A novel approach to facilitate excitation and readout processes of isolated negatively charged nitrogen‐vacancy (NV) centers is proposed. The approach is based on the concept of all‐dielectric nanoantennas. It is shown that the all‐dielectric nanoantenna can significantly enhance both the emission rate and emission extraction efficiency of a photoluminescence signal from a single NV center in a diamond nanoparticle on a dielectric substrate. The proposed approach provides high directivity, large Purcell factor, and efficient beam steering, thus allowing an efficient far‐field initialization and readout of several NV centers separated by subwavelength distances.
A semiconductor optical amplifier at 2.0‐µm wavelength is reported. This device is heterogeneously integrated by directly bonding an InP‐based active region to a silicon substrate. It is therefore compatible with low‐cost and high‐volume fabrication infrastructures, and can be efficiently coupled to other active and passive devices in a photonic integrated circuit. On‐chip gain larger than 13 dB is demonstrated at 20 °C, with a 3‐dB bandwidth of ∼75 nm centered at 2.01 µm. No saturation of the gain is observed for an on‐chip input power up to 0 dBm, and on‐chip gain is observed for temperatures up to at least 50 °C. This technology paves the way to chip‐level applications for optical communication, industrial or medical monitoring, and non‐linear optics.
Narrow‐linewidth lasers are key elements in optical metrology and spectroscopy. Spectral purity of these lasers determines accuracy of the measurements and quality of collected data. Solid state and fiber lasers are stabilized to relatively large and complex external optical cavities or narrow atomic and molecular transitions to improve their spectral purity. While this stabilization technique is rather generic, its complexity increases tremendously moving to longer wavelenghts, to the infrared (IR) range. Inherent increase of losses of optical materials at longer wavelengths hinders realization of compact, room temperature, high finesse IR cavities suitable for laser stabilization. In this paper, we report on demonstration of quantum cascade lasers stabilized to high‐Q crystalline mid‐IR microcavities. The lasers operating at room temperature in the 4.3‐4.6 μm region have a linewidth approaching 10 kHz and are promising for on‐chip mid‐IR and IR spectrometers.
Teleportation describes the transmission of information without transport of neither matter nor energy. For many years, however, it has been implicitly assumed that this scheme is of inherently nonlocal nature, and therefore exclusive to quantum systems. Here, we experimentally demonstrate that the concept of teleportation can be readily generalized beyond the quantum realm. We present an optical implementation of the teleportation protocol solely based on classical entanglement between spatial and modal degrees of freedom, entirely independent of nonlocality. Our findings could enable novel methods for distributing information between different transmission channels and may provide the means to leverage the advantages of both quantum and classical systems to create a robust hybrid communication infrastructure.
We demonstrate a scheme incorporating dual‐coupled microresonators through which mode interactions are intentionally introduced and controlled for Kerr frequency comb (microcomb) generation in the normal‐dispersion region. Microcomb generation, repetition rate selection, and mode locking are achieved with coupled silicon nitride microrings controlled via an on‐chip microheater. The proposed scheme shows for the first time a reliable design strategy for normal‐dispersion microcombs and may make it possible to generate microcombs in an extended wavelength range (e.g. in the visible) where normal material dispersion is likely to dominate.
Tailoring of electromagnetic spontaneous emission predicted by E. M. Purcell more than 50 years ago has undoubtedly proven to be one of the most important effects in the rich areas of quantum optics and nanophotonics. Although during the past decades the research in this field has been focused on electric dipole emission, the recent progress in nanofabrication and study of magnetic quantum emitters, such as rare‐earth ions, has stimulated the investigation of the magnetic side of spontaneous emission. Here, we review the state‐of‐the‐art advances in the field of spontaneous emission enhancement of magnetic dipole quantum emitters with the use of various nanophotonics systems. We provide the general theory describing the Purcell effect of magnetic emitters, overview realizations of specific nanophotonics structures allowing for the enhanced magnetic dipole spontaneous emission, and give an outlook on the challenges in this field, which remain open to future research.
We report complete spatial shaping (both phase and amplitude) of the second‐harmonic beam generated in a nonlinear photonic crystal. Using a collinear second‐order process in a nonlinear computer generated hologram imprinted on the crystal, the desired beam is generated on‐axis and in the near field. This enables compact and efficient one‐dimensional beam shaping in comparison to previously demonstrated off‐axis Fourier holograms. We experimentally demonstrate the second‐harmonic generation of high‐order Hermite–Gauss, top hats and arbitrary skyline‐shaped beams.
