Prediction of the reverberation time in high absorbent room using a modified-diffusion model

A modification of the diffusion model’s boundary condition, based on the Eyring absorption coefficient, to account for high walls absorption is proposed. Numerical comparisons are carried out for three geometrical configurations (a proportionate room, a corridor and a flat enclosure). Comparisons with the statistical theory and a ray-tracing software show that the modified boundary condition increases the accuracy of the diffusion model in term of reverberation time in all the simulated configurations. An experimental comparison in the case of a non-uniformly absorbent room (a reverberation chamber covered with patches of glass wool) is also carried out. The modified-diffusion model results match well with the ray-tracing ones. Both models are in agreement with the experimental data for most of third octave bands (discrepancy close to or below 10%). However, some discrepancies up to 40% can also be observed in a few octave bands, probably due to experimental considerations and to the modal behaviour of the room at low frequencies.     

A hybrid model for the acoustic response of a two-dimensional rough surface to an impulse incident from a refracting medium

A numerical model to calculate the impulse response of a two-dimensional, impenetrable, rough surface directly in the time domain has been recently introduced [J. Acoust. Soc. Am. (2000) 107, 27]. This model is based on wedge diffraction theory and assumes that the half-space containing the source and receiver is homogeneous. In this work, the model is extended to handle media where the index of refraction varies with the distance to the surface by merging the scattering model with a ray-based propagation model. The resulting hybrid model is tested against a Finite-Difference Time-Domain (FDTD) method for the problem of backscattering from a corrugated surface in the presence of a refractive layer. This new model can be applied, for example, to calculate acoustic reverberation from the sea surface in cases where the water mass is inhomogeneous and in the presence of a subsurface bubble layer at low frequencies where dispersion is negligible. It can also be used for atmospheric propagation problems where there is a sound speed gradient overlying rough terrain.     

Effect of carrier transit time on the bandwidth of traveling-wave photodetector

We present an impulse response of traveling-wave photodetector considering the photo-excited carrier transit time as well as the velocity mismatch between lightwave and microwave. The transit time effect on the bandwidth is found to be more significant than the velocity mismatch effect, if the thickness of the intrinsic absorption region is over 0.2μm. The effect of the intrinsic absorption region thickness is also examined. The optimal thickness of the intrinsic absorption region is determined considering the transit time, the optical confinement factor, and the velocity mismatch.     

Effect of ambient noise on the vocal output and the preferred listening level of conversational speech

The effect of ambient noise on vocal output and the preferred listening level of conversational speech was investigated under conditions typical of everyday speech communication. For a speaker-listener distance of 1 m, vocal output and the preferred listening level in quiet were both about 50 dB(A). Deviations from this value were observed when the noise level exceeded a level of about 40 dB(A). The regression lines for the data points above this level showed a 3 dB rise for a 10 dB rise in noise level. The experiments further suggest that both speaker and listener (when the latter is able to control the playback level of recorded speech) try to compensate for the noise interference by raising the level of speech in order to keep the (subjective) loudness of speech in noise equal to the loudness of speech in quiet.     

Perceptual validation of virtual room acoustics: Sound localisation and speech understanding

The reliability of algorithms for room acoustic simulations has often been confirmed on the basis of the verification of predicted room acoustical parameters. This paper presents a complementary perceptual validation procedure consisting of two experiments, respectively dealing with speech intelligibility, and with sound source front–back localisation.The evaluated simulation algorithm, implemented in software ODEON®, is a hybrid method that is based on an image source algorithm for the prediction of early sound reflection and on ray-tracing for the later part, using a stochastic scattering process with secondary sources. The binaural room impulse response (BRIR) is calculated from a simulated room impulse response where information about the arriving time, intensity and spatial direction of each sound reflection is collected and convolved with a measured Head Related Transfer Function (HRTF). The listening stimuli for the speech intelligibility and localisation tests are auralised convolutions of anechoic sound samples with measured and simulated BRIRs.Perception tests were performed with human subjects in two acoustical environments, i.e. an anechoic and reverberant room, by presenting the stimuli to subjects in a natural way, and via headphones by using two non-individualized HRTFs (artificial head and hearing aids placed on the ears of the artificial head) of both a simulated and a real room.Very good correspondence is found between the results obtained with simulated and measured BRIRs, both for speech intelligibility in the presence of noise and for sound source localisation tests. In the anechoic room an increase in speech intelligibility is observed when noise and signal are presented from sources located at different angles. This improvement is not so evident in the reverberant room, with the sound sources at 1-m distance from the listener. Interestingly, the performance of people for front–back localisation is better in the reverberant room than in the anechoic room.The correlation between people’s ability for sound source localisation on one hand, and their ability for recognition of binaurally received speech in reverberation on the other hand, is found to be weak.     

