Generation of high-contrast and high-intensity laser pulses using an OPCPA preamplifier in a double CPA, Ti:sapphire laser system

We demonstrate a high-contrast, high-intensity double chirped-pulse amplification (CPA) Ti:sapphire laser system using an optical parametric chirped-pulse (OPCPA) pre- amplifier. By injecting cleaned microjoule seed pulses into the OPCPA, a temporal contrast greater than 10¹⁰ within picosecond times before the main femtosecond pulse is demonstrated with an output pulse energy of 1.7 J and a pulse duration of 30 fs, corresponding to a peak power of 60 TW at a 10 Hz repetition rate. This system uses a cryogenically-cooled Ti:sapphire final amplifier and generates focused peak intensities in excess of 10²⁰ W/cm².     

1.5 mJ, 6.4 fs parametric chirped-pulse amplification system at 1 kHz

We demonstrate an optical parametric chirped-pulse amplification (OPCPA) system with the pulse energy of 1.5 mJ at a 1 kHz repetition rate. The newly developed 100 ps Ti:sapphire pump laser system, which was optically synchronized with OPCPA seed pulses, delivered 10 mJ, 400 nm pump pulses. After three-stage parametric amplification, recompression of the amplifier output from 45 ps to 6.4 fs was performed. The pulse width of 6.4 fs is, to our knowledge, the shortest ever obtained by OPCPA, and the average power of 1.5 W (1.5 mJ, 1 kHz) is believed to be the highest among few-cycle OPCPA systems.     

0.85-PW, 33-fs Ti:sapphire laser

We have successfully produced a laser pulse with a peak power of 0.85 PW for a pulse duration of 33 fs in a four-stage Ti:sapphire amplifier chain based on chirped-pulse amplification. To our knowledge this result represents the highest peak power pulses yet produced in any Ti:sapphire chirped-pulse amplification system.     

High-energy, high-contrast, multiterawatt laser pulses by optical parametric chirped-pulse amplification

We describe a compact, reliable, high-power, and high-contrast noncollinear optical parametric chirped-pulse amplifier system. With a broadband Ti:sapphire oscillator and grating-based stretching and compression, the chirped pulses are amplified from 0.1 nJ to 122 mJ in type I beta-barium borate optical parametric chirped-pulse amplifiers with a total gain of over 10(9) at 10 Hz repetition rate. Pulse compression down to 19-fs duration achieved after amplification indicates a peak power of 3.2 TW at an average power of 0.62 W. The prepulse contrast is measured to be less than 10(-8) on picosecond time scales.     

Development of a high-contrast,high-peak power,Ti:Sapphire/OPCPA laser system

We report on a high-contrast, high-peak power laser system, which combines both conventional laser amplification and optical parametric chirped pulse amplification (OPCPA) techniques. By employing an OPCPA system after a regenerative amplifier, we have enhanced the prepulse contrast by six orders of magnitude. A prepulse contrast of better than 4.4 × 10^?11 has been measured with a high-energy broadband pulse of 24 mJ at a 10 Hz repetition rate from the OPCPA system. With a subsequent four-pass Ti:sapphire amplifier, we have achieved an amplified energy of 279 mJ and an ultrashort recompressed amplified pulse duration of 23.5 fs. We also discuss the basic design aspects and present our preliminary experimental investigations for higher energy operation to a multijoule.     

Broadband femtosecond OPCPA system driven by the single-shot narrow-band iodine photodissociation laser SOFIA

A two-stage optical parametric amplifier driven by a frequency-tripled beam from the high-energy iodine laser system SOFIA was built. This single-shot Optical Parametric Chirped Pulse-Amplification facility (OPCPA) and the system synchronizing the pump and signal pulses are described in detail. The chirped seed pulse of a Ti:sapphire oscillator running at the central wavelength of 800?nm is amplified in the two-stage (LBO and KDP) optical parametric amplifier over 10⁸ times. The amplified spectral bandwidth of 68?nm corresponds to the pulse duration of 14?fs when a transform-limited pulse is assumed. This implies a compressed pulse of TW power. Systematic gain measurements reveal a good match with the theoretical predictions. Signal and idler beam fluence profiles are presented. The suitability of the iodine photo-dissociation laser as a pump source for the OPCPA technique is thus proved for the first time experimentally. A distinctive feature of the iodine laser is its very narrow gain bandwidth (<0.1?cm^?1) and, therefore, the conventional chirped-pulse amplification technique does not lead to pulse durations at the femtosecond level.     

