Palladium polyether diphosphinite complex anchored in polyethylene glycol as an efficient homogeneous recyclable catalyst for the Heck reactions

Palladium polyether diphosphinite complex anchored on polyethylene glycol is reported as an efficient catalyst for Heck coupling reactions. The catalyst is soluble in the solvent with reactants and products during reaction and can be separated from reaction media in biphasic form by the addition of anti-solvent like n-hexane and further recycled. The developed methodology offers mild reaction condition, short reaction time with an excellent recyclability of the catalyst. Aryl iodides as well as aryl bromides are well tolerated giving excellent yields.     

Recovery of Algal Oil from Marine Green Macro-algae Enteromorpha intestinalis by Acidic–Hydrothermal Process

In this study, the recovery of algal oil from Enteromorpha intestinalis based on an acidic–hydrothermal reaction was investigated. Overall, the algal oil yield after the acidic–hydrothermal reaction was increased under the conditions of high reaction temperature, high catalyst concentration, and long reaction time within the tested ranges. Significantly, catalyst concentration, compared with reaction temperature and time, less affected algal oil recovery. The optimal acidic–hydrothermal reaction conditions for production of algal oil from E. intestinalis were as follows—200 °C reaction temperature, 2.92 % catalyst concentration, 54 min reaction time. Under these conditions, an 18.6 % algal oil yield was obtained. By increasing the combined severity factor, the algae oil recovery yield linearly increased.     

Solvent-free synthesis of β-enamino ketones and esters catalysed by recyclable iron(III) triflate

A novel application of highly stable Fe(OTf)₃ as an efficient catalyst for the synthesis of a variety of β-enamino ketones and esters under solvent-free conditions is described. Notably, this protocol of a “green synthesis”, which produced β-enamino ketones and esters by the reaction of a variety of β-dicarbonyl compounds and primary amines, exhibits attractive properties including high yields, short reaction periods, lower loading of catalyst and chemo- and regio-selectivity. In addition, the catalyst was easily recovered from the reaction system and readily reused with minimal loss of activity.     

CuO nano-particles supported on silica,a new catalyst for facile synthesis of benzimidazoles,benzothiazoles and benzoxazoles

A facile synthetic route for benzimidazoles, benzothiazoles and benzoxazoles comprising the reaction of corresponding o-phenylenediamine, o-aminothiophenol and o-aminophenol with various aldehydes using silica supported nano-copper (II) oxide as a catalyst has been described. The catalyst exhibited a clean reaction profile with excellent yields in a short reaction time. The catalyst can be recycled effectively after use.     

An efficient and greener protocol towards synthesis of unsymmetrical N,N′-biphenyl urea

A simple and efficient route for the synthesis of Unsymmetrical N,N′-diphenyl urea have been developed in aqueous medium under base and catalyst free condition from corresponding substituted isocyanate and amines. The remarkable key feature of the reaction includes the use of water as an inexpensive and environmentally benign reaction medium, absence of base and any additional catalyst, and easy isolation of the product.     

Intramolecularly two-centered cooperation catalysis for the synthesis of cyclic carbonates from CO2 and epoxides

A catalyst system containing an electrophilic center and a sterically hindered nucleophilic center in one molecule was applied to the cycloaddition reaction of CO₂ and epoxides. This intramolecularly two-centered cooperation catalyst showed activity even at a high [epoxide]/[catalyst] ratio up to 50 000 under mild conditions such as solvent-free, ambient temperature, and low CO₂ pressure. The reaction of CO₂ with (S)-propylene oxide at 80 °C in the presence of the bifunctional catalyst gives (S)-propylene carbonate in 96% ee with retention of stereochemistry.     

Cascade synthesis of selective dihydro pyridazino fused acridinone derivatives via MCM-41 catalyzed ring-opening/ring-closure reaction

An enhanced one-pot synthesis of new functionalized 5,6-dihydro-5,5-dimethyl-2-phenyl-2H-pyridazino[3,4,5-kl]acridin-1(4H)-one derivatives with different substituted patterns by using mesoporous MCM-41 catalyst via a ring opening/ring closure reaction process has been established. This MCM-41 silica catalyst has been synthesized and characterized using an array of sophisticated analytical techniques like BET, XRD, UHRTEM, etc. This reaction could be conducted from inexpensive substrates within short period under neat reflux conditions. Compared with the usual methods, the remarkable advantages of this method are milder reaction conditions, operational simplicity, higher yields, short reaction times and an environmentally friendly procedure.     