Statistical comparison of reverberation times measured by the integrated impulse response and interrupted noise methods, computationally simulated with ODEON software, and calculated by Sabine, Eyring and Arau-Puchades’ formulas

This paper evaluates several procedures to determine the reverberation time, RT, in a classroom. These procedures are: (1) measurement by the integrated impulse response method, (2) measurement by the interrupted noise method, (3) computer simulation using ODEON Version 9.0 software, and (4) calculations using the Sabine, Eyring, and Arau-Puchades formulas. The resulting data are analyzed statistically to verify their similarity. No statistical difference was found between the values obtained by the two measuring methods. The computer simulation produced accurate data. The best formula for calculating RT in the classroom in question is Eyring’s formula.     

Effect of secondary decay on isoscaling: Results from the canonical thermodynamical model

The projectile fragmentation reactions using ⁵⁸Ni and ⁶⁴Ni beams at 140 MeV/n on targets ⁹Be and ¹⁸¹Ta are studied using the canonical thermodynamical model coupled with an evaporation code. The isoscaling property of the fragments produced is studied using both the primary and the secondary fragments and it is observed that the secondary fragments also respect isoscaling though the isoscaling parameters α and β changes. The temperature needed to reproduce experimental data with the secondary fragments is less than that needed with the primary ones. The canonical model coupled with the evaporation code successfully explains the experimental data for isoscaling for the projectile fragmentation reactions.     

Physiological responses to the pulsation threshold paradigm. I: Pulsation threshold patterns do not reproduce physiological rate profiles of high-pass and low-pass noise maskers

This article compares psychophysical measures of human processing of acoustic stimuli with one neurophysiological representation (normalized discharge rate profiles) of those stimuli. Psychophysical pulsation threshold patterns (PTPs) were derived for high-pass and low-pass noise maskers. Spectral features of both maskers are clearly evident in the PTPs. However, while the representation of high-pass noise in the PTPs becomes sharper with increasing masker level, the representation of low-pass noise degenerates as masker level is increased. One assumption that has been used previously to interpret pulsation threshold data is that PTPs reflect the profile of activity in primary neural elements in response to the masking stimulus. To investigate this hypothesis, normalized-rate profiles of responses to both maskers were derived from populations of auditory-nerve fibers in cats. Normalized-rate profiles do not exhibit the same behavior as PTPs for high-pass noise maskers in that the neural representation of the band edge degenerates as sound level increases. Furthermore, the distinction between the passband and the stop band is lost in the neural rate profiles, whereas the distinction improves in the high-pass noise PTPs.     

The Effect of Reloading on Disuse Muscle Atrophy: Time Course of Hypertrophy and Regeneration Focusing on the Myofiber Cross-sectional Area and Myonuclear Change

The purpose of this study was to investigate the effect of reloading on atrophied muscle and the time course of hypertrophy and regeneration. Forty-nine male Wistar rats were randomly assigned to groups for hindlimb suspension (HS), hindlimb suspension and reloading (R), or control (C0). Rats in the HS group were suspended for 14 days. Rats in the R group were randomly divided into five subgroups for different post-hindlimb-suspension recovery times. Briefly, each subgroup was suspended for 14 days and given 1 day of reloading (R1), 3 days of reloading (R3), 7 days of reloading (R7), 10 days of reloading (R10), or 14 days of reloading (R14). Myonuclear numbers were significantly decreased in the groups with hindlimb suspension and 1 day and 3 days of reloading compared with that in the control group. We focused on the processes of change of mean myofiber cross-sectional area and myonuclear domain size; the degrees of increase of both indexes were limited until 3 days of reloading, and significantly increased after 7 days of reloading. An important finding of the current study was that the processes of muscle hypertrophy and regeneration did not show uniform change. In addition, there were differences in the ratio of increase among the stages of hypertrophy and regeneration. Therefore, consideration of the duration and method of physiotherapeutic intervention for atrophied muscle on the basis of the process of hypertrophy and regeneration is needed to provide more effective physiotherapy.     

Parameter motivated mutual correlation analysis: Application to the study of currency exchange rates based on intermittency parameter and Hurst exponent

We present a novel method for the parameter oriented analysis of mutual correlation between independent time series or between equivalent structures such as ordered data sets. The proposed method is based on the sliding window technique, defines a new type of correlation measure and can be applied to time series from all domains of science and technology, experimental or simulated. A specific parameter that can characterize the time series is computed for each window and a cross correlation analysis is carried out on the set of values obtained for the time series under investigation. We apply this method to the study of some currency daily exchange rates from the point of view of the Hurst exponent and the intermittency parameter. Interesting correlation relationships are revealed and a tentative crisis prediction is presented.