Optical switching and contrast enhancement in intense laser systems by cascaded optical parametric amplification

Optical parametric chirped-pulse amplification (OPCPA) can be used to improve the prepulse contrast in chirped-pulse amplification systems by amplifying the main pulse with a total saturated OPCPA gain, while not affecting the preceding prepulses of the seed oscillator mode-locked pulse train. We show that a simple modification of a multistage OPCPA system into a cascaded optical parametric amplifier (COPA) results in an optical switch and extreme contrast enhancement that can completely eliminate the preceding and trailing oscillator pulses. Instrument-limited measurement of a prepulse contrast ratio of 1.4 x 10(11) is demonstrated from COPA at a 30 mJ level.     

Hundred mJ, sub-picoseconds, high temporal contrast OPCPA/Yb:YAG ceramic thin disk hybrid laser system

The authors have demonstrated an optical parametric chirped-pulse amplification (OPCPA)/Yb:YAG ceramic thin disk hybrid laser system having hundred mJ level pulse energy sub-picosecond pulse duration with high temporal contrast. At an input chirped-pulse energy of 3.8?mJ from an OPCPA preamplifier an output energy of 130?mJ has been generated from multipass diode-pumped Yb:YAG ceramic thin disk amplifier. A recompressed pulse duration of 450?fs with a contrast level of less than 7.2×10^?9 at ?150?ps before the main pulse has been obtained. The contrast level is the highest value achieved in Yb:YAG chirped-pulse amplification (CPA) laser system at 100?mJ level.     

Femtosecond pulse parametric amplification at narrowband high power gas laser pumping

In ultrashort pulse amplification a narrowband gas pump pulse laser has been used for the first time. An all-stage optical parametric chirped pulse amplifier (OPCPA) was driven by a single-shot iodine photodissociation laser. For the first time a broadband amplification was achieved in potassium dihydrogen phosphate crystal at 800 nm seeding. Ti:sapphire laser pulses stretched from 12.5 fs to 250 ps were amplified and compressed to 27 fs at a 0.5 TW output power. The results suggest using narrowband high power gas lasers as OPCPA drivers to generate petawatt beams.     

Proton acceleration to 40 MeV using a high intensity, high contrast optical parametric chirped-pulse amplification/Ti:sapphire hybrid laser system

Using a high-contrast (10(10):1) and high-intensity (10(21) W/cm(2)) laser pulse with the duration of 40 fs from an optical parametric chirped-pulse amplification/Ti:sapphire laser, a 40 MeV proton bunch is obtained, which is a record for laser pulse with energy less than 10 J. The efficiency for generation of protons with kinetic energy above 15 MeV is 0.1%.     

Generation of 10(11) contrast 50 TW laser pulses

We demonstrate what we believe to be the highest-contrast (10(11)), multiterawatt, chirped-pulse amplification (CPA) Ti:sapphire laser by applying the modified cross-polarized-wave (XPW) generation method. This method produces a contrast improvement of 3 orders of magnitude using microjoule input energy. Microjoule energy can be achieved by direct amplification without the complications of a double CPA system. The 10(11) contrast is sufficient for experiments on high-damage-threshold solid targets with focused intensities up to 10(22) W/cm(2).     

Contrast and phase characterization of a high-peak-power 20-fs laser pulse

We fully characterize a high-peak-power, ultrashort laser pulse in a Ti:sapphire chirped-pulse amplification laser system. The contrast, temporal, and spectral phases of the 20-fs pulse are determined by using high-dynamic-range cross-correlation and frequency-resolved optical gating techniques. Minimization of the total phase error can be achieved by balancing the phase terms of the group delay dispersion and quartic. The laser system is currently being applied to perform high-field atomic ionization experiments at 10²⁰ W/cm².     

Experimental demonstration of joule-level non-collinear optical parametric chirped-pulse amplification in yttrium calcium oxyborate

In this Letter, we report on what is, to our knowledge, the first experimental demonstration of yttrium calcium oxyborate (YCOB) for joule-level and broadband non-collinear optical parametric chirped-pulse amplification centered at 800 nm. Based on a Ti:sapphire chirped-pulse amplification front end, an amplified signal energy of 3.36 J was generated with a pump of 35 J in the crystal. Compressed pulse duration of 44.3 fs, with a bandwidth of 49 nm, was achieved. The results confirm that YCOB crystal is another potential alternative as a final amplifier besides Ti:sapphire in a petawatt laser at 800 nm.     

