首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到17条相似文献,搜索用时 46 毫秒
1.
An efficient and high-power diode-laser single-end-pumped Nd:YVO4 laser with cw emission at 1342nm is presented. With a crystal single-end-pumped by a fibre-coupled diode laser, an output power of 7.36 W is obtained from the laser cavity of concave-convex, eorresponding to an optical-to-optical conversion efficiency of 32.8%. The laser is operated in TEM00 mode with small rms noise amplitude of 0.3%. This represents, to the best of our knowledge, the highest power obtained from a diode-laser single-end-pumped Nd:YVO4 cw laser at 1342nm 80 far.  相似文献   

2.
We present a high power and efficient operation of the ^4F3/2 → ^4I9/2 transition in Nd:GdVO4 at 912nm. In the cw mode, the maximum output power of 8.6 W is achieved when the incident pump power is 40.3 W, leading to a slope efficiency of 33.3% and an optical-optical efficiency of 21.3%. To the best of our knowledge, this is the highest cw laser power at 912nm obtained with the conventional Nd:GdVO4 crystal. Pulsed operation of 912nm laser has also been realized by inserting a small aeousto-optie (A-O) Q-Switch inside the resonator. As a result, the minimal pulse width of 20ns and the average laser power 1.43 W at the repetition rate of lOkHz are obtained, corresponding to 7.1 kW peak power. We believe that this is the highest laser peak power at 912nm. Furthermore, duration of 65ns has also been acquired when the repetition rate is 100 kHz.  相似文献   

3.
A high-power cw end-pumped laser device is demonstrated with a slab crystal of Nd:GdVO4 operating at 1063nm. Diode laser stacks at 880nm are used to pump Nd:GdVO4 into emitting level 4^F3/2. The 149 W output power is presented when the absorbed pump power is 390 W and the optical-to-optieal conversion efficiency is 38.2%. When the output power is 120 W, the M^2 factors are 2.3 in both directions. Additionally, mode overlap inside the resonator is analyzed to explain the beam quality deterioration.  相似文献   

4.
We report a high-power high-efficient continuous-wave (cw) diode-end-pumped Nd:YVO4 1342-nm laser with a short plane-parallel cavity and an efficient cw intracavity frequency-doubled red laser at 671 nm with a compact three-element cavity. At incident pump power of 20.6 W, a maximum output power of 7 W at 1342 nm is obtained with a slope effciency of 37.3%. By inserting a type-Ⅰ critical phase-matched LBO crystal as intracavity frequencydoubler, a cw red output as much as 2.85-W is achieved with an incident pump power of 16.9 W, inducing an optical-to-optical conversion efficiency of 16.9%. To the best of our knowledge, this is the highest output of diodepumped solid-state Nd:YVO4 red laser. During half an hour, the red output is very stable, and the instability of output power is less than 1%.  相似文献   

5.
A maximum of 9.9 W cw TEM00 output at 532nm laser has been obtained by intracavity frequency doubling with LBO in laser-diode single-end-pumped Nd:YVO4. The Nd:YVO4/LBO green laser has a simple threemirror V-fold cavity structure. The optical-optical conversion efficiency was 34.8%. Based on the equation of thermal conduction, a general solution for the laser-crystal interior temperature distribution is obtained by the semi-analytical thermal analysis method. Using the software system, the cavity parameters have been optimized according to the stability condition and the astigmatic compensation principle. The astigmatism in the cavity has been effectively controlled and the resonator was insensitive to the thermal lens in the Nd:YVO4 crystal.  相似文献   

6.
We investigate a high-energy good-beam-quality krypton-lamp-pumped pulsed Nd: YA G solid-state laser with one pump cavity. The symmetrical resonator laser is developed and is rated at 80 J with beam parameter product 12mm mrad. The total system electro-optics efficiency of the lamp-pumped YAG laser is as high as 3.3% and the stability of output energy is ±2% with pulse width tunable between 0.1 ms and 10ms. The experimental results are consistent with the theoretical analysis and simulation.  相似文献   

7.
8.
A high efficiency, high power diode-side-pumped quasi continuous wave (QCW) Nd:YAG ceramic rod laser at 1064 nm based on the domestic transparent ceramic is reported. The average output power of 961 W is achieved with double ceramic rods by means of a symmetrical convex-convex cavity. The optical-to-optical conversion efficiency is 38.3% and the slope efficiency is 45.3%. To the best of our knowledge, this is the highest level of efficiency achieved for the domestic Nd:YAG ceramic rod laser.  相似文献   

9.
DUAN Xiao-Ming, YAO Bao-Quan, ZHANG Yun-Jun, SONG Cheng-Wei, GAO Jing, JU You-Lun, WANG Yue-Zhu( National Key Laboratory of Tunable Laser Technology, Harbin Institute of Technology, Harbin 150001)  相似文献   

