Effects of molecular weight,rubber toughening,and environment on fatigue crack propagation behavior of block amide copolymers

The Fatigue Crack Propagation (FCP) behavior of block amide copolymers is investigated as a function of molecular weight, rubber toughening as well as environmental conditions. The enhancement of FCP resistance with increasing average molecular weight is shown and correlated to features observed on the fracture surface. Particular attention is paid to hysteretic heating, measured with an infrared camera, in the crack tip zone of different average molecular weight copolymers and rubber-toughened copolymer. A FCP approach of stress-cracking in an aqueous solution of zinc chloride is proposed here. An improvement in FCP resistance as the average molecular weight increases, similar to that exhibited in normal environment, appears. The shift in da/dN values over the tested range of can be approximated by an exponential function:      

Living cationic polymerization of 2-chloroethyl vinyl ether: Kinetics,mechanism and application to polymer synthesis

The cationic polymerization of 2-chloroethyl vinyl ether initiated by HI/weak Lewis acid (I₂ or ZnI₂) systems has been studied from both a kinetic-mechanistic and a synthetic viewpoint. At low temperature and in toluene as solvent, the polymerization proceeds via a living process and the kinetic order with respect to monomer varies according to the nature of the Lewis acid activator. This behaviour can be explained by the coordination of the Lewis acid with both the monomer and the chain-end, the latter leading to a strong activation of the -I bond towards monomer insertion. The living polymerization obtained from divinylether precursors leads to -I ended telechelics, and their transformation into dihydroxytelechelic oligomers has been performed. The chemical modification of chloroalkyl side groups by phase transfer catalysis allows the attachment of specific groups without consumption of-OH ends.     

Synthesis and properties of polyamides containing imidazoline rings

The novel polyamide containing an imidazoline ring(PAI) was synthesized by a two-stage melt polymerization of dimethyl terephthalate (DMT) with diethylenetriamine (DETA) or triethylenetetramine (TETA). The heat resistance of PAI was superior to that of polyamide which was synthesized only in the first-stage reaction and didn't contain imidazoline ring. Their chemical structures were identified by infrared spectroscopy and NMR. The optimum condition for production was studied by varying several reaction factors, including the contents of H₂O and H₃PO₄, the reaction temperature and the reaction time at second-stage reaction under vacuum. According to study of the characteristics of solution behavior of PAI, both the viscosity and the degree of cyclization could be described by equation of in m-cresol at 30°C.     

Step‐Growth Radical Addition‐Coupling Polymerization (RACP) for Synthesis of Alternating Copolymers

We report a new type of step‐growth radical addition‐coupling polymerization (RACP) involving consecutive addition of carbon‐centered radical derived from α,α′‐dibromo dibasic ester to NO double bond of C‐nitroso compound followed by cross‐coupling of carbon‐centered radical and in situ formed nitroxyl radical, which produces alternating copolymers with high molecular weight and unimodal molecular weight distribution from saturated and unsaturated monomers.

     

Oxazolidines versus schiff bases

The formation of oxazolidines from propionaldehyde and aliphatic β-aminoalcohols is complicated by the appearance of appreciable amounts of unsaturated Schiff bases. The simple Schiff base, often the dominant species when aromatic aldehydes react with amines, could not be detected in the present aliphatic systems. We conclude that in aliphatic systems the order of stability is and . The gem-dimethyl group α to nitrogen stablizes the heterocyclic ring remarkably.     

Synthesis and psychotropic properties of furyl- and thienyl-germatranes

Trihalogermyl-furans and -thiophenes were prepared by inserting germanium dibromide (GeBr₂) generated from the dibromogermane(II) dioxanate complex into the carbon-halogen bond of halo-furans and -thiophenes. Their ethanolysis and transesterification by triethanolamine yielded the germatranes which were subjected to psychotropic activity assays. The psychotropic properties of germatranes were found to depend on the type of the heterocycle and on the position of the germatrane moiety.     

Eine neue einfache Methode zur Entalkylierung von Phosphon- und Phosphinsäureestern

A New Facile Method for the Dealkylation of Phosphonic and Phosphinic Acid Esters The synthesis of phosphonic and phosphinic acid esters of the type is realized by reaction of dialkylphosphonates and O-alkylphosphinates with chlorotrimethylsilane in the presence of catalytical amounts of NH₄Cl and hexamethyldisilazane (HMDZ).     

Zur Darstellung von Cyclophosphaten,Cyclophosphatophosphonaten, Diphosphonaten und Diphosphiten in Harnstoffschmelzen

Preparation of Cyclophosphates, Cyclophosphatophosphonates, Diphosphonates, and Di-phosphites in Urea Melts Ammonium cyclotriphosphate (NH₄)P₃O₉, ammonium cyclotetraphosphate [P^IV? P^IV ? O? ]₂, ammonium cyclotriphosphatophosphonates Ammonium organyldiphosphonates And ammonium diphosphites are prepared in high yields on heating acidic phosphates, phosphonates, and phosphites in urea or urea/ammonium nitrate melts. The mechanism of the dehydration of phosphorus compounds containing POH groups in molten urea is discussed.     

Electron impact studies. CVII—Negative ion mass spectra of the oxime group. Monoximes derived from α-dicarbonyl systems

Specific losses of water are observed from the molecular anions of monoximes of α-diketones. Labelling studies, kinetic energy release values and the +E spectra of ions have been used to aid in the elucidation of the fragmentation pathways. It is proposed that the majority of ions have α-keto nitrile structures.     