Compact, high-throughput expansion-compression scheme for chirped pulse amplification in the 10 fs range

A novel pulse stretching-compression system suitable for kHz-rate chirped-pulse amplification of ≈10 fs pulses in Ti:sapphire systems is demonstrated. The material dispersion of the system components used for pulse selection and isolation broadens the wide-band seed pulses by a factor of ≈300, allowing amplification up to the submillijoule energy range. The compressor consists of a pair of prisms and newly-developed chirped multilayer dielectric mirrors for compensating high order dispersion. Using this simple scheme a recompression of unamplified pulses down to 15 fs with a throughput as high as 80% is demonstrated.     

Multimillijoule chirped parametric amplification of few-cycle pulses

The concept of optical parametric chirped-pulse amplification is applied to attain pulses with energies up to 8 mJ and a bandwidth of more than 100 THz. Stretched broadband seed pulses from a Ti:sapphire oscillator are amplified in a multistage noncollinear type I phase-matched beta-barium borate parametric amplifier by use of an independent picosecond laser with lock-to-clock repetition rate synchronization. Partial compression of amplified pulses is demonstrated down to a 10-fs duration with a down-chirped pulse stretcher and a nearly lossless compressor comprising bulk material and positive-dispersion chirped mirrors.     

Phase-preserving chirped-pulse optical parametric amplification to 17.3 fs directly from a Ti:sapphire oscillator

Phase-stabilized 12-fs, 1-nJ pulses from a commercial Ti:sapphire oscillator are directly amplified in a chirped-pulse optical parametric amplifier and recompressed to yield near-transform-limited 17.3-fs pulses. The amplification process is demonstrated to be phase preserving and leads to 85-microJ, carrier-envelope-offset phase-locked pulses at 1 kHz for 0.9 mJ of pump, corresponding to a single-pass gain of 8.5 x 10(4).     

High-repetition-rate 12 fs pulse amplification by a Ti:sapphire regenerative amplifier system

We demonstrate the direct generation of 12 fs pulses from a Ti:sapphire regenerative amplifier system at a 1 kHz repetition rate utilizing properly designed broadband components for chirped-pulse amplification. Optimized designs of a regenerative amplifier with a multilayer gain-narrowing compensator and an adaptive dispersion compensator with a spatial light modulator contribute to the shorter pulse amplification.     

High-power parametric amplification of 11.8-fs laser pulses with carrier-envelope phase control

Phase-stable parametric chirped-pulse amplification of ultrashort pulses from a carrier-envelope phase-stabilized mode-locked Ti:sapphire oscillator (11.0 fs) to 0.25 mJ/pulse at 1 kHz is demonstrated. Compression with a grating compressor and a LCD shaper yields near-Fourier-limited 11.8-fs pulses with an energy of 0.12 mJ. The amplifier is pumped by 532-nm pulses from a synchronized mode-locked laser, Nd:YAG amplifier system. This approach is shown to be promising for the next generation of ultrafast amplifiers aimed at producing terawatt-level phase-controlled few-cycle laser pulses.     

Sub-picosecond pulses at 100 W average power from a Yb:YLF chirped-pulse amplification system

We present a high-repetition-frequency, diode-pumped, and chirped-pulse amplification system operating at 106 W average output power with excellent beam quality (M(2)=1.3), based on cryogenically cooled Yb:YLF. 1 nJ seed pulses, derived from a mode-locked Ti:sapphire laser, are first amplified to 1 mJ pulse energy at 10 kHz repetition frequency in a regenerative amplifier. The second-stage, multipass amplifier increases the pulse energy to 10.6 mJ, resulting in a spectral width of 2.2 nm. The pulses are compressed to 865 fs in duration, which is 1.26 times the transform limit.     

Broadband, high gain two-stage optical parametric chirped pulse amplifier using BBO crystals for a femtosecond high-power Ti:sapphire laser system

We design a two-stage non-collinear optical parametric chirped pulse amplifier using BBO crystals for a high-power Ti:sapphire laser system, and numerically analyze the output characteristics of the OPCPA system. We find optimal phase-matching conditions and calculate the parametric gains as a function of pump intensity and interaction length. By constructing a two-stage OPCPA system using two BBO crystals, we obtain 12 mJ output energy corresponding to a high gain of 10⁷, a pulse duration of 37 fs, and a contrast ratio of 5×10⁻⁸.