoalkylsilane. SERS of PAHs was investigated over uncoated gold island films and over such films coated with a self-assembled monolayer (SAM) of 1-propanethiol. Adsorption of PAHs on a plain SERS-active Au-film led to a surface-induced decomposition of PAHs, due to catalytic properties of nanostructured gold. Thus, the functionalization of the SERS-active substrates by means of SAM was done aiming at a specific chemical interaction toward PAHs. Thus, in addition to preventing decomposition of the PAHs, the coating also concentrates the hydrophobic PAHs close enough to the SERS-active interface. Results show that high sensitivity, SERS-active nanostructured gold substrates that show selectivity towards PAHs were obtained, with the following properties: strong intensification of the Raman signal, reproducibility, and stability over time. The employed methodology enables the observation of excellent Raman spectra of PAHs in aqueous environment at ppm levels.     

Sample preparation and analytical methods for polycyclic aromatic hydrocarbons in sediment

Polycyclic aromatic hydrocarbons (PAHs) are a large category of ubiquitous persistent environmental pollutants, some of them have strong carcinogenicity to human and animals. These pollutants can easily enter the river through multiple ways including rainfall, dry deposition and water washout, and deposit in the sediment. However, it is easy for them to re-enter the river water and pollute water sources, as well as aquatic animals and plants, bringing potential harm to human health. Therefore, it is requisite to accurately analyze the PAHs in sediment. In this review, the analytical methods of PAHs in sediment, focused on the methods of sample extraction, purification, concentration and determination, are summarized.     

Improved analysis of polycyclic aromatic hydrocarbons in aqueous solutions by gas chromatography

The analysis of organics in aqueous solutions by gas chromatography needs sample pretreatment in order to avoid contact of water with the stationary phase of the column. A new method based on dehydration by boron trifluoride and its use for the analysis of polycyclic aromatic hydrocarbons in microemulsions is described.     

Evaluation and optimization of extraction and clean-up methods for the analysis of polycyclic aromatic hydrocarbons in peat samples

The analysis of PAH in peat samples is complicated by the high content of organic matter in peat which affects both extraction efficiency and analytical quality. Therefore, we evaluated the efficiencies of three extraction methods (accelerated solvent extraction (ASE), fluidized bed extraction, ultrasonic extraction) and several clean-up techniques in order to find the best set of methods. ASE proved to be the best extraction method. For clean-up, a procedure using aluminium oxide and silica gel showed the highest efficiency, whereas a method originally developed for soil samples failed to remove the peat matrix satisfactorily. With the optimized extraction and clean-up procedure, 170 samples from Canadian bogs were analysed for PAH. With overall recovery rates between 69?±?14 and 89?±?16% and an inaccuracy of ≤20%, the optimized method was a well suitable tool for the analysis of PAH in peat samples.     

Progress in the analytical research methods of polycyclic aromatic hydrocarbons (PAHs)

Abstract

Polycyclic aromatic hydrocarbons (PAHs) are one species of persistent organic pollutants (POPs) with strong carcinogenicity and teratogenicity. They can be widely found in the environment, which cause great harm to the ecological environment. In addition, they endanger human health by polluting food from the natural environment and food processing. Therefore, it is necessary to accurately detect PAHs in various sample matrices, which requires the accurate, practical and rapid detection methods. This review aims to investigate the progress of research methods for PAHs, including pretreatment methods and detection methods. A summary analysis of different methods is performed by searching the literature on numerous methods for detecting PAHs published in various journals. There are many pretreatment methods for PAHs, such as solid phase extraction (SPE), cloud point extraction (CPE) and so on. The most commonly used methods for detecting PAHs are high-performance liquid chromatography (HPLC) and gas chromatography-mass spectrometry (GC-MS). Spectrophotometry, chromatography and chromatography-mass spectrometry have been used more frequently owing to their accuracy and convenience. At the same time, some immunological methods, such as immunosensormethods, enzyme-linked immunosorbent assays (ELISA), immunofluorescence, etc. are also widely used.     

Identification and quantitative analysis of nitrogen-containing polycyclic aromatic hydrocarbons in sediments

An integrated analytical methodology has been developed for determining nitrogen-containing polycyclic aromatic hydrocarbons, which enables quantitation of individual contaminants as low as 1 μg/kg in sediment samples. A cross-sectional profile from the Hamilton Harbour sediment samples was analyzed for azaarenes. These contaminants were separated by Soxhlet extraction, and pH adjustment allowed their isolation from different classes of neutral and acidic components. Separation and identification of the organic bases in each sample were achieved by using open tubular column gas chromatography with thermionic detection and HRGC-mass spectrometry. Organic bases present in the samples included mostly azaarenes such as acridines, benzacridines, azafluorene, benzoquinolines, azapyrenes, etc. Quantitation and environmental significance of these compounds are discussed. Recoveries of individual azaarenes at two different levels were evaluated. Data presented indicate that detection limits of this method are between 1 and 10 μg/kg. Recovery azaarenes from bottom sediment samples at concentration levels between 1 to 100 μg/kg is 81 ± 17%.     