We investigate the fractional Schrödinger equation with a periodic ‐symmetric potential. In the inverse space, the problem transfers into a first‐order nonlocal frequency‐delay partial differential equation. We show that at a critical point, the band structure becomes linear and symmetric in the one‐dimensional case, which results in a nondiffracting propagation and conical diffraction of input beams. If only one channel in the periodic potential is excited, adjacent channels become uniformly excited along the propagation direction, which can be used to generate laser beams of high power and narrow width. In the two‐dimensional case, there appears conical diffraction that depends on the competition between the fractional Laplacian operator and the ‐symmetric potential. This investigation may find applications in novel on‐chip optical devices.
Wide‐angle, polarization‐independent structural reflective colors from both directions based on a one‐dimensional photonic crystal are demonstrated. Our device produces a distinct and saturated color with high angular tolerant performance up to ±70° for any polarization state of an incident light wave, which is highly desirable for a broad range of research areas. Moreover, the purity of the color and luminous intensity of the proposed device are improved as compared to conventional colorant‐based color filters and colloidal glasses. The present approach may have the potential to replace existing color filters and pigments and pave the way for various applications, including color displays and image sensor technologies.
Monocrystalline titanium dioxide (TiO2) micro‐spheres support two orthogonal magnetic dipole modes at terahertz (THz) frequencies due to strong dielectric anisotropy. For the first time, we experimentally detected the splitting of the first Mie mode in spheres of radii m through near‐field time‐domain THz spectroscopy. By fitting the Fano lineshape model to the experimentally obtained spectra of the electric field detected by the sub‐wavelength aperture probe, we found that the magnetic dipole resonances in TiO2 spheres have narrow linewidths of only tens of gigahertz. Anisotropic TiO2 micro‐resonators can be used to enhance the interplay of magnetic and electric dipole resonances in the emerging THz all‐dielectric metamaterial technology.
This work proves the feasibility of a novel concept of differential absorption lidar based on the Scheimpflug principle. The range‐resolved atmospheric backscattering signal of a laser beam is retrieved by employing a tilted linear sensor with a Newtonian telescope, satisfying the Scheimpflug condition. Infinite focus depth is achieved despite employing a large optical aperture. The concept is demonstrated by measuring the range‐resolved atmospheric oxygen concentration with a tunable continuous‐wave narrow‐band laser diode emitting around 761 nm over a path of one kilometer during night time. Laser power requirements for daytime operation are also investigated and validated with single‐band atmospheric aerosol measurements by employing a broad‐band 3.2‐W laser diode. The results presented in this work show the potential of employing the continuous‐wave differential absorption lidar (CW‐DIAL) technique for remote profiling of atmospheric gases in daytime if high‐power narrow‐band continuous‐wave light sources were to be employed.
Electromagnetic (EM) materials with perfect absorption have long been investigated for their important applications in many practical technologies. The trial‐and‐error method has been mostly employed to achieve this target, either by varying the constituent compositions for traditional natural material absorbers or by running computer simulations for general metamaterial (MM) absorbers. In this work, the authors propose a new method with analytical guidance to build omnidirectional perfect absorbers inspired by the recently proposed spatial Kramers‐Kronig (KK) nonreflecting dielectric profile. The subtle combination of the spatial and time dispersions in the metamaterial‐engineered KK profile gives the desired broadband response property. More importantly, these features remain invariant when the sample is uniformly compressed or stretched with large thickness change, i.e., this particular broadband absorber is deformable, which has been firstly reported in the literature. The current results will pave a new way to design high‐efficiency EM absorbers that could also be extended in general to manipulate waves for other fields or applications.
Whispering gallery modes (WGMs) have been exploited for a broad range of sensing applications. However, the vast majority of WGM sensors consist of passive resonators, requiring complex interrogation systems to be employed, ultimately limiting their practicality. Active resonators containing a gain medium, allowing remote excitation and collection of the WGM‐modulated fluorescence spectra, have emerged as an alternative to passive resonators. Although research is still in its infancy, recent progress has reduced the performance gap between the two paradigms, fueled by the potential for new applications that could not previously be realized. Here, recent developments in sensors based on active WGM microresonators are reviewed, beginning with a discussion of the theory of fluorescence‐based and lasing WGMs, followed by a discussion of the variety of gain media, resonator architectures, and emerging sensing applications. We conclude with a discussion of the prospects and future directions for improving active WGM sensors.
