Hydrothermal synthesis of ZnO nanobelts and gas sensitivity property

The ZnO nanobelts were synthesized by a hydrothermal method. The XRD spectrum indicates that the sample is wurtzite (hexagonal) structured ZnO with lattice constants of , . SEM and TEM images show the nanobelts to have lengths of 10-20 μm, widths of 50-500 nm, thicknesses of about 30-60 nm, and growth direction of [0001]. Gas sensitivity experiments on ZnO nanobelts were carried out under different temperatures. The results indicated high sensitivities with an operating temperature of only 220 ^°C for the oxidative gas O₂, and 305 ^°C for the gas N₂. The mechanism of gas sensitive effects is analyzed in detail.     

Optical phonon modes and structure of ZnGa2Se4 and ZnGa2S4

We present the infrared and Raman study of the optical phonon modes of the defective compounds ZnGa₂Se₄ and ZnGa₂S₄. Most of the compounds have been found to crystallize in the thiogallate structure (defect chalcopyrite) with space group where all cations and vacancies are ordered. For some Zinc compounds a partially disordered cationic sublattice with various degrees of cation and vacancy statistical distribution, which lead to the higher symmetry (defect stannite), has been reported. For ZnGa₂Se₄ we have found three modes of A symmetry, showing Raman activity only. In addition, we have observed each five modes of B and E symmetry, showing infrared as well as Raman activity. The number of modes and their symmetry assignment, based on polarized measurements, clearly indicate space group for the investigated crystals of ZnGa₂Se₄.Regarding ZnGa₂S₄ we have found three modes exclusively showing Raman activity (2A⊕1B₁), and only eight modes showing infrared as well as Raman activity (3B₂⊕5E). The assignment of the modes has been derived by analyzing the spectral positions of the vibrational modes in comparison to a number of compounds. From the number and symmetry assignment of the optical phonon modes we confirm that ZnGa₂S₄ most likely crystallizes in space group .     

Preparation-dependent properties of Ca(Cu,Mn)7O12 CMR materials

Both magnetic ordering temperatures and lattice constants were observed to be a function of preparation temperature for single-phase CaCuMn₆O₁₂ CMR ceramics of the same cation, oxygen composition and crystal structure. It was found for the first time that higher preparation temperatures result in a linear increase of a cubic cell parameter a, , and in a sharp decrease of magnetic ordering temperatures , by about , for quenched samples. High resolution NPD experiments have shown the presence of antisite defects resulting in partial occupation of octahedral (8c) sites by Cu²⁺ at higher preparation temperatures as never assumed for an ideal structure. The data obtained give a new insight to the problem of functional properties reproducibility suggesting stronger requirements for the production control of CMR materials.     

Measurements of insulator band parameters using combination of single-electron and two-electron spectroscopy

We describe the application of low energy time-of-flight coincidence (e,2e) spectroscopy for measurements of the energy band parameters of a dielectric. The (e,2e) spectrometer can operate also in a single-electron mode by switching off coincidence conditions, and can be used for recording electron energy loss spectra (EELS). Thus, the combination of (e,2e) and EELS allows the measurement of energy gap E_g, valence bandwidth ΔE_val, electron affinity χ and excitonic levels position E_ex of a dielectric. The energy band parameters of LiF film deposited on Si(001) surface are measured: ΔE_val=      

Rotational spectrum of HCBr produced by 193-nm laser photolysis of bromoform

The pure rotational spectrum of bromomethylene (HCBr) was studied by kinetic microwave spectroscopy between 420 and 472 GHz. The HCBr radical was produced by 193-nm ArF laser photolysis of bromoform (CHBr₃). More than 130 rotational transitions for both and species in the ground vibrational state were measured involving 1?J?33 and 0?K_a?5. The spectra were well described by an S-reduced Watson Hamiltonian in the I^r representation including the nuclear quadrupole and spin-rotation hyperfine terms. Rotational, centrifugal distortion, nuclear quadrupole and spin-rotation coupling constants were derived for both and species in the ground vibrational state.     

Oxidation of a ZnS nanobelt into a ZnO nanotwin belt or double single-crystalline ZnO nanobelts

Single-crystalline wurtzite ZnS nanobelts are synthesized by the vapor phase transport (VPT) process. When oxidized, a single-crystalline ZnS nanobelt turns into a ZnO nanotwin belt containing two twinning parts with a sharp and clear edge, which is a (0001) twinning plane parallel to and running through the length direction. The two twinning parts in a ZnO nanotwin belt have the same crystalline direction, [0001], along their width, and the and crystalline directions along the length direction. On some ZnO nanobelts, nanovoids appear along the twinning planes and when those nanovoids connect with each other, one original ZnS nanobelt can divide into two single-crystalline ZnO nanobelts with quite clear edges.     