Use of nanoporous Na+-montmorillonite sulfonic acid (SANM) as an eco-benign, efficient and reusable solid acid catalyst for the one-pot synthesis of 14-aryl-14-H-dibenzo[a,j]xanthenes and 1,8-dioxo-dodecahydroxanthene derivatives

Nanoporous Na⁺-montmorillonite sulfonic acid was found to be an efficient and green catalyst for the synthesis of various 14-aryl-14H-dibenzo[a,j]xanthenes and 1,8-dioxo-dodecahydroxanthene derivatives by the reaction of aldehydes with 2-naphthol and 1,3-cyclohexanedione, respectively. This novel synthetic method has the advantages of high yields, short reaction times and recyclability of the catalyst, simplicity and easy workup compared to the conventional methods reported in the literature.     

Transition metal catalyzed ring opening reactions of 2-phenyl-3-vinyl substituted 2H-azirines

Treatment of 2-phenyl-3-vinyl-substituted 2H-azirines with Grubbs' catalyst induces a clean rearrangement and affords products derived from carbon-nitrogen bond cleavage of the 2H-azirine ring. However, when the reaction was carried out using Wilkinson's catalyst in an alcoholic solvent, the only product obtained in high yield corresponded to an α,β-unsaturated oxime.     

N-sulfonic acid poly(4-vinylpyridinium) chloride: an efficient and reusable solid acid catalyst in N-Boc protection of amines

N-sulfonic acid poly(4-vinylpyridinium) chloride is easily prepared by the reaction of poly(4-vinylpyridine) with neat chlorosulfonic acid. This reagent can be used as an efficient catalyst for the N-Boc protection of amines at room temperature and neat conditions. This new method consistently has the advantages of excellent yields and short reaction times. Further, the catalyst can be reused and recovered for several times.     

Irreversible cleavage of a carbene-rhodium bond in Rh-N-heterocyclic carbene complexes: implications for catalysis

Despite the generally accepted belief that carbene-metal bonds are strong and do not dissociate, the reaction of Rh-N-heterocyclic carbene complexes with triphenylphosphine in dichloroethane was determined to take place via cleavage of the Rh-carbene bond. The products of this reaction are Wilkinson’s catalyst and a bisimidazolium salt derived from reaction between dichloroethane and two equivalents of the carbene. The implications of this reaction for catalysis are significant since the carbene complex shows lower activity than Wilkinson’s catalyst in hydrogenation reactions. In non-halogenated solvents, the catalyst shows higher stability, such that the rate of exchange with free phosphine could be measured, and was determined to be ca. 10 times slower than in Wilkinson’s catalyst.     

Synthesis of fully substituted pyrazolo[3,4-b]pyridine-5-carboxamide derivatives via a one-pot four-component reaction

A one-pot four-component reaction of an aliphatic or aromatic amine, diketene, an aromatic aldehyde and 1,3-diphenyl-1H-pyrazol-5-amine in the presence of p-toluenesulfonic acid as a catalyst has been developed. In this reaction, a new class of fully substituted pyrazolo[3,4-b]pyridine-5-carboxamide derivatives is produced under mild reaction conditions and in good yields at ambient temperature.     

Michael reaction of 1,3-dicarbonyls with enones catalyzed by a hydroxyapatite-bound La complex

A hydroxyapatite-bound La complex, which functioned as an efficient heterogeneous catalyst for the Michael reaction of 1,3-dicarbonyls with enones under aqueous or solvent-free conditions, was prepared using a cation-exchange method. Further application to an asymmetric version by a fluoroapatite-bound La complex catalyst modified with (R,R)-tartaric acid is also described.     

Efficient aldehyde olefination reactions catalyzed by an iron porphyrin complex in an ionic liquid

The commercially available complex Fe(TPP)Cl is an active and highly (E)-selective catalyst for the olefination of a variety of aldehydes in the presence of PPh₃ and diazoacetate in the ionic liquid (bmim)(PF₆). Dependent on the reactivity of the applied aldehyde, the reaction can be carried out at a reaction temperature of 50-80 °C. After 0.5-24 h quantitative olefin yields are reached with a broad variety of different aldehydes. Due to the application of an ionic liquid as reaction medium the products can be easily removed from the catalyst by a simple extraction and the catalyst is conveniently reusable without significant activity loss. Spectroscopic investigations indicate that the reaction mechanism includes the quantitative formation of a phosphorus ylide, which then reacts further in a Wittig reaction under formation of an olefin.     

