废水中痕量酚的流动注射停流-催化光度法测定

基于在硫酸介质中痕量酚对溴酸钾氧化罗丹明B反应的催化作用,建立了测定痕量酚的快速、简便的流动注射流－催化光度分析的新方法。该方法的线性范围为0．60－4．00mg/L,检出限为0．1mg/L,进样频率为34／h。11次重得测定的相对标准偏差小于2．0％。该法用于废水中酚的测定,并与4－氨基安替比林比色法对照,结果满意。     

Spectrophotometric reaction rate method for determination of barbituric acid by inhibition of the hydrochloric acid-bromate reaction

A new kinetic-spectrophotometric method was developed for the determination of barbituric acid. The method is based on its inhibition effect on the reaction between hydrochloric acid and bromate. The decolorization of methyl orange by the reaction products was used to monitor the reaction spectrophotometrically at 510 nm. The variable affecting the rate of the reaction was investigated. The method is simple, rapid, relatively sensitive and precise. The limit of detection is 7.9x10(-7) M and calibration rang is 1x10(-6)-6.0x10(-4) M barbituric acid. The linearity range of the calibration graph is depends on bromate concentration. The relative standard deviation of seven replication determination of 5.6x10(-6) M barbituric acid was 1.8%. The influence of potential interfering substance was studied.     

流动注射催化动力学光度法测定碘离子

Based on catalysis of I- on the decolor reaction between potassium bromate and indigo carmine in the acid medium,and combined with flow injection analysis,a new flow-injection catalytic kinetic spectrophotometric method was found for determination of iodide in sample.The experimental results show that the determination is carried out at temperature of 80℃ and the concentration of H_2SO_4,KBrO_3,and indigo carmine is 1.2 mol/L,1.8×10~(-2) mol/L and 1.0×10~(-4) mol/L respectively,the linear range for the method is 0.50～1.8 mg/L.The detection limit is 0.0022 mg/L.The relative standard deviation is 1.92%.The proposed method was applied to the determination of iodide in troche successfully.The recovery was between 99.2% and 103.6%.     

KBrO3氧化甲基紫褪色动力学光度法测定食品中痕量钒

基于0.004 mol/L的柠檬酸介质中,痕量V(Ⅴ)催化KBrO3氧化甲基紫的褪色反应,建立了测定痕量V(Ⅴ)的动力学光度法。方法的检出限为1.23μg/L,线性范围为0～0.16μg/mL。讨论了酸度、反应物浓度、温度、反应时间、干扰离子等因素的影响,确定了该体系反应的最佳条件。在25 mL溶液中,测定2.0μg V(Ⅴ)的RSD为1.9%(n=11)。方法可用于测定小麦和苹果中的痕量V(Ⅴ),RSD为1.1%～2.7%,标准加入回收率为97.6%～99.0%。     

大体积进样–Ag柱除氯–离子色谱法测定水中溴酸盐

建立以大体积进样(250μL)–离子色谱测定水中溴酸盐(BrO_3~–)的方法。采用Ag柱离线去除样品中大量Cl~–以消除Cl~–干扰,同时保证痕量溴酸盐未沉淀,过滤后直接进样测定。BrO_3~–的质量浓度在2.0~25.0μg/L范围内与色谱峰面积呈良好的线性关系,线性相关系数r=0.999 2,方法检出限为0.8μg/L。自来水和矿泉水样品3浓度水平加标回收率为85.0%~101.0%,测定结果的相对标准偏差为3.6%~12.9%(n=6)。该方法样品处理简单,检出限低,准确度和精密度高,满足分析测试的要求。     

抑制型电导检测离子色谱法测定饮用水中的痕量溴酸盐

建立一种直接进样测定饮用水中痕量溴酸盐的电导检测离子色谱法。选用Metrosep A Supp 5阴离子交换分离柱,碳酸盐淋洗液。抑制型电导检测采用化学抑制器和CO2抑制器顺序双抑制系统。实验结果显示,溴酸根阴离子与常见共存阴离子完全分离,溴酸盐含量在5~100 μg/L范围内具有良好的线性(r=0.9999),精密度高(相对标准偏差（RSD）<4%),方法的检出限为0.50 μg/L,样品加标平均回收率为96.1%~107%。该方法操作简单,分离效果好,可与常见阴离子实现同时分析,灵敏度高,重现性好,可作为饮用水中溴酸盐的标准测定方法。     

Kinetic-spectrophotometric determination of ascorbic acid by inhibition of the hydrochloric acid-bromate reaction