Effect of high temperature treatments on defect centers and impurities in hydrothermally grown ZnO

Deep level transient spectroscopy (DLTS) has been employed to study electron traps in hydrothermally grown n-type ZnO samples after thermal treatments up to 1500 °C. Schottky barrier contacts were formed by e-beam evaporation of Pd, followed by DLTS and secondary ion mass spectrometry (SIMS) measurements in order to investigate possible correlations between electron traps in the upper part of the band gap and the concentration of the most prominent impurities. The DLTS results show three different levels having energy positions of , , and (E_c denotes the conduction band edge). The SIMS results showed that the most pronounced impurities were Li, Al, Si, Mg, Fe, Mn, and Ni with concentrations up to . A decrease in the level is observed after temperature treatments above 1300 °C, and in the same temperature range the Li concentration drops from ∼10¹⁷ to . However, based on absolute concentration values an association between Li and the level can be ruled out. In contrast, the level, which is not stable above 1300 °C, may be associated with Li but further experimental data are needed to substantiate this assignment. The level occurred in selected samples and is presumably impurity-related but no correlation was found with the main impurities detected by SIMS. Except for Li, the concentration of all the impurities remained essentially constant as a function of heat treatment temperature.     

Room temperature ferromagnetism in Zn-Mn-O

Zn-Mn-O semiconductor crystallites with nominal manganese concentration x=0.01, 0.04 and 0.10 were synthesized by a solid state reaction method using oxalate precursors. A sintering procedure was carried out in air at 500 and 900  ^°C. The samples were investigated by X-ray diffraction, magnetization measurements and electron paramagnetic resonance. X-ray diffraction spectra reveal that the dominant crystal phase in the Zn-Mn-O system corresponds to the wurtzite structure of ZnO. Room temperature ferromagnetism is observed in Zn-Mn-O samples with manganese concentrations x=0.01 and 0.04 sintered at low temperature (500  ^°C). Saturation magnetization in the x=0.01 sample is found to be at . The ferromagnetic phase seems to be developed by Zn diffusion into Mn-oxide grains.     

The high quality ZnO growth on c-Al2O3 substrate with Cr2O3 buffer layer using plasma-assisted molecular beam epitaxy

High quality epitaxial ZnO films were grown on c-Al₂O₃ substrates with Cr₂O₃ buffer layer by plasma-assisted molecular beam epitaxy (P-MBE). The hexagonal crystalline Cr₂O₃ layer was formed by oxidation of the Cr-metal layer deposited on the c-Al₂O₃ substrate using oxygen plasma. The epitaxial relationship was determined to be ZnO//Cr₂O₃//Cr//Al₂O₃ and ZnO//Cr₂O₃//[0 0 1]Cr//Al₂O_3. The Cr₂O₃ buffer layer was very effective in improving the surface morphology and crystal quality of the ZnO films. The photoluminescence spectrum showed the strong near band-edge emissions with the weak deep-level emission, which implies high optical quality of the ZnO films grown on the Cr₂O₃ buffer.     

4-benzyl pyridinium dihydrogenmonophosphate C6H5CH2C5H4NHH2PO4 : Single-crystal structure and its conductivity in polycrystalline form

The salt 4-benzyl pyridinium dihydrogenmonophosphate is monoclinic P2₁/c with the following unit cell dimensions: ; ; ; and β=97.328(11). Also, , D_x=1.403, , F(000)=560; ; and R=0.0495 and R_w=0.0964 for 3733 independent reflections. The structure consists of infinite parallel two-dimensional planes built of H₂PO₄⁻ anions and C₆H₅CH₂C₅H₄NH⁺ cations mutually connected by strong O-H ?O and N-H ?O hydrogen bonding. There are no contacts other than the normal Van der Waals interactions between the layers. The conductivity relaxation parameters associated with some H⁺ conduction have been determined from an analysis of the spectrum measured in a wide temperature range.     

Electro-optic behavior of lithium niobate at cryogenic temperatures

The unclamped relative permittivity, , and the Pockels coefficient, , of congruent lithium niobate at a frequency f = 5760 Hz have been determined at low temperatures (7 K < T < 300 K). A He cryostat setup mounted to one arm of an electronically phase-stabilized Michelson interferometer was utilized for the measurement of . A continuous decrease in both parameters was observed as T → 0 K with limiting values of and , respectively.     

First-principles study on the formation energies of intrinsic defects in LiNbO3

First-principles plane-wave ultrasoft pseudopotential method within local density approach (LDA) has been used to study three possible vacancy-defect models for non-stoichiometric lithium niobate (LiNbO₃): (1) the oxygen-vacancy model , (2) the niobium-vacancy model , and (3) the lithium-vacancy model . The corresponding formation energies are obtained via energy minimization of a supercell. In Nb-rich environment, the calculated defect formation energies, both under oxidation and reduction conditions, show little effect on the intrinsic defect structures. We find that the lithium vacancy model has the most stable configuration in the non-stoichiometric lithium niobate crystals. Our calculations also show that the formation of any type of neutral defects and Frenkel pairs in a Nb-rich environment is difficult.