Phosphine-catalyzed [4+2] cycloaddition of sulfamate-derived cyclic imines with allenoates: synthesis of sulfamate-fused tetrahydropyridines

Using n-PrPPh₂ as the nucleophilic catalyst, the [4+2] cycloaddition reaction of the sulfamate-derived cyclic imines with allenoates works efficiently to yield various sulfamate-fused tetrahydropyridines in high yields with excellent diastereoselectivities. Using amino acid-based bifunctional phosphine as chiral catalyst, an asymmetric [4+2] cycloaddition reaction was achieved, giving chiral sulfamate-fused tetrahydropyridines in high yields with good enantiomeric excesses.     

Catalytic degradation of polystyrene in the presence of active charcoal

To obtain useful products from polystyrene degradation waste, the catalytic degradation of polystyrene over an active charcoal catalyst was carried out. By controlling the reaction conditions, the selective recovery of styrene dimer derivatives, a promising sourse of useful industrial additives, was investigated. Cis- and trans-l,3-diphenyl-2-butene. 1,3-diphenyl-1-butene and 1,3-diphenylbutane were detected as the main products. The yield of styrene dimer derivatives was about 15 wt.% of the total liquid products recovered. Also. selective recovery of the styrene dimer derivatives by the catalytic reaction of polystyrene in the presence of a catalyst was possible by controlling the contact time and activity of the catalyst.     

Facile and rapid immobilization of copper(II) bis(oxazoline) catalysts on silica: application to Diels-Alder reactions, recycling, and unexpected effects on enantioselectivity

Two chiral copper(II) bis(oxazoline) complexes have been immobilized on silica via electrostatic interactions using a remarkably straightforward procedure. The immobilized catalysts were tested in a standard Diels-Alder reaction and gave surprising results. Where the immobilized Cu((S,S)-phenyl-box)(OTf)₂ catalyst was used, the predominant enantiomer formed was the opposite of that produced using the same catalyst in a homogeneous reaction. This is a startling result given that the only difference is the electrostatic immobilization of the catalyst on amorphous silica. The activity of the catalyst in a hetero Diels-Alder reaction was also tested. This catalyst was also recycled, successfully maintaining a similar activity to the homogeneous analogue through a number of cycles.     

Enantioselective aza-Friedel–Crafts reaction catalyzed by a water inclusion complex of O,O′-diacyl tartaric acid

The efficiency of an O,O′-diacyl tartaric acid derivative as a chiral Brønsted acid catalyst was investigated in the enantioselective Friedel–Crafts reaction of indoles with an α-imino ester. The inclusion of water in the O,O′-di-p-toluoyl-d-tartaric acid catalyst is crucial for obtaining the enantioselectivity, and under optimal conditions the corresponding Friedel–Crafts product was obtained with an enantioselectivity of up to 88% ee.     

An efficient and green synthesis of benzo[4,5]imidazo[1,2-a]pyrimidines using highly active and stable poly acrylic acid-supported layered double hydroxides

A facile and efficient method for the synthesis of benzo[4,5]imidazo[1,2-a]pyrimidines has been achieved via highly active and reusable heterogeneous poly acrylic acid-supported layered double hydroxides (PAA-g-LDHs) catalyst promoted one-pot reaction of 1H-benzo[d]imidazol-2-amine, with α,β-unsaturated carbonyl compounds under solvent-free conditions. PAA-g-LDHs catalyst was successfully synthesized via reversible addition-fragmentation chain-transfer polymerization using grafting reaction and was characterized by different analytical techniques. The significant features of this reaction include expedient one-pot process, short reaction time, excellent yields, wide substrate scope and operational simplicity. Also, the catalyst could be reused for several consecutive runs without any apparent loss in its catalytic activity.     

Nanocrystalline TiO2-HClO4:A novel,efficient and recyclable catalyst for the chemoselective N-Boc protection of amines under solvent-free conditions

Nanocrystalline TiO₂-HClO₄,as newly reported catalyst,has been used as an efficient and reusable catalyst for the chemoselective N-Boc protection of amines.The clean,mild acidity condition, quantitative yields of products,short reaction time and low reaction temperature are attractive features of this reaction.In practice,this method is a combination of a satisfactory synthesis and more significantly easy product isolation and purification.