A new analytical method was developed for the determination of ascorbic acid in fruit juice and pharmaceuticals. The method is based on its inhibition effect on the reaction between hydrochloric acid and bromate. The decolourisation of Methyl Orange by the reaction products was used to monitor the reaction spectrophotometrically at 510 nm. The linearity range of the calibration graph depends on bromate concentration. The variable affecting the rate of the reaction was investigated. The method is simple, rapid, relatively sensitive and precise. The limit of detection is 7.6 x 10(-6) M and calibration rang is 8 x 10(-6)-1.2 x 10(-3) M ascorbic acid. The relative standard deviation of seven replication determinations of 8 x 10(-6) and 2 x 10(-5) M ascorbic acid was 2.8 and 1.7%, respectively. The influence of potential interfering substance was studied. The method was successfully applied for the determination of ascorbic acid in pharmaceuticals.     

Simultaneous kinetic determination of phenols by use of the kalman filter

A multicomponent analysis method based on the Kalman filter algorithm is proposed for the determination of phenolic compounds. The method relies on the oxidative coupling of phenols (phenol, 2-chlorophenol and 3-chlorophenol) to N,N-diethyl-p-phenylenediamine in the presence of hexacyanoferrate(III), the reaction being monitored via changes in the absorbance at 660 nm of the dye formed. Phenols can be determined individually over the concentration range 1.25-25 muM with a relative standard deviation of ca 0.6-0.8%. Differences in the kinetic behaviour of the three species were exploited by using the linear Kalman filter to resolve mixtures of the phenols at the muM level in a widely variable concentration ratios with errors less than 10%.     

Bromide/bromate speciation by NTI-IDMS and ICP-MS coupled with ion exchange chromatography

 Two different mass spectrometric methods, negative thermal ionization isotope dilution mass spectrometry (NTI-IDMS) and inductively coupled plasma mass spectrometry (ICP-MS), off-line and on-line coupled with anion exchange chromatography, have been developed for simultaneous bromide and bromate determinations in water samples. The detection limits of these methods are in the range of 0.03–0.09 μg/L using a 50 mL sample.The results are independent of the content of other anions, which could be demonstrated by the analyses of six mineral waters containing chloride and sulfate of up to 160 mg/L and 1500 mg/L, respectively. Bromide has been analyzed by the NTI-IDMS method in the range of 10–500 μg/L and bromate in the range of 1–50 μg/L with relative standard deviations of 0.3–1.2% and 0.4–6%. Quantification for the ICP-MS method was carried out by the standard addition technique, which resulted in relative standard deviations of 5.5% for bromide at the 500 μg/L level and of 13% for bromate at the level of about 3 μg/L. These results are compared with those described in the literature for ion chromatographic (IC) and other methods and those obtained in this work by IC using UV detection, which allows high concentrations of chloride in the bromate fraction. The detection limits of this IC method are 6 μg/L for bromide and 30 μg/L for bromate. NTI-IDMS and ICP-MS therefore fit the recommendations of the European Union (detection limit<2.5 μg/L; precision and accuracy better than 25% at the 10 μg/L level) for methods analyzing the carcinogenic bromate much better than IC and other methods applied up to now. As a definitive but time consuming method, NTI-IDMS is preferably applicable as a calibration technique, whereas ICP-MS, with relatively short analysis times, due to on-line coupling with chromatography, can be used as a sensitive and powerful routine method for trace bromide and bromate species in water samples. Received: 5 July 1996/Accepted: 7 August 1996     

Bromate assay in water by inductively coupled plasma mass spectrometry combined with solid-phase extraction cartridges

Based on selective sorption of bromide, bromoacetic acids (BAA) and bromomethanes on solid-phase extraction (SPE) cartridges, a sensitive and convenient method was developed for the determination of bromate in waters by inductively coupled plasma mass spectrometry (ICP–MS). Dionex OnGuard Ag and reversed-phase (RP) cartridges were tested for retention characteristics for bromide, BAA and bromomethanes. When a sample acidified with nitric acid was passed through an RP cartridge, BAA and bromomethanes were retained, afterwards bromide was absorbed as a precipitate of silver bromide and bromate was unretained when the nearly neutral sample passed a combination of Ag and H cartridges. After SPE pretreatment the recovery of bromate was 96–106%, and bromide remaining in the aqueous phase was found to be less than 0.06 g L^–1 when the original bromide concentrations were less than 5 mg L^–1. Effectiveness of stacked Ag and H cartridges in removing bromide from chloride-containing samples was also examined. Common cations and other anions did not interfere with bromate determination. The detection limit for bromate is 57 ng L^–1. This method has been applied to analyse waters from various sources, and the recovery of the spiked bromate was in the range of 92–107%.