10.
We present the design and experimental results for a diode pumped Nd:YLF regenerative amplifier applied to amplify a nanosecond laser pulse. Numerical simulation shows that the maximum output energy and the best stability can be obtained when the regenerative amplifier operates in a saturated mode for all pulse duration and temporal profiles. Using extra post-pulse is a good method to decrease the square-pulse distortion caused by gain saturation effect. The amplifier shows output energy of 4.2mJ with a total energy gain of more than 10^7 and output energy stability of better than 1% rms. When extra post-pulse is added, square-pulse distortion is decreased from 1.33 to 1.17 for the amplifier that is seeded with an optical pulse of 3ns.  相似文献   

11.
We report a high-effciency Nd:YAG laser operating at 1064 nm and 1319nm, respectively, thermally boosted pumped by an all-solid-state Q-switched Ti:sapphire laser at 885 nm. The maximum outputs of 825.4 m W and 459.4mW, at 1064nm and 1319nm respectively, are obtained in a 8-ram-thick 1.1 at.% Nd:YAG crystal with 2.1 W of incident pump power at 885nm, leading to a high slope efficiency with respect to the absorbed pump power of 68.5% and 42.0%. Comparative results obtained by the traditional pumping at 808nm are presented, showing that the slope efficiency and the threshold with respect to the absorbed pump power at 1064nm under the 885nm pumping are 12.2% higher and 7.3% lower than those of 808rim pumping. At 1319nm, the slope efficiency and the threshold with respect to the absorbed pump power under 885nm pumping are 9.9% higher and 3.5% lower than those of 808 nm pumping. The heat generation operating at 1064 nm and 1319 nm is reduced by 19.8% and 11.1%, respectively.  相似文献   

12.
We report on a diode-laser-pumped cw Nd: YAG laser operating at a power level of 150 W. By using a transverse pump geometry, the radiation of 54 diode lasers with an output power of 10 W each is coupled into a Nd:YAG rod. In multimode operation, an optical slope efficiency of 32% and an optical to optical efficiency of 29% are obtained. In TEM00 operation, an output power of more than 30 W is realized with an optical to optical efficiency of 10%.  相似文献   

13.
A cw diode side-pumped Nd:YAO laser is frequency doubled to 532nm with an intracavity KTP crystal in a Vshaped arrangement, achieving an output power of 40 W corresponding to an optical-optical conversion efficiency of 9.7%. The instabilities and the M2-parameters of the laser are measured at different output powers after the beam is filtered.  相似文献   

14.
We investigated the energetic and thermal performance of a diode-side-pumped Nd:YAG rod laser with up to 50 W power deposited as excess heat into a 3-mm-diameter, 10-cm-length rod. The rod design produces an extremely flat gain profile resulting in “textbook” expressions of thermal lensing and birefringence. Thermal and energetic measurements are compared to corresponding “textbook” theoretical expressions. Discrepancies between various published thermo-mechanical YAG parameters are resolved by a self-consistent set of measured and calculated data for rod thermal lens focal lengths, birefringence depolarization and ratio of heat to stored energy (χ). Measured thermal and energetic performance under lasing and nonlasing conditions are presented, which agree with published theoretical expressions and measurements. Compensation of rod thermal lensing with simple spherical concave lenses is demonstrated. In addition various methods for compensating birefringence depolarization are theoretically and experimentally analyzed and compared. Received: 19 July 1999 / Revised version: 22 October 1999 / Published online: 23 February 2000  相似文献   

15.
A novel method is developed to obtain 1.05μm laser operation with a Yb:YAG laser. By using a Yb:YAG crystal with proper length and doping concentration, a femtosecond Yb: YAG laser is realized at the central wavelength of 1053nm. The measured pulse duration and spectral bandwidth (FWHM) are 170fs and 7nm; the repetition rate is 80 MHz. Under a power pump of 2 W, an average mode-locking power of 180mW is achieved.  相似文献   

16.
An efficient continuous-wave (CW) simultaneous dual-wavelength lasing (SDWL) of an LD end-pumped Nd:YAG laser utilizing a quasi-three-level transition at 946 nm and a four-level transition at 1064 nm is reported. A theoretical model has been introduced to determine the threshold conditions for SDWL. The temperature distributions of a Nd:YAG crystal under different pump powers have been analyzed. In the experiments, a CW SDWL output power of 5.12 W at a temperature of 273 K has been achieved with a pump power of 17 W, giving a slope efficiency of 16.36%.  相似文献   

17.
We have demonstrated a highly efficient, high average output power laser based on the optimized resonator made up of multiple Nd:YAG rods. The laser consists of three groups, each of which contains two rods with one quartz 90° rotator between them. By a desirable design of the resonator, the average output power of 1906W at 1064nm is reached with repetition rate of 1.1kHz. The optical to optical conversion efficiency is up to 50.8% with the pulse width 224μs and it is the highest conversion efficiency of six rods resonator.  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号