Le Spectre de L'Alcool Propargylique en Fonction du pH. Un Exemple de Transferts Protoniques Complexes sur un Diacide Organique

Dimethyl sulphoxide (DMSO) is used as a solvent to investigate the kinetic acidity of very weak organic diacids by ¹H d.n.m.r. An inspection of the spectrum of propargyl alcohol as a function of the pH allows the assignment of various proton transfer mechanisms:      

Fabrication of Compositional‐Gradient Biodegradable Polymeric Films Showing Self‐Bending Deformation

A compositional graded film of poly(ε‐caprolactone) (PCL) with 4,4′‐thiodiphenol (TDP), in the film thickness direction, was fabricated by self‐diffusing of TDP in the PCL melt. We found out the self‐bending deformation of the gradient film, which bent into a rolled‐up shape by itself. The initial shape of the film was flat when the sample was quenched from the melt. Upon the fast crystallization of PCL, the gradient film bent to the side with low TDP content. Then, after PCL crystallized the film bent to the opposite direction, that is, to the side with high TDP content. This bending to the TDP rich region was induced by not only the crystallization of PCL but also mass transfer due to the diffusion of TDP from TDP rich region to poor region.

     

Interfaces between coexisting phases in polymer mixtures: What can we learn from Monte Carlo simulations?

Symmetric binary polymer mixtures are studied by Monte Carlo simulation of the bond fluctuation model, considering both interfaces between coexisting bulk phases and interfaces confined in thin films. It is found that the critical behavior of interfacial tension and width is compatible with that of the Ising model, as expected from the universality principle. In the strong segregation limit, only qualitative but not quantitative agreement with the self-consistent field (SCF) theory is found. It is argued that the SCF theory requires but for the short chains studied (N = 32 effective monomer units per chain), the limit is only reached for close to unity. Also, the effective χ-parameter decreases in the interface. It is shown that the interfacial width w does not increase by the adsorption of block copolymers as long as their areal density is still dilute (“mushroom” regime). But a broadening of interfaces does occur for thin films confined between walls at distance D, due to fluctuations that lead to for short-range forces, in agreement with experiment.     

An efficient and facile microwave‐assisted synthesis of benzo[b][4,7]phenanthroline derivatives in water

A series of benzo[b][4,7]phenanthroline derivatives were synthesized via a three‐component reaction of aromatic aldehydes, 6‐aminoquinoline and either 1,3‐cyclohexanedione or dimedone in water under microwave irradiation without use of any catalyst. This method has the advantages of short reaction time, high yields, low cost and environmental friendliness as well as easy operation.     

Synthesis of titanium polyesters

Titanium polyesters of the form where Cp denotes cyclopentadiene, have been synthesized by utilizing both the interfacial and solution techniques. Polymer yield increases with reaction time. The reactive titanium reactant in the solution polycondensations is believed to be the Cp₂Ti⁺² cation.     

Salt effects in the base-catalyzed polymerization of unsaturated amide compounds. II. Polymerization of p-vinylbenzamide and acrylamide

In the presence of a variety of inorganic salts, p-vinylbenzamide underwent vinyl-type polymerization by anionic initiators to form the polystyrene derivative, whereas in dimethyl sulfoxide as solvent the aromatic polyamide was always obtained through a proton-transfer mechanism regardless of the presence of the salts. In the presence of of the salts, acrylamide is generally polymerized to the polyamide through a proton transfer reaction.     

Polymerization of butadiene initiated by the 1:1 chelate of n-butyllithium and N,N,N′,N′-tetramethylethylenediamine

Evidence is given for the species involved in the initiation and propagation steps in the polymerization of butadiene with n-butyl lithium: tetramethylethylene diamine (TMEDA) as being the monomeric butyl lithium and the solvated ion pair, (A), respectively. Species A is also produced on the metalation of polybutadiene with butyl lithium: TMEDA.     

Durch Nachbargruppenbeteiligung induzierte (1,2)-Chlorwasserstoff-Eliminierung aus ionisiertem 2-(β-Chloräthyl)- benzoesäuremethylester

By using deuterium labelled compounds and collisional activation spectra the mechanism of the unusually intensive HCl elimination from 2-(β-chloroalkyl)benzoic acid methyl ester as well as the structure of the product ion have been elucidated. It can be shown that the structure of the stable ion (lifetime τ～10?5 s) is best represented by 2-vinyl benzoic acid methyl ester whereas the reactive ion (lifetime τ<10^?6 s) at least partially rearranges to a cyclic ion. The hydrogen chloride elimination from 2-(β-chloroalkyl)benzoic acid is apparently a simple 1,2 process. A closer examination reveals that the reaction represents a further example of an unusual neighbouring group participation of the ester function.     

Polymerization of aromatic nuclei. XIX. Polymerization of thiophene by aluminum chloride

Thiophene was polymerized in high yield on exposure to aluminum chloride in solvent under mild conditions. Experimental evidence [IR, NMR, UV, and mass spectra, elemental analyses, reductive desulfurization, and comparison with the literature trimer of thiophene (prepared with phosphoric acid)] suggests the following structure: From gel permeation chromatography an average weight of 1290 was obtained, which corresponded to the presence of 15 rings; the highest-molecular-weight chains contained about 192 rings. Mechanistically, participation of cationic intermediates is proposed. Apparently chain extension can occur by various routes, including participation of neutral oligomer molecules.