High performance semiconductor lasers on silicon are critical elements of next generation photonic integrated circuits. Transfer printing methods provide promising paths to achieve hybrid integration of III‐V devices on Si platforms. This paper presents materials and procedures for epitaxially releasing thin‐film microscale GaAs based lasers after their full fabrication on GaAs native substrates, and for subsequently transfer printing arrays of them onto Si wafers. An indium‐silver based alloy serves as a thermally conductive bonding interface between the lasers and the Si, for enhanced performance. Numerical calculations provide comparative insights into thermal properties for devices with metallic, organic and semiconductor interfaces. Under current injection, the first of these three interfaces provides, by far, the lowest operating temperatures. Such devices exhibit continuous‐wave lasing in the near‐infrared range under electrical pumping, with performance comparable to unreleased devices on their native substrates.
Microresonator‐based Kerr frequency comb (microcomb) generation can potentially revolutionize a variety of applications ranging from telecommunications to optical frequency synthesis. However, phase‐locked microcombs have generally had low conversion efficiency limited to a few percent. Here we report experimental results that achieve conversion efficiency ( on‐chip comb power excluding the pump) in the fiber telecommunication band with broadband mode‐locked dark‐pulse combs. We present a general analysis on the efficiency which is applicable to any phase‐locked microcomb state. The effective coupling condition for the pump as well as the duty cycle of localized time‐domain structures play a key role in determining the conversion efficiency. Our observation of high efficiency comb states is relevant for applications such as optical communications which require high power per comb line.
Nanostructures that feature nonreciprocal light transmission are highly desirable building blocks for realizing photonic integrated circuits. Here, a simple and ultracompact photonic‐crystal structure, where a waveguide is coupled to a single nanocavity, is proposed and experimentally demonstrated, showing very efficient optical diode functionality. The key novelty of the structure is the use of cavity‐enhanced material nonlinearities in combination with spatial symmetry breaking and a Fano resonance to realize nonreciprocal propagation effects at ultralow power and with good wavelength tunability. The nonlinearity of the device relies on ultrafast carrier dynamics, rather than the thermal effects usually considered, allowing the demonstration of nonreciprocal operation at a bit‐rate of 10 Gbit s−1 with a low energy consumption of 4.5 fJ bit−1.
A compact 64‐channel hybrid demultiplexer based on silicon‐on‐insulator nanowires is proposed and demonstrated experimentally to enable wavelength‐division‐multiplexing and mode‐division‐multiplexing simultaneously in order to realize an ultra‐large capacity on‐chip optical‐interconnect link. The present hybrid demultiplexer consists of a 4‐channel mode multiplexer constructed with cascaded asymmetrical directional‐couplers and two bi‐directional 17 × 17 arrayed‐waveguide gratings (AWGs) with 16 channels. Here each bi‐directional AWG is equivalent as two identical 1 × 16 AWGs. The measured excess loss and the crosstalk for the monolithically integrated 64‐channel hybrid demultiplexer are about ‐5 dB and ‐14 dB, respectively. Better performance can be achieved by minimizing the imperfections (particularly in AWGs) during the fabrication processes.
In the development of microfluidic chips, conventional 2D processing technologies contribute to the manufacturing of basic microchannel networks. Nevertheless, in the pursuit of versatile microfluidic chips, flexible integration of multifunctional components within a tiny chip is still challenging because a chip containing micro‐channels is a non‐flat substrate. Recently, on‐chip laser processing (OCLP) technology has emerged as an appealing alternative to achieve chip functionalization through in situ fabrication of 3D microstructures. Here, the recent development of OCLP‐enabled multifunctional microfluidic chips, including several accessible photochemical/photophysical schemes, and photosensitive materials permiting OCLP, is reviewed. To demonstrate the capability of OCLP technology, a series of typical micro‐components fabricated using OCLP are introduced. The prospects and current challenges of this field are discussed.
The recent progress in integrated quantum optics has set the stage for the development of an integrated platform for quantum information processing with photons, with potential applications in quantum simulation. Among the different material platforms being investigated, direct‐bandgap semiconductors and particularly gallium arsenide (GaAs) offer the widest range of functionalities, including single‐ and entangled‐photon generation by radiative recombination, low‐loss routing, electro‐optic modulation and single‐photon detection. This paper reviews the recent progress in the development of the key building blocks for GaAs quantum photonics and the perspectives for their full integration in a fully‐functional and densely integrated quantum photonic circuit.
