| 结构参数对静电驱动微机械陀螺动态性能的影响 |
| |
| 引用本文： | 李欣业,王雅雪,张华彪,张利娟,于涛.结构参数对静电驱动微机械陀螺动态性能的影响[J].应用数学和力学,2021,42(12):1248-1257. |
| |
| 作者姓名： | 李欣业 王雅雪 张华彪 张利娟 于涛 |
| |
| 作者单位： | 1.河北工业大学 机械工程学院, 天津 300401 |
| |
| 基金项目： | 国家自然科学基金（11972145；11302223） |
| |
| 摘 要： | 为研究结构参数对静电驱动微机械陀螺动态性能的影响，考虑支承刚度的三次非线性和静电力的分式非线性，基于两自由度动力学模型，利用谐波平衡法结合留数定理求解了系统的周期响应，得到了驱动电极的梳齿厚度、梳齿间隙以及检测电极的极板面积、极板间隙变化时电容变化量随驱动力频率和载体角速度的变化曲线，以及电容灵敏度和非线性度随这些参数的变化曲线。结果表明，检测电容变化量随驱动力频率的变化曲线会呈现明显的非线性特征，即第二个峰向右倾斜，从而引起跳跃现象。驱动电极的梳齿厚度、梳齿间隙和检测电极的极板间隙对检测电容变化量随载体角速度的变化影响较大，而检测电极的极板面积的影响很小。驱动电极梳齿厚度、梳齿间隙以及检测电极的极板面积对电容灵敏度和非线性度的影响基本上是线性的，但检测电极的极板间隙对电容灵敏度和非线性度的影响是非线性的。
|
| 关 键 词： | 微机械陀螺 三次非线性刚度 分式非线性静电力 周期响应 灵敏度分析 非线性度分析 |
| 收稿时间： | 2020-10-19 |
Effects of Structure Parameters on Dynamic Performances of Electrostatic Drive Micro-Machined Gyroscopes |
| |
| Affiliation: | 1.School of Mechanical Engineering, Hebei University of Technology, Tianjin 300401, P.R.China2.School of Mechanical Engineering, Tianjin University of Commerce, Tianjin 300134, P.R.China3.School of Automotive & Transportation, Tianjin University of Technology and Education, Tianjin 300222, P.R.China |
| |
| Abstract: | In view of the cubic nonlinear stiffness and the nonlinear electrostatic force in fraction form, a 2DOF model was analyzed with the harmonic balance method and the residue theorem, and the effects of structure parameters on dynamic performances of micro-machined gyroscopes were studied. The variations of the capacitance with the driving force frequency and the carrier angular velocity were obtained for different thicknesses and gaps of driving electrode comb teeth, different electrode plate areas and different detecting electrode gaps. In addition, the variations of sensitivity and nonlinearity with these structure parameters were also presented. It is found that, the variation curves of the detection capacitance with the driving force frequency show obvious nonlinear characteristics. In other words, the 2nd peak leans rightward, which results in jumping. The effects of thicknesses and gaps of driving electrode comb teeth, and gaps between detecting electrode plates on the variation curves of the capacitance with the carrier angular velocity are much greater than those of detecting electrode plate areas. The variations of sensitivity and nonlinearity with thicknesses and gaps of driving electrode comb teeth and detecting electrode plate areas, are approximately linear, however, those with gaps between detecting electrode plates are nonlinear. |
| |
| Keywords: | |
|
| 点击此处可从《应用数学和力学》浏览原始摘要信息 |
|
点击此处可从《应用数学和力学》下载全文 |
|