Quantitative analysis for polycyclic aromatic hydrocarbons by spectral decomposition of molecular fluorescence

Analysis of the molecular fluorescence spectra of several polycyclic aromatic hydrocarbons (PAH) by the technique of spectral decomposition is discussed. Peak characterization parameters obtained by this technique are utilized to obtain quantitative measurement of a mixture containing benzidiae and dibenzochrysene in solution. Application of the technique to a large number of reference compounds is discussed as an aid to routine identification of suspected carcinogens and other compounds containing fluorophores.     

HPLC analysis of the large polycyclic aromatic hydrocarbons in a diesel particulate

Summary High performace liquid chromatography (HPLC) was used to separate the large polycyclic aromatic hydrocarbons in a diesel particulate extract. Identification of individual peaks was made using a photodiode array UV/visible detector to collect their absorbance spectra. Comparisons between standard compounds and the peaks were made using both retention times and spectra. Compounds of up to 10 rings were identified.     

Miniaturisated method for the analysis of polycyclic aromatic hydrocarbons in leaf samples

A new methodology is proposed for monitoring 16 priority polycyclic aromatic hydrocarbons, using tree leaves as passive samplers, by means of a mini-ultrasonic probe coupled with reversed-phase liquid chromatography (RP-LC) and fluorescence (FL) detection. Separation and detection of the 16 PAHs were completed in 19 min, using a 3 μm (particle size) C₁₈ column RP-LC with acetonitrile–water gradient elution. The ultrasonic probe device used was equipped with a 2 mm titanium tip, and sample and solvent amounts used were just 50 mg and 1 mL, respectively. Multivariate optimisation of the variables affecting extraction was conducted by means of full factorial analysis to determine which of the variables were significant. A central composite design was applied to define surface responses and to calculate optimal values for the variables. The accuracy of the method was determined by both analysis of a Certified Reference Material with a similar matrix (IAEA-140 OC, seaweed) and by comparison of the results obtained with those from a previously developed method. The proposed analytical method avoids some of the main problems encountered in the determination of PAH in complex matrices; no clean-up step is necessary, consequently sample preparation time and costs can be significantly reduced. The developed method was applied to determine PAH in leaf samples from medlar and red and white mangrove trees, situated near PAH pollution sources.     

Comparison of different extraction methods for the determination of polycyclic aromatic hydrocarbons in soil

Two different extraction methods for the determination of polycyclic aromatic hydrocarbons in soil are compared: the extraction in combination with ultrasonic treatment, and the Soxhlet extraction method according to DIN-draft 38414 Part 21. Different types of real soil were extracted and analysed by HPLC with diode-array detector and fluorescence detection. The results show that the efficiency of the ultrasonic method is comparable to the Soxhlet method.     

Palladium-catalyzed pentannulation of polycyclic aromatic hydrocarbons

We present a new and versatile one-step synthesis of a series of small molecular chromophores based on cyclopentannulated polycyclic aromatic hydrocarbons (PAH). Easily available pyrene, anthracene, and perylene bromides serve as starting materials for the reactions. The formation of the five-membered ring is achieved by the straightforward palladium(0)-catalyzed carbannulation with various substituted acetylenes. This approach is applicable either to single or multiple annulation procedures leading to hitherto inaccessible PAH topologies. According to the resulting products of the diverse reactions, a mechanistic explanation is proposed. UV/Vis absorption as well as cyclovoltammetric measurements were performed for characterization demonstrating the value of this annulation technique. Optical absorptions of up to 780 nm and absorption coefficients ranging from 8000 to 34,000 M(-1) cm(-1) were detected.     

Simplified determination of polycyclic aromatic hydrocarbons

Accurate quantitative analysis for selected polycyclic aromatic hydrocarbons present on urban dust can be obtained by using a simple procedure consisting of sonic-probe extraction with cyclohexane; clean-up with Florisil((R))-XAD-4((R)), and measurement by high-resolution gas chromatography with flame-ionization detection (HRGC/FID). The analysis can be further simplified by eliminating the clean-up step if HRGC/electron-impact mass-spectrometry (MS) is available. Both the FID and MS methods give results consistent with those obtained by standard procedures. The direct HRGC/MS procedure, combined with chemical ionization, can also be applied to the determination of polycyclic organic materials present in solvent-refined coal, shale oil and crude oil.     

Analysis of nitrated polycyclic aromatic hydrocarbons

Many nitrated polycyclic aromatic hydrocarbons (NPAH) that are present in low concentrations in the environment and in emission sources have been shown to be mutagenic and/or carcinogenic. This paper reviews the current methods of analysis of these compounds with the emphasis on NPAH measurements in ambient particulate matter samples.