Spectrophotometric determination of formaldehyde by using formaldehyde dehydrogenase

A new method for the determination of formaldehyde by using formaldehyde dehydrogenase is described. The method is based on the quantitative oxidation of formaldehyde with oxidized nicotinamide adenine dinucleotide (NAD⁺), in the presence of formaldehyde dehydrogenase, to form the reduced dinucleotide (NADH). This enzyme does not require glutathione as a co-factor and the NADH produced, which is directly proportional to the concentration of formaldehyde in the assay solution, is then measured spectrophotometrically at 340 nm. Formaldehyde can be determined in the range 0.3–8.0 μg ml^?1 (1.0×10^?5–2.7× 10^?4 M) with a sensitivity of 0.216 absorbance/ μg ml^?1 (0.0065 absorbance/μM). Optimal conditions and the selectivity of this enzyme toward formaldehyde are described.     

Singlet-triplet perturbations in formaldehyde

The magnetic rotation spectrum of formaldehyde in the region of 3260 Å has been studied under high resolution using magnetic flux densities ranging from 80–5000 G. Approximately 40 magnetically sensitive rotational levels have been identified. Matrix elements and possible mechanisms are discussed.     

Hydroformylation of formaldehyde

The reaction between hydridotetracarbonylcobalt and monomeric formaldehyde at 0°C in the presence of 1 atm of carbon monoxide leads to stoichiometric hydroformylation with the formation of glycolaldehyde in high yield.     

Analysis of infrared intensities in formaldehyde

Results obtained from band contour simulation have been used for separating the individual absolute intensities of overlapping bands in the infrared spectrum of formaldehyde. By the methods of intensity analysis the derivatives of dipole moment with respect to symmetry coordinates were evaluated, and the results were confirmed by quantum-chemical methods.     

Spectrophotometric determination of formaldehyde in air

A spectrophotometric method for the determination of formaldehyde in air is described, based on the colour reaction of formaldehyde, p-aminoazobenzene and sulphur dioxide in hydrochloric acid medium. Beer's law is obeyed at 505 nm in the range 2-12 mug of formaldehyde per 25ml of final solution (0.08-0.48 ppm). Optimum conditions for colour development, and possible interferences, have been studied.     

The vibrations of formaldehyde

A new six-dimensional variational code is presented for the determination of the vibrational energy levels of four-atom molecules which are either linearly connected or centrally connected. Internal (displacement) coordinates are used. It is demonstrated for the CCSD(T) surface of formaldehyde, due to Martin, Lee and Taylor, and it is shown that a small scaling of the force constants leads to a high-accuracy surface.     

Fluorometric determination of formaldehyde

A simple, selective and sensitive fluorometric method is presented for the determination of formaldehyde in water based on its reaction with 3,4-diaminoanisole in alkaline ethanol-water solution to give a strongly fluorescing Schiff base. The dependence of the fluorescence intensity on the solvent composition, quenching by acetic and sulphuric acid, heating time and interference by other compounds is discussed. The detection limit of the method is 0.6 μg/L. The recovery of formaldehyde spiked into river water is 93% with an R.S.D of 6.05% at a concentration level of 10 μg/L.     

Fluorometric determination of formaldehyde

A simple, selective and sensitive fluorometric method is presented for the determination of formaldehyde in water based on its reaction with 3,4-diaminoanisole in alkaline ethanol-water solution to give a strongly fluorescing Schiff base. The dependence of the fluorescence intensity on the solvent composition, quenching by acetic and sulphuric acid, heating time and interference by other compounds is discussed. The detection limit of the method is 0.6 μg/L. The recovery of formaldehyde spiked into river water is 93% with an R.S.D of 6.05% at a concentration level of 10 μg/L. Received: 18 November 1996 / Revised: 17 February 1997 / Accepted: 18 February 1997     

Transformations of formaldehyde and glycolaldehyde during the hydroformylation of formaldehyde in the presence of rhodium catalysts

Hydroformylation of formaldehyde to give glycolaldehyde (GA) in the presence of RhCl(PPh₃)₃, RhCl(CO)(PPh₃)₂, or the RhCl₃ + PPh₃ system inN,N-dimethylacetamide was studied. The hydroformylation is accompanied by the Cannizzaro-Tishchenko reaction, condensation of CH₂O with GA to give C₃-C₁₆ polyoxyaldehydes (POA), and dimerization of GA. The formation of POA, which probably occurs through coordination of GA with a Rh atom, predominates among the side reactions. The optimum conditions for hydroformylation of CH₂O were found to be: RhCl₃ + PPh₃ as the catalyst,T 383 K, 12MPa, [H₂O] 1.8 mol L^–1, [Rh] 2.5 · 10^–3 g-at. L^–1, and [CH₂O] 0.03 g L^–1. At a substrate conversion of 62–67 %, the selectivity of GA formation reaches 96 %, and the yield is 60–65 %.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 1, pp. 75–78, January, 1995.     

Spectrophotometric determination of formaldehyde

A new spectrophotometric method for the determination of micro amounts of formaldehyde in aqueous and methanol solutions is based on the oxidation of formaldehyde by hydrous silver oxide at pH 11-12.5 and oxidation of the metallic silver produced, with iron(III) in the presence of Ferrozine. The absorbance of the resulting iron(II)-Ferrozine complex at 562 nm is proportional to the amount of formaldehyde and corresponds to an apparent molar absorptivity of 5.58 x 10(4) 1.mole(-1).cm(-1).     

Lifetimes of triplet formaldehyde

By direct optical excitation into the ³A₂ state of H₂CO (D₂CO) with a tunable laser, phosphorescence is observed and lifetimes are measured for this state. Very short lifetimes, apparently limited by intersystem crossing, are observed.     

Flow-injection chemiluminescence determination of formaldehyde in water

A modification of the Trautz-Schorigin reaction into a flow-injection analysis configuration is described. Different approaches were used at the optimization of chemiluminescence determination of formaldehyde in water based on the reaction of formaldehyde, gallic acid and hydrogen peroxide in an alkaline solution. Detection system with a 218 μl chemiluminescence cell was optimized by both a one-variable-at-a-time method, and a modified simplex method. A calibration graph is linear in the concentration range 4 × 10⁻⁸ to 1 × 10⁻⁵ M HCHO. The detection limit of formaldehyde for a signal-to-noise ratio of 3 is 4 × 10⁻⁸ M. The relative standard deviations for 15 repeated measurements of 1 × 10⁻⁶ and 5 × 10⁻⁶ mol l⁻¹ HCHO are 4.32 and 3.33%, respectively. The analysis time is 1.5 min. The method was applied to the determination of formaldehyde in urban rainwater. A comparison of results found by proposed method with those obtained by fluorimetric reference method provided a good agreement.     

Spectrofluorimetric determination of formaldehyde in maple syrup

A quick and simple method was developed for determination of formaldehyde in maple syrup. In this method, formaldehyde reacts with Fluoral P to form a complex which is chemically extracted by isobutanol and determined by spectrofluorimetry. Performance, as gauged by the limits of detection (0.16 mg/kg) and quantitation (0.21 mg/kg), recovery (>79%), and variability (1.9-16.1%, depending on fortification level and class of syrup) were superior to the current official AOAC standard method.     

Headspace gas-chromatographic determination of formaldehyde in urine

A method is proposed for determining formaldehyde by headspace gas chromatography using an o-(2,3,4,5,6-pentafluorobenzyl)hydroxylamine (PFBHA) derivatizing agent. Formaldehyde in urine was derivatized to o-(pentafluorobenzyl)oxime and extracted by heating an urine sample with PFBHA in a sealed vial. Gas-chromatographic analysis of the headspace was performed in the temperature-programmed mode using an HP-5 capillary column with a flame ionization detector. The limit of detection is 3.5 μg/L. The accuracy of the procedure, equivalent to an extended relative uncertainty, does not exceed 21%. The examination of the procedure using urine samples of the population of the Irkutsk region has shown that the regional reference levels of formaldehyde concentration are in the range 44–83 μg/L.     

GDME-based methodology for the determination of free formaldehyde in cosmetics and hygiene products containing formaldehyde releasers

Analytical and Bioanalytical Chemistry - Formaldehyde is often applied in the industrial production of different products, such as textiles, insulation materials, or cosmetics, due to its...     

CIDNP during photoreactions of formaldehyde in solution

CIDNP has been studied during photolysis of formaldehyde in solution. The primary photochemical process is the hydrogen abstraction by predominant triplet excited formaldehyde from ground state formaldehyde. In the presence of bromotrichloromethane a singlet reaction occurs.     

Direct detection of formaldehyde in air by a novel NAD+- and glutathione-independent formaldehyde dehydrogenase-based biosensor

An amperometric enzyme-based sensor-system for the direct detection of formaldehyde in air is under investigation. The biosensor is based on a native bacterial NAD(+)- and glutathione-independent formaldehyde dehydrogenase as biorecognition element. The enzyme was isolated from Hyphomicrobium zavarzinii strain ZV 580, grown on methylamine hydrochloride in a fed-batch process. The sensor depends on the enzymatic conversion of the analyte to formic acid. Released electrons are detected in an amperometric measurement at 0.2V vs. Ag/AgCl reference electrode by means of a redox-mediator. To optimize the sensing device, Ca(2+) and pyrroloquinoline quinone (PQQ) were added to the buffer solution as reconstitutional substances. At this stage, the sensor shows linear response in the tested ppm-range with a sensitivity of 0.39 microA/ppm. The signal is highly reproducible with respect to sensitivity and base line signal. Reproducibility of sensitivity is more than 90% within the same bacterial batch and even when enzyme of different bacterial batches is used.     

A colorimetric formaldehyde assay

A room-temperature assay of formaldehyde is described. The assay uses few reagents and is colorimetric, read at a wavelength of 649 nm. Tryptophan and tryptamine were noted as interfering with the assay, probably by binding with the formaldehyde. High levels of sugar show smaller effects on final absorbance. Glyceraldehyde also reacts in the assay, but six other aldehyde compounds do not, although they do reduce the absorbance of added formaldehyde.     

Condensation of formaldehyde with trifluoroethylene

Summary The condensation of trifluoroethylene with paraformaldehyde in the presence of sulfuric and chlorosulfonic acids has been carried out. -Fluorohydracrylic, -fluoro--chloropropionic, and -fluoro--bromopropionic acids